Geoeffective Disturbances in the Solar Wind near the Solar Activity Minimum according to the Data of a Two-year Series of Observations of Interplanetary Scintillations with the BSA LPI Radio Telescope

Astronomy Reports - A joint analysis of the monitoring data of interplanetary scintillations with solar and geophysical data showed that at the descending phase of the 24 solar activity cycle, the...     

COMPUTATION AND MAPPING OF THE ELEMENTS OF THE WATER-ICE BUDGET OF GLACIERS

Two general approaches for compiling maps of components of the water-ice budget in regions of glacier nourishment are compared and the resulting maps are analyzed. The compilation of raw data is based on field measurements rather than remote sensing information. Translated by Edward Torrey, Alexandria, VA 22308 from: Materialy glyatsiologicheskikh issledovaniy, 1991, No. 72, pp. 94-102.     

Spin rate estimation of sounding rockets using GPS wind-up

Carrier phase wind-up is a well-known effect that arises from the relative rotation between a transmitting and receiving antenna. In GPS measurements at L1 frequency, this effect translates into an error of 19.029 cm per full relative rotation of antennas. Since this effect is independent of the satellite elevation for pure rotation about the antenna boresight axis, it is usually absorbed by the clock estimation in navigation algorithms. Therefore, the impact of wind-up is usually neglected for applications that do not require accuracies to the cm level like RTK. However, in receiving platforms with high rotation rate, the accumulated wind-up value can be important and actually be larger than receiver noise or even ionospheric variations. Therefore, in such scenarios, the wind-up contribution can be isolated and used as a source of information to compute the spin rate of such platforms using an appropriate combination of GPS observables. This work shows some results of a coarse, yet simple, approach to monitor the rotation angle and spin-rate of spin stabilized sounding rockets flown by DLR.     

Variability analysis of groundwater levels — AGIS-based case study

The present study has analyzed the variability in depth to water level below ground level (bgl) vis-à-vis groundwater development and rainfall from 1987 to 2007 in agriculture dominated Kaithal district of Haryana state in India. Spatial distribution of groundwater depth was mapped and classified into different zones using ILWIS 3.6 GIS tools. Change detection maps were prepared for 1987–1997 and 1997–2007. Groundwater depletion rates during successive decades were compared and critical areas with substantial fall in groundwater levels were identified. Further, block wise trends of change in groundwater levels were also analyzed. The water table in fresh belt areas of the district (Gulha, Pundri and Kaithal blocks) was observed to decline by a magnitude ranging from 10 m to 23 m. In Kalayat and Rajaund blocks, the levels were found fluctuating in a relatively narrow range of 4–9 m. During 1997–2007, the depletion has been faster compared to the preceding decade. Excessive groundwater depletion in major part of the district may be attributed to indiscriminate abstraction for irrigation and decrease in rainfall experienced since 1998. Changes in cropping pattern and irrigation methods are needed in the study area for sustainable management of the resource.     

Characterization and quantification of data voids in the shuttle Radar topography mission data

The goal of this study was to characterize and quantify the occurrence of data voids in data from the Shuttle Radar Topography Mission (SRTM) for the conterminous United States. For this purpose, SRTM data and corresponding data from the national elevation data were downloaded in 21 samples spatially organized to cover the main topography of the U.S. Void locations in SRTM data were compared to terrain attributes and subsequently the area of individual data voids to the same attributes. It was found that data voids amounted to 0.3% of the total dataset. Data voids were found in all topographic settings but more often in slopes steeper than approximately 20/spl deg/ that face south (170/spl deg/), and also in flat areas such as lakes and rivers. It was also found that more than 50% of all data voids were composed of connected pixels in groups less than six pixels. The largest data voids could be attributed to water bodies, while the rest could be explained by terrain-radar interaction characteristics.     

Change in cloud-top temperatures over Europe

Long-term measurements from Advanced Very High Resolution Radiometer (AVHRR) onboard the National Oceanic and Atmospheric Administration satellites were evaluated to assess variability in cloud-top temperatures over central and eastern Europe that saw radical infrastructural changes after the fall of the East Bloc in 1989 that has affected the pollution levels and hence cloud albedo. Four years in the late 1980s (1985-1988) and in the late 1990s (1997-2000) were chosen, as these are distinctively marked as episodes of very high and lower air pollution (sulphates and particulate matter). During the late 1980s, low- and medium-level clouds were colder by more than 2 K and convective clouds even by 4 K. Cloud-tops over and around polluted regions are higher, and their temperatures showed stronger variability, suggesting an indirect aerosol effect in the thermal spectral range as well.     

Wet tropospheric effects on precise relative GPS height determination

Summary Considerable interest has been generated recently in the use of the Global Positioning System (GPS) for precise height determination. A major error source in these measurements is the propagation delay due to atmospheric water vapour. In order to achieve the high precisions required for such applications as absolute sea-level monitoring improvement of wet delay modelling is necessary. Results from a GPS campaign show a significant correlation (0.91) between the variability of the wet delay measured using a water vapour radiometer (WVR) at the Onsala site and the absolute value of the residual error in the height determination of a 134 km baseline from Onsala to Jönköping. This correlation indicates that the atmosphericvariability as inferred from the WVR data includes information on the quality of the GPS height estimate. During periods of high atmospheric activity, e.g., during the passage of a weather front, the use of a six-parameter gradient model reduces the spread for the vertical coordinate from 40 mm to 20 mm (with standard deviations of 17 mm and 9 mm respectively) over the 134 km baseline (less than 1 × 10^–7) using 8 hour data spans on 11 different days over a six month period.     

Thermodynamic controls on element partitioning between titanomagnetite and andesitic–dacitic silicate melts

Titanomagnetite–melt partitioning of Mg, Mn, Al, Ti, Sc, V, Co, Ni, Cu, Zn, Ga, Zr, Nb, Mo, Hf and Ta was investigated experimentally as a function of oxygen fugacity (fO₂) and temperature (T) in an andesitic–dacitic bulk-chemical compositional range. In these bulk systems, at constant T, there are strong increases in the titanomagnetite–melt partitioning of the divalent cations (Mg²⁺, Mn²⁺, Co²⁺, Ni²⁺, Zn²⁺) and Cu²⁺/Cu⁺ with increasing fO₂ between 0.2 and 3.7 log units above the fayalite–magnetite–quartz buffer. This is attributed to a coupling between magnetite crystallisation and melt composition. Although melt structure has been invoked to explain the patterns of mineral–melt partitioning of divalent cations, a more rigorous justification of magnetite–melt partitioning can be derived from thermodynamic principles, which accounts for much of the supposed influence ascribed to melt structure. The presence of magnetite-rich spinel in equilibrium with melt over a range of fO₂ implies a reciprocal relationship between a(Fe²⁺O) and a(Fe³⁺O_1.5) in the melt. We show that this relationship accounts for the observed dependence of titanomagnetite–melt partitioning of divalent cations with fO₂ in magnetite-rich spinel. As a result of this, titanomagnetite–melt partitioning of divalent cations is indirectly sensitive to changes in fO₂ in silicic, but less so in mafic bulk systems.