Slump debris flows in the Akovolwo Mountains area of Benue State,Nigeria

In September 1979, rain-induced complex landslides occurred in two separate localities along the slopes of the Akovolwo Mountains near Jato-Aka in the Kwande Local Government area of Benue State, Nigeria.The two movements developed on bedrock slopes covered by a veneer of colluvium and (or) residuum no more than 1.5 to 2m deep. Each started as a slump and graduated into a debris flow. The slump, extending downhill a short distance away from the head scarp, had been reconstituted into a debris flow as the initial movement (sliding movement) of the soil mass caused remoulding of the saturated moving mass into viscous debris-laden mud. The resulting mass moved partly along a pre-existing mountain stream channel and partly along a fresh channel it cleared in the savanna forest. At the break of slope, the mass of boulders was dumped and a trail of smaller fragments littered the channels towards the Katsina-Ala River.     

THE BEGINNING OF THE USING OF ZINC IN CHINA.

In my work, Lapidarium Sinicum, the chapter on brass is speciallydevoted to this inquiry. Recently Dr. Read of the U. S. Bureau of Mineswrote to Dr. Ting, suggesting the question whether "The knowledge ofzinc-smelting in India is previous to that developed in China." Therefore     

An Improved Approach for Parameterizing Surface-Layer Turbulent Transfer Coefficients in Numerical Models

Based on classic iterative computation results, new equations to calculate the surface turbulent transfer coefficients are proposed, which allow for large ratios of the momentum and heat roughness lengths. Compared to the Launiainen scheme, our proposed scheme generates results closer to classical iterative computations. Under unstable stratification, the relative error in the Launiainen scheme increases linearly with increasing instability, even exceeding 15%, while the relative error of the present scheme is always less than 8.5%. Under stable stratification, the Launiainen scheme uses two equations, one for 0 < Ri _B ≤ 0.08 and another for 0.08 < Ri _B ≤ 0.2, and does not consider the condition that Ri _B > 0.2, while its relative errors in the region 0 < Ri _B ≤ 0.2 exceed 31 and 24% for momentum and heat transfer coefficients, respectively. In contrast, the present scheme uses only one equation for 0 < Ri _B ≤ 0.2 and another equation for Ri _B > 0.2, and the relative error of the present scheme is always less than 14%.     

The biogeochemical sulfur cycle in the marine boundary layer over the Northeast Pacific Ocean

The major components of the marine boundary layer biogeochemical sulfur cycle were measured simultaneously onshore and off the coast of Washington State, U.S.A. during May 1987. Seawater dimethylsulfide (DMS) concentrations on the continental shelf were strongly influenced by coastal upwelling. Concentration further offshore were typical of summer values (2.2 nmol/L) at this latitude. Although seawater DMS concentrations were high on the biologically productive continental shelf (2–12 nmol/L), this region had no measurable effect on atmospheric DMS concentrations. Atmospheric DMS concentrations (0.1–12 nmol/m³), however, were extremely dependent upon wind speed and boundary layer height. Although there appeared to be an appreciable input of non-sea-salt sulfate to the marine boundary layer from the free troposphere, the local flux of DMS from the ocean to the atmosphere was sufficient to balance the remainder of the sulfur budget.     

Nutrient pore water chemistry,Great Bay,New Hampshire: Benthic fluxes

Benthic fluxes of C, N, P and Si have been measured at two sites in Great Bay Estuary, New Hampshire. Higher fluxes of reactive phosphate, nitrate and reactive silicate were observed at the site where bioturbation is known to occur and the fluxes of NH₄ ⁺, PO₄ ^?3 and reactive silicate at this location were from 3 to 6 times higher than that calculated by simple pore water diffusion models. *** DIRECT SUPPORT *** A01BY019 00010     

Observational estimation of heat budgets on drifting ice and open water over the Arctic Ocean

It is of major scientific interests to determine the parameters of momentum, heat and vapor exchange in the planetary boundary layer in order to study the effects of ocean-ice-atmosphere interactions and their feedback mechanisms on global climate[1]. Lin…     

The geometry and petrogenesis of hydrothermal dolomites at Navan, Ireland

The dolomites at Navan, Ireland, formed in Courceyan peritidal and shallow-shelf limestones. The dolomite body has a plume-like geometry, cross-cutting both lithological boundaries and diagenetic barriers generated by sea-floor cementation and emergence. The dolomitizing fluids rose parallel to major faults to diffuse laterally through the succession, controlled by variations in permeability that reflect both facies variation on deposition and pre-dolomitization diagenesis. Cathodoluminescent zones reveal three principal stages of dolomite emplacement, separated by dissolution surfaces, with each stage reflecting several changes in the character of dolomitizing solutions. The predominance of dull zones indicates burial rather than surface conditions. The dolomites formed some time after burial in response to an areally limited hydrothermally-driven flow. Isotope values (σ¹⁸O of — 6σ6 to — 10.4%_δ and σ¹³C of — 0σ2 to +2σ5%_δ PDB), and fluid inclusion data, suggest that these fluids had compositions similar to those of Carboniferous seawater. However, these became hotter with time, with temperature increasing from 60 to 160δC. The Navan dolomites are closely associated with Europe's largest zinc-lead deposit. The distribution of the ores follows the same trend as that of the dolomites and paragenetic relationships indicate that dolomitization and mineralization were temporally and genetically related.