Heat flow near obstacles in the solar convection zone

Disturbances in the heat flow in the solar convection zone are calculated with a turbulent thermal diffusion coefficient based on a mixing length approximation. As a consequence of the radiative boundary condition at the surface and the strong increase of the diffusion coefficient with depth, the convection zone resembles a thermally superconducting shell enclosed between a thin surface layer and an interior core of low thermal conductivity. Thermal disturbances originating in the convection zone do not penetrate into the interior, and penetrate only weakly through the solar surface. A thermally isolating obstacle buried entirely in the convection zone casts a shadow of reduced temperature at the solar surface; the brightening surrounding this shadow is undetectable. The shadow is weak unless the object is located close to the surface (less than 2000 km). Assuming a sunspot to be an area of reduced thermal conductivity which extends a finite depth into the convection zone, the heat flow around this obstacle is calculated. The heat flux blocked below the spot (missing flux) spreads over a very extended area surrounding the spot. The brightening corresponding to this missing flux is undetectable if the reduction of the thermal conductivity extends to a depth greater than 1000 km. It is concluded that no effect other than a decrease of the convective efficiency is needed to explain the temperature change observed at the solar surface in and around a sunspot. The energy balance is calculated between magnetic flux tubes, oriented vertically in the solar surface, (magnetic elements in active regions and the quiet network) and their surroundings. Near the visible surface radiation enters the tube laterally from the surrounding convection zone. The heating effect of this influx is important for small tubes (less than a few arcseconds). Due to this influx tubes less than about 1 in diameter can appear as bright structures irrespective of the amount of heat conveyed along the tube itself. Through the lateral influx, small tubes such as are found in the quiet network act as little leaks in the solar surface through which an excess heat flux escapes from the convection zone.     

Is there Aβ/L relation for any type of qso absorption line system?

The possible correlation noted between the intrinsic quasar luminosity and the absorption line expulsion velocity is re-examined using homogeneous data sets for metal and L only line systems. The method of analysis is chosen to enable any reasonable form of correlation to be found. No correlation is detected at a confidence level >10%.     

Diffusion-deposition patterns in Martian streaks

The spreading angle of a number of light and dark Martian streaks is determined from selected Mariner 9 images. The resulting frequency distributions of spreading half-angles have maxima at ～5° for light, and ～7° for dark streaks; however the dark streaks have a secondary maximum spreading angle at ～14°. The smaller values, which include most streaks, are interpreted as crater-wake spreading phenomena. The larger value, found in only a few dark streaks or “tails,” may result from atmospheric diffusion and subsequent deposition of material from isolated sources such as vents or blowouts. An atmospheric diffusion-deposition analysis is presented, assuming this streak origin, from which it is possible to deduce the eddy diffusivity, K, in Mars' boudary layer. Calculated K values are found to agree with various theoretical estimates. They lie in the range 10⁷ and 10⁹ cm² sec^?1 and exhibit the proper scale dependence. Thus it appears that, in addition to streak-derived wind direction patterns and speed information, it is possible in a few cases to derive information on Mars' boundary-layer turbulence from streak-spreading measurements.     

Reconstruction of the diagenesis of the fluvial-lacustrine- deltaic sandstones and its influence on the reservoir quality evolution-- Evidence from Jurassic and Triassic sandstones, Yanchang Oil Field, Ordos Basin

The reservoir quality of Jurassic and Triassic fluvial and lacustrine-deltaic sandstones of the Yanchang Oil Field in the Ordos Basin is strongly influenced by the burial history and facies-related diagenetic events. The fluvial sandstones have a higher average porosity (14.8%) and a higher permeability (12.7×10?3 ?m2) than those of the deltaic sandstones (9.8% and 5.8 ×10?3 ?m2, respectively). The burial compaction, which resulted in 15% and 20% porosity loss for Jurassic and Triassic sandstones, respectively, is the main factor causing the loss of porosity both for the Jurassic and Triassic sandstones. Among the cements, carbonate is the main one that reduced the reservoir quality of the sandstones. The organic acidic fluid derived from organic matter in the source rocks, the inorganic fluid from rock-water reaction during the late diagenesis, and meteoric waters during the epidiagenesis resulted in the formation of dissolution porosity, which is the main reason for the enhancement of reservoir-quality.     

Causes of Geochemical Diversity of Carbon Dioxide Water in Crystalline Rock Masses

The problem of the diversity of the geochemical types of carbon dioxide waters (CDW) in petrografically and mineralogically uniform crystalline rock masses is solved with allowance made for the effect of different boundary conditions (physicochemical parameters) on the geochemical effect of interaction in the rock–water system. The formation of the entire geochemical spectrum of CDW in crystalline rock masses is shown to be explicable on the basis of a model of interaction in granite–water systems at different mass ratios of reacting rock (S) and water (L), different temperatures T, and equilibrium concentrations of dissolved CO₂ (P _CO2).     

Inferring erosional resistance of bedrock units in the east Tennessee mountains from digital elevation data

Measures of local relief, regional relief, and slope were calculated from digital elevation models (DEMs) for 50 bedrock units in the Ridge and Valley and Blue Ridge provinces of Tennessee. Each of these measures was normalized and the three were then averaged to produce the erosional resistance index (ERI). Bedrock units with higher ERI values include coarse clastics, intermediate clastics, and metaplutonics. Units with lower values include shales, limestones, limestones plus dolostones, and carbonates plus fine clastics. Dolostones tend to have intermediate values. The calculated ERI values were compared with subjective ratings by a geologist with decades of field experience in east Tennessee. Generally, the agreement between the two ratings was good, the most glaring exception being several shales with improbably high ERI values. These turned out to be thin units cropping out beneath very hard sandstones, allowing them to stand higher and steeper than would otherwise be possible. A systematic method for detecting such erroneously high ERI values is suggested. Inspection of a drainage map superimposed on the geology map shows that in a given area, streams tend to flow on rock units with the lowest ERI values. In addition, statistical analysis shows that bedrock units with the lowest ERI values are, on average, almost three times closer to the nearest stream and six times as likely to have streams flowing on them than are units with highest values. Further, the effect of ERI on stream location is strongest for streams with drainage areas between 1 and 30 km². Thus, small streams appear to be subject to greater lithologic control than are larger streams.