Microboudin structures of piemontite along the Sambagawa metamorphic belt, Japan: implications for lateral variation of differential stress during regional metamorphism

Evidence is presented of a lateral variation in differential stress during metamorphism along a regional metamorphic belt on the basis of the proportion of microboudinaged piemontite grains (p) in a quartz matrix in metacherts. It is proposed that p is a practical indicator of relative differential stress. Analysis of 123 metacherts from the 800 km long Sambagawa metamorphic belt, Japan, reveals that p‐values range from < 0.01 to 0.7 in this region. Most samples from Wakayama in the mid‐belt area have p‐values of 0.4–0.6, whereas those from western Shikoku have p‐values of < 0.1. This difference cannot be explained by variations in metamorphic temperature, and is instead attributed to a regional, lateral variation in differential stress during metamorphism.     

Deep-ocean vertical noise directionality

The structure of beam noise measured at the output of a vertical array in a range dependent ocean basin was investigated using the modified wide-angle parabolic equation (PE). Noise sources were distributed throughout the basin, and the field due to each noise source at an array located in the midbasin was calculated. The response of the array to the superposition of the noise sources was found by beamforming. An efficient and direct approach that superimposes the noise sources on the PE field as the field is marched toward the array was developed. Downslope calculations of the midbasin vertical directionality were made between 50 and 400 Hz with this technique. Use of a geoacoustic model shows that the bottom behaves as a low-pass filter     

Inverted echo sounder measurement of dynamic height through an ENSOcycle in the central equatorial Pacific

A four-year record from an inverted echo sounder deployed near Palmyra Island at 6°N in the central Pacific Ocean is compared with a simultaneous record of subsurface pressure from this island lagoon. A factor m, converting round-trip acoustic travel time to surface dynamic height relative to a deep pressure level, was estimated from the ratio of the spectra of the two records in the energetic synoptic oscillation band. Year-to-year variation in m was not statistically significant. For the overall record, m was found to be -70±8 dynamic m/s, where the error bounds represent a 90% confidence interval. This is consistent with first-baroclinic-mode excitation     

Three-dimensional linear solution for wave propagation with slopingbottom

This paper presents a three-dimensional analytic linear wave solution for surface gravity wave propagation over a sloping bottom that is valid for small, but realistic, slopes. The sloping-bottom linear model is compared to published laboratory data and to predictions of two-dimensional, constant-bottom nonlinear theories. The model is shown to describe the measured wave-height growth in the wave transformation region up to a limiting local Ursell number U_r of 0.35-1.0, depending on the wave type, although, as a linear model, it does not predict the harmonics observed in that range. For U_r<0.35, the harmonics can generally be neglected and the sloping-bottom linear theory agrees closely with both the published wave-height data and third-order Stokes nonlinear theory. As a three-dimensional linear model, superposition can be invoked to synthesize and relate wave structure in the transformation region to complex incident ocean spectra with both wind wave and swell components that arrive with a range of incidence angles. As such, the sloping-bottom linear model presented here should be a convenient useful tool for ocean modeling through a significant portion of the wave transformation region     

A time series analysis of sound propagation in a strongly multipathshallow water environment with an adiabatic normal mode approach

Measured time series were generated by small omnidirectional explosive sources in a shallow water area. A bottom-mounted hydrophone recorded sound signals that propagated over a sloping bottom. The time series in the 250-500 Hz band were analyzed with a broad-band adiabatic normal mode approach. The measured waveforms contain numerous bottom interacting multipaths that are complicated by the subbottom structure that contains high-velocity layers near the water-sediment interface. Several of the details of the geoacoustic structure and the depth of the water column at the receiver are inferred from comparisons of the measured data to simulated time series. The sensitivity of broad-band matched-field ambiguity surfaces in the range-depth plane for a single receiver to selected waveguide parameters is examined. A consistent analysis is made where the simulated time series are compared to the measured time series along with the single-receiver matched-field localization solutions for ranges out to 5 km. In this range interval, it was found that the peak cross-correlation between the measured and simulated time series varied between 0.84 and 0.69. The difference between the GPS range and the range obtained from the matched-field solution varied from 0 to 63 m. The geoacoustic structure obtained in the analysis consists of an 8-m low-velocity sediment layer over an 8-m high-velocity layer followed by a higher velocity, infinite half-space     

Evolution of 2:1 layered silicates in low-grade metamorphosed Liassic shales of Central Switzerland

White mica from the Liassic black shales and slates in Central Switzerland was analysed by transmission electron microscopy (TEM) and electron microprobe to determine its textural and compositional evolution during very low-grade prograde metamorphism. Samples were studied from the diagenetic zone, anchizone and epizone (T ≈100°–450 °C). Phyllosilicate minerals analysed include illite/smectite (I/S), phengite, muscovite, brammallite, paragonite, margarite and glauconite. Textural evolution primarily is towards larger, more defect-free grains with compositions that approach those of their respective end-members. The smectite-to-illite transformation reduced the amounts of the exchange components SiK_?1Al_?1, MgSiAl_?2, and Fe³⁺Al_?1. These trends continue to a lesser degree in the anchizone and epizone. Correlations between the proportion of smectite in I/S and the composition of I/S indicate that smectite layers may contain a high layer charge. Illite in I/S bears a compositional resemblance to macrocrystalline phengite in some samples, but is different in others. Paragonite first appears in the upper diagenetic zone or lower anchizone as an interlayer-deficient brammallite, and it may be mixed with muscovite on the nanometre scale. Owing to the small calculated structure factor for paragonite-muscovite superstructures, conventional X-ray powder diffraction cannot distinguish between mixed-layer structures and a homogeneous compositionally intermediate solid solutions. However, indirect TEM evidence shows that irregularly shaped domains of Na- and K-rich mica exist below 10 nm. Subsequent coarsening of domains at higher grades produced discrete paragonite grains at the margins of muscovite crystals or in laths parallel to the basal plane of the host muscovite. Margarite appears in the epizone and follows a textural evolution similar to paragonite in that mixtures of margarite, paragonite, and muscovite may initially occur on the nanometre scale. However, no evidence of interlayer-poor margarite has been found.     

Depositional and post‐depositional history of warm stage deposits at Knocknacran,Co. Monaghan,Ireland: implications for preservation of Irish last interglacial deposits

Organic‐rich deposits, uncovered during overburden removal from mantled gypsum karst at Knocknacran opencast gypsum mine, Co. Monaghan, are the best candidate to date for a last interglacial record in Ireland. The two till and organic‐rich deposits (preserved at different quarry elevations) were emplaced on to a Tertiary dolerite surface during high‐energy flood events and subsequently folded and faulted by movement towards sinkholes in underlying gypsum. Uranium–thorium disequilibrium dating suggests that the organic‐rich deposits in the upper section were hydrologically isolated at ca. 41 ka and those in the lower section at ca. 86 ka. Interpretation of the pollen content, although tentative because of the depositional and post‐depositional history of the material, suggests that the organic material originated in a warm stage possibly warmer than the post‐Eemian interstadials. The unusual setting of preservation may indicate that in situ, last interglacial deposits have generally been removed by erosion in Ireland. Copyright © 2004 John Wiley & Sons, Ltd.     

Factors affecting the distribution and abundance of Macrobrachium petersi (Hilgendorf) in the Keiskamma River and estuary,South Africa

A dry (1979–1980) and a wet (1980–1981) season had a marked effect on the freshwater inflow into the Keiskamma estuary. Under low inflow conditions, which results in elevated salinities in the upper reaches, an upstream migration of adult Macrobrachium petersi (Hilgendorf) to freshwater takes place. During periods of increased river inflow adult M. petersi move downstream to the more saline reaches of the estuary. These two migratory responses have been interpreted as (a) a breeding migration under high inflow conditions which ensures that larvae are in close proximity to salinities that favour growth and development, and (b) an adult upstream migration back to freshwater to escape elevated estuarine salinities as a result of the low freshwater inflow.     

On salinity regimes and the vertical structure of residual flows in narrow tidal estuaries

An examination is made of the circulation in narrow estuaries subject to a predominant tidal forcing. Velocity structures are derived separately for residual flow components associated with (a) river flow, (b) wind stress, (c) a well-mixed longitudinal density gradient and (d) a fully stratified saline wedge. Dimensionless parameters are introduced to indicate the magnitude of each component and these parameters are evaluated for 9 major estuaries, thereby revealing their sensitivity to each component.For a channel of constant breadth and depth, formulae are deduced for the length of saline intrusion, L. Comparisons with observed data show that such formulae may be used with confidence to predict changes in L arising from variations in river flow, tidal range or channel depths.The level of stratification is shown to be related to a product of two parameters, one associated with velocity structure and a second involving the square of the ‘flow ratio’ $\text{u}\text{u}\text{?}$ (i.e. residual velocity/amplitude of the tidal velocity). This relationship provides a simple classification system for estuarine stratification which can be used to indicate the sensitivity of any particular estuary to changing conditions.     

Asymmetrical breakwater gap wave diffraction using finite and infinite elements

An experimental technique and configuration has been developed by the author to simulate and measure (using short range photogrammetric techniques) the wave heights of waves diffracting into a model basin of infinite extent. The finite and infinite element program “WAVE” developed in the Department of Civil Engineering, University College of Swansea, Wales, has been modified to run on the UNIVAC 1100 at the University of Cape Town. The program is used to model the experimental configuration being tested mathematically. Two configurations, namely a symmetrical and an asymmetrical breakwater gap configuration, are analysed both experimentally and numerically. It is concluded that there is a good correlation between the finite element and experimental results and that the “WAVE” program is a very useful tool for the prediction of wave heights in large harbour basins.