Rock magnetic records of the sediments of the eastern Arabian Sea: Evidence for late Quaternary climatic change

Rock-magnetic measurements along with grain size, acid-insoluble residue (AIR), organic carbon (OC), CaCO₃ and δ¹⁸O of the planktonic foraminifers of the sediments were determined for 15 gravity cores recovered from the western continental margin of India. Magnetic susceptibility (MS) values in the surficial sediments reflect the land-derived input and, in general, are the highest in terrigenous sediment-dominated sections of the cores off Saurashtra–Ratnagiri, followed by the sediments off Indus–Gulf of Kachchh and then Mangalore–Cape Comorin.

The down-core variations in mineral magnetic parameters reveal that the glacial sediments off the Indus are characterized by low MS values/S-ratios associated with high AIR-content, low OC/CaCO₃ contents and relatively high δ¹⁸O values, while those off SW India are characterized by low MS values/high S-ratio% associated with low AIR content, and relatively high OC, CaCO₃ and δ¹⁸O values. Conversely, the Early Holocene sediments of all cores are characterized by high MS values/S-ratio% associated with high AIR content, low OC, CaCO₃ contents and gradually decreased δ¹⁸O values. These results imply that during the Last Glacial Maximum (LGM), the cores off northwestern India received abundant continental supply leading to the predominance of eolian/fluvial sedimentation. In the SW region the influence of hinterland flux is less evident during this period, but convective mixing associated with the NE monsoon resulted in increased productivity. During the early Holocene intense SW monsoon conditions resulted in high precipitation on land, which in turn contributed increased AIR content/MS values in the continental margin sediments. A shallow water core off Kochi further suggests that the intense SW monsoon conditions prevailed until about 5 ka. The late Holocene organic-rich sediments of the SW margin of India were, however, subjected to early diagenesis at different intervals in the cores. Therefore, caution is needed when interpreting regional climatic change from down-core changes in sediment magnetic properties.     

Numerical and experimental study on hydrodynamic interaction of side-by-side moored multiple vessels

This paper aims to investigate the basic interaction characteristics of side-by-side moored vessels both numerically and experimentally. A higher-order boundary element method (HOBEM) combined with generalized mode approach is applied to analysis of motion and drift force of side-by-side moored multiple vessels (LNG FPSO, LNGC and shuttle tankers). Model tests were carried out for the same floating bodies investigated in the numerical study in regular and irregular waves. Global and local motion responses and drift forces of three vessels are compared with those of calculations. Discussions is highlighted on applicability of numerical method to prediction of sophisticated multi-body interaction problem of which motion behavior is very important to analysis of mooring dynamics of deep sea floating bodies.     

Wave run-up and overtopping on smooth and rough slopes of coastal structures

A series of hydraulic model tests has been carried out in a glass wave flume to investigate the influences of wave height, wave period, wave steepness, surf similarity parameter, roughness, layer thickness and porosity on wave run-up and overtopping of 1:2 sloped impermeable and permeable breakwaters fronted by a 1:10 gentle, smooth beach slope. The analysis of results involves the correlation between the overtopping energy transfer with the relative wall height and the relationship between wave run-up and overtopping rate. Further, measured wave run-up and overtopping rates are compared with the results given in the Shore Protection Manual (1984), Automated Coastal Engineering System (1992)and results of other investigators.     

Modeling of coupled tide–wave–surge process in the Yellow Sea

A coupled wave–tide–surge model has been developed in this study in order to investigate the effect of the interactions among tides, storm surges, and wind waves. The coupled model is based on the synchronous dynamic coupling of a third-generation wave model, WAM cycle 4, and the two-dimensional tide–surge model. The surface stress, which is generated by interactions between wind and wave, is calculated by using the WAM model directly based on an analytical approximation of the results using the quasi-linear theory of wave generation. The changes in bottom friction are created by the interactions between waves and currents and calculated by using simplified bottom boundary layer model. In consequence, the combined wave–current-induced bottom velocity and effective bottom drag coefficient were increased in the shallow waters during the strong storm conditions.     

Spatial patterns and environmental risks of ringnet fishing along the Kenyan coast

Ringnet fishing began in the early 20th century and is practised worldwide, mainly to target nearshore pelagic species. The method was introduced to Kenya’s coastal waters by migrant fishers from Tanzania. However, the impacts of this fishing gear remain poorly assessed. We assessed the spatial distribution of ringnet fishing effort and its possible effects on ecosystem components, such as coral reefs, marine megafauna and marine protected areas, on the south coast of Kenya. We tracked 89 ringnet fishing trips made from December 2015 to January 2016 and used spatial multicriteria analysis to determine hotspots of possible environmental risks. The results showed that habitat type and bathymetric profile influenced the spatial distribution of ringnet fishing effort. Mixed seagrass and coral habitats had the highest concentration of the effort. Most of the habitats in the study area were moderately exposed to the impacts of the ringnet fishery. The study identifies high-risk areas that require spatial measures to minimise possible environmental risks of the gear both to habitats and to endangered sea turtles.     

Imaging of Buried Archaeological Materials: The Reflection Properties of Archaeological Wood

Effective marine archaeological site management demands detailed information on not only the spatial distribution of artefacts but also the degradation state of the materials present. Although sonar methods have frequently been used in an attempt to detect buried wooden shipwrecks they are currently unable to indicate their degradation state. To assess the sensitivity of acoustic measurements to changes in the degradation state of such material, and hence the potential for sonars to quantify degradation, laboratory measurements of compressional wave velocity, as well as bulk density for oak and pine samples, in varying states of decay, were undertaken. These data enabled the calculation of theoretical reflection coefficients for such materials buried in various marine sediments. As wood degrades, the reflection coefficients become more negative, resulting in the hypothesis that the more degraded wood becomes, the easier it should be to detect. Typical reflection coefficients of the order of −0.43 and −0.52 for the most degraded oak and pine samples in sand are predicted. Conversely, for wood exposed to seawater the predicted reflection coefficients are large and positive for undegraded material (0.35 for oak, 0.18 for pine) and decrease to zero or slightly below for the most degraded samples. This indicates that exposed timbers, when heavily degraded, can be acoustically transparent and so undetectable by acoustic methods. Corroboration of these experimental results was provided through comparison with high resolution seismic reflection data that has been acquired over two shipwrecks.     

Multi-decadal synthesis of benthic–pelagic coupling in the western arctic: Role of cross-shelf advective processes

Using geographic information systems (GIS) software and geostatistical techniques, we utilized three decades of water-column chlorophyll a data to examine the relative importance of autochthonous versus allochthonous sources of reduced carbon to benthic communities that occur from the northern Bering to the eastern Beaufort Sea shelf. Spatial trend analyses revealed areas of high benthic biomass (>300 g m⁻²) and chlorophyll (>150 mg m⁻²) on both the southern and northern Chukchi shelf; both areas are known as depositional centers for reduced organic matter that originates on the Bering Sea shelf and is advected northward in Anadyr and Bering shelf water masses. We found a significant correlation between biomass and chlorophyll a in the Chukchi Sea, reflective of the strong benthic–pelagic coupling in a system that is utilized heavily by benthic-feeding marine mammals. In contrast, there was no significant correlation between biomass and chlorophyll in the Beaufort Sea, which by comparison, is considerably less productive (biomass and chlorophyll, <75 g m⁻² and <50 mg m⁻², respectively). One notable exception is an area of relatively high biomass (50–100 g m⁻²) and chlorophyll (80 mg m⁻²) near Barter Island in the eastern Beaufort Sea. Compared to other adjacent areas in the Beaufort Sea, the chlorophyll values in the vicinity of Barter Island were considerably higher and likely reflect a long-hypothesized upwelling in that area and close coupling between the benthos and autochthonous production. In the Bering Sea, a drop in benthic biomass in 1994 compared with previous measurements (1974–1993) may support earlier observations that document a decline in biomass that began between the 1980s and 1990s in the Chirikov Basin and south of St. Lawrence Island. The results of this study indicate that the benthos is an excellent long-term indicator of both local and physical advective processes. In addition, this work provides further evidence that secondary production on arctic shelves can be significantly augmented by reduced carbon advected from highly productive adjacent shelves.     

Seasonal variations of alkenones and U37 in the Chesapeake Bay water column

Alkenone unsaturation indices (U^K₃₇ and U^K′₃₇) have long been used as proxies for surface water temperature in the open ocean. Recent studies have suggested that in other marine environments, variables other than temperature may affect both the production of alkenones and the values of the indices. Here, we present the results of a reconnaissance field study in which alkenones were extracted from particulate matter filtered from the water column in Chesapeake Bay during 2000 and 2001. A multivariate analysis shows a strong positive correlation between U^K₃₇ (and U^K′₃₇) values and temperature, and a significant negative correlation between U^K₃₇ (and U^K′₃₇) values and nitrate concentrations. However, temperature and nitrate concentrations also co-vary significantly. The temperature vs. U^K₃₇ relationships (U^K₃₇=0.018 (T)−0.162, R²=0.84, U^K′₃₇=0.013 (T)−0.04, R²=0.80) have lower slopes than the open-ocean equations of Prahl et al. [1988. Further evaluation of long-chain alkenones as indicators of paleoceanographic conditions. Geochimica et Cosmochimica Acta 52, 2303–2310] and Müller et al. [1998. Calibration of the alkenone paleotemperature index U^K′₃₇ based on core-tops from the eastern South Atlantic and the global ocean (60°N–60°S). Geochimica et Cosmochimica Acta 62, 1757–1772], but are similar to the relationships found in controlled studies with elevated nutrient levels and higher nitrate:phosphate (N:P) ratios. This implies that high nutrient levels in Chesapeake Bay have either lowered the U^K₃₇ vs. temperature slope, or nutrient levels are the main controller of the U^K₃₇ index. In addition, particularly high abundances (>5% of total C₃₇ alkenones) of the tetra-unsaturated ketone, C_37:4, were found when water temperatures reached 25 °C or higher, thus posing further questions about the controls on alkenone production as well as the biochemical roles of alkenones.