Estimation of winds over the sea from land-based measurements

Simultaneous measurements of wind velocities at two different sites, one over the sea and the other over land, can differ substantially and therefore cannot be interchanged. In situations where the wind data at an offshore site are missing while simultaneous measurements from a land-based station exist, a linear mean-square estimation (LMSE) technique can be used to estimate the missing data. This technique relies on past wind data gathered simultaneously at the two locations, and it generates from the associated correlation a set of four transfer functions capable of predicting one data set from the other. In the present case, the LMSE technique is outlined briefly, and is then applied to construct seasonal transfer functions between a land-based station and two coastal/offshore sites in Kuwait. Comparisons between the actually observed wind characteristics and those predicted by the LMSE technique are favorable, and thus tend to confirm the applicability of the technique under appropriate conditions.     

A densely sampled core and climate variable aliasing

Undersampled records are susceptible to aliasing, in which a high frequency appears incorrectly as a lower one. We study the sampling requirements in a core taken from Rockall Trough using bulk density, P-wave velocity, and magnetic susceptibility as measured on an automated system. At 2-cm spacing (approximately 33 years in this core), all variables show a characteristic red-noise behavior, but with a spectral slope that is sufficiently weak so that significant aliasing appears to be present. P-wave velocity shows the largest potential corruption, probably owing to the weaker spatial averaging present in the sensor. Approximately 50% of the apparent low-frequency energy is aliased in all variables at some frequencies in both quiet and active regions of the record. In this core, a sampling interval of 0.2 cm appears to be "safe" in both active and quiet portions of the core, aliasing little or no energy, except in the P-wave record. For cores of different duration, sampling interval, and measurement type, the considerations will be identical, the importance of the problem depending directly upon the shape of the overall spectrum describing the entire frequency (wavenumber) range of physical variability.     

Physical and biological factors influencing the spatial distribution of age-0 walleye pollock (Theragra chalcogramma) around the Pribilof Islands, Bering Sea

The waters around the Pribilof Islands, in the southeast Bering Sea, are a main nursery area for age-0 pollock. Each summer, the islands are surrounded by a well-mixed inshore region, separated from a stratified offshore region by a frontal zone. To study the spatial distribution of age-0 pollock around this frontal structure in relation to physical and biological factors that are likely to influence it, such as advection, age-0 pollock feeding, and predation, samples were collected during September of four consecutive years, 1994–97, along two transects. Samples collected included water column hydrography and currents, acoustic backscatter, and groundfish predator density.Our analysis suggested that different mechanisms may be involved in controlling age-0 pollock distribution north and south of the islands. On the shelf area north of the islands, high age-0 pollock density was significantly associated with areas of high potential for growth only in years or portions of the frontal transect in which predator numbers were relatively low, indicating the importance of predation in controlling fish distribution in this area. In contrast, south of the islands, age-0 pollock distribution was associated more with prey availability, which appeared to be determined by vertical spatial overlap between predators and prey. Moreover, south of the islands, the stronger geostrophic currents, typical of the slope region, were more likely to affect the overall standing biomass of juvenile pollock, by constantly advecting fish away from the area.     

An experimental pressure compensated wet suit

Personal thermal insulation by means of neoprene from wet suits provides adequate temporary control of body heat loss only at the shallow end of the air diving depth range, but it constitutes by far the most popular approach to diver thermal support. Howewer, compression of the trapped gas phase in neoprene foam seriously reduces its insulation performance on exposure to high ambient pressure. With conventional wet suits equipped with heating, the necessary level of power required at depths greater than about 30 m is too high, and also unsafe without the back up that increased insulation would provide. One approach to the goal of depth-insensitive insulation is to use a wet suit with a continuous internal gas space pressurized nominally to ambient pressure, so that its thickness remains substantially constant at all depths. The composite material properties required are: outer skins that are tough, flexible and free of pin holes; an open foam internal structure capable of resisting, without significant dimensional change, the relatively small pressure changes that occur over the height of a man; and a high bond strength.Samples of a composite material that meets these requirements have been developed, and a prototype suit has been successfully fabricated by conventional techniques.     

Sedimentology of a subtidal,tide-dominated sand body in the Yellow Sea,southwest Korea

Odanam Satoe, a subtidal, tide-dominated sand body in the Yellow Sea, Korea, is linear in plan and asymmetrical in cross-section. It consists of fine- to medium-grained, well-sorted subangular sand. Bedforms consist of high-amplitude (1–2 m) sandwaves on the lower flanks of the gentler-sloping bar surface, and medium-amplitude (0.5-1 m) sandwaves on the sand body trough adjoining the steeper face, the bar crest and shallower parts of the gently sloping bar surface. Bedforms are absent on the relatively steeper bar surface, which is characterized by 2° slopes. Bedform orientation on the gentler slope is oblique by 30° to the bar crest, parallel to the sand-body crest on the crest itself, and opposite to the steeper sand-body face in the trough below the steeper slope of the bar.Bottom current velocity data show that tidal currents are semi-rotary with a flood time—velocity asymmetry over the gentler slope, and ebb time—velocity asymmetry over the steeper slope during most of the tidal cycle. Tidal-current flow parallels bar elongation over the steeper slope, whereas over the gentler slope, tidal-current flow is directed at 30° to the bar crest and changes to normal to the crest one hour prior to low tide. Bedform orientation mapped with side-scan sonar shows agreement with these flow directions.Sand dispersal around the sand body is controlled by time—velocity asymmetry and partial rotary flow directions of tidal currents. This circulation causes not only a trapezoidal mode of grain dispersal, but also westerly migration of the sand body documented from comparative bathymetric surveys in 1964 and 1980.     

Harpacticoida taxocen diversity in the silty-sandy littoral zone of Kandalaksha Bay of the White Sea

The fauna composition, ecological groups, and life forms of Harpacticoids of soft littoral grounds from 15 sites off the Karelian coast in Kandalaksha Bay of the White Sea were studied. Six types of harpacticoid taxocens with different sets of dominating species are described. On silty sands with clear signs of desalination, the Stenchelia palustris taxocen is common; medium-grained sands are characterized by the Heterolaophonte minuta, Paraleptastacus kliei — Huntemannia jadensis, and Amphiascoides nanus — Scottopsyllus minor taxocens; while on coarse sands, the Ameira parvula and Ameira scotti — Mesochra lilljeborgi taxocens have developed. The diversity of the taxocens is partly explained by the differences in the grain-size composition and salinity at different sites. In addition, groups of various taxocens dwelling on the same type of the sediments were found in different minor bights of the coastline.     

Interstitial water chemistry of villefranche bay sediments: Trace metal diagenesis

Pore water aliquots were taken with an in situ close interval sampler: the “Peeper”.We report here the pore water concentration profiles of TCO₂, SO₄, TH₂S, Ca and the trace metals Mn, Cu, Pb, Cd and Cr from sediments of a relatively polluted area, the Villefranche Bay, on the French Riviera (close to Nice).We investigated the major ion concentrations in order to establish geochemical mass balances of organic matter oxidation. ΔTCO₂/ΔSO₄ was <−2.0, reflecting the precipitation of calcite as confirmed by the calcium profile. Reduction of sulfate led to increasing sulfide concentrations with depth.Trace metal interstitial water concentrations decreased from 63 to 5 nM, 18 to 4 nM and 6.6 to less than 2 nM for Cu, Pb and Cr, respectively. Cd showed a different pattern with top and deep values of 0.7 nM and a minimum of 0.27 nM.Thermodynamic calculations were performed which suggest the potential formation of mineral phases such as sulfides.     

Dynamic response of the leg of a tension leg platform subjected to an axial, suddenly applied load at one end

This paper deals with the solution of the problem of the dynamic response of the leg of a tension leg platform subjected to an axial, suddenly applied load at one end, considering a highly simplified model but taking into account several complicating factors. The problem is solved by means of a non-harmonic Fourier expansion in terms of eigenfunctions obtained from a non-regular Sturm-Liouville system.