Comparison of 15 evaporation methods applied to a small mountain lake in the northeastern USA

Few detailed evaporation studies exist for small lakes or reservoirs in mountainous settings. A detailed evaporation study was conducted at Mirror Lake, a 0.15 km² lake in New Hampshire, northeastern USA, as part of a long-term investigation of lake hydrology. Evaporation was determined using 14 alternate evaporation methods during six open-water seasons and compared with values from the Bowen-ratio energy-budget (BREB) method, considered the standard. Values from the Priestley–Taylor, deBruin–Keijman, and Penman methods compared most favorably with BREB-determined values. Differences from BREB values averaged 0.19, 0.27, and 0.20 mm d⁻¹, respectively, and results were within 20% of BREB values during more than 90% of the 37 monthly comparison periods. All three methods require measurement of net radiation, air temperature, change in heat stored in the lake, and vapor pressure, making them relatively data intensive. Several of the methods had substantial bias when compared with BREB values and were subsequently modified to eliminate bias. Methods that rely only on measurement of air temperature, or air temperature and solar radiation, were relatively cost-effective options for measuring evaporation at this small New England lake, outperforming some methods that require measurement of a greater number of variables. It is likely that the atmosphere above Mirror Lake was affected by occasional formation of separation eddies on the lee side of nearby high terrain, although those influences do not appear to be significant to measured evaporation from the lake when averaged over monthly periods.     

The effect of cracks on the thermal expansion of rocks

Thermal expansion during the first heating cycle at atmospheric pressure was measured in several directions in seven igneous rocks between 25° and 400°C at slow heating rates. The coefficient of thermal expansion measured under these conditions increases more rapidly as temperature is increased than the average thermal expansion coefficient of the constituent minerals. The “extra” expansion is attributed to the formation of cracks by differential expansion of mineral grains. The presence of such cracks in the rocks during the cooling part of the cycle and during any subsequent heating and cooling cycles will result in a substantial decrease in the coefficient of thermal expansion as compared to that measured during the first heating cycles. The effect of cracks initially present in a rock was studied by measuring the full tensor of the coefficient of thermal expansion on two rocks with anisotropic crack distributions. In these two rocks the coefficient of thermal expansion is least in the direction perpendicular to the plane of greatest crack concentration. The implication of our data is that thermal expansion depends greatly on the fracture state of the rock. Both the fractures in the rock and the boundary conditions on the rock are significant for the interpretation of thermal expansion measurements and for their application to other problems.     

Armalcolite stability as a function of pressure and oxygen fugacity

The stability of synthetic armalcolite of composition (Fe_0.5Mg_0.5Ti₂O₅ was studied as a function of total pressure up to 15 kbar and 1200°C and also as a function of oxygen fugacity (?O₂) at 1200°C and 1 atm total pressure. The high pressure experiments were carried out in a piston-cylinder apparatus using silver-palladium containers. At 1200°C, armalcolite is stable as a single phase at 10 kbar. With increasing pressure, it breaks down ($\text{dT}\text{dP}\text{= 20°C/}\text{kbar}$), to rutile, a more magnesian armalcolite, and ilmenite solid solution. At 14 kbar, this three-phase assemblage gives way ($\text{dT}\text{dP}\text{= 30°C/}\text{kbar}$) to a two-phase assemblage of rutile plus ilmenite solid solution.A zirconian-armalcolite was synthesized and analyzed; 4 wt % ZrO₂ appears to saturate armalcolite at 1200°C and 1 atm. The breakdown of Zr-armalcolite occurs at pressures of 1–2 kbar less than those required for the breakdown of Zr-free armalcolite. The zirconium partitions approximately equally between rutile and ilmenite phases.The stability of armalcolite as a function of ?O₂ was determined thermogravimetrically at 1200°C and 1 atm by weighing sintered pellets in a controlled atmosphere furnace. Armalcolite, (Fe_0.5Mg_0.5)-Ti₂O₅, is stable over a range ?O₂ from about 10^?9.5to 10^?10.5 atm. Below this range to at least 10^?12.8 atm, ilmenite plus a reduced armalcolite are formed. These products were observed optically and by Mössbauer spectroscopy, and no metallic iron was detected; therefore, some of the titanium must have been reduced to Ti³⁺. This reduction may provide yet another mechanism to explain the common association of ilmenite rims around lunar armalcolites.     

Salinograph trends as indicators of the recession characteristics of stream components

Compared to hydrograph recession analysis, which is widely applied in engineering hydrology, the quantitative assessment of stream salinity with time (i.e. the salinograph) has received significantly less attention. In particular, while in many previous hydrological studies an inverse relationship between hydrograph and salinograph responses is apparent, the concept of salinity accession (the inversely related salinity counterpart to hydrograph recession) has not been introduced nor quantitatively evaluated in previous literature. In this study, we conduct a mathematical analysis of salinograph accession, and determine new quantitative relationships between salinity accession and hydrograph recession parameters. An equation is formulated that reproduces the general trend in salinity accession. A salinity accession parameter k_c is then introduced and is shown to be the ratio of direct runoff to total stream flow recession parameters: k_r/k. The groundwater recession parameter k_g was estimated using a simple and rapid method that uses both salinograph and hydrograph data. Salinity accession type‐curves illustrate that under certain conditions, the relative steepness of individual salinographs is dependent upon the ratio of groundwater salinity to direct runoff salinity: C_g/C_r. The salinity accession algorithms are applied to two contrasting field settings: Scott Creek, South Australia and Sandy Creek, northern Queensland, Australia. It was found that k_g > k during periods of obvious stream flow recession, for the events analysed. Salinograph accession behaviour was fairly similar for both sites, despite contrasting environments. Using assumed end‐member salinities for groundwater and direct runoff based upon field observations, the behaviour of k_c from the Scott Creek site was approximately reproduced by varying the initial groundwater to runoff flow ratio: Q_g0/Q_r0, within reasonable parameter ranges. The use of salinograph information when used in addition to standard hydrograph analyses provided useful information on recession characteristics of stream components. Copyright © 2008 John Wiley & Sons, Ltd.     

Linear stability for some symmetric periodic simultaneous binary collision orbits in the four-body problem

We apply the analytic-numerical method of Roberts to determine the linear stability of time-reversible periodic simultaneous binary collision orbits in the symmetric collinear four-body problem with masses 1, m, m, 1, and also in a symmetric planar four-body problem with equal masses. In both problems, the assumed symmetries reduce the determination of linear stability to the numerical computation of a single real number. For the collinear problem, this verifies the earlier numerical results of Sweatman for linear stability with respect to collinear and symmetric perturbations.     

Three-dimensional benchmark for variable-density flow and transport simulation: matching semi-analytic stability modes for steady unstable convection in an inclined porous box

This benchmark for three-dimensional (3D) numerical simulators of variable-density groundwater flow and solute or energy transport consists of matching simulation results with the semi-analytical solution for the transition from one steady-state convective mode to another in a porous box. Previous experimental and analytical studies of natural convective flow in an inclined porous layer have shown that there are a variety of convective modes possible depending on system parameters, geometry and inclination. In particular, there is a well-defined transition from the helicoidal mode consisting of downslope longitudinal rolls superimposed upon an upslope unicellular roll to a mode consisting of purely an upslope unicellular roll. Three-dimensional benchmarks for variable-density simulators are currently (2009) lacking and comparison of simulation results with this transition locus provides an unambiguous means to test the ability of such simulators to represent steady-state unstable 3D variable-density physics.     

一次春季强寒潮的降水相态变化分析

应用NCEP 1°×1°资料、常规观测资料、自动站资料、多普勒天气雷达资料,对2007年3月河北省一次早春强寒潮天气背景下的降水多相态转换的成因与雨雪转换的预报进行了分析.结果表明:850hPa及以下蒙古高压和江淮气旋共同作用产生的偏东风导致低层大气温度持续下降,降水性质从雨转为雪.随着江淮气旋入海,高低空风向发生突变,从东北风转为西北风,加上太行山地形作用,使太行山东麓部分地区低层大气出现小幅升温,0℃层高度抬升,致使从雪转为雨.多普勒天气雷达回波图上,0℃层亮带高度的迅速下降,可作为从液态降水向固态降水转换的判据之一.天气学分析表明,当0℃层高度低于950hPa、地面气温在0℃上下、1000hPa温度低于2℃、925hPa温度低于-2℃时,降水性质将从雨向雨夹雪或雪转变.     

Sea-level and reef accretion history of Marine Oxygen Isotope Stage 7 and late Stage 5 based on age and facies of submerged late Pleistocene reefs,Oahu, Hawaii

In situ Pleistocene reefs form a gently sloping nearshore terrace around the island of Oahu. TIMS Th–U ages of in situ corals indicate that most of the terrace is composed of reefal limestones correlating to Marine Oxygen Isotope Stage 7 (MIS 7, ~ 190–245 ka). The position of the in situ MIS 7 reef complex indicates that it formed during periods when local sea level was ~ 9 to 20 m below present sea level. Its extensiveness and geomorphic prominence as well as a paucity of emergent in situ MIS 7 reef-framework deposits on Oahu suggest that much of MIS 7 was characterized by regional sea levels below present. Later accretion along the seaward front of the terrace occurred during the latter part of MIS 5 (i.e., MIS 5a–5d, ~ 76–113 ka). The position of the late MIS 5 reefal limestones is consistent with formation during a period when local sea level was below present. The extensiveness of the submerged Pleistocene reefs around Oahu compared to the relative dearth of Holocene accretion is due to the fact that Pleistocene reefs had both more time and more accommodation space available for accretion than their Holocene counterparts.     

Planning for Tsunami-Resilient Communities

The National Tsunami Hazard Mitigation Program (NTHMP) Steering Committee consists of representatives from the National Oceanic and Atmospheric Administration (NOAA), the Federal Emergency Management Agency (FEMA), the U.S. Geological Survey (USGS), and the states of Alaska, California, Hawaii, Oregon, and Washington. The program addresses three major components: hazard assessment, warning guidance, and mitigation. The first two components, hazard assessment and warning guidance, are led by physical scientists who, using research and modeling methods, develop products that allow communities to identify their tsunami hazard areas and receive more accurate and timely warning information. The third component, mitigation, is led by the emergency managers who use their experience and networks to translate science and technology into user-friendly planning and education products. Mitigation activities focus on assisting federal, state, and local officials who must plan for and respond to disasters, and for the public that is deeply affected by the impacts of both the disaster and the pre-event planning efforts. The division between the three components softened as NTHMP scientists and emergency managers worked together to develop the best possible products for the users given the best available science, technology, and planning methods using available funds.