Horizontal and Vertical Well Comparison for In Situ Air Sparging

A laboratory study was conducted to determine the effectiveness ol vertical and horizontal well configurations for ground water remediation using in situ air sparging. A lexan lank was designed and constructed to allow both the visualization of air flow and quantitative measurement of the distribution of air flow. Two media, sand and glass beads. were tested with both Vertical and horizontal air sources. In each case, most of the air traveled through preferential channels as continuous flow rather than as discrete bubbles as reported in other studies. Liven though glass beads were selected to have the same grain-size distribution as the sand, air flow was quite different through the two media. Results show that glass beads are not a suitable material for modeling air flow through natural sediments. In this study, the horizontal well proved to be more effective than the vertical well by impacting more of the media with a uniform distribution of air throughout the media. The vertical well resulted in a nonuniform distribution of air flow with most of the air concentrated directly above the well.     

Synergistic Application of Four Remedial Techniques at an Industrial Site

The soil and ground water at a General Motors plant site were contaminated with petroleum products from leaking underground storage tanks. Based on the initial assessment, the site was complex from the standpoint of geology (clay layers), hydrology (a recharge zone with a perched water table), and contaminant (approximately 4800 gallons of mixed gasoline and oil). After a thorough study of remedial alternatives, a synergistic remedial approach was adopted including pump and treat, product removal, vapor extraction, and bioventing. The system was designed and implemented at the site through 22 dual-extraction wells. Over a 21-month period, 4400 gallons of gasoline and oil were removed from the system, including 59 percent by vapor extraction, 28 percent by bioventing, and 13 percent by pump and treat. Synergism between the various remedial methods was demonstrated clearly. Ground water pump and treat lowered the water table, allowing air to flow for vapor extraction. The vacuum applied for vapor extraction increased the ground water removal rate and the efficiency of pump and treat. The vapor extraction system also added oxygen to the soil to stimulate aerobic biodegradation.     

On the construction of geomagnetic timescales from non-prejudicial treatment of magnetic anomaly data from multiple ridges

When marine magnetic-anomaly data are used to construct geomagnetic polarity timescales, the usual assumption of a smooth spreading-rate function at one seafloor spreading ridge forces much more erratic rate functions at other ridges. To eliminate this problem, we propose a formalism for the timescale problem that penalizes non-smooth spreading behaviour equally for all ridges. Specifically, we establish a non-linear Lagrange multiplier optimization problem for finding the timescale that (1) agrees with known chron ages and with anomaly-interval distance data from multiple ridges and (2) allows the rate functions for each ridge to be as nearly constant as possible, according to a cumulative penalty function. The method is applied to a synthetic data set reconstructed from the timescale and rate functions for seven ridges, derived by Cande & Kent (1992) under the assumption of smooth spreading in the South Atlantic. We find that only modest changes in the timescale (less than 5 per cent for each reversal) are needed if no one ridge is singled out for the preferential assumption of smoothness. Future implementation of this non-prejudicial treatment of spreading-rate data from multiple ridges to large anomaly-distance data sets should lead to the next incremental improvement to the pre-Quaternary geomagnetic polarity timescale, as well as allow a more accurate assessment of global and local changes in seafloor spreading rates over time.     

The chemical and hydrologic structure of Poa´s Volcano, Costa Rica

Comparison of the chemical characteristics of spring and river water draining the flanks of Poa´s Volcano, Costa Rica indicates that acid chloride sulfate springs of the northwestern flank of the volcano are derived by leakage and mixing of acid brines formed in the summit hydrothermal system with dilute flank groundwater. Acid chloride sulfate waters of the Rio Agrio drainage basin on the northwestern flank are the only waters on Poa´s that are affected by leakage of acid brines from the summit hydrothermal system. Acid sulfate waters found on the northwestern flank are produced by the interaction of surface and shallow groundwater with dry and wet acid deposition of SO₂ and H₂SO₄ aerosols, respectively. The acid deposition is caused by a plume of acid gases that is released by a shallow magma body located beneath the active crater of Poa´s.No evidence for a deep reservoir of neutral pH sodium chloride brine is found at Poa´s. The lack of discharge of sodium chloride waters at Poa´s is attributed to two factors: (1) the presence of a relatively volatile-rich magma body degassing at shallow depths (< 1 km) into a high level summit groundwater system; and (2) the hydrologic structure of the volcano in which high rates of recharge combine with rapid lateral flow of shallow groundwater to prevent deep-seated sodium chloride fluids from ascending to the surface. The shallow depth of the volatile-rich magma results in the degassing of large quantities of SO₂ and HCl. These gases are readily hydrolyzed and quickly mix with meteoric water to form a reservoir of acid chloride-sulfate brine in the summit hydrothermal system. High recharge rates and steep hydraulic gradients associated with elevated topographic features of the summit region promote lateral flow of acid brines generated in the summit hydrothermal system. However, the same high recharge rates and steep hydraulic gradients prevent lateral flow of deep-seated fluids, thereby masking the presence of any sodium chloride brines that may exist in deeper parts of the volcanic edifice.Structural, stratigraphic, and topographic features of Poa´s Volcano are critical in restricting flow of acid brines to the northwestern flank of the volcano. A permeable lava-lahar sequence that outcrops in the Rio Agrio drainage basin forms a hydraulic conduit between the crater lake and acid chloride sulfate springs. Spring water residence times are estimated from tritium data and indicate that flow of acid brines from the active crater to the Rio Agrio source springs is relatively rapid (3 to 17 years). Hydraulic conductivity values of the lava-lahar sequence calculated from residence time estimates range from 10⁻⁵ to 10⁻⁷ m/s. These values are consistent with hydraulic conductivity values determined by aquifer tests of fractured and porous lava/pyroclastic sequences at the base of the northwestern flank of the volcano.Fluxes of dissolved rock-forming elements in Rio Agrio indicate that approximately 4300 and 1650 m³ of rock are removed annually from the northwest flank aquifer and the active crater hydrothermal system, respectively. Over the lifetime of the hydrothermal system (100's to 1000's of years), significant increases in aquifer porosity and permeability should occur, in marked contrast to the reduction in permeability that often accompanies hydrothermal alteration in less acidic systems. Average fluxes of fluoride, chloride and sulfur calculated from discharge and compositional data collected in the Rio Agrio drainage basin over the period 1988–1990 are approximately 2, 38 and 30 metric tons/day. These fluxes should be representative of minimum volatile release rates at Poa´s in the last 10 to 20 years.     

The effects of source and receiver motion on seismic data1

The effects of source and receiver motion on seismic data are considered using extensions of the standard convolutional model. In particular, receiver motion introduces a time-variant spatial shift into data, while source motion converts the effect of the source signature from a single-channel convolution in time to a multichannel convolution in time and space. These results are consistent with classical Doppler theory and suggest that Doppler shifting can introduce distortions into seismic data even at relatively slow acquisition speeds. It is shown that, while both source and receiver motion are known to be important for marine vibroseis acquisition, receiver motion alone can produce significant artifacts in marine 3D data. Fortunately, the convolutional nature of the distortions renders them amenable to correction using simple deconvolution techniques. Specifically, the effects of receiver motion can be neutralized by applying an appropriate reverse time-variant spatial shift, while those due to source motion can be addressed by introducing time-variant spatial shifts both before and after standard, deterministic, signature deconvolution or correlation.     

Lithological heterogeneity in a back-barrier sand island: Implications for modelling hydrogeological frameworks

Sediment mineralogy, quartz-grain surface-textures, grain-size analysis, bore-hole logging and ground penetrating radar are combined to develop a three dimensional stratigraphic model of a back-barrier sand island in southeast Queensland, Australia. The island consists of an unconsolidated sedimentary pile above an erosional bounding surface at the top of the underlying bedrock. The stratigraphy is complex, recording the shift in depositional environments from fluvio-deltaic to strandplain, via estuarine stages of evolution. The back-barrier island deposits are correlated with the stratigraphy of the adjacent coastal plain to the west and the barrier island to the east. Extrapolation of optically stimulated luminescence dates obtained from the barrier island combined with direct dating of the back-barrier island sediments is used to constrain the depositional age and chronology of the back-barrier island stratigraphy. The modern depositional environment evolved from a chenier plain into a barrier island system by the flooding of an interdune swale and development of a shore-parallel back-barrier tidal lagoon. The lithological heterogeneity of the back-barrier island succession was controlled by the presence of a bedrock incised palaeovalley and changes in relative sea-level.Sedimentary facies associations constrain the spatial distribution of hydraulic properties controlled by lithological heterogeneity. Post-depositional alteration horizons are integrated with the facies model to account for the effects of weathering and diagenesis on hydraulic behaviour. The derived hydrostratigraphy describes a vertically stacked, dual aquifer, island groundwater system consisting of a semi-confined palaeovalley aquifer overlain by an unconfined strand-plain aquifer.Hydrostratigraphic analysis based on sedimentary facies associations, integrated with post-depositional alteration characteristics reveals great complexity of groundwater systems within small island settings. The facies modelling approach employed in this study more accurately estimates the distribution of lithological heterogeneity and the associated variations in hydraulic properties in the sedimentary pile.