Response of circular footings and anchor plates in non-homogeneous elastic soils

The axisymmetric elastic response of circular footings and anchor plates in a linearly non-homogeneous elastic soil is analysed. It is assumed that footings/anchors are flexible and subjected to axisymmetric vertical loads. The response of the footing/anchor is modelled by using the classical Poisson–Kirchhoff thin plate theory. A variational technique is used to analyse the interaction problem. A representation for the contact stress is established by using a fundamental solution corresponding to a unit vertical pressure acting over an annular region in the interior of the non-homogeneous soil. The fundamental solution can be derived by using rigorous analytical procedures. The influence of the footing flexibility and the degree of soil non-homogeneity on the displacements, bending moments and contact stresses of a surface footing is examined over a wide range of governing parameters. In the case of anchor plates the influence of depth of embedment, degree of soil non-homogeneity and anchor flexibility on the anchor displacement is investigated.     

A sapphirine–phlogopite–cordierite paragenesis in a low-P amphibolite facies terrain, Arunta Inlier, Australia

Summary Silica-undersaturated phlogopite schists from the Cackleberry Metamorphics, Arunta Inlier, central Australia, preserve relatively low-temperature sapphirine-bearing parageneses that developed during low-pressure upper amphibolite facies metamorphism. Peak metamorphic phlogopite–cordierite–sapphirine assemblages are interpreted to have formed during the same event recorded in nearby metapelites, at c.3 kbar and 650–700 °C. Initial cooling of the terrain resulted in the breakdown of sapphirine to corundum–chlorite–phlogopite and corundum–spinel–chlorite assemblages. Further retrogression at greenschist facies conditions resulted in the replacement of sapphirine by diaspore–chlorite intergrowths. The reaction textures are consistent with a near-isobaric heating-cooling path at low-pressure, and provide evidence for the stability of sapphirine at c.700 °C at low pressures in rocks of an appropriate Mg- and Fe³⁺-rich bulk composition. Received August 15, 2001 accepted December 27, 2001     

Sources and sinks of sea salt in a newfoundland blanket bog

Over an oceanic peatland, the concentration of Na in fog averaged 38.1 mgl^?1 compared with 1.8 mgl^?1 in rain, resulting in a significant flux of mineral elements to the surface. Between 16 May and 20 June 1990 the average mass flux of Na to the bog surface by fog, rain, and dry deposition was 21.9, 10.4 and 7.0 mg m^?2 d^?1. There was little long-term storage of Na within the peatland system, where Na losses measured in stream runoff averaged 34.8 mg m² d^?1, and deep groundwater losses 4 mg m^?2 d^?1. Calcium and Mg were preferentially retained in the organic soil, whereas K was relatively mobile. Potassium tended to become concentrated in the unsaturated zone. Stream runoff had a consistently higher pH than groundwater, corresponding to higher Ca and Mg concentrations, which may have been from mineral sources in the headwater ponds. Otherwise, the stream water chemistry was closely related to groundwater in the upper layers of the peat deposit.     

Comparison of results from several AOGCMs for global and regional sea-level change 1900–2100

 Sea-level rise is an important aspect of climate change because of its impact on society and ecosystems. Here we present an intercomparison of results from ten coupled atmosphere-ocean general circulation models (AOGCMs) for sea-level changes simulated for the twentieth century and projected to occur during the twenty first century in experiments following scenario IS92a for greenhouse gases and sulphate aerosols. The model results suggest that the rate of sea-level rise due to thermal expansion of sea water has increased during the twentieth century, but the small set of tide gauges with long records might not be adequate to detect this acceleration. The rate of sea-level rise due to thermal expansion continues to increase throughout the twenty first century, and the projected total is consequently larger than in the twentieth century; for 1990–2090 it amounts to 0.20–0.37 m. This wide range results from systematic uncertainty in modelling of climate change and of heat uptake by the ocean. The AOGCMs agree that sea-level rise is expected to be geographically non-uniform, with some regions experiencing as much as twice the global average, and others practically zero, but they do not agree about the geographical pattern. The lack of agreement indicates that we cannot currently have confidence in projections of local sea-level changes, and reveals a need for detailed analysis and intercomparison in order to understand and reduce the disagreements. Received: 1 September 2000 / Accepted: 20 April 2001     

Why Mt Etna?

The Etna volcano is located in an apparently anomalous position on the hinge zone of the Apennines subduction and its Na-alkaline geochemistry does not favour a magma source from the deep slab as indicated for the Aeolian K-alkaline magmatism. The steeper dip of the regional foreland monocline at the front of the Apennines in the Ionian Sea than in Sicily, implies a larger rollback of the subduction hinge in the Ionian Sea. Moreover, the lengthening of the Apennines arc needs extension parallel to the arc. Therefore, the larger southeastward subduction rollback of the Ionian lithosphere with respect to the Hyblean plateau in Sicily, should kinematically produce right-lateral transtension and a sort of vertical 'slab window' which might explain (i) the Plio-Pleistocene alkaline magmatism of eastern Sicily (e.g. the Etna volcano) and (ii) the late Pliocene to present right lateral transtensional tectonics and seismicity of eastern Sicily. The area of transfer of different dip and rollback occurs along the inherited Mesozoic passive continental margin between Sicily and the oceanic Ionian Sea, i.e. the Malta escarpment.     

Grain boundary diffusion in enstatite

We have investigated grain boundary diffusion rates in enstatite by heating single crystals of quartz packed in powdered San Carlos olivine (Mg_0.90Fe_0.10)₂SiO₄ at controlled oxygen fugacities in the range 10^?5.7 to 10^?8.7?atm and temperatures from 1350° to 1450?°C for times from 5 to 100?h at 1?atm total pressure. Following the experiments, the thickness of the coherent polycrystalline reaction rim of pyroxene that had formed between the quartz and olivine was measured using backscatter scanning imaging in the electron microprobe. Quantitative microprobe analysis indicated that the composition of this reaction phase is (Mg_0.92Fe_0.08)₂Si₂O₆. The rate of growth of the pyroxene increases with increasing temperature, is independent of the oxygen fugacity, and is consistent with a parabolic rate law, indicating that the growth rate is controlled by ionic diffusion through the pyroxene rim. Microstructural observations and platinum marker experiments suggest that the reaction phase is formed at the olivine-pyroxene interface, and is therefore controlled by the diffusion of silicon and oxygen. The parabolic rate constants determined from the experiments were analyzed in terms of the oxide activity gradient across the rim to yield mean effective diffusivities for the rate-limiting ionic species, assuming bulk transport through the pyroxene layer. These effective diffusivities are faster than the lattice diffusivities for the slowest species (silicon) calculated from creep experiments, but slower than measured lattice diffusivities for oxygen in enstatite. Thus, silicon grain boundary diffusion is most likely to be the rate-limiting process in the growth of the pyroxene rims. Also, as oxygen transport through the pyroxene rims must be faster than silicon transport, diffusion of oxygen along the grain boundaries must be faster than through the lattice. The grain boundary diffusivity for silicon in orthopyroxenite is then given by D¯gbSiδ=(3.3±3.0)×10^?9f0.0O₂e^?400±65/RT?m³s^?1, where the activation energy for diffusion is in kJ/mol, and δ is the grain boundary width in m. Calculated growth rates for enstatite under these conditions are significantly slower than predicted by an extrapolation from similar experiments performed at 1000?°C under high pressure (hydrous) conditions by Yund and Tullis (1992), perhaps due to water-enhancement of diffusion in their experiments.     

An experimental study in forming a long synthetic aperture at sea

The testing of a synthetic aperture technique, the ETAM algorithm, is extended and its performance for CW pseudorandom signals and broadband ship noise is examined. The results show the limitations of the technique and are of special interest for operational systems development. In the CW experiments, the transmitted signal was generated with high temporal coherence, and loss of the spatial and temporal coherence of the received signal was introduced only by the medium and the stability of the towed array. In the experiments that included the pseudorandom signal and the ship noise, the temporal coherence of the transmitted signals was deliberately chosen to be poor in order to study the effects and the performance of this algorithm with broadband signals. The related experimental results show that for received signals, which have their segments over the synthesizing period highly cross-correlated, a synthetic aperture array gain was achieved that corresponds to the length of an equivalent fully populated array     

A techno-economic comparison of power systems for autonomousunderwater vehicles

This paper compares lead-acid batteries, sodium-sulfur batteries, solid polymer fuel cells and closed-cycle diesel engines for autonomous underwater vehicle (AUV) applications. The service is described in terms of a parametric mission and life cycle. A generic AUV is used as a basis for comparison. Power systems are evaluated by two criteria: (1) submerged endurance capability and (2) life cycle cost. This study determines categories of service for which each power system is preferred. The solid polymer fuel cell can provide greater submerged endurance than other power systems examined. For extremely long duration AUV missions, the fuel cell is the required system, indicating a possible market niche for today's fuel cell technology. Considering cost projections for each power system, the results also show that the SPFC can become cost-competitive with conventional technologies, particularly for services characterized by high levels of utilization     

Multiple-source localization using GPS technology and receivedarrival time structure analysis in an air-deployed system

An efficient and robust method has been developed to locate multiple impulsive sources in an ocean environment. Global position system (GPS) receivers were installed on sonobuoys to obtain their locations within a few meters of accuracy. A sonobuoy field was deployed in a ring-type pattern. Charges were then set off at arbitrary locations within the ring, High-resolution plots were used to obtain direct path and/or first bottom bounce arrivals on each buoy. A model grid of arrival times was constructed, corresponding to the dimensions of the buoy field. A ray model previously developed here at the Applied Research Laboratories at the University of Texas at Austin (ARL:UT) was used to obtain model travel times. The minimum value of the least-square-type error between the real arrival times and the modeled travel times resulted in an unambiguous location of the source, within the limits of the grid spacing chosen. This value was calculated by picking one receiver as the reference and then summing the timing errors of the remaining receivers relative to the reference. Successive iterations with finer grid spacings result in source localization within the accuracy of the buoy locations. The localization routine was extended by allowing permutations of the pulse arrivals on each buoy to account for multiple sources closely separated in time and/or space. An automated correlation technique is presented as an alternative to the leading edge-detection method used here for obtaining relative arrival times. Two proof-of-concept experiments were performed and some results of data obtained at Lake Travis and the Gulf of Mexico are presented