Ground deformation modeling of flank dynamics prior to the 2002 eruption of Mt. Etna

On 22 September 2002, 1 month before the beginning of the flank eruption on the NE Rift, an M-3.7 earthquake struck the northeastern part of Mt. Etna, on the westernmost part of the Pernicana fault. In order to investigate the ground deformation pattern associated with this event, a multi-disciplinary approach is presented here. Just after the earthquake, specific GPS surveys were carried out on two small sub-networks, aimed at monitoring the eastern part of the Pernicana fault, and some baselines belonging to the northeastern EDM monitoring network of Mt. Etna were measured. The leveling route on the northeastern flank of the volcano was also surveyed. Furthermore, an investigation using SAR interferometry was performed and also the continuous tilt data recorded at a high precision sensor close to the epicenter were analyzed to constrain the coseismic deformation. The results of the geodetic surveys show a ground deformation pattern that affects the entire northeastern flank of the volcano, clearly shaped by the Pernicana fault, but too strong and wide to be related only to an M-3.7 earthquake. Leveling and DInSAR data highlight a local strong subsidence, up to 7 cm, close to the Pernicana fault. Significant displacements, up to 2 cm, were also detected on the upper part of the NE Rift and in the summit craters area, while the displacements decrease at lower altitude, suggesting that the dislocation did not continue further eastward. Three-dimensional GPS data inversions have been attempted in order to model the ground deformation source and its relationship with the volcano plumbing system. The model has also been constrained by vertical displacements measured by the leveling survey and by the deformation map obtained by SAR interferometry.     

Double-average characteristics of sediment motion in one-dimensional bed load

The sediment transport process on a flat bed was investigated experimentally, with reference to the relationship between the average solid discharge and the concentration and velocity of the moving grains. The instantaneous values of the quantities were measured and, therefore, it was possible to quantify the contribution of the temporal fluctuations of concentration and velocity to the resulting average sediment transport rate. Recognizing that the sediment transport process is an episodic phenomenon, an intermittency factor was defined and its contribution to the solid discharge, typically implicit in earlier formulations of the sediment flux, was highlighted. Conceptual analyses of the spatial scale dependence of the quantities were also made.     

The Cathedral of S. Giorgio in Ragusa Ibla (Italy): characterization of construction materials and their chromatic alteration

The Cathedral of St. Giorgio in Ragusa Ibla (Sicily) is one of the most important Baroque monuments of eastern Sicily. The restoration of the monument underway has put forward notable questions regarding the stone materials used and their state of degradation. The façade appears to be made mainly of a creamy white calcarenite, and of mortars and plasters. However, detailed analysis has highlighted a more complex use of the raw material. The mortar and plaster have a different composition in regards to their architectural use while the natural stone material is distinguished not only by a creamy-white calcarenite but also by a dark coloured bituminous calcarenite (pitch rock), which now appears whiter because of superficial chromatic alterations. This process was reproduced in the laboratory using an accelerated aging technique on samples of bituminous calcarenite, which allowed the cause of the alternation to be identified as photo-oxidation of the asphaltenes. Following this process of photo-oxidation, other forms of chromatic alterations affected the façade (brown–orange-coloured patinas). FTIR, Scanning Electron Microscope and thin section microscopic observation allowed the characterization of also the products of this process to be carried out, highlighting the complex mechanism which the processes underwent.     

Enhancing the credibility of ecology: Is interdisciplinary research for land use planning useful?

Interdisciplinary approaches involving inputs from both the natural and social sciences represent one operational and social response to the complexity of today's environmental and land use problems. The resulting amalgam can be useful to both science and society, given the right mix of ingredients. Important steps in the planning and conduct of interdisciplinary research include problem indentification; definition of a precise scientific theme derived from the social demand; choice of relevant disciplines; selection of study area and spatial scale; ensuring that the project is adaptable to changing circumstances; obtaining the involvement of scientists, planners and local people; developing a continuum of actions from basic and applied research through to training and information diffusion; early and explicit definition of the criteria for evaluation. Though interdisciplinary approaches have shown their worth, they founder easily. Obstacles include the behavioural and psychological characteristics of individual scientists, differences in scientific method, and bottlenecks of a more administrative, institutional, political and financial nature.The views expressed are those of the authors and not necessarily those of the authors' employers.     

Climatic variations in the coastal zone — Comparison between the Po River delta (Adriatic Sea,Italy) and the Huanghe River delta (Bohai Sea,China)

The aim of this work is to research the influence of natural climatic changes on the evolution of the coastal zone in modern times and the possible implication of human activities on the configuration of the present coastline. Comparison of data of two very far and different areas, the Po River delta, Adriatic Sea and the Huanghe River delta, Bohai Sea, reveals the planetary diffusion of climatic fluctuations and their effects on coastal evolution. Contribution No. 820 from the Marine Geology Institute, C. N. R., Italy. Contribution No.2207 from the Institute of Oceanology, Academia Sinica. Project supported by the National Natural Science Foundation of China.     

A procedure to estimate the seismic hazard in an urban area: an application to Acireale (Eastern Sicily)

A “standard procedure” to characterize the seismic hazard of a given area was proposed. It is based on a multidisciplinary approach implying: (1) the knowledge of the seismic history of the area; (2) detailed geological surveys; (3)seismic noise measurements; (4) simulations of earthquake scenarios. The downtown of Acireale, a typical baroque town located on Eastern Sicily, was chosen as the “test area”. A catalog of the local seismogenic faults (able to generate earthquakes in historical times) has been compiled, as well as a seismic catalog for the effects of both local and regional earthquakes. The analysis of both catalogs allowed us to make the following conclusions: (1) the most important seismogenic faults affecting the Acireale municipality do not affect the downtown, while the related local earthquakes attenuate their energy (and intensity) in short (few km) distances; (2) the highest seismic intensity (degree X) experienced in Acireale downtown was caused by the 1693 regional earthquake; (3) over the last 140 years, the downtown has experienced the highest intensity value of VII only once, while six times the intensity was VI. On the whole, this implies a moderate seismic hazard. The estimation of the seismic hazard has been also approached by the experimental method of recording seismic noise. Measurements have been performed at seven different sites, where drills gave detailed information on the shallow subsurface geology to obtain HV (horizontal/vertical) spectral ratios. On the whole, the highest site amplification factor was moderate (about 7). A further investigation based on synthetic seismograms (and spectra) produced by simulating two given earthquake scenarios was also performed. The two scenarios are, respectively, representative of the largest expected earthquake in the area (the 1693 shock) and of a moderate (magnitude ca. 5.5) local earthquake (as the 1818 one). Moderate to strong locally expected accelerations were evidenced.     

Clinopyroxene of spinel-peridotite mantle xenoliths from Lake Nji (Cameroon Volcanic Line, W Africa): crystal chemistry and petrological implications

The crystal chemistry of six clinopyroxenes enclosed in protogranular spinel-peridotite mantle xenoliths from Lake Nji (Cameroon, W Africa) was studied by means of single-crystal X-ray diffraction and electron microprobe. These spinel-peridotite xenoliths are characterised by clinopyroxene contents distinctly higher than those reported by Lee et al. (1996) for spinel-peridotite xenoliths of the same region (19–11% and 15–8% respectively) and by high clinopyroxene/orthopyroxene ratios: 0.7–2.7 (present study) and about 0.4 (Lee et al. 1996). The clinopyroxene crystal chemistry indicates that the xenoliths show the compositional features of a mantle source contaminated by small-volume melts, responsible for the high clinopyroxene content. The protogranular texture of the Cameroon xenoliths (upper portion of lithospheric mantle) testifies that the spinel peridotite and the associated small-volume melts completely re-equilibrated at the spinel-peridotite facies. This is also supported by the petrological and geochemical data of Lee et al. (1996) on the Etinde–Biu Plateau spinel-peridotite xenoliths, which underwent Late Proterozoic–Early Paleozoic enrichment in incompatible trace elements. Received: 6 October 1999 / Accepted: 27 March 2000     

Plan‐form evolution of ancient meandering rivers reconstructed from longitudinal outcrop sections

The mode of channel‐bend transformation (i.e. expansion, translation, rotation or a combination thereof) has a direct bearing on the dimensions, shape, bedding architecture and connectivity of point‐bar sandstone bodies within a fluvial meander belt, but is generally difficult to recognize in vertical outcrops. This study demonstrates how the bend transformation mode and relative rate of channel‐floor aggradation can be deciphered from longitudinal outcrop sections aligned parallel to the meander‐belt axis, as a crucial methodological aid to the reconstruction of ancient fluvial systems and the development of outcrop analogue models for fluvial petroleum reservoirs. The study focuses on single‐storey and multi‐storey fluvial meander‐belt sandstone bodies in the Palaeogene piggyback Boyabat Basin of north‐central Turkey. The sandstone bodies are several hundred metres wide, 5 to 40 m thick and encased in muddy floodplain deposits. The individual channel‐belt storeys are 5 to 9 m thick and their transverse sections show lateral‐accretion bed packages representing point bars. Point bars in longitudinal sections are recognizable as broad mounds whose parts with downstream‐inclined, subhorizontal and upstream‐inclined bedding represent, respectively, the bar downstream, central and upstream parts. The inter‐bar channel thalweg is recognizable as the transition zone between adjacent point‐bar bedsets with opposing dip directions into or out of the outcrop section. The diverging or converging adjacent thalweg trajectories, or a trajectory migrating in up‐valley direction, indicate point‐bar broadening and hence channel‐bend expansion. A concurrent down‐valley migration of adjacent trajectories indicates channel‐bend translation. Bend rotation is recognizable from the replacement of a depositional riffle by an erosional pool zone or vice versa along the thalweg trajectory. The steepness of the thalweg trajectory reflects the relative rate of channel‐floor aggradation. This study discusses further how the late‐stage foreland tectonics, with its alternating pulses of uplift and subsidence and a progressive narrowing of the basin, has forced aggradation of fluvial channels and caused vertical stacking of meander belts.