Laboratory condensation of refractory dust in protosolar and circumstellar conditions

In order to better understand condensation processes that took place in the solar nebula and to evaluate the effect of kinetics on the condensed matter, we have built an experimental apparatus for studying condensation of multi-elemental refractory gases at high-temperature and low-pressure. The condensation of a Mg-Si-rich gas, with solar interelement ratios of Ca, Al, Mg and Si, and of a Ca-Al-rich gas under a total pressure of ∼4 × 10⁻³ bar at temperatures from 1045 to 1285 °C and for run times of 4-60 min results in direct formation of crystalline oxides or silicates such as corundum, spinel, anorthite, melilite, Al-diopside, forsterite and enstatite. The mineralogy of the condensates, close to that predicted at equilibrium, varies with the duration of an experiment and the temperature of condensation. The chemical reactions between gas and condensates are rapid enough to attain a steady state in less than one hour. The condensation results in chemical fractionation of the gas, i.e. a depletion of the gas in refractory elements at high temperature. Finally, besides revealing the textures of refractory crystals, which condense from a gas of complex chemical composition, this study shows that certain phases, such as spinel, have favored kinetics of condensation. Our experimental results confirm that refractory inclusions in primitive meteorites could have formed by condensation from a hot nebular gas. Similarly, we confirm that crystalline grains can condense at high temperature in the outflows of evolved stars. In both cases, our results indicate that kinetic processes certainly influence grain mineralogy. Kinetic processes must thus be taken into account in modeling the pressure-temperature conditions of circumstellar environments.     

Diagenesis and fracturing of Paleocene–Eocene carbonate turbidite systems in the Ionian Basin: The example of the Kelçyra area (Albania)

The Kelçyra area is emplaced in a foreland fold-and-thrust belt (FFTB), characterized by a westward thrusting with the Triassic evaporites as the major décollement level. Several secondary features related with this evolution, like backthrusting, folding, duplex structures, evaporite diapirism are present. During the FFTB evolution, the study area has been subjected to several fracturing events with associated stages of fluid migration. During the pre-deformational stage, complex textures such as crack-and-seal features most likely reflect expulsion of overpressured fluids. These fluids were dominantly host-rock buffered. Within the post-deformational stage, a meteoric fluid caused cementation and development of a karst network during a period of emergence after the thrust emplacement. Subsequently, Mg calcite reprecipitated in the more stable carbonate phase calcite and dolomite, which filled part of the karts network. The latter is finally dedolomitized and locally partially dissolved by a second meteoric fluid flow, which greatly increased the secondary porosity.     

Lower Eocene carbonate-cemented “chimney” structures (Varna, Bulgaria) — Control of seepage rates on their formation and stable isotopic signature

The genesis of Lower Eocene calcite-cemented columns, “pisoid”-covered structures and horizontal interbeds, clustered in dispersed outcrops in the Pobiti Kamani area (Varna, Bulgaria) is related to fossil processes of hydrocarbon migration. Field observations, petrography and stable isotope geochemistry of the cemented structures and associated early-diagenetic veins, revealed that varying seepage rates of a single, warm hydrocarbon-bearing fluid, probably ascending along active faults, controlled the type of structure formed and its geochemical signature. Slow seepage allowed methane to oxidize within the sediment under ambient seafloor conditions (δ¹⁸O = − 1 ± 0.5‰ V-PDB), explaining columns' depleted δ¹³C ratios of − 43‰. Increasing seepage rates caused methane to emanate into the water column (δ¹³C = − 8‰) and raised precipitation temperatures (δ¹⁸O = − 8‰). Calcite-cemented conduits formed and upward migrating fluids also affected interbed cementation. Even higher-energy fluid flow and temperatures likely controlled the formation of “pisoids”, whereby sediment was whirled up and cemented.     

Studies on flow characteristics of coal–oil–water slurry system

Experiments were carried out to investigate the rheological properties of coal–oil–water suspension containing solids of different sizes. Two different coal samples with mean particle sizes of 120 mesh, 175 mesh and 220 mesh were used. The coal concentration was varied from 5% to 25% by weight. Sodium silicate has been used as an additive to study the behavior of the variation of average viscosity of the suspension. A generalized correlation has been developed to predict the average viscosity of suspension in terms of particle diameter of the coal, concentration of coal, viscosity of the suspending medium and the concentration of water. Experimental investigations revealed that coal–oil–water suspensions show an increase in the viscosity with decrease in coal size but with the addition of an additive, the average viscosity tends to decrease initially up to a certain optimum dosages and thereafter it increases with further addition of additives. Two empirical correlations are proposed for average viscosity of the coal–oil–water suspension, μ_sL in terms of physical properties of the solid and viscosity of the suspending medium with and without additives.     

On the Importance of Geolithological Features for the Estimate of the Site Response: The Case of Catania Metropolitan Area (Italy)

The evaluation of seismic site response in the urban area of Catania was tackled by selecting test areas having peculiar lithological and structural features, potentially favourable to large local amplifications of ground motion. The two selected areas are located in the historical downtown and in the northern part of Catania where the presence of a fault is evident. Site response was evaluated using spectral ratio technique taking the horizontal- to-vertical component ratio of ambient noise. Inferences from microtremor measurements are compared with results from synthetic accelerograms and response spectra computed at all drillings available for this area. Such method is particularly suitable in urban areas where the nature of the outcropping geological units is masked by city growth and anthropic intervention on the surface geology. The microtremor H/V spectral ratios evaluated at soft sites located within the downtown profile tend to be smaller than that usually reported in the literature for such soils. A tendency for amplifications to peaks near 2 Hz is observed only in some sites located on recent alluvial deposits. Evidences for amplifications of site effects (frequency range 4–8 Hz) were observed in the sampling sites located on the fault, with a rapid decrease of spectral amplitude just a few tenths of metres away from the discontinuity. Numerical simulations evidenced the importance of geolithological features at depth levels even greater than 20–30 m. Besides this, the results strongly confirm the importance of the subsurface geological conditions, in the estimate of seismic hazard at urban scale.     

Deformability characteristics of brazilian laterites

This paper summarizes the resilient and permanent deformation characteristics of laterite gravels, determined by cyclic loading in triaxial tests of compacted specimens. A study of laterite pavements was carried out on eight paved road sections in the state of Mato Grosso. Also reported is the influence of fine sand admixture, specimen size and soaking in two laterite samples from Roraima and Rondônia in the North of Brazil. The experimental relationships of resilient moduli against applied stresses are interpreted empirically for models what may be incorporated in a structural analysis of full depth of laterite pavement.     

Patterns in the Turkish reinsurance claim data, 1998–2002: An application of the extreme value theory

The devastating 1999 Marmara and Düzce earthquakes led to a significant increase in the earthquake studies in Turkey in geological, engineering and financial aspects. Extreme Value Theory (EVT) has a range of applications from stock market changes to natural disasters like floods and hurricanes. Here EVT is fitted to the ordinary and earthquake reinsurance claims of Turkey.     

法国国家测绘局（IGN）述评

法国是世界测绘强国之一。法国国家测绘局（IGN）是法国测绘的领导机构。本文介绍了IGN的概况，并对IGN大地测量、地图制图、对外服务、研究机构等情况作了较详细的描述。在此基础上对IGN的未来发展特点提出了几点看法。     

Determination of Area-Averaged Water Vapour Fluxes with Large Aperture and Radio Wave Scintillometers over a Heterogeneous Surface – Flevoland Field Experiment

A large aperture scintillometer (LAS) andradio wave scintillometer (RWS)were installed over a heterogeneous areato test the applicability of the scintillation method.The heterogeneity in the area, whichconsisted of many plots, was mainly caused bydifferences in thermal properties ofthe crops; the variations in theaerodynamic roughness lengthwere small. The water vapour fluxesderived from the combined LAS-RWSsystem, also known as the two-wavelengthmethod, agreed fairly well with the aggregatedwater vapour fluxes derived from in-situeddy covariance measurements. The water vapourfluxes derived from a stand-alone LASare also presented. It was found that a single LASand an estimate of the area averagedavailable energy (using a simple parameterisationscheme) can provide also reasonablearea-averaged water vapour fluxes.     

鄂尔多斯古生界流体包裹体特征及其与油气演化关系

对鄂尔多斯盆地奥陶系碳酸盐岩、石炭-二叠系石英砂岩成岩作用研究的基础上,分别对上述岩石流体包裹体作了初步研究。奥陶系碳酸盐岩包裹体均一温度具有三个区段 :6 0～ 10 0℃,10 0～ 16 0℃,16 0～ 2 2 0℃;石炭-二叠系石英砂岩包裹体均一温度三个区段为 90～ 110℃,12 0～ 14 0℃,16 0～ 2 2 0℃。并利用包裹体测温资料结合已有的镜质体反射率、磷灰石裂变径迹等研究成果,对流体包裹体在鄂尔多斯盆地油气田形成、演化中应用作了初步探讨。