Dynamics of contaminants in phosphogypsum of the fertilizer industry of Huelva (SW Spain): From phosphate rock ore to the environment

The dynamics of trace elements from phosphate rock ore to the environment in a phosphoric acid plant located in SW Spain and the impact of phosphogypsum wastes were investigated through total digestion and BCR-sequential extraction. Based on total concentration, element transfer factors as criteria for examining the potential environmental risk of waste with respect to ore rock were calculated, and it was observed that most trace elements are only transferred into phosphogypsum at rates of 2–12%. However, based on those concentrations that are likely to be most readily mobile in the environment, phosphogypsum acts as a higher emission source of contaminants than the original rock. About 100 million tonnes of phosphogypsum are stack-piled in a dump of 1200 ha over salt-marshes of an estuary formed by the confluence of the Tinto and Odiel rivers. Phosphogypsum has been applied, at the recommended rate of 20–25 t/ha since 1978–2001, to improve fertility and reduce Na saturation in agricultural soils of the Guadalquivir river valley (140 km²). Phosphogypsum capacity as a source of mobile contaminants in three environmental scenarios (water leaching, exposure to oxidising and reducing conditions) was quantified by combining sequential extraction and waste mass. The amounts of mobile contaminants that could be released for every tonne of phosphogypsum are approximately 7 × 10² g Sr, 1.1 × 10² g Fe, 55 g Y, 30 g Ce, 12 g Cr, 11 g Ti, 5 g Zn, 4 g each of Cu and Pb, 3 g each of V and Cd, 2 g each of As and Ni and 1 g U. Multiplying these amounts by 100 Mt and 20–25 t/ha, it is possible to calculate risk assessments of phosphogypsum for both estuarine zones, e.g. in a hypothetical stack collapse and waste spilling, and agricultural soils, respectively.     

Preliminary mineralogical and petrological study of the Ortosa Au–Bi–Te ore deposit: a reduced gold skarn in the northern part of the Rio Narcea Gold Belt, Asturias, Spain

The Ortosa deposit (NW Spain) in the northern part of the Rio Narcea Gold Belt (RNGB) is located in the Cantabrian Zone of the Iberian Massif. This zone corresponds to the westernmost exposure of the European Hercynides. The deposit is hosted by marine shales, siltstones, calcareous siltstones and interbedded sandy limestones of the upper part of the Silurian Furada Formation. These rocks are intruded by a main stock and numerous sills and dikes consisting of a reduced, ilmenite-bearing quartz-monzodiorite (Ortosa intrusion). Skarn metasomatism and associated gold mineralization overprinted these sedimentary and igneous rocks, forming endo- and exoskarns.The earliest stage of alteration involved potassium metasomatism from which metasomatic biotite developed in the hornfels around the intrusion. In the endoskarn, the first metasomatic mineral to form is actinolite. Subsequently, quartz, pyroxene (Hd_30–45), and sulfides (mainly arsenopyrite and pyrrhotite) formed, followed by a second generation of amphibole (ferroactinolite and ferrohornblende). The exoskarn is a pyroxene-garnet skarn, which is often banded. The prograde minerals are pyroxene (Hd_10–30) and grossular garnet. The retrograde mineralogy consists of hedenbergite-rich pyroxene (Hd_50–87), amphibole (ferroactinolite–ferrohornblende), and the metallic minerals with minor fluorapatite, K-feldspar, albite, epidote–clinozoisite, vesuvianite and calcite. A final stage of retrograde alteration is characterized by calcite, quartz, and chlorite.Pyrrhotite and arsenopyrite are the more abundant metallic minerals, and löllingite, chalcopyrite, pyrite and sphalerite are present in smaller amounts. The gold occurs as native gold and maldonite, and is accompanied by hedleyite, native bismuth, and bismuthinite. These Au–Bi–Te mineral assemblages occupy cavities and fractures in the arsenopyrite or in the pyrrhotite.Estimated physiochemical conditions of formation based on the composition and stability fields of major calc-silicate and sulfide minerals indicate that the hedenbergite-rich pyroxene and the earliest sulfides (löllingite–pyrrhotite–arsenopyrite) crystallized at temperatures between 470 and 535°C at low log fS₂ between −10 and −6.5 and low log fO₂ of −22. The Ortosa skarns can be included in the reduced gold skarn subtype defined by Meinert (Mineralogical Association of Canada, Quebec city, Que., Canada, 1998, 26,359–414 ).     

Field multi-step limestone and MgO passive system to treat acid mine drainage with high metal concentrations

Passive treatment systems have become one of the most sustainable and feasible ways of remediating acid mine drainage (AMD). However, conventional treatments show early clogging of the porosity or/and coating of the reactive grains when high acidity and metal concentrations are treated. The performance of fine-grained reagents dispersed in a high porosity matrix of wood shavings was tested as an alternative to overcome these durability problems. The system consisted of two tanks of 3 m³ filled with limestone sand and wood shavings, and one tank of 1 m³ with caustic magnesia powder and wood shavings, separated by several oxidation cascades and decantation ponds. The system treated about 1.5 m³/day of AMD containing an average of 360 mg/L Fe, 120 mg/L Al, 390 mg/L Zn, 10 mg/L Cu, 300 μg/L As and 140 μg/L Pb, a mean pH of 3.08 and a net acidity of 2500 mg/L as CaCO₃ equivalent. The water reached pH 5 and 6 in the first and second limestone tanks, respectively (suitable to remove trivalent metals); and pH 8–9 in the MgO tank (suitable to remove divalent metals). After 9 months of operation, the system achieved an average removal of 100% Al, Cu, As, Pb, more than 70% Fe, about 25% Zn and 80% acidity. Goethite, schwertmannite, hydrobasaluminite, amorphous Al(OH)₃ and gypsum were the main precipitates in the two limestone tanks. Precipitation of divalent metals (Fe (II), Zn, and traces of Cd, Ni and Co) were complete inside the third tank of MgO, but preferential flow along the walls was responsible for its low treatment performance. Goethite, gypsum, Zn-schulenbergite and sauconite are the crystalline solid phases identified in the MgO tank.     

Trends in warm days and cold nights over the Iberian Peninsula: relationships to large-scale variables

The aims of this study are to identify the trend of warm days and cold nights over the Iberian Peninsula and to connect the variations with large-scale variables. The reasons for performing this analysis are the effects that extremes events have on different ecosystems. Here, we present the results on spatial and temporal variability of warm days (TX90), or those exceeding the 90th percentile of maximum temperature, and cold nights (TN10), or those falling below the 10th percentile of minimum temperature. The extreme indices were derived from daily observations at stations and gridded data over land area for the period 1950 to 2006. Significant trends of more warm days and fewer cold nights were found. The trend to fewer cold nights is within the interval of global results given by the IPCC AR4 report; however, the trend to warm days is greater than the corresponding global trend. The influence of large-scale variables on these extreme indices was examined by means of the Empirical Orthogonal Function, correlation, composite maps and multiple regression analyses. Changes in TX90 are connected with the Scandinavian teleconnection index and a preferred mode of geopotential height at 500 hPa over the North Atlantic. Changes in TN10 are connected with the East Atlantic teleconnection index and the leading mode of Sea Surface Temperature (SST) variability over the North Atlantic area. Based on the links between the extreme indices and the large-scale variables we derived statistical models to describe the response of TX90 and TN10 to atmospheric circulation and SST variations. The models characterized the observed variations of TX90 and TN10 reasonably well. The results of this study encourage us to analyze, in further work, how temperature extremes might change over the Iberian Peninsula under warmer climate conditions.     

A Wind-Tunnel Investigation of Wind-Turbine Wakes: Boundary-Layer Turbulence Effects

Wind-tunnel experiments were performed to study turbulence in the wake of a model wind turbine placed in a boundary layer developed over rough and smooth surfaces. Hot-wire anemometry was used to characterize the cross-sectional distribution of mean velocity, turbulence intensity and kinematic shear stress at different locations downwind of the turbine for both surface roughness cases. Special emphasis was placed on the spatial distribution of the velocity deficit and the turbulence intensity, which are important factors affecting turbine power generation and fatigue loads in wind energy parks. Non-axisymmetric behaviour of the wake is observed over both roughness types in response to the non-uniform incoming boundary-layer flow and the effect of the surface. Nonetheless, the velocity deficit with respect to the incoming velocity profile is nearly axisymmetric, except near the ground in the far wake where the wake interacts with the surface. It is found that the wind turbine induces a large enhancement of turbulence levels (positive added turbulence intensity) in the upper part of the wake. This is due to the effect of relatively large velocity fluctuations associated with helicoidal tip vortices near the wake edge, where the mean shear is strong. In the lower part of the wake, the mean shear and turbulence intensity are reduced with respect to the incoming flow. The non-axisymmetry of the turbulence intensity distribution of the wake is found to be stronger over the rough surface, where the incoming flow is less uniform at the turbine level. In the far wake the added turbulent intensity, its positive and negative contributions and its local maximum decay as a power law of downwind distance (with an exponent ranging from −0.3 to −0.5 for the rough surface, and with a wider variation for the smooth surface). Nevertheless, the effect of the turbine on the velocity defect and added turbulence intensity is not negligible even in the very far wake, at a distance of fifteen times the rotor diameter.     

Projection of future climate change conditions using IPCC simulations, neural networks and Bayesian statistics. Part 1: Temperature mean state and seasonal cycle in South America

Projections for South America of future climate change conditions in mean state and seasonal cycle for temperature during the twenty-first century are discussed. Our analysis includes one simulation of seven Atmospheric-Ocean Global Circulation Models, which participated in the Intergovernmental Panel on Climate Change Project and provided at least one simulation for the twentieth century (20c3m) and one simulation for each of three Special Report on Emissions Scenarios (SRES) A2, A1B, and B1. We developed a statistical method based on neural networks and Bayesian statistics to evaluate the models’ skills in simulating late twentieth century temperature over continental areas. Some criteria [model weight indices (MWIs)] are computed allowing comparing over such large regions how each model captures the temperature large scale structures and contributes to the multi-model combination. As the study demonstrates, the use of neural networks, optimized by Bayesian statistics, leads to two major results. First, the MWIs can be interpreted as optimal weights for a linear combination of the climate models. Second, the comparison between the neural network projection of twenty-first century conditions and a linear combination of such conditions allows the identification of the regions, which will most probably change, according to model biases and model ensemble variance. Model simulations in the southern tip of South America and along the Chilean and Peruvian coasts or in the northern coasts of South America (Venezuela, Guiana) are particularly poor. Overall, our results present an upper bound of potential temperature warming for each scenario. Spatially, in SRES A2, our major findings are that Tropical South America could warm up by about 4°C, while southern South America (SSA) would also undergo a near 2–3°C average warming. Interestingly, this annual mean temperature trend is modulated by the seasonal cycle in a contrasted way according to the regions. In SSA, the amplitude of the seasonal cycle tends to increase, while in northern South America, the amplitude of the seasonal cycle would be reduced leading to much milder winters. We show that all the scenarios have similar patterns and only differ in amplitude. SRES A1B differ from SRES A2 mainly for the late twenty-first century, reaching more or less an 80–90% amplitude compared to SRES A2. SRES B1, however, diverges from the other scenarios as soon as 2025. For the late twenty-first century, SRES B1 displays amplitudes, which are about half those of SRES A2.     

Dinophysoid dinoflagellates from subphotic depths:Amphisolenia sp.aff.brevicauda,Dinofurcula tricornuta sp.nov.,and Dinophysis profunda sp.nov.(Dinophysales,Dinophyceae)

Three species of dinophysoid planktonic dinoflagellates are described from the eastern Mediterranean Sea. Amphisolenia sp. aff. brevicauda was collected at 70-m depth in the Ionian Sea. This small species showed a more asymmetric midbody and a proportionally longer neck when compared to the closer relative A. brevicauda. Three individuals of Dinofurcula tricornuta sp. nov. collected at 154-m depth in the Marmara Sea are characterized by three posterior-oriented processes when compared to its con...     

Late pleistocene/early holocene environments and climates,fauna, and human occupation in the argentine altiplano

The Barro Negro site (23°S lat., 65°37′W long.) in the Altiplano (Puna) of northwestern Argentina contains a well stratified sequence of remains of Hippidion, the American extinct horse, camelids, and archaeological materials, which is the focus of this study. In addition to establishing a reliable chronology, paleoenvironmental information was obtained based on analyses of pollen and stable isotopes (oxygen and carbon) from bone and marl. The data indicate that Hippidion was present at the site between 12,000 and 10,000 yr B. P., at a time when Altoandean grasslands had expanded to lower elevations. By 10,000 yr B.P., when modern semi-arid sub-puna scrub had replaced the Altoandean grasslands, only camelids (Lama or Vicugna) were present, simultaneous with the first evidence of local human occupation. This suggests that a climatic shift from cool and moist (winter rain regime) to warm and dry (summer rain regime) conditions took place simultaneously with the disappearance of the American horse and the appearance of camelids and man.