Aerosol characterization and optical thickness retrievalsusing GOME and METEOSAT satellite data

Summary ?Retrievals of atmospheric aerosol optical thickness are highly dependent on the choice of the class describing the aerosol properties leading to significant errors while using classes available in the literature. High spectral resolution measurements from GOME (Global Ozone Monitoring Experiment) between the ultraviolet and the near infrared can be used for an accurate characterization of the aerosol optical properties. The radiometer MVIRI (METEOSAT Visible and Infrared Imager) on board the geostationary satellite METEOSAT, while being equipped only with broadband VIS channel, ensures an adequate half-hourly monitoring of the atmospheric conditions over a large portion of the Earth. The present algorithm is based on a combination of data from both sensors for the retrieval of the aerosol optical thickness at the reference wavelength of 0.55 μm (AOT). A case of a desert dust outbreak from the African continent over the Atlantic Ocean is examined. AOT values obtained using a priori fixed classes taken from the literature are compared with those retrieved with this algorithm using the GOME-derived classes. Systematic differences of the order of a few tenths on average are found which remain significant also after considering the measurement errors. This represents a novelty introduced by the synergetic use of both sensors. Received March 13, 2002     

Particle size dependent response of aerosol counters

During an international workshop at the Institute for Experimental Physics of the University of Vienna, Austria, which was coordinated within the Committee on Nucleation and Atmospheric Aerosols (IAMAS-IUGG), 10 instruments for aerosol number concentration measurement were studied, covering a wide range of methods based on various different measuring principles. In order to investigate the detection limits of the instruments considered with respect to particle size, simultaneous number concentration measurements were performed for monodispersed aerosols with particle sizes ranging from 1.5 to 50 nm diameter and various compositions.The instruments considered show quite different response characteristics, apparently related to the different vapors used in the various counters to enlarge the particles to an optically detectable size. A strong dependence of the 50% cutoff diameter on the particle composition in correlation with the type of vapor used in the specific instrument was found. An enhanced detection efficiency for ultrafine hygroscopic sodium chloride aerosols was observed with water operated systems, an analogous trend was found for n-butanol operated systems with nonhygroscopic silver and tungsten oxide particles.     

Pseudodynamic tests on rubber base isolators with numerical substructuring of the superstructure and strain‐rate effect compensation

A pseudodynamic testing procedure has been applied by which the seismic response of a base‐isolated building is obtained by using as specimen the isolators, while the superstructure is numerically simulated. The procedure also takes advantage of the continuous pseudodynamic testing capabilities of the ELSA laboratory, which increase the accuracy of the results and reduce the strain‐rate effect of the rubber bearings. A simple proportional correction of the measured forces compensates the remaining strain‐rate effect due to the unrealistic speed of the test. The correction factor is obtained by means of a characterizing test on the specific rubber isolators. The developed method has been successfully applied to the prediction of the seismic response of a base‐isolated four‐storey building submitted to several specified accelerograms. The results for those earthquakes as well as the effects of some changes of the parameters of the system are discussed. Copyright © 2002 John Wiley & Sons, Ltd.     

Towards a direct collapse–load method of design for concrete frames subjected to severe ground motions

Most current methods of design for concrete structures under earthquake loads rely on highly idealized ‘equivalent’ static representations of the seismic loads and linear‐elastic methods of structural analysis. With the continuing development of non‐linear methods of dynamic analysis for the overload behaviour and collapse of complete concrete structures, a more direct and more accurate design procedure becomes possible which considers conditions at system collapse. This paper describes an evaluation procedure that uses non‐linear dynamic collapse–load analysis together with global safety coefficients. A back‐calibration procedure for evaluating the global safety coefficients is also described. The aim of this paper is to open up discussion of alternative methods of design with improved accuracy which are necessary to move towards a direct collapse–load method of design. Copyright © 2002 John Wiley & Sons, Ltd.     

A non-linear stress-stiffness model for geomaterials at small to intermediate strains

A double exponential fitting model (DEFM) capable of expressing the non-linear stress-stiffness relationship of geomaterials has been proposed by Shibuya et al. (1997). The model comprises two material constants; the elastic stiffness at very small strains and the strength, together with other free parameters to determine the complete stress-stiffness relationship. In this paper, the capability of the original function used for DEFM in simulating the tangent stiffness-stress relationship of geomaterials is first discussed. Second, the methods for determining the free model parameters, as well as its conversion to obtain a stress-strain relationship are proposed. The applicability of DEFM to predicting non-linear stress-stiffness relationship is examined in detail in a total of forty-nine fitting cases of compression test data on sedimentary rock, artificial soft rock and soft clay. It is found that the DEFM is effective in expressing the non-linear stress-stiffness relationship of various kinds of geomaterials at small to intermediate strains, say less than 0.5%. The superiority of this model compared to other fitting models currently in use is also demonstrated in some of the fitting cases.     

Groundwater-flow modeling in the Yucatan karstic aquifer, Mexico

The current conceptual model of the unconfined karstic aquifer in the Yucatan Peninsula, Mexico, is that a fresh-water lens floats above denser saline water that penetrates more than 40 km inland. The transmissivity of the aquifer is very high so the hydraulic gradient is very low, ranging from 7–10 mm/km through most of the northern part of the peninsula. The computer modeling program AQUIFER was used to investigate the regional groundwater flow in the aquifer. The karstified zone was modeled using the assumption that it acts hydraulically similar to a granular, porous medium. As part of the calibration, the following hypotheses were tested: (1) karstic features play an important role in the groundwater-flow system; (2) a ring or belt of sinkholes in the area is a manifestation of a zone of high transmissivity that facilitates the channeling of groundwater toward the Gulf of Mexico; and (3) the geologic features in the southern part of Yucatan influence the groundwater-flow system. The model shows that the Sierrita de Ticul fault, in the southwestern part of the study area, acts as a flow barrier and head values decline toward the northeast. The modeling also shows that the regional flow-system dynamics have not been altered despite the large number of pumping wells because the volume of water pumped is small compared with the volume of recharge, and the well-developed karst system of the region has a very high hydraulic conductivity. Electronic Publication     

Seismic Hazard for Selected Sites in Greece: A Bayesian Estimate of Seismic Peak Ground Acceleration

A procedure for estimating maximum values of seismic peak ground accelerationat the examined site and quantiles of its probabilistic distribution in a future timeinterval of a given length is considered. The input information for the method areseismic catalog and regression relation between peak seismic acceleration at a givenpoint and magnitude and distance from the site to epicenter (seismic attenuation law).The method is based on Bayesian approach, which simply accounts for influenceof uncertainties of seismic acceleration values. The main assumptions for the method are Poissonian character of seismic events flow and distribution law of Gutenberg-Richter's type. The method is applied to seismic hazard estimation in six selected sitesin Greece.     

A double-head photon-counting photometer for fast timing observations

The structure of the electronics of the two-head, high-speed photometer operating on the 152-cm G.D. Cassini telescope of Bologna University has been fully redesigned for high-time-resolution observations of fast variable sources, in particular, of the optical counterparts of X-ray binary systems. The fast photometer now permits sampling times from 0.1 ms to 100 s. The handling of the system clock and I/O configuration have been modified to provide rigorous synchronization of the sampling time with an external high-stability clock and the continuous acquisition of an uninterrupted data stream. The continuous data-acquisition process, which is driven by an external clock, is limited only by the capacity of the hard disk and is supported by a double-buffer SRAM memory designed to overcome any discontinuity in the asynchronous communication with the computer. Real-time monitoring of the data enables continuous evaluation of the weather conditions, and the directly displayed light curve can be used to determine the optimal management of the observations.     

Simultaneous use of geochemical and geophysical methods to characterise abandoned landfills

. Groundwater sampling and geophysical methods determined a serious contamination problem associated with refilled exploitation sites at the Cal Dimoni area, Llobregat delta, Barcelona, Spain. To characterise this process, hydrogeochemical analyses were performed and showed the following modifications to groundwater chemical composition: increasing pH values, changing redox conditions, significant increases in total organic carbon (TOC) and certain trace elements, and high groundwater conductivity values. Major ion content accumulations were found under the refilled area. In contrast, elements involved in the oxidation–reduction processes, such as iron, manganese and nitrates, clearly diminished. Electromagnetic prospecting methods were also performed and delineated the contamination plume extent. These methods also showed separate sources of contamination, one clearly related to the groundwater–refilled zone leachate interaction, another as a consequence of the manure–accumulation surface site. Geochemical and geophysical methods have shown similar results for locating groundwater contamination sources, and for determining leachate generation mechanisms and flow paths.