Analysis of mutations in the p53 tumor suppressor gene and Ki- and Ha-ras proto-oncogenes in hepatic tumors of European flounder (Platichthys flesus).

DNA from five tumors, three other-injured livers and two normal liver tissue samples from the European flounder were analyzed for mutations in exons 5-8 of the tumor suppressor gene p53 and at codons 12, 13 and 61 of Ha- and Ki-ras proto-oncogenes. No tumor-specific mutations were identified by direct sequencing and single-strand conformation polymorphism of these genes. A number of silent polymorphisms were noted in p53. In addition to a need for more extensive analyses of flounder liver tumor samples for ras or p53 mutations, other cancer-related genes should be investigated.     

Improved Resolution of Ambient Flow through Fractured Rock with Temperature Logs

In contaminant hydrogeology, investigations at fractured rock sites are typically undertaken to improve understanding of the fracture networks and associated groundwater flow that govern past and/or future contaminant transport. Conventional hydrogeologic, geophysical, and hydrophysical techniques used to develop a conceptual model are often implemented in open boreholes under conditions of cross-connected flow. A new approach using high-resolution temperature (±0.001°C) profiles measured within static water columns of boreholes sealed using continuous, water-inflated, flexible liners (FLUTe™) identifies hydraulically active fractures under ambient (natural) groundwater flow conditions. The value of this approach is assessed by comparisons of temperature profiles from holes (100 to 200 m deep) with and without liners at four contaminated sites with distinctly different hydrogeologic conditions. The results from the lined holes consistently show many more hydraulically active fractures than the open-hole profiles, in which the influence of vertical flow through the borehole between a few fractures masks important intermediary flow zones. Temperature measurements in temporarily sealed boreholes not only improve the sensitivity and accuracy of identifying hydraulically active fractures under ambient conditions but also offer new insights regarding previously unresolvable flow distributions in fractured rock systems, while leaving the borehole available for other forms of testing and monitoring device installation.     

Impact of Sea-level Rise and Storm Surges on a Coastal Community

A technique to evaluate the risk of storm tides (the combination of a storm surge and tide) under present and enhanced greenhouse conditions has been applied to Cairns on the north-eastern Australian coast. The technique combines a statistical model for cyclone occurrence with a state-of-the-art storm surge inundation model and involves the random generation of a large number of storm tide simulations. The set of simulations constitutes a synthetic record of extreme sea-level events that can be analysed to produce storm tide return periods. The use of a dynamic storm surge model with overland flooding capability means that the spatial extent of flooding is also implicitly modelled. The technique has the advantage that it can readily be modified to include projected changes to cyclone behaviour due to the enhanced greenhouse effect. Sea-level heights in the current climate for return periods of 50, 100, 500 and 1000 years have been determined to be 2.0 m, 2.3 m, 3.0 m and 3.4 m respectively. In an enhanced greenhouse climate (around 2050), projected increases in cyclone intensity and mean sea-level see these heights increase to 2.4 m, 2.8 m, 3.8 m and 4.2 m respectively. The average area inundated by events with a return period greater than 100 years is found to more than double under enhanced greenhouse conditions.     

Arsenic anomalies in shallow Venetian Plain (Northeast Italy) groundwater

A pilot area within the Venetian Plain was selected to assess the arsenic (As) contamination of groundwater. The area represents a typical residential, industrial and agricultural organization representative of most western countries, and is also devoid of lithologies with high or anomalous As content. Hydrogeological and chemical data have been collected, the latter spatialized by a geostatistical approach. The unconfined aquifer reservoir varies from a predominantly gravel composition in the north to a sandy and silt–clay composition further south, including peat layers. The hydrochemical features of the waters are rather homogeneous, featuring low mineral content and a Ca-bicarbonate signature. In contrast, the redox state is highly variable; oxidizing conditions are predominant in the northern and coarse parts of the aquifer, whereas reducing potentials prevail in the southern and silt–clay parts. Several well waters contain arsenic in excess of drinkable limits (=10 ppb), and most of these wells are located in the southern area. A large portion of the studied area has a high probability of containing non-potable water (up to 150 ppb As). Remarkably, As “hot spots” (As > 300 ppb, up to 431 ppb) were identified at the transition from gravel to silt–clay sediments. No industrial or agricultural source of As has been found.     

FluBiDi – a model to estimate flood based on runoff: validation using extreme and natural basin conditions

FluBiDi is a two-dimensional model created to simulate real events that can take days and months, as well as short events (minutes or hours) and inclusive laboratory tests. To verify the robustness of FluBiDi, it was tested using a previous study with both designed and real digital elevation models. The results highlight good agreement between the models (i.e. Mike Flood, SOBEK, ISIS 2D, and others) tested and FluBiDi (around 90% for a specific instant and 95% for the complete time simulation). In the simulated hydrographs, the discharge peak value, time to peak, and water level results were accurate, reproducing them with an error of less than 5%. The velocity differences observed in a couple of tests in FluBiDi were associated with very short periods of time (seconds). However, FluBiDi is highly accurate for simulating floods under real topographical conditions with differences of around 2 cm when water depth is around 150 cm. The average water depth and velocities are precise, and the model describes with high accuracy the pattern and extent of floods. FluBiDi has the capability to be adjusted to different types of events and only requires limited input data.     

Sea-level rise impacts on longitudinal salinity for a low-gradient estuarine system

Climatic Change - Salinity response to sea-level rise is evaluated for a low-gradient, tidally active estuary, the lower St. Johns River, Florida. A high-resolution numerical model is forced by...     

Alteration processes in the CV chondrite parent body based on analysis of NWA 2086 meteorite

Analysis of the NWA 2086 CV3 chondrite showed a matrix/chondrule ratio of 52%, similar to Bali, Mokoia, and Grosanaja. Nearly twice as many chondrule fragments as intact ones demonstrate that an early fragmentation phase occurred prior to final accretion. After this event, no substantial mechanical change or redeposition is evident. Rims with double‐layered structures were identified around some chondrules, which, in at least one case, is attributed to an accretionary origin. The rim's outer parts with a diffuse appearance were formed by in situ chemical alteration. During this later process, Mg content decreased, Fe content increased, and olivine composition was homogenized, producing a rim composition close to that of the matrix. This alteration occasionally happened along fractures and at confined locations, and was probably produced by fluid interactions. Iron oxides are the best candidate for a small grain‐sized alteration product; however, technical limitations in the available equipment did not allow exact phase identification. These results suggest that NWA 2086 came from a location (possible more deeply buried) in the CV parent body than Mokoia or Bali, and suffered less impact effects—although there is no evidence of sustained thermal alteration. This meteorite may represent a sample of the CV parent asteroid interior and provide a useful basis for comparison with other CV meteorites in the future.     

The use of acidimetric titration as a novel approach to study particulate trace metal speciation and mobility: Application to sediments of the Scheldt estuary

The study of trace metal speciation has benefited from a great deal of interest leading to the development and the diversification of sequential extraction schemes (SES), which triggered the need for harmonization by the standard, measurements and testing programme (SM & T). However, some uncertainties still persist in the application of the harmonized 3-step protocol, because of the difficulty in conceptualizing a technique that can be applied to environmental samples irrespective of their nature. The alternative method proposed in this study is based on the solubility of the sample components progressively dissolved during the course of an acidimetric titration by 1 mol L⁻¹ HCl. The major HCl-reactive mineralogical components are identified using mass balance calculation of H⁺ consumed by their dissolution together with the amount of major elements released into solution. The speciation of minor and trace elements is investigated by comparing their titrations to those of the major elements. This approach is much simpler than SES because it uses simple non-selective H⁺ at room temperature instead of a complex experimental design of so-called specific reagents. The different mineral components of the solid are no longer operationally defined and the problem of selectivity is irrelevant to the titration approach. The method was applied to several sediment samples from the Scheldt estuary and the particulate phase was further examined by Scanning Electron Microprobe and X-ray Diffraction techniques. The nearly complete consumption of H⁺ in the suspension is balanced by the total dissolution of carbonates and Fe-oxyhydroxides. In contrast to the speciation inferred from the Tessier SES, the acidimetric titration has demonstrated that the carbonate phase does not significantly contain trace metals with the exceptions of 40% of the Mn and 30% of the Co. In contrast, the Fe-oxyhydroxides seem to play a major role and account for 70% of Pb and 20% of Cr, in addition to 60% of P and additional amounts of 20% Co and 40% Mn. 70% of the Cu also occur in the oxyhydroxide phase, more likely coprecipitated with gibbsite. 90% of the Cd and 85% of Zn can be attributed to the Acid Volatile Sulfide (AVS) phase as evidenced from S titration. The acidimetric titration method not only provides information on the speciation of trace metals but also allows the quantification of their reactivity and mobility, if one considers that the titration roughly mimics pH changes that may occur as a result of chemical disequilibrium in the environment. The results demonstrate the potential of the acidimetric titration as an alternative to SES protocols in geochemical and environmental regulation studies. This method is applicable to a wide variety of environmental materials with little or minor adjustments.