Seismotectonic significance of the 29 January 1989 Etne earthquake, SW Norway

The integrated analysis of geological, seismological and field observations with lineament data derived from satellite images allows the identification of a possible seismogenic fault zone for an earthquake which occurred near Etne in southwestern Norway, on 29 February 1989. The hypocentre of the earthquake was located at the mid-crust at a depth of 13.8±0.9 km which is typical of small intraplate earthquakes. The Etne earthquake occurred as a result of normal faulting with a dextral strike-slip component on a NW–SE trending fault. Available geological and lineament data indicate correlation of the inferred seismogenic fault with the NW–SE trending Etne fault zone. An aeromagnetic anomaly related to the Etne fault zone forms a regional feature intersecting both Precambrian basement and allochthonous Caledonian rocks. Based on these associations the occurrence of the Etne event is ascribed to the reactivation of a zone of weakness along the Etne fault zone. Slope-instabilities developed in the superficial deposits during the Etne event demonstrate the existence of potentially hazardous secondary-effects of such earthquakes even in low seismicity areas such as southwestern Norway.     

Optimization of grid-drilling using computer simulation

A computer simulation method has been developed to find efficient drilling grids for mineral deposits. A well-known ore deposit is used as a model to develop an efficient pattern for undiscovered ore bodies in the same area or in other prospects where similar geometry is suspected. The model for this study is the Austinville, Virginia deposit, a Mississippi Valley-type deposit composed of 17 ore bodies totaling 34 million short tons (30 million metric tons). The method employs a computer program that simulates drilling the model deposit with different patterns, including various levels of follow-up drilling. Follow-up holes are drilled in fences at one half the original spacing around holes in the grid that show ore-grade mineralization. Each pattern is drilled 100 times from random starting locations to provide a range of outcomes of drilling, including the best, worst, and most likely. For this study, patterns of 100 drill holes were composed of 10 fences spaced 1000–5000 feet (305–1524 m) apart, each with 10 holes spaced 200–1000 feet (61–305 m) apart. In all, 25 grids were used with zero to three levels of follow-up drilling. The 600/2000 grid, with drill holes spaced 600 feet (183 m) apart in fences spaced 2000 feet (610 m) apart, was compared with the 200/5000 grid because they represented contrasting outcomes. The 600/2000 grid penetrated many ore bodies consistently but with few multiple hits to individual ore bodies; whereas the 200/5000 grid inconsistently penetrated few ore bodies with many multiple hits. The 600/2000 grid was more efficient than the 200/5000 grid at hitting large ore bodies of 1,000,000 short tons or greater (900,000 metric tons or greater) and was made more effective by adding one cycle of follow-up drilling. The 600/2000 grid had a 97% chance of hitting one or more large ore bodies with at least one drill hole per ore body, and the 200/5000 grid had a 64% chance. Once hit, there was an 82% chance that the largest ore body would be penetrated by three or more holes when using the 600/2000 grid and an 88% chance using the 200/5000 grid.     

Thaw modification of frost-fissure wedges,Richards Island,Pleistocene Mackenzie Delta,Western Arctic Canada

Thaw modification is the general process whereby frost-fissure wedges are modified during thaw, and by which frost-fissure pseudomorphs may develop. Specific processes of thaw modification are inferred from ice-wedge pseudomorphs, composite-wedge pseudomorphs and deformed sand wedges in the Pleistocene Mackenzie Delta: i.e. thermal erosion, collapse, subsidence, refreezing, loading, buoyancy, spreading, folding and shearing. Thaw modification is believed to result in selective preservation of pseudomorphs and wedges. Sand wedges are more likely to be preserved than are ice-wedge pseudomorphs or compositewedge pseudomorphs, because only those sand wedges that penetrate massive ice or icy sediments are prone to thaw modification. Furthermore, whereas ice wedges preferentially develop in ice-rich, fine-grained sediments (thaw-sensitive), their pseudomorphs appear to be selectively preserved in ice-poor, coarse-grained sediments (thaw-stable).     

Recharge and salinization in the Madrid Basin

The purpose of this work was to reinvestigate the existing hydrogeological conceptual model of the basin of Madrid, Spain. A cumulative chemical isotopic diagram which enabled the distinction between different groups of water as well as calculation of the mode of their blending was used for this investigation. It was found that the groups of discharge were lighter in their isotopic composition than that of recharge. The previous explanation of this fact, backed by carbon-14 dating, was the long residence time due to flow lines going down to depths of more than 1000 m. This flow model assumes homogenous conditions to these depths. This assumption can not be supported by evidence from deep wells. Thus a modified model is suggested which maintains homogenous conditions only to about 300 m and a deep confined aquifer below containing paleowater. The higher degree of depletion of this water has been explained by a colder climate on top of an altitude effect. Another interesting observation was the correlation between the isotopic composition of the rains, the month of the rain event and the composition of the recharge group groundwater. It could be seen that the winter rains resemble the groundwater composition, which shows that practically all the spring and summer rains were evapotranspirated.     

THE EUROPEAN MACROSEISMIC SCALE (MSK-92)

A new updated version of the MSK macroseismic intensity scale has been prepared by a Working Group of the European Seismological Commission and has been published in April 1993 (European Macroseismic Scale 1992: updated MSK scale, 1993, ed. by G. Grünthal, Cahiers du Centre Européen de Geodynamique et de Séismologie, no. 7).     

Impact of sea level rise on aquifer system of Agatti Atoll

The freshwater aquifer of Agatti Island varies from a depth of 6 m to 27 m from mean sea level. A 50-cm sea level rise may cause 26.69 percent freshwater contamination due to salt water intrusion.     

The stable isotope signature of kilometre-scale fracturedominated metamorphic fluid pathways, Mary Kathleen, Australia

Abstract Large calcite veins and pods in the Proterozoic Corella Formation of the Mount Isa Inlier provide evidence for kilometre-scale fluid transport during amphibolite facies metamorphism. These 10- to 100-m-scale podiform veins and their surrounding alteration zones have similar oxygen and carbon isotopic ratios throughout the 200 × 10-km Mary Kathleen Fold Belt, despite the isotopic heterogeneity of the surrounding wallrocks. The fluids that formed the pods and veins were not in isotopic equilibrium with the immediately adjacent rocks. The pods have δ¹³C_calcite values of –2 to –7% and δ¹⁸O_calcite values of 10.5 to 12.5%. Away from the pods, metadolerite wallrocks have δ¹⁸O_whole-rock values of 3.5 to 7%. and unaltered banded calc-silicate and marble wallrocks have δ¹³C_calcite of –1.6 to –0.6%, and δ¹⁸O_calcite of 18 to 21%. In the alteration zones adjacent to the pods, the δ¹⁸O values of both metadolerite and calc-silicate rocks approach those of the pods. Large calcite pods hosted entirely in calc-silicates show little difference in isotopic composition from pods hosted entirely in metadolerite. Thus, 100- to 500-m-scale isotopic exchange with the surrounding metadolerites and calc-silicates does not explain the observation that the δ¹⁸O values of the pods are intermediate between these two rock types. Pods hosted in felsic metavolcanics and metasiltstones are also isotopically indistinguishable from those hosted in the dominant metadolerites and calc-silicates. These data suggest the veins are the product of infiltration of isotopically homogeneous fluids that were not derived from within the Corella Formation at the presently exposed crustal level, although some of the spread in the data may be due to a relatively small contribution from devolatilization reactions in the calc-silicates, or thermal fluctuations attending deformation and metamorphism. The overall L-shaped trend of the data on plots of δ¹³C vs. δ¹⁸O is most consistent with mixing of large volumes of externally derived fluids with small volumes of locally derived fluid produced by devolatilization of calc-silicate rocks. Localization of the vein systems in dilatant sites around metadolerite/calc-silicate boundaries indicates a strong structural control on fluid flow, and the stable isotope data suggest fluid migration must have occurred at scales greater than at least 1 km. The ultimate source for the external fluid is uncertain, but is probably fluid released from crystallizing melts derived from the lower crust or upper mantle. Intrusion of magmas below the exposed crustal level would also explain the high geothermal gradient calculated for the regional metamorphism.