Impact of Reservoir Permeability,Permeability Anisotropy and Designed Injection Rate on CO2 Gas Behavior in the Shallow Saline Aquifer at the CaMI Field Research Station,Brooks, Alberta

Natural Resources Research - Carbon capture and storage is part of Canada’s climate change action plan to reduce greenhouse gas emissions. The Containment and Monitoring Institute Field...     

The use of optimization to construct critical accelerograms for given structures and sites

In this paper a methodology has been presented for constructing the most critical accelerogram from among a be class of candidate accelerograms for a given site and structure. This most critical accelerogram could be used to assess seismic resistance of a structure with a high level of confidence. Specifically, the method superimposes accelerograms recorded at similar sites to create the candidate accelerograms, then uses optimization and approximation techniques find the most critical accelerogram. The most critical accelerogram is defined as the one which maximizes damage is structure, as computed by non-linear dynamic structural analysis, as well as satisfies constraints on ground parameters to ensure credibility. The damage has been defined as cumulative inelastic energy dissipation or sure of interstorey drifts. The method is applied to ten examples in the paper.     

Acid mine drainage contaminates groundwater of a Tennessee watershed

Water samples were collected from 18 natural springs within the West Fork of the Obey River watershed. Overton County, Tennessee, to determine if groundwater was adversely affected by runoff from abandoned surface coal mines Six springs were found to be affected severely and deemed unfit as a source of potable water Water quality of the remaining springs was essentially unaffected it appeared that proximity to surface mines, elevation at the outflow, and geology of the surrounding strata determined the quality of the groundwater The unit is jointly supported by Tennessee Technological University, the Tennessee Wildlife Resource Agency, and the US. Fish and Wildlife Service     

Thermal Impact of Residential Ground-Water Heat Pumps

A computer simulation study was conducted to quantify the potential thermal impact of residential water-source heat pump usage on ground-water aquifers. In a first phase of the study, weather data for nine locations throughout the country were used to estimate the energy requirements for heating and air conditioning a typical residence. These energy requirements were then translated into the volumetric water demands for a selected heat pump at each location. A representative model aquifer was then defined and its characteristics used, along with the heat pump water requirements and design ΔT's (difference between inlet and outlet water temperature) to identify the important parameters that contribute to heat transfer and to model the movement of the thermal front resulting from injection of heat pump discharge water at the nine locations. The major factor that determines the heat pump thermal impact was found to be the net amount of heat injected into, or removed from an aquifer. Other significant factors included well design, heat pump design ΔT, and physical properties of the aquifer such as thickness, porosity and dispersivity. The study showed that, in climates where winter heating demand is very nearly equal to summer cooling demands, the injection of heat pump discharge water did not cause any significant modification of the ambient model aquifer temperature. However, in hot or cold climates where air conditioning or heating demand dominates, measurable thermal changes occurred in the model aquifer. In most cases, the maximum temperature     

A Syringe and Cartridge Method for Down-Hole Sampling for Trace Organics in Ground Water

A newly developed technique which allows the down-hole sampling and subsequent analysis of ground water for trace organic contaminants was tested during an investigation of contaminant migration at an inactive landfill site in Burlington, Ontario, Canada. The sampling device, which is lowered down piezometers with a tube, consists of a small cylindrical cartridge of sorbent material attached to a syringe. Vacuum or pressure applied at the surface controls the movement of the plunger in the syringe. The volume of the syringe determines the volume of sample water that passes through the cartridge. The cartridge is removed from the syringe at the surface. One cartridge is used for each sampling; the syringe is reusable. The residual water in the cartridge is removed in the laboratory, and the cartridge is desorbed to a fused silica capillary column for analysis by gas chromatography (GC). The analyses discussed here were performed on a GC/mass spectrometer/data system (GC/MS/DS). Of the many organic compounds that were identified in the samples, three compounds were clearly landfill-related: 1,1,1-trichloroethane, chlorobenzene, and para-dichlorobenzene. The three compounds were found at levels substantially above blank levels in 9, 5, and 5 piezometers, respectively. The average concentrations were 14., 5.3, and 0.88μg/1 (ppb), respectively. The pooled coefficients of variation for the analyses for the three compounds were 27., 6.9, and 6.4%, respectively. The volatility of 1,1,1-trichloroethane was probably the cause of the greater variability in its analytical data. The main advantages of the technique over most conventional sampling methods include: (1) down-hole sampling in a manner which minimizes the potential for volatilization losses; (2) avoidance of passage of the sample through long sections of tubing that may contaminate the sample or cause adsorptive losses; (3) convenience of sample handling, storage, and shipping; and (4) high sensitivity.     

Anisotropic models of the upper mantle

Long period Rayleigh wave and Love wave dispersion data, particularly for oceanic areas, have not been simultaneously satisfied by an isotropic structure. In this paper available phase and group velocity data are inverted by a procedure which includes the effects of transverse anisotropy, anelastic dispersion, sphericity, and gravity. We assume that the surface wave data represents an azimuthal average of actual velocities. Thus, we can treat the mantle as transversely isotropic. The resulting models for average Earth, average ocean, and oceanic regions divided according to the age of the ocean floor, are quite different from previous results which ignore the above effects. The models show a low-velocity zone with age dependent anisotropy and velocities higher than derived in previous surface wave studies. The correspondence between the anisotropy variation with age and a physical model based on flow aligned olivine is suggestive. For most of the Earth SH > SV in the vicinity of the low-velocity zone. Neat the East Pacific Rise, however, SV > SH at depth, consistent with ascending flow. Anisotropy is as important as temperature in causing radial and lateral variations in velocity. The models have a high velocity nearly isotropic layer at the top of the mantle that thickens with age. This layer defines the LID, or seismic lithosphere. In the Pacific, the LID thickens with age to a maximum thickness of ～50 km. This thickness is comparable to the thickness of the elastic lithosphere. The LID thickness is thinner than derived using isotropic or pseudo-isotropic procedures. A new model for average Earth is obtained which includes a thin LID. This model extends the fit of a PREM, type model to shorter period surface waves.     

Sources of magnetic susceptibility in a slate

Magnetic susceptibility and its anisotropy in the Borrowdale Volcanic slates at Kentmere in the English Lake District are attributed largely to preferred orientation of a paramagnetic chlorite of diabantite-ripidolite composition. In units of 10⁻⁶ cgs/g, the principal susceptibilities for the slates are 9.61; 9.42; 8.69 and for the chlorite grains the minimum anisotropy is represented by principal susceptibilities of 11.57; 11.22 and 9.15. Because the magnetic susceptibility is carried by a tightly packed, matrix-forming mineral that has recrystallised during the deformation it is not possible to imagine simple grain rotation as being responsible for the anisotropy of susceptibility.     

Evidence for Enhanced Mineral Dissolution in Organic Acid-Rich Shallow Ground Water

Total concentrations of formate, acetate, and isobutyrate varied from less than 5 to greater than 9,000 μmol/l over distances of < 3 m in ground water from a shallow hydrocarbon contaminated aquifer. Laboratory incubations of aquifer material indicate that organic acid concentrations were dependent on the amount of hydrocarbon loading in the sediment and the relative rates of microbial organic acid production and consumption. In heavily contaminated sediments, production greatly exceeded consumption and organic acid concentrations increased. In lightly contaminated sediments rates were essentially equal and organic acid concentrations remained low. Concentrations of dissolved calcium, magnesium, and iron generally were one to two orders of magnitude higher in organic acid-rich ground water than in ground water having low organic acid concentrations. Carbonate and Fe(III)-oxyhydroxide minerals were the likely sources of these elements. Similarly, concentrations of dissolved silica, derived from quartz and k-feldspar, were higher in organic acid-rich ground water than in other waters. The positive relation (r = 0.60, p < .05, n = 16) between concentrations of silica and organic acids suggests that the microbially mediated buildup of organic acids in ground water enhanced quartz/k-feldspar dissolution in the aquifer, although it was not the only factor influencing their dissolution. A model that included organic acid microequivalents normalized by cation microequivalents significantly strengthened the correlation (r = 0.79, p < .001, n = 16) between dissolved silica and organic acid concentrations, indicating that competition between silica and cations for complexation sites on organic acids also influenced quartz/k-feldspar dissolution. Physical evidence for enhanced mineral dissolution in organic acid-rich waters included scanning electron microscopy images of highly corroded quartz and k-feldspar grains from portions of the aquifer containing organic acid-rich ground water. Microporosity generated in hydrocarbon contaminated sediments may adversely affect remediation efforts that depend on the efficient injection of electron acceptors into an aquifer or on the recovery of solutes from an aquifer.     

Archean inheritance in zircon from late Paleozoic granites from the Avalon zone of southeastern New England: an African connection

In southeastern New England the Narragansett Pier Granite locally intrudes Carboniferous metasedimentary rocks of the Narragansett basin, and yields a monazite UPb Permian emplacement age of 273 ± 2Ma. Zircon from the Narragansett Pier Granite contains a minor but detectable amount of an older, inherited component, and shows modern loss of lead. Zircon from the late-stage, aplitic Westerly Granite exhibits a more pronounced lead inheritance —permitting the inherited component to be identified as Late Archean. Such old relict zircon has not been previously recognized in Proterozoic to Paleozoic igneous rocks in New England, and may be restricted to late Paleozoic rocks of the Avalon zone. We suggest that the Archean crustal component reflects an African connection, in which old Archean crust was underplated to the Avalon zone microplate in the late Paleozoic during collision of Gondwanaland with Avalonia.