Hard X-ray and radio emission at the onset of great solar flares

A study of the onset phase often great hard X-ray bursts is presented. It is shown from hard X-ray and radio observations in different wavelength ranges that the energization of the electrons proceeds on a global time-scale of some tens of seconds. In nine of the bursts two phases of emission can be distinguished during the onset phase: the pre-flash phase, during which emission up to an energy limit ranging from some tens of keV to 200 keV is observed, followed ten to some tens of seconds later by the flash phase, where the count rate in all detector channels rises simultaneously to within some seconds. For two of the events strong -ray line emission is observed and is shown to start close to the onset of the flash phase.Proceedings of the Second CESRA Workshop on Particle Acceleration and Trapping in Solar Flares, held at Aubigny-sur-Nère (France), 23–26 June, 1986.     

Great Microwave Bursts and hard X-rays from solar flares

The microwave and hard X-ray characteristics of 13 solar flares that produced microwave fluxes greater than 500 solar flux units have been analyzed. These Great Microwave Bursts were observed in the frequency range from 3 to 35 GHz at Bern, and simultaneous hard X-ray observations were made in the energy range from 30 to 500 keV with the Hard X-Ray Burst Spectrometer on the Solar Maximum Mission spacecraft. The principal aim of this analysis is to determine whether or not the same distribution of energetic electrons can explain both emissions. The temporal and spectral behaviors of the microwaves as a function of frequency and the X-rays as a function of energy were tested for correlations, with results suggesting that optically thick microwave emission, at a frequency near the peak frequency, originates in the same electron population that produces the hard X-rays. The microwave emission at lower frequencies, however, is poorly correlated with emission at the frequency which appears to characterize this common source. A single-temperature and a multitemperature model were tested for consistency with the coincident X-ray and microwave spectra at microwave burst maximum. Four events are inconsistent with both of the models tested, and neither of the models attempts to explain the high-frequency part of the microwave spectrum. A source area derived on the basis of the single-temperature model agrees to within the uncertainties with the observed area of the one burst for which spatially resolved X-ray images are available.Swiss National Science Foundation Fellow from the University of Bern.Also Energy/Environmental Research Group, Incorporated, Tucson, Arizona, and Department of Physics and Astronomy, University of North Carolina, Chapel Hill. Present address: Johns Hopkins University Applied Physics Laboratory, Laurel, Maryland.     

Inner-shell photoionization of O iii

A 25-state R -matrix calculation is performed to obtain photoionization cross-sections for transitions from the 1s²2s²2p²³P ground state of the O  iii ion. Results are obtained for a range of photon energies, including those at which K-shell photoionization processes take place. We compare our results with those from previous calculations. Excellent agreement is obtained. We also consider resonances owing to transitions of a 1s electron excited into the 2p orbital and compare with a recent calculation.     

Estimation of undiscovered deposits in quantitative mineral resource assessments—examples from Venezuela and Puerto Rico

Quantitative mineral resource assessments used by the United States Geological Survey are based on deposit models. These assessments consist of three parts: (1) selecting appropriate deposit models and delineating on maps areas permissive for each type of deposit; (2) constructing a grade-tonnage model for each deposit model; and (3) estimating the number of undiscovered deposits of each type. In this article, I focus on the estimation of undiscovered deposits using two methods: the deposit density method and the target counting method.In the deposit density method, estimates are made by analogy with well-explored areas that are geologically similar to the study area and that contain a known density of deposits per unit area. The deposit density method is useful for regions where there is little or no data. This method was used to estimate undiscovered low-sulfide gold-quartz vein deposits in Venezuela.Estimates can also be made by counting targets such as mineral occurrences, geophysical or geochemical anomalies, or exploration plays and by assigning to each target a probability that it represents an undiscovered deposit that is a member of the grade-tonnage distribution. This method is useful in areas where detailed geological, geophysical, geochemical, and mineral occurrence data exist. Using this method, porphyry copper-gold deposits were estimated in Puerto Rico.     

Quantifying the effects of plant litter in the topsoil on the soil detachment process by overland flow in typical grasslands of the Loess Plateau,China

Plant litter can be incorporated into topsoil by a natural process, affecting the soil erosion process. This is a widespread phenomenon in erosion-prone areas. This study was conducted to investigate the effect of litter incorporation on the process of soil detachment on the Loess Plateau, China. Four common plant litters (Bothriochloa ischaemum L. Keng., Artemisia sacrorum Ledeb., Setaria viridis L. Beauv., and Artemisia capillaris Thunb.) were collected, then incorporated into the silt loam soil at five rates (0.1, 0.4, 0.7, 1.0, and 1.3 kg m⁻²) on the basis of our field investigation. Twenty litter–soil treatments and one bare soil control were prepared. After 50 days of natural stabilization, 30 soil samples of each treatment were collected. We used a flume test to scour the soil samples under six flow shear stress conditions (5.66, 8.31, 12.21, 15.55, 19.15, and 22.11 Pa). The results showed that the different incorporated litter masses and morphological characteristics, such as litter tissue density (ranging from 0.52 to 0.68 g cm⁻³), length density (2.34 to 91.00 km m⁻³), surface area density (LSAD; 27.9 to 674.2 m² m⁻³), and volume ratio (0.003 to 0.050 m³ m⁻³), caused varied soil detachment capacities (0.043 to 4.580 kg·m⁻²·s⁻¹), rill erodibilities (0.051 to 0.237 s m⁻¹), and critical shear stresses (2.02 to 6.83 Pa). The plant litter incorporated within the soil reduced the soil detachment capacities by 38%–59%, lowered the rill erodibilities by 32%–46%, and increased the critical shear stresses by 98%–193% compared with the bare soil control. The soil containing B. ischaemum (L.) Keng. litter was more resistant to erosion. By comparing different parameters, we found that the contact area between the litter and soil was the main factor affecting the soil detachment process. The soil erosion resistance increased with the increasing contact area between the soil and litter. Furthermore, the litter incorporation effect on rill erodibility can be comprehensively reflected by LSAD (R² = .93; Nash–Sutcliffe efficiency = 0.79), which could be used to adjust the rill erodibility parameter in physical process-based soil erosion models.     

A spatially distributed model for assessment of the effects of changing land use and climate on urban stream quality

While the effects of land use change in urban areas have been widely examined, the combined effects of climate and land use change on the quality of urban and urbanizing streams have received much less attention. We describe a modelling framework that is applicable to the evaluation of potential changes in urban water quality and associated hydrologic changes in response to ongoing climate and landscape alteration. The grid‐based spatially distributed model, Distributed Hydrology Soil Vegetation Model‐Water Quality (DHSVM‐WQ), is an outgrowth of DHSVM that incorporates modules for assessing hydrology and water quality in urbanized watersheds at a high‐spatial and high‐temporal resolution. DHSVM‐WQ simulates surface run‐off quality and in‐stream processes that control the transport of non‐point source pollutants into urban streams. We configure DHSVM‐WQ for three partially urbanized catchments in the Puget Sound region to evaluate the water quality responses to current conditions and projected changes in climate and/or land use over the next century. Here, we focus on total suspended solids (TSS) and total phosphorus (TP) from non‐point sources (run‐off), as well as stream temperature. The projection of future land use is characterized by a combination of densification in existing urban or partially urban areas and expansion of the urban footprint. The climate change scenarios consist of individual and concurrent changes in temperature and precipitation. Future precipitation is projected to increase in winter and decrease in summer, while future temperature is projected to increase throughout the year. Our results show that urbanization has a much greater effect than climate change on both the magnitude and seasonal variability of streamflow, TSS and TP loads largely because of substantially increased streamflow and particularly winter flow peaks. Water temperature is more sensitive to climate warming scenarios than to urbanization and precipitation changes. Future urbanization and climate change together are predicted to significantly increase annual mean streamflow (up to 55%), water temperature (up to 1.9 °C), TSS load (up to 182%) and TP load (up to 74%). Copyright © 2016 John Wiley & Sons, Ltd.     

Spatial discretization of large watersheds and its influence on the estimation of hillslope sediment yield

The combined use of water erosion models and geographic information systems has facilitated soil loss estimation at the watershed scale. Tools such as the Geo‐spatial interface for the Water Erosion Prediction Project (GeoWEPP) model provide a convenient spatially distributed soil loss estimate but require discretization to identify hillslopes and channels. In GeoWEPP, the TOpographic PArameteriZation (TOPAZ) model is used as an automated procedure to extract a watershed boundary, hillslopes and channels from a digital elevation model (DEM). Previous studies in small watersheds have shown that the size of the hillslopes and the channel distribution affect the model estimates, but in large watersheds, the effects on the soil loss estimates have yet to be tested. Therefore, the objective of this study was to evaluate the effect of discretization on the hillslope sediment yield estimates using GeoWEPP in two large watersheds (>10 km²). The watersheds were selected and discretized varying the TOPAZ parameters [critical source area (CSA) and minimum source channel length (MSCL)] in a 30‐m resolution digital elevation model. The drainage networks built with TOPAZ were compared with each other using the drainage density index. The results showed that the discretization affected hillslope sediment yield estimates and their spatial distribution more than the total runoff. The drainage density index and the hillslope sediment yield were proportional but inversely related; thus, soil loss estimates were highly affected by the spatial discretization. As a result of this analysis, a method to choose the CSA and MSCL values that generates the greatest fraction of hillslopes having profile lengths less than 200 m was developed. This slope length condition is particularly crucial when using the WEPP and GeoWEPP models, in order for them to produce realistic estimates of sheet and rill erosion. Finally, and as a result of this analysis, a more reliable method was developed for selecting the TOPAZ channel network parameters (CSA and MSCL). Copyright © 2015 John Wiley & Sons, Ltd.     

Solar flare hard X-ray observations

Recent hard X-ray observations of solar flares are reviewed with emphasis on results obtained with instruments on the Solar Maximum Mission satellite. Flares with three different sets of characteristics, designated as Type A, Type B, and Type C, are discussed and hard X-ray temporal, spatial, spectral, and polarization measurements are reviewed in this framework. Coincident observations are reviewed at other wavelengths including the UV, microwaves, and soft X-rays, with discussions of their interpretations. In conclusion, a brief outline is presented of the potential of future hard X-ray observations with sub-second time resolution, arcsecond spatial resolution, and keV energy resolution, and polarization measurements at the few percent level up to 100 keV.     

Utility of scaled chrysophytes for inferring lakewater pH in northern New England lakes

Scaled chrysophytes in the surface sediments of 58 soft-water northern New England lakes were analyzed to assess their usefulness for inferring pH. The distributions of many taxa are correlated with lakewater pH and associated variables. Canonical correspondence analysis (CCA) and clustering grouped chrysophyte taxa according to their distributions along the pH gradient. For example, Chrysodidymus synuroideus, Mallomonas hindonii, and M. hamata commonly occur in acidic waters (pH<5.5), whereas M. caudata and M. pseudocoronata are common in circumneutral to alkaline waters. Of the five predictive models developed to infer pH, CCA based calibration had the lowest standard error (0.35 pH units). A CCA based predictive model was also developed to infer total alkalinity. The study provides strong evidence that, in the absence of past measured pH data, stratigraphic studies of sedimentary chrysophyte scales will provide accurate reconstructions of pH in northern New England lakes.This is the sixth of a series of papers to be published by this journal which is a contribution of the Paleoecological Investigation of Recent Lake Acidification (PIRLA) project. Drs. D.F. Charles and D.R. Whitehead are guest editors for this series.