Urban seismic stations: soil–structure interaction assessment by spectral ratio analyses

In this work we present and discuss the results of ambient seismic noise analyses computed at four sites where seismic stations, managed by the INGV (Italian Institute for Geophysics and Vulcanology) and the DPC (Italian Department of Civil Protection), are installed inside buildings. The experiments were performed considering different types of installation: sensor located at the bottom of a school, directly installed on rock (case 1); sensor located at the bottom of a medieval fortress, built on an isolate hill, directly installed on rock (case 2); sensor installed on the foundations of a medieval fortress, built on an isolate hill (case 3); sensor installed on the foundations of a school, built on alluvial deposits (case 4). Since recent works proposed the use of spectral ratio techniques to study the dynamic characterization of buildings, ambient seismic-noise measurements were performed for each site close to the stations (at the base of the structures), at the top of the structures and outside the buildings. In order to check the source of vibrations both horizontal to vertical spectral ratio (HVNR) and standard spectral ratio (SSR) techniques were applied. For all stations the results from ambient seismic noise were compared to those obtained from earthquakes (HVSR). In order to detect preferential directions of amplification, for each site average HVNRs and HVSRs were computed considering one azimuth for each set of 5°. We obtain different results for different types of installation: in cases 1 and 2, where the sensors are directly installed on rock, the vibrations of the structure do not affect the noise measures performed close to the stations, which show flat HVNR in the whole frequency range: in both cases the eigenfrequency of the building is given by the HVNR calculated from the measures performed at the top of the structure. In cases 3 and 4, where the sensors are installed on the foundations of the considered structures, both the amplification peaks between 5 and 9 Hz (case 3) and between 5.5 and 7 Hz (case 4) include the contribution of the free oscillations of the buildings. In particular, in case 4, HVNRs performed outside building highlight possible soil–structure resonance effects in case of an earthquake.     

Study of a high SO2 event observed over an urban site in western India

Continuous measurements of SO₂, NO_x and O₃ along with sampling based measurements of CO, CH₄, NMHCs and CO₂ were carried out during May, 2010 at Ahmedabad. The diurnal variations of SO₂ in ambient air exhibited elevated values during the night and lower levels during the sunlit hours. The mean concentration of SO₂ during the study period was 0.95 ± 0.88 ppbv. However, the ambient SO₂ exceeded 17 ppbv in the night of 20 May, 2010. On the same day, tropospheric columnar SO₂ from OMI showed almost 350% increase corroborating the surface observations over an extended height regime. This was also the highest columnar value of SO₂ during the summer of 2010. Columnar loadings were also found to be high for formaldehyde, precipitable water vapor and aerosol optical depth on 20 May. Elevated concentrations were also recorded for other trace gases like NO₂ and O₃. Analysis of related data of trace gases indicated characteristics of fresh emissions with dominant contributions from mobile sources during the study period. However, SO₂/NO₂ ratio of 0.36 during the event period on 20th May connotes non-local influences. Analyses of meteorological parameters suggest combined impacts of transport and inversion causing higher levels of SO₂ and other pollutants during 20?C21 May. Episodes of such enhancements may perturb chemical and radiative balance of the atmosphere.     

Acid mine drainage at Cerro Rico de Potosí I: unabated high-strength discharges reflect a five century legacy of mining

Intensive mining and processing of Ag, Sn, Pb and Zn ores have occurred in various locations within and around the city of Potosí, Bolivia since 1545. Surface and subsurface waters, stream sediments and soils are contaminated with various ecotoxic metals in the headwaters of the economically vital, yet highly impacted, upper Rio Pilcomayo watershed. Previous studies have documented downstream trace metal contamination, however, not addressed specific sources. The AMD discharges identified in this study help link downstream pollution to primary origins. The majority of AMD would be considered high-strength due to metal concentrations and acidity orders of magnitude greater than typical AMD. Discharges from both operating and abandoned portals as well as tailings-related deposits displayed a high degree of heterogeneity with total metal concentrations ranging from 0.11 to 7480, <0.022 to 889, <0.0006 to 65.3, <0.001 to 310, 0.12 to 72,100, 0.3 to 402, <0.012 to 34.8, and 0.24 to 19,600 mg/L of Al, As, Cd, Cu, Fe, Mn, Pb and Zn, respectively. Net acidity and pH ranged from −10 to 246,000 mg/L as CaCO₃ equivalent and 0.90–6.94 standard units, respectively. Data were gathered during two sampling events centered around the most extreme periods of the dry and wet seasons of one water-year. Loadings to local streams were marginally greater for most metals in the wet season. If observed loadings are historically representative, Cerro Rico AMD has contributed thousands of tonnes of ecotoxic metals to the upper Rio Pilcomayo over the last five centuries. Metal and hydrogen ion concentrations in the majority of AMD sampled were several orders of magnitude above discharge limits set by the Bolivian government, yet no action has historically or contemporarily been taken.     

Distribution of Indus born mica along Gulf of Kachchh coast: Implications in understanding current dynamics

Indus is one of the major sources of sediments to the Gulf of Kachchh. Yet only its <63 micron fraction is studied in detail with regards to the offshore current dynamics. Hence here we present our study on characteristic signature of the Indus sediment load (i.e. mica minerals) in >63 micron size fraction along the coast of Gulf of Kachchh. The spatial distribution of mica minerals along the Gulf of Kachchh coast was studied which showed in general decreasing trend as we move along the northern and southern coast of the Gulf of Kachchh but, an increase in amount near the southern mouth at Okha. The study shows that the earlier proposed tidal barrier is ineffective in restricting movement of mica across the mouth of the gulf due to its characteristic transport mechanism. Also the presence of mudflats along the gulf of Kachchh coast plays a vital role as sediment receptors in the active sediment transport processes and mica minerals prove to be a promising simple tracer in studying the Indus born sediments in the region.     

Diffusive equilibrium in thin films provides evidence of suppression of hyporheic exchange and large‐scale nitrate transformation in a groundwater‐fed river

The hyporheic zone of riverbed sediments has the potential to attenuate nitrate from upwelling, polluted groundwater. However, the coarse‐scale (5–10 cm) measurement of nitrogen biogeochemistry in the hyporheic zone can often mask fine‐scale (<1 cm) biogeochemical patterns, especially in near‐surface sediments, leading to incomplete or inaccurate representation of the capacity of the hyporheic zone to transform upwelling NO₃^?. In this study, we utilised diffusive equilibrium in thin‐films samplers to capture high resolution (cm‐scale) vertical concentration profiles of NO₃^?, SO₄^2?, Fe and Mn in the upper 15 cm of armoured and permeable riverbed sediments. The goal was to test whether nitrate attenuation was occurring in a sub‐reach characterised by strong vertical (upwelling) water fluxes. The vertical concentration profiles obtained from diffusive equilibrium in thin‐films samplers indicate considerable cm‐scale variability in NO₃^? (4.4 ± 2.9 mg N/L), SO₄^2? (9.9 ± 3.1 mg/l) and dissolved Fe (1.6 ± 2.1 mg/l) and Mn (0.2 ± 0.2 mg/l). However, the overall trend suggests the absence of substantial net chemical transformations and surface‐subsurface water mixing in the shallow sediments of our sub‐reach under baseflow conditions. The significance of this is that upwelling NO₃^?‐rich groundwater does not appear to be attenuated in the riverbed sediments at <15 cm depth as might occur where hyporheic exchange flows deliver organic matter to the sediments for metabolic processes. It would appear that the chemical patterns observed in the shallow sediments of our sub‐reach are not controlled exclusively by redox processes and/or hyporheic exchange flows. Deeper‐seated groundwater fluxes and hydro‐stratigraphy may be additional important drivers of chemical patterns in the shallow sediments of our study sub‐reach. © 2015 The Authors. Hydrological Processes Published by John Wiley & Sons Ltd.     

Computing the Sensitivity Kernels for 2.5-D Seismic Waveform Inversion in Heterogeneous,Anisotropic Media

2.5-D modeling and inversion techniques are much closer to reality than the simple and traditional 2-D seismic wave modeling and inversion. The sensitivity kernels required in full waveform seismic tomographic inversion are the Fréchet derivatives of the displacement vector with respect to the independent anisotropic model parameters of the subsurface. They give the sensitivity of the seismograms to changes in the model parameters. This paper applies two methods, called ‘the perturbation method’ and ‘the matrix method’, to derive the sensitivity kernels for 2.5-D seismic waveform inversion. We show that the two methods yield the same explicit expressions for the Fréchet derivatives using a constant-block model parameterization, and are available for both the line-source (2-D) and the point-source (2.5-D) cases. The method involves two Green’s function vectors and their gradients, as well as the derivatives of the elastic modulus tensor with respect to the independent model parameters. The two Green’s function vectors are the responses of the displacement vector to the two directed unit vectors located at the source and geophone positions, respectively; they can be generally obtained by numerical methods. The gradients of the Green’s function vectors may be approximated in the same manner as the differential computations in the forward modeling. The derivatives of the elastic modulus tensor with respect to the independent model parameters can be obtained analytically, dependent on the class of medium anisotropy. Explicit expressions are given for two special cases—isotropic and tilted transversely isotropic (TTI) media. Numerical examples are given for the latter case, which involves five independent elastic moduli (or Thomsen parameters) plus one angle defining the symmetry axis.     

Constraints on the flux of meteoritic and cometary water on the Moon from volatile element (N–Ar) analyses of single lunar soil grains,Luna 24 core

We report new nitrogen and argon isotope and abundance results for single breccia clasts and agglutinates from four different sections of the Luna 24 drill core in order to re-evaluate the provenance of N trapped in lunar regolith, and to place limits on the flux of planetary material to the Moon’s surface. Single Luna 24 grains with ⁴⁰Ar/³⁶Ar ratios <1 show δ¹⁵N values between ?54.5‰ and +123.3‰ relative to terrestrial atmosphere. Thus, low-antiquity lunar soils record both positive and negative δ¹⁵N signatures, and the secular increase of the δ¹⁵N value previously postulated by Kerridge (Kerridge, J.F. [1975]. Science 188(4184), 162–164. doi:10.1126/science.188.4184.162) is no longer apparent when the Luna and Apollo data are combined. Instead, the N isotope signatures, corrected for cosmogenic ¹⁵N, are consistent with binary mixing between isotopically light solar wind (SW) N and a planetary N component with a δ¹⁵N value of +100‰ to +160‰. The lower δ¹⁵N values of Luna 24 grains compared to Apollo samples reflect a higher relative proportion of solar N, resulting from the higher SW fluence in the region of Mare Crisium compared to the central near side of the Moon. Carbonaceous chondrite-like micro-impactors match well the required isotope characteristics of the non-solar N component trapped in low-antiquity lunar regolith. In contrast, a possible cometary contribution to the non-solar N flux is constrained to be ?3–13%. Based on the mixing ratio of SW to planetary N obtained for recently exposed lunar soils, we estimate the flux of micro-impactors to be (2.2–5.7) × 10³ tons yr^?1 at the surface of the Moon. Our estimate for Luna 24 agrees well with that for young Apollo regolith, indicating that the supply of planetary material does not depend on lunar location. Thus, the continuous influx of water-bearing cosmic dust may have represented an important source of water for the lunar surface over the past ～1 Ga, provided that water removal rates (i.e., by meteorite impacts, photodissociation, and sputtering) do not exceed accumulation rates.     

Equatorial Indian Ocean evaporation estimates from operational meteorological satellites and some inferences in the context of monsoon onset and activity

The estimation of evaporation from the sea surface is not yet achieved adequately by remote sensing techniques, in general. However, for approximate averaged estimates over moderate space and time scales over a specific tropical region, e.g., weekly values over the Indian Ocean as needed in monsoon moisture diagnosis, it may be possible to extrapolate satellite wind and humidity data to the ocean surface and then use bulk aerodynamic parameterization for estimating evaporation. In the present investigation, GOES low-level cloud winds and TIROS-N moisture profiles over the Indian Ocean are extrapolated to the ocean surface. The planetary boundary layer (PBL) wind shear is obtained over different sub-regions and periods during the monsoon season, by reference to objectively analysed fields. These shear values are applied to GOES satellite winds to obtain sea-surface winds. The humidity extrapolation was based on (i) an exponential fit for water vapour density and (ii) a vertical distribution of relative humidity approximately proportional to atmospheric pressure. The exchange coefficient is varied slightly depending on wind speed and boundary-layer stability inferred approximately from TIROS-N sea surface temperatures and temperature profiles. The evaporation estimate as based on these satellite parameters is assessed by comparison with ships' surface observations. Sensible heat exchange is also estimated and assessed. Some inferences based on these estimates are also presented, in relation to monsoon onset and activity.