Cooling of Accretion-Heated Neutron Stars

We present a brief, observational review about the study of the cooling behaviour of accretion-heated neutron stars and the inferences about the neutron-star crust and core that have been obtained from these studies. Accretion of matter during outbursts can heat the crust out of thermal equilibrium with the core and after the accretion episodes are over, the crust will cool down until crust-core equilibrium is restored. We discuss the observed properties of the crust cooling sources and what has been learned about the physics of neutron-star crusts. We also briefly discuss those systems that have been observed long after their outbursts were over, i.e, during times when the crust and core are expected to be in thermal equilibrium. The surface temperature is then a direct probe for the core temperature. By comparing the expected temperatures based on estimates of the accretion history of the targets with the observed ones, the physics of neutron-star cores can be investigated. Finally, we discuss similar studies performed for strongly magnetized neutron stars in which the magnetic field might play an important role in the heating and cooling of the neutron stars.     

Determination of Te,As, Bi,Sb and Se (TABS) in Geological Reference Materials and GeoPT Proficiency Test Materials by Hydride Generation‐Atomic Fluorescence Spectrometry (HG‐AFS)

The study of Te, As, Bi, Sb and Se (TABS) has increased over the past years due to their use in the development of low‐carbon energy technologies. However, there is a scarcity of mass fraction values of TABS in geological reference materials. This underlines the difficulty in undertaking routine determinations of these elements. The mass fractions of TABS were determined in geological reference materials using hydride generation‐atomic fluorescence spectrometry (HG‐AFS), calibrated with standard solutions. Comparisons with literature values were used to validate the method. Samples from the GeoPT proficiency test were also analysed. For most elements, there are no assigned or even provisional values for many of the GeoPT and reference materials because of the wide range of results reported. For mass fractions above the quantification limit of the method, our results are in good agreement with the median of GeoPT results. Thus, we propose GeoPT median values as informational values for these elements. In contrast, at mass fractions < 0.5 µg g^?1 median values of Se from GeoPT are systematically higher than our results. Our Se results are in agreement with the reference materials down to 0.02 µg g^?1, which suggest that many of the results for Se reported in GeoPT testing are too high.     

Hydraulic properties and scale effects investigation in regional rock aquifers,south-western Quebec,Canada

This paper reports on the characterization of hydraulic properties of regional rock aquifers carried out within a groundwater resources assessment project in the St. Lawrence Lowlands of south-western Quebec. To understand the aquifer behavior at both the fracture level and at field scale, hydraulic investigations were carried out using various aquifer tests. The groundwater flow at the local scale is controlled mostly by the fracture system. Results of the constant-head injection tests show a weak decreasing trend of hydraulic conductivity with depth indicating that a major part of the groundwater flow occurs in the first meters of the rock sequence. At the regional scale, the equivalent porous media approach is applicable. The hydraulic conductivity measurements were correlated to the scale of the aquifer tests expressed with the investigated aquifer volume. A simple interpolation procedure for the hydraulic conductivity field was developed based on the distance between field measurements and the tested aquifer volumes. The regional distribution of the hydraulic conductivity for the major fractured aquifer units indicates that dolostone is the most permeable whereas sandstone and crystalline rocks are the least permeable units.

---

Resumen Este artículo trata de la caracterización de las propiedades hidráulicas en acuíferos regionales rocosos, la cual se llevó a cabo dentro del proyecto de evaluación de los recursos de agua subterránea en St. Lawrence Lowlands al suroeste de Quebec. Para entender el comportamiento del acuífero tanto a nivel de fractura como a escala del campo, se ejecutaron investigaciones hidráulicas usando varias pruebas de acuífero. El flujo del agua subterránea a escala local está controlado principalmente por el sistema de fracturas. Los resultados de las pruebas de inyección con cabeza constante muestran una tendencia decreciente débil de la conductividad hidráulica con la profundidad, indicando que la mayor parte del flujo de agua subterránea sucede en los primeros metros de la secuencia rocosa. A escala regional se puede aplicar la aproximación equivalente de medios porosos. Las medidas de la conductividad hidrálica fueron comparadas con la escala de las pruebas del acuífero, expresadas con el volumen investigado del acuífero. Se desarrolló un proceso de interpolación simple para la conductividad hidráulica de campo, con base en la distancia entre las medidas de campo y los volúmenes probados del acuífero. La distribución regional de la conductividad hidráulica, para las unidades acuíferas fracturadas mayores, indica que la dolomita es más permeable mientras que la arenisca y las rocas cristalinas son las unidades menos permeables.

---

Résumé Larticle présente les propriétés hydrauliques dun aquifère régional rocheux qui ont été mesurées dans le cadre dun projet concernant lestimation de la ressource en eau de la plaine de St. Lawrence située dans la partie sud-ouest de Quebec. Affin de comprendre le comportement de l› aquifère tant à l› échelle de fracture qu› à l› échelle régionale on a mené des investigations hydrauliques en utilisant des essais differents. À l› échelle locale lécoulement est déterminé en principal par le système des fractures. Les résultats des essais dinjection au niveau constant ont montré une tendence de décroissance de la conductivité hydraulique avec la profondeur ce qui indique que l› écoulement ait lieu en principal dans les premiers mètres de la structure rocheuse. À l› échelle règionale on peut appliquer lapproche de milieux poreux equivalent. Les mesures de conductivité hydraulique ont été corrélées avec l› échelle des essais de pompage exprimée en termes de volume investigué de l› aquifère. On a mis au point une méthode simple dinterpolation pour le champ de la conductivité hydraulique basée sur la distance entre les essais in situ et les volume investigués de l› aquifère. La distribution règionale de la conductivité hydraulique montre que pour la majorité des unités de roche fracturé les plus perméable sont les roches dolomitiques alors que les grés et les roches cristalines presentent la plus faible perméabilité.

     

First Psocodean (Psocodea,Empheriidae) from the Cretaceous Amber of New Jersey

<正>Representatives of the extinct psocid family Empheriidae are known from Eocene Baltic amber, Lowermost Eocene French amber(Oise),and Lower Cretaceous Spanish amber(Alava).We report herein the first discovery of an empheriid psocid from the Cretaceous amber of New Jersey as Jerseyempheria grimaldii gen.et sp. nov.The fossil is figured and described.The new species is distinguished from related taxa.A discussion and checklist of Empheriidae are provided.     

A New Thorny Lacewing (Insecta: Neuroptera: Rhachiberothidae) from the Early Cretaceous Amber of Lebanon

<正>A new genus and species of Rhachiberothidae,Raptorapax terribilissima gen.et sp.nov.from the Cretaceous amber of Lebanon is described.The new genus is assigned to the subfamily Paraberothinae.The new material confirms the great diversity of the group in the Cretaceous age and its decrease in diversity in recent times.     

Selenium and sulfur concentrations in the Bushveld Complex of South Africa and implications for formation of the platinum-group element deposits

We have determined the S, Se, Cu and La contents through a complete stratigraphic section of the Bushveld Complex. The principle aim was to determine which phases controlled these elements. S, Se and Cu show positive correlations, but these elements do not correlate with La. In most cases, the concentration of S, Se and Cu in rocks containing greater than 800 ppm S can be modeled by segregation of a Fe–Ni–Cu sulfide liquid from a fractionating magma. As the magma evolved, Se and Cu were depleted by the continual segregation of sulfide liquid and the S/Se and S/Cu of the rocks increased. The Se/Cu ratio is higher in the more evolved rocks, which suggests that Se has a slightly lower partition coefficient than Cu into sulfide liquid (1,200 versus 1,700). The Lower and lower Critical Zone of the complex contains on average only 99 ppm S. The low S content of these rocks has led some authors to suggest that these rocks do not contain cumulate sulfides, despite the fact that they are moderately enriched in PGE. These samples fall along the same trend as the S-rich samples on the S-versus-Se plot and the S/La and Se/La ratios are greater than the initial magmas suggesting that despite the low S contents cumulate sulfides are present. Three models may be suggested in order to explain the low S content in the Lower and Critical Zone rocks: (a) the sulfides that were present have migrated away from the cumulate pile into the footwall or center of the intrusion; (b) the magma was saturated in sulfides at depth and during transport some sulfides lagged in embayments; (c) the rocks have lost both S and Se at high temperature. The first two models have important implications for exploration.     

Multiple origin and regional significance of bedding parallel veins in a fold and thrust belt: The example of a carbonate slice along the Appalachian structural front

The development and evolution of bedding parallel veins (BPV) are investigated in the Saint-Dominique carbonate slice (southern Québec Appalachian structural front), in order to emphasize the regional significance of BPV in a fold and thrust belt and their importance in establishing its structural and diagenetic evolution. Structural and microstructural analyses reveal that most BPV display a laminated structure locally crosscut by a massive one. Both structures show mutual crosscutting relationships with bedding parallel or bedding perpendicular stylolites and with bedding perpendicular veinlets, indicating that BPV cementation and deformation are continuous processes. Opening both sub-parallel and sub-perpendicular to the BPV walls are documented. Early BPV are planes of weakness that focus later reactivation, and evidence of successive and sometimes opposite senses of opening are locally preserved within a single BPV. The bedding parallel orientation of these veins proved particularly helpful in establishing the structural evolution of an area mostly characterized by front parallel structures with little crosscutting relationships otherwise. Petrographic and geochemical (δ¹⁸O _VPDB and δ¹³C) analyses of structural cements suggest a common, locally derived source for the fluids that percolated through BPV, non-bedding parallel veins and faults. The isotopic ratios also reveal a significant enrichment in ¹⁸O and ¹³C through time. This evolution is tentatively correlated with tectonic, syn-convergence exhumation of the Saint-Dominique slice during its imbrication along the Appalachian structural front, after its burial under Taconian thrust sheets.     

A New Mapping Protocol for Laser Ablation (with Fast-Funnel) Coupled to a Time-of-Flight Mass Spectrometer (LA-FF-ICP-ToF-MS) for the Rapid,Simultaneous Quantification of Multiple Minerals

Although in situ analysis by LA-ICP-MS is considered a rapid technique with minimal sample preparation and data reduction, mapping areas of millimetres in size using a small beam (< 15 μm) can be time consuming (several hours) when a quadrupole ICP-MS is used. In addition, fully quantitative imaging using internal standardisation by LA-ICP-MS is challenging in samples with more than one mineral phase present due to varying ablation rates. A new protocol for the quantification of multiple coexisting phases, mapped at a rate of about 12 mm² h^-1 and a resolution of 12 μm × 12 μm per pixel, is presented. The protocol allows mapping of most atomic masses, ranging from ²³Na to ²³⁸U, using a time-of-flight mass spectrometer (ICP-ToF-MS, TOFWERK) connected to a 193 nm excimer laser. A fast-funnel device was successfully used to increase the aerosol transport speed, reducing the time usually required for mapping by a factor of about ten compared with a quadrupole ICP-MS. The lower limits of detection for mid and heavy masses are in the range 0.1–10 μg g^-1, allowing determination of trace to ultra-trace elements. The presented protocol is intended to be a routine analytical tool that can provide greater access to the spatial distribution of major and trace elements in geological materials.     

Triploporella ? edgelli n. sp., a new Dasycladalean alga from the Lower Cretaceous of Lebanon

The Dasycladalean assemblage of the Jezzinian strata (uppermost Barremian–lowermost Aptian) of Lebanon consists of two organo‐genera and eight genera with eleven species, including eight Triploporellaceae. Although Triploporella marsicana (Praturlon, 1964) was reported by Saint‐Marc from the same interval, it is not found in our material. However, a lookalike, which is herein described as Triploporella ? edgelli n. sp., is identified. This new species has cyst‐containers within the primary segments of its laterals but, because it lacks calcified secondary segments, it is left in open nomenclature.     

The effects of longitudinal variations in valley geometry and wood load on flood response

We use field measurements and airborne LiDAR data to quantify the potential effects of valley geometry and large wood on channel erosional and depositional response to a large flood (estimated 150-year recurrence interval) in 2011 along a mountain stream. Topographic data along 3 km of Biscuit Brook in the Catskill Mountains, New York, USA reveal repeated downstream alternations between steep, narrow bedrock reaches and alluvial reaches that retain large wood, with wood loads as high as 1261 m³ ha⁻¹. We hypothesized that, within alluvial reaches, geomorphic response to the flood, in the form of changes in bed elevation, net volume of sediment eroded or aggraded, and grain size, correlates with wood load. We hypothesized that greater wood load corresponds to lower modelled average velocity and less channel-bed erosion during the flood, and finer median bed grain size and a lower gradation coefficient of bed sediment. The results partly support this hypothesis. Wood results in lower reach-average modelled velocity for the 2011 flood, but the magnitude of change in channel-bed elevation after the 2011 flood among alluvial and bedrock reaches does not correlate with wood load. Wood load does correlate with changes in sediment volume and bed substrate, with finer grain size and smaller sediment gradation in reaches with more wood. The proportion of wood in jams is a stronger predictor of bed grain-size characteristics than is total wood load. We also see evidence of a threshold: greater wood load correlates with channel aggradation at wood loads exceeding approximately 200 m³ ha⁻¹. In this mountain stream, abundant large wood in channel reaches with alluvial substrate creates lower velocity that results in finer bed material and, when wood load exceeds a threshold, reach scale increases in aggradation. This suggests that reintroducing small amounts of wood or one logjam for river restoration will have limited geomorphic effects. © 2020 John Wiley & Sons, Ltd.