Eradication success down under: heat treatment of a sunken trawler to kill the invasive seaweed Undaria pinnatifida

Eradication of invasive species is difficult in the marine environment, and there have only been a few successes. We report the successful eradication of the invasive seaweed Undaria pinnatifida from a sunken trawler in the Chatham Islands, New Zealand. New heat-treatment methods were developed as the most cost effective and environmentally acceptable option to kill Undaria. Monitoring of the trawler for three years after it sank found no Undaria after the vessel was treated. Key factors in the success of the eradication programme included: early detection, a rapid response, pre-existing knowledge of Undaria, an adaptive management approach, targeting of multiple life history stages, and the cooperation of the vessel's insurer.     

The diffusive boundary layer of sediments: oxygen microgradients over a microbial mat

Oxygen microelectrodes were used to analyze the distribution of the diffusive boundary layer (DBL) at the sediment-water interface in relation to surface topography and flow velocity. The sediment, collected from saline ponds, was covered by a microbial mat that had high oxygen consumption rate and well-defined surface structure. Diffusion through the DBL constituted an important rate limitation to the oxygen uptake of the sediment. The mean effective DBL thickness decreased from 0.59 to 0.16 mm as the flow velocity of the overlying water was increased from 0.3 to 7.7 cm s-1 (measured 1 cm above the mat). The oxygen uptake rate concurrently increased from 3.9 to 9.4 nmol cm-2 min-1. The effects of surface roughness and topography on the thickness and distribution of the DBL were studied by three-dimensional mapping of the sediment-water interface and the upper DBL boundary at 0.1-mm spatial resolution. The DBL boundary followed mat structures that had characteristic dimensions > 1/2 DBL thickness but the DBL had a dampened relief relative to the mat. The effective surface area of the sediment-water interface and of the upper DBL boundary were 31 and 14% larger, respectively, than a flat plane. Surface topography thereby increased the oxygen flux across the sediment-water interface by 49% relative to a one-dimensional diffusion flux calculated from the vertical oxygen microgradients.     

Small-scale electrical resistivity tomography of wet fractured rocks

This paper describes a series of experiments that tested the ability of the electrical resistivity tomography (ERT) method to locate correctly wet and dry fractures in a meso-scale model. The goal was to develop a method of monitoring the flow of water through a fractured rock matrix. The model was a four by six array of limestone blocks equipped with 28 stainless steel electrodes. Dry fractures were created by placing pieces of vinyl between one or more blocks. Wet fractures were created by injecting tap water into a joint between blocks. In electrical terms, the dry fractures are resistive and the wet fractures are conductive. The quantities measured by the ERT system are current and voltage around the outside edge of the model. The raw ERT data were translated to resistivity values inside the model using a three-dimensional Occam's inversion routine. This routine was one of the key components of ERT being tested. The model presented several challenges. First, the resistivity of both the blocks and the joints was highly variable. Second, the resistive targets introduced extreme changes the software could not precisely quantify. Third, the abrupt changes inherent in a fracture system were contrary to the smoothly varying changes expected by the Occam's inversion routine. Fourth, the response of the conductive fractures was small compared to the background variability. In general, ERT was able to locate correctly resistive fractures. Problems occurred, however, when the resistive fracture was near the edges of the model or when multiple fractures were close together. In particular, ERT tended to position the fracture closer to the model center than its true location. Conductive fractures yielded much smaller responses than the resistive case. A difference-inversion method was able to correctly locate these targets.     

Effects of rate-limited mass transfer on water sampling with partially penetrating wells

Nonequilibrium concentration type curves are numerically developed and sensitivity analyses are performed to examine the relationships between effluent concentrations in partially penetrating monitoring/extraction wells, the vertical plume shape, and the mass transfer characteristics of the aquifer. The governing two-dimensional, axisymmetric nonequilibrium solute transport equation is solved in three stages using an operator-splitting approach. In the first two stages, the advection and dispersion terms are solved with the Eulerian-Lagrangian method, based on the backward method of characteristics for advection and the standard implicit Galerkin finite element method for dispersion. In the third step, the first-order, immobile-mobile domain mass transfer term is computed analytically for both two-site and lognormally distributed, multirate models. Effluent concentration variations with time and contour plots of the pore water concentration distribution in the aquifer are compared for a wide range of field- and laboratory-measured mass transfer rates, various plume shapes, and relevant physical/chemical parameter values, including pumping rate, vertical anisotropy ratio, retardation factor, and porosity. The simulation results show that rate-limited mass transfer can have a significant impact on sample and aquifer pore water concentrations during three-dimensional transport to a partially penetrating well. An alternative dimensionless form of the nonequilibrium solute transport equation is derived to illustrate the key parameter groupings that quantify rate-limited sorption effects and show the relative importance of individual parameters. A hypothetical field application example demonstrates the fitting of dimensional type curves to discrete-interval sampling data in order to evaluate the mass transfer characteristics of an aquifer and shows how type curve superposition can be used to model complex plume shapes.     

Palaeoecology, reference conditions and classification of ecological status: the EU Water Framework Directive in practice

The European Union's Water Framework Directive (WFD) requires that all Member States within the European Union determine reference conditions for aquatic ecosystems to provide a baseline against which to measure the effects of past and present activities. Reference conditions are subsequently used to classify the ecological status of European waters. The decisions regarding environmental status will be important future elements in the management of European coastal waters. We have developed a number of classification scenarios for total nitrogen (TN) in the overlying waters of the southern part of Roskilde Fjord, Denmark, taking as our basis a palaeoecological reconstruction of fluctuations in TN between 1850 and 1995. We present a provisional classification scheme for the ecological status of Roskilde Fjord, sensu the WFD. Decision(s) regarding the deviation from reference conditions will give a wide range of apparent ecological status from good, through moderate and poor, to bad depending upon the definition of an acceptable deviation from reference conditions. The determination of an acceptable deviation will ultimately be a political decision, and will result in a wide range in the protection of coastal waters in Europe. There is still, however, an urgent need for a sound scientific documentation of the various scenarios for the implementation of the WFD.     

Does sedimentary organic delta 13C record variations in quaternary ocean [CO2(aq)]?

Ocean surface water [CO2(aq)] variations based on glacial/interglacial changes in sediment delta 13Corg are shown to compare favorably with reconstructions based on ice core [CO2]. In particular, an approximate 80 microatmospheres increase in atmospheric pCO2 during the last glacial-interglacial transition is calculated to correspond to a 3-4 micromolar increase in ocean surface water [CO2(aq)] at atmospheric equilibrium. A widespread marine delta 13Corg decrease of 1-2% accompanied this event and was not preceded by an equivalent isotopic change in surface water total dissolved inorganic carbon. These observations support the hypothesis that [CO2(aq)] influences photosynthetic isotope fractionation between marine inorganic and organic carbon pools, and therefore that plankton/sediment delta 13Corg may serve as a proxy for surface water [CO2(aq)].