基于拓扑相似性的道路网综合模型

针对道路网综合时须保持道路网眼空间分布特征这一基本要求,在讨论道路网眼拓扑形式化描述的基础上提出了一种基于拓扑相似性的道路网综合模型.该模型通过制定道路网拓扑相似性评价指标来进行道路网综合方案选择,同时针对拓扑相似性相同的不同道路删除方案,进一步提出了利用道路形状加以评价的方法.结果表明,该模型原理正确,无论对于保持道路网眼空间分布还是形状特征都具有很好的效果.     

四川盆地泸州古隆起嘉陵江组储层特征研究

对研究区嘉陵江组沉积背景认识的基础上,通过岩心观察、岩石薄片确定了不同类型的储集岩和储集空间,得出本地区储层岩石类型和储渗空间类型均多样化的特点。从成因角度识别出来了溶蚀孔隙型储层、膏溶孔洞型储层、裂缝型储层等三类储层。研究不同类型储层的孔、渗特征及关系表明,溶蚀孔隙型储层物性要优于膏溶孔洞型储层,而溶蚀孔隙型储层中的颗粒云岩溶蚀孔隙型储层物性最好、颗粒灰岩溶蚀孔隙型物性其次、粉晶云岩溶蚀孔隙型储层物性最差,其原因是不同储层受沉积环境和成岩作用控制和影响。     

菲降解菌的降解特性及酶促反应动力学研究

通过对取自MBR膜生物反应器中的活性污泥加入菲进行富集培养、驯化,分离、纯化出一株能以菲为唯一碳源和能源的短杆状革兰氏阴性菌J-1,细菌长2～5μm,宽1～3μm;研究了初始底物浓度、温度、pH对菌株J-1降解菲的影响,探讨了菌株J-1胞内酶对菲降解的底物抑制动力学。试验表明:菌株J-1在48h内能将不同浓度菲的水溶液中的菲完全降解;菲浓度增加,达到完全降解的时间延长。温度对细菌的降解能力影响较大,菌株J-1对菲降解的最佳温度为28℃。1.15mg·L-1的菲,28℃时48h内能完全降解,而相同时间内10℃时的降解率仅为36.65%。菌株J-1对pH的波动具有一定的适应性,pH在一定范围内(6.0～8.4)变化对菲降解的影响不大,降解反应的最佳pH为7.2。菌株J-1对菲的降解符合一级动力学反应方程。较高的底物浓度对酶促降解反应具有抑制作用,酶促反应的最大速率常数vm=1.17mg·L-1·h-1,米氏常数Km=61.70mg·L-1;底物抑制常数kS=49.60mg·L-1;最佳底物浓度[S]opt=55.32mg·L-1。     

一种基于双重距离的空间聚类方法

传统聚类方法大都是基于空间位置或非空间属性的相似性来进行聚类,分裂了空间要素固有的二重特性,从而导致了许多实际应用中空间聚类结果难以同时满足空间位置毗邻和非空间属性相近。然而,兼顾两者特性的空间聚类方法又存在算法复杂、结果不确定以及不易扩展等问题。为此,本文通过引入直接可达和相连概念,提出了一种基于双重距离的空间聚类方法,并给出了基于双重距离空间聚类的算法,分析了算法的复杂度。通过实验进一步验证了基于双重距离空间聚类算法不仅能发现任意形状的类簇,而且具有很好的抗噪性。     

福建石炭纪岩相古地理分析

笔者总结了福建省石炭纪生物地层与岩石地层的研究成果,提出了生物地层与岩石地层的划分对比。在详尽的相分析基础上对该纪地层进行了相系、相、亚相及微相的划分,并按“优势相”的原则分期编制了林地期、黄龙期及船山期的岩相古地理图。笔者采用“相、层、位”控矿观点对石炭纪的矿产成因及成矿规律作了探讨。     

19802000北京市农业土地生产性的变动分析

根据1980、1990、2000年的统计资料和实地走访观察,本文分析了北京市乡镇一级的粮食作物、蔬菜作物和果品作物的分布格局及农业土地生产性近20年的变化。研究认为:1980年北京农业生产分布格局与土地生产性为比较典型的杜能模式;随着农业经营的多样化,1990年和2000年北京农业土地生产性呈现出多样的分布格局;北京粮食作物、蔬菜作物、果品作物的分布格局及农业土地生产性近20年的变化与此阶段的农业生产政策、农业以外的社会经济活动变化有较强的关联性;对北京以上问题的研究为验证杜能、辛克利亚、布莱昂特城市周边农业地域研究经典理论的演变提供了实证案例。     

Uniaxial compression and tension tests of anthracite and loading rate dependence of peak strength

The mechanical characteristics of coal under uniaxial compressive stress and uniaxial tensile stress are key factors in investigations of the stability of galleries and coal faces, and are vital considerations for the efficient design of coalmines, disaster prevention, and environmental preservation. These mechanical characteristics have long been a topic of research, but remain insufficiently understood. In this study we performed uniaxial compression tests and uniaxial tension tests on coal, with particular attention to two concerns. The first was to measure the loading rate dependence of the peak strength of coal. Coal shows high sample-to-sample scatter in strength; test methods that are successful in comparatively homogeneous rock types cannot be used for coal. We therefore used an alternative test method that was recently developed by the authors. Anthracite samples were subjected to alternating slow and fast strain rates. Measured variations in stress during this process were used to estimate the loading rate dependence of peak strength. The second objective was to obtain complete stress–strain curves for coal under uniaxial tensile stress. It is difficult to hold samples secure during a tensile test; consequently, such curves have yet to be obtained. This study presents a successful application of the authors' method to the analysis of coal samples, yielding a complete stress–strain curve under tensile stress. The two methods presented here hold promise for application not only to anthracite but also to a wide variety of coals. It is possible to derive the values of the constants used in constitutive equations from the obtained experimental results. Once these equations are determined, they can be incorporated into finite-element software to investigate various time-dependent behaviors of coal and aid in the efficient design of coalmines and the prevention of subsidence and mine disasters.     

Exploiting the dual functions of polymer depressants in fine particle flotation

Fine hydrophilic particles are known to be entrained with water in flotation of many ores. Flocculation of the hydrophilic particles by polymer depressants could potentially reduce the mechanical entrainment of these particles. This paper reports testwork completed on fine particles of several solids, iron oxide, hydroxyapatite and sphalerite, as well as on a relatively coarse quartz sample (− 75 + 38 μm). Dodecylamine was used as a collector for quartz, and several dispersants and polymer depressants, including sodium silicate, sodium metaphosphate, zinc sulfate, cornstarch, corn dextrin and carboxymethyl celluloses (with molecular weights of both 700,000 and 80,000) were used as flotation modifiers. The major part of the testwork involved flotation tests in a 200 mL flotation column. It was observed that flocculation of the fine hydrophilic particles significantly reduced their mechanical entrainment, while dispersion severely aggravated it. Thus, in the flotation separation of synthetic mixtures of the − 75 + 38 μm quartz and fine (reagent grade) iron oxide or hydroxyapatite, polymer depressants that caused flocculation performed better than those that did not cause flocculation.