三类高强度悬式瓷绝缘子的成分和物相分析

为探讨高原牌70kN和进口120，210kN瓷绝缘子的成分和结构性能，中采用原子吸收光谱（AAS）和X射线衍射（XRD）方法，对三类产品进行了检测。结果表明，有效成分除K2O外，70kN和210kN的SiO2,Al2O3,Fe2O3含量接近，主晶相基本相同，有刚玉，莫来石、石英和长石等；结晶相总量：70kN35%，120kN40%,210kN48%，这表明机械强度愈大，结晶相含量愈高，只需调整70kN原样的部分成分，粒度和工艺，即生产出高等级（如210kN)瓷绝缘子。     

高峰公司100号矿体矿床建模与矿山生产动态管理的研究

重点论述高峰锡矿 10 0号矿体的矿床数学经济模型的建立 ,分析模型在采矿、选矿等矿山生产动态管理中的作用及意义     

中国科学院固体地球科学知识创新工程现状与发展态势

回顾了中国科学院国家知识创新试点工程实施以来特别是启动阶段3年里固体地球科学知识创新工程试点各项工作的进展情况，包括项目与经费、创新成果、人才吸引、科研竞争力提升、院地合作推进等方面，分析和总结了中国科学院固体地球科学知识创新工程现状，并展望了固体地球科学知识创新工程若干重要发展态势。     

Division of Gas Accumulation System and Laws Controlling Distribution of Natural Gas in Typical Petroliferous Basins of China

Considering the existing problems of the petroleum system, this paper brings forward the concept of natural gas accumulation system and presents the dividing principles. Then detailed statistics on the accumulation factors of the 32 typical natural gas accumulation systems in China and studies on the laws controlling distribution of gas are collected. The research shows that the petroleum accumulation system is the basic unit controlling petroleum generation, migration and accumulation. Generating intensity, generating amount, accumulating efficiency and migration distance plays an important role in the distribution of natural gas. Through analysis on results of resources evaluation, discovered reserves and residual reserves, potential areas in middle-scaled petroliferous basins in China are forecasted in this paper. Ordos, Sichuan, Tarim and Qaidam basins are found out to be the main basins developing and enriching gas accumulation systems.     

Physical properties of ultrahigh-pressure metamorphic rocks from the Sulu terrain, eastern central China: implications for the seismic structure at the Donghai (CCSD) drilling site

About 30 samples representing major lithologies of Sulu ultrahigh-pressure (UHP) metamorphic rocks were collected from surface exposures and exploration wells, and compressional (Vp) and shear wave (Vs) velocities and their directional dependence (anisotropy) were determined over a range of constant confining pressures up to 600 MPa and temperatures ranging from 20 to 600 °C. Samples range in composition from acidic to ultramafic. P- and S-wave velocities measured at 600 MPa vary from 5.08 to 8.64 km/s and 2.34 to 4.93 km/s, respectively. Densities are in the range from 2.60 to 3.68 g/cm³. To make a direct tie between seismic measurements (refraction and reflection) and subsurface lithologies, the experimental velocity data (corresponding to shallow depths) were used to calculate velocity profiles for the different lithologies and profiles of reflection coefficients at possible lithologic interfaces across the projected 5000-m Chinese Continental Scientific Drilling Program (CCSD) crustal segment. Comparison of calculated in situ velocities with respective intrinsic velocities suggests that the in situ velocities at shallow depths are lowered by an increased abundance of open microcracks. The strongly reflective zone beneath the Donghai drill site can be explained by the impedance contrasts between the different lithologies. Contacts between eclogite/peridotite and felsic rocks (gt-gneiss, granitic gneiss), in particular, may give rise to strong seismic reflections. In addition, shear-induced (lattice preferred orientation (LPO)-related) seismic anisotropy can increase reflectivity. For the explanation of the high velocity bodies (>6.4 km/s) around 1000 m and below 3200-m depth, large proportions of eclogite/peridotite (about 40 and 30 vol.%, respectively) are needed.     

厚层覆盖区综合物化探方法找金试验研究——以广西兴安金石金矿为例

在兴安金石金矿外围 4号分散流异常区 ,通过地电化学提取金测量法 ,查明测区存在 5个走向规模小于 5 0 m的金异常区 ,W( Au) 最大值为 72 .4× 10 - 9,高出背景值十几倍 ,并藉综合土壤吸附汞测量 ,高精度磁测和激发极化法等多种物化探方法来确定这些异常区的地质、地球化学和地球物理特征 ,提出金矿成矿的有利部位在金的地电提取高异常区、高汞量异常区、高磁性异常区、低视电阻率异常区和中等视极化率异常区的“三高一低一中”的找矿模式。确定测区的北北东角 (右下角 )一带具备有利的金矿成矿条件     

泥页岩吸水扩散系数测量新方法

介绍了一种模拟井下温压条件下泥页岩吸水扩散系数测量的新方法及共实验装置和实验数据回归处理技术.利用该装置对泥页岩的扩散系数值进行了测定,并据此对泥浆滤液在泥页岩井壁中的渗透运移规律进行了数值计算.使用结果表明,该种测量方法新颖科学、数据可靠,且大大的简化了实验过程,缩短了实验时间,所得结果更符合现场实际,具有较大的实用价值.     

历史地震资料与地震的中长期预测

故障诊断模型的基本内容是根据动态系统的外部特征来判断系统内部是否发生故障及确定故障发生的部位、时间和大小。由于故障诊断技术在监测及诊断故障的思路上和地震预报有很多相似之处，因此，把故障诊断技术应用于地震预报是可行的。由于该模型与其他数学模型一样，需要有较多的学习过程，所以历史地震资料在该模型中有重要作用。而其中的鲁棒性故障诊断模型在抑制各子模型的个性，凸现其共性方面有其特有的性质，所以把它作为一种综合模型，能抑制各子模型的个性，突出在地震预测方面的共性，从而提高预测的精确性。本文根据一个实例，说明了这种综合性模型的可行性。在文章的最后，由信息量的分析，说明了模型的鲁棒性特征。     

Estimation of azimuth and slowness of tele-seismic signals recorded by a local seismic network

Introduction The azimuth and slowness are two major features of seismic signals. The accurate estimation of them is quite important for both phase identification and event location. Generally, there are two types of seismic stations, i.e. 3-component stations (3C) and arrays. To estimate the two direc-tional parameters, the polarization analysis (Jurkevics, 1988) is commonly used for 3C stations and the frequency-wavenumber spectrum analysis ( f-k) (Capon, 1969; Kvaerna, Doornbos, 1986) is …     

地震前兆时空非均匀性指标Cv值的实验检验

在双向加载条件下，对两种构造和介质不同的岩石标本进行变形实验，测量了标本表面不同部位的应变．在此基础上，利用王晓青和陈学忠等提出的描述地震前兆非均匀分布的参量————Cv值，分析了标本变形失稳过程中应变异常的分布，以期从实验角度检验Cv值方法并探讨其物理意义．研究表明，Cv值的变化与岩石变形特征的变化有关，是描述前兆分布非均匀性的一种有效指标；Cv值在失稳发生前先异常上升，然后下降，并在Cv值恢复过程中或恢复后伴随着失稳事件的发生．因此，Cv值是一种有效的预报指标．