Physiography of the Exmouth and Scott Plateaus,Western Australia,and adjacent northeast Wharton Basin

The continental margin of Western Australia is a rifted or “Atlantic”-type margin, with a complex physiography. The margin comprises a shelf, an upper and lower continental slope, marginal plateaus, a continental rise, and rise or lower slope foothills. Notches or terraces on the shelf reflect pre-Holocene deposition of prograded sediment, whose seaward limit was determined by variations in relative sea level, wave energy, and sediment size and volume. The upper continental slope has four physiographic forms: convex, due to sediment outbuilding (progradation) over a subsiding marginal plateau; scarped, due to erosion of convex slopes; stepped, due to deposition at the base of a scarped slope; and smooth, due to progradation of an upper slope in the absence of a marginal plateau. Lying at the same level as the upper/lower slope boundary are two extensive marginal plateaus: Exmouth and Scott. They represent continental crust which subsided after continental rupture by sea-floor spreading. Differential subsidence, probably along faults, gave rise to the various physiographic features of the plateaus. The deep lower continental slope is broken into straight northeasterly-trending segments, that parallel the Upper Jurassic/Lower Cretaceous rift axis, and northwesterly-trending segments that parallel the transform direction. The trends of the slope foothills are subparallel to the rift direction. The four abyssal plains of the region (Perth, Cuvier, Gascoyne and Argo) indicate a long history of subsidence and sedimentation on Upper Jurassic/Lower Cretaceous oceanic crust.     

Comparison of sedimentation-compression curves obtained by nuclear and gravimetric methods for Wilkinson Basin,Gulf of Maine,sediments

Accurate measurements of bulk density are important in the construction of sedimentation-compression curves of water-saturated, fine-grained cohesive sediments for consolidation studies. The bulk density of five cores was measured nondestructively on a laboratory nuclear transmission densitometer and the water content, expressed as void ratio, was derived from an empirical relationship between bulk density and water content. Bulk density and water content measured destructively was determined every 10 cm for a comparison with the nuclear data. Agreement between nuclear and gravimetric methods was within ± 0.02 g/cm³ for bulk density ranging from 1.2 to 1.4 g/cm³. Sedimentation-compression curves made using both methods were in generally good agreement.In the Wilkinson Basin, void ratio gradually decreases with increasing effective overburden pressure. This indicates that consolidation by dewatering the surficial sediments is normal and that the environmental conditions during deposition remained relatively constant.     

Concentration du chrome dans deux profils de l'ocean pacifique

Determination of total chromium on two profiles and chromium III on four samples of equatorial Pacific Ocean water have been carried out using coprecipitation of chromium from sea water with hydrous iron oxides, followed by ion-exchange separation and isotope dilution mass spectrometry. Results for two Pacific profiles show increasing total chromium concentration from surface to 250 m. The Cr concentration appears to be different below 1,000 m, with nearly homogeneous concentrations for the first profile and regularly increasing Cr concentrations from 0.330 to 0.550 μg/l at 3,900 m for the second one. Results for Cr(III) show that trivalent species are dominant in these samples.     

Improved in situ gamma-ray transmission densitometer for marine sediments

The first-generation University of Illinois gamma-ray transmission densitometer, designed for the in situ measurement of sediment bulk density, was modified by incorporating in the detector probe (1) an Americium-241 alpha particle pulser and an anti-walk gain stabilization control to maintain better temperature stability and (2) a small power supply and a IC preamplifier to eliminate the need for a high-voltage coaxial cable between the detector and external signal conditioning electronics package. This second-generation Lehigh University system has been successfully deployed since 1971 in routine use from ships and submersibles in the Atlantic and Pacific Oceans and the Gulf of Mexico. Results are presented of system operations to (1) measure bulk density over the range of 1.2–1.8 Mg/m³ in the Hudson Canyon, (2) penetrate 1.9 m into the seafloor in the San Diego trough and, (3) be lowered to a water depth of 3.6 km in the Gulf of Mexico.     

Chlorinated hydrocarbons in seawater: Analytical method and levels in the northeastern Pacific

A method is described for analyzing nanogram quantities of chlorinated hydrocarbons from 1-1 samples of seawater. Seawater samples are pumped through a copper column containing a mixture by weight of 5% activated carbon powder, 10% MgO and 85% refined diatomaceous earth. The chlorinated hydrocarbons in the seawater are adsorbed or trapped on the column and subsequently eluted with 30% benzene in acetone (v/v) for analysis by gas-liquid chromatography.This procedure was used to analyze chlorinated hydrocarbon levels in samples collected off the southern California coast. We suggest that anthropogenic chlorinated hydrocarbons can be used for the investigation of large-scale ocean currents and mixing processes.     

Dives into outer Coronado Canyon System

Dives in Lockheed's submarine “Deep Quest” followed the floor of the fan valley and outer gorge of Coronado Canyon, southwest of the California—Baja California border. Both the fan valley and outer gorge have meandering courses. Basin depressions and intermittent steep descents characterize the outer gorge. No indications were found of recent activity of turbidity currents at either location, but a sand layer 30 cm below the surface is interpreted as related to a lower stand of sea level at the close of the last ice age. Abundant organisms were seen on the valley floor and in the overlying water.     

Deep tow studies of the Tamayo transform fault

The Tamayo transform fault occurs at the north end of the East Pacific Rise where it enters the Gulf of California. The two deep-tow surveys reported here show that the transform fault zone changes significantly as a function of distance from the spreading center intersections. At site 1, near the intersection, one side of the fault is young and the fault zone is narrow and well-defined. Strike slip occurs in a zone approximately 1-km wide suggesting a correspondingly narrow zone of decoupling between the Pacific and North American plates. On the young side of the strike-slip zone, normal faults occur along shear zones which are 45°–50° oblique to the transform strike. They occur parallel to the short axis of the strain ellipse for transform fault strain here, i.e., perpendicular to the least compressive stress. The transform walls are formed by normal faulting as has been pointed out in previous detailed surveys. Here, however, the age contrast of 2.5 m.y. across the transform valley is apparent in the morphology of the normal fault scarps. While the scarps are steep and well-defined on the young side, the scarps on the older side have gradual 10°–30° slopes and appear to be primarily talus ramps. Apparently, the scarps have been tectonically eroded by continued strike slip activity after the initial stages of normal faulting. Thus, transform valleys should be quite asymmetric in cross-section where there is a significant age contrast and one side is less than approximately 0.5 m.y. old. Also, along older sections of the transform valley walls, normal faulting may not be at all obvious due to degradation of the scarps by tectonic erosion. This phenomenon makes the likelihood of transform faults providing windows into the oceanic crust most unlikely except in special cases.The picture of transform deformation is more complex at site 2 in the central portion of the fault where both sides of the fault are greater than 1 m.y. old. Here the transform valley is wider (25–30 km as opposed to 2–5 km). There is no clear simple zone of strike slip tectonics. In fact, the only clear evidence for deformation is the intrusion of magmatic or serpentinite diapirs through the sediments of the transform valley floor. The diapirs have deformed the turbidite layers flooring the valley and in one carefully studied case the turbidite sequence has been uplifted, perched atop the diapir. The pattern of deformation on this outcropping diapir shows radial and concentric fractures which can be modeled by a vertical intrusion circular in plan view. Magnetic studies limit the possible composition to basalt or serpentinite. A 60-km-long median ridge is also likely to be the product of intrusion along the transform fault. The survey at site 2 pointed out the importance of vertical tectonics in the transform valley floor and in particular the importance of diapiric intrusions of either basaltic or serpentinite composition.Based on initial boundary conditions and present tectonic elements in the Tamayo fault zone, a possible history of the mouth of the Gulf of California is outlined. The median ridge was emplaced starting approximately 0.8 m.y. ago by regional extension across the transform fault, the result of leaky transform faulting. The diapirs occur along a possible relay zone of extension midway along the fault which began approximately 0.15 m.y. ago. The extension in this case is parallel to the trend of the transform fault, is still occurring at present, and may evolve into a true spreading center.Contribution of the Scripps Institution of Oceanography, new series.     

Comparison of three oxidation methods used for the analysis of the dissolved organic carbon in seawater

Three methods for the determination of dissolved organic carbon in seawater were compared. Samples were analysed using persulphate oxidation, high-temperature combustion, and ultraviolet photo-oxidation. The dissolved organic carbon content of the seawater samples ranged from 0.6 to 1.6 mg C/I. This study shows that results of high-temperature oxidation and photo-oxidation procedures differ by less than 5%, whereas results with persulphate oxidation are about 15% less than those obtained with the high-temperature oxidation. The relative merits of each of the oxidation techniques for the determination of organic matter in seawater are discussed.     

The sea as a source of atmospheric phosphorus

The geochemical fractionation of phosphorus on the drop produced by bubbles bursting in seawater has been studied using a field sampling system called the Bubble Interfacial Microlayer Sampler (BIMS). The droplets from bursting bubbles were collected on filter samples in Narragansett Bay, Rhode Island during the summer of 1975. Phosphorus was found to be fractionated by the bubble-bursting process. The enrichment factor ranged from 4 to 170. Enrichment was found to increase with decreasing phosphorus concentration at 20 cm depth while it decreases with increasing wind velocity. Enrichment was independent of bubbling depth. Together these facts suggest that the sea-surface microlayer is the source of the phosphorus on the ejected drops. Organic phosphorus on the filter samples was found to be enriched relative to surface-water phosphorus by factors of 100–200, while reactive phosphorus was enriched by factors of only 6–8. This suggests that surface-active organic phosphorus compounds are the source phosphorus in the microlayer.The organic phosphorus content of samples of atmospheric particulates collected over the phosphate-rich upwelling waters near the Peru coast was found to correlate significantly with sea-salt sodium. Enrichments calculated using the average phosphorus concentration of the surface water in this area agree well with the results of the BIMS study. Thus it appears that phosphorus fractionation does occur in nature and may be important in supplying this nutrient to some coastal regions of the world.