Distribution and transport of organic matter along a filament-eddy system in the Canaries – NW Africa coastal transition zone region

The distribution and transport of chlorophyll a (Chla), particulate (POC) and dissolved (DOC) organic carbon, and the respiratory ETS activity of the microplankton community were studied along a filament-eddy system located in the transition zone between the NW Africa upwelling and Canary Islands waters. Two independent filaments (F1 and F2) stemming from the coastal jet, between Cape Juby and Cape Bojador, merged about 100 km offshore, turning southward and onshore forced by the circulation of a recurrent oceanic cyclonic eddy. In general, the coastal upwelling waters presented higher Chla, but lower POC, DOC and ETS activity than filament waters. However, differences in organic carbon distribution and respiratory activity were observed among stations from the two filaments. The bio-chemical fields were strongly influenced by a complex sub-mesoscale hydrography resulting from the interaction of cyclonic and anticyclonic island eddies with the filaments. The combined F1 + F2 filament system transported 97.1 kg s⁻¹ of excess (non-refractory) total organic carbon (e-TOC), a value comparable to other published estimates from upwelling filaments in the NE Atlantic. About 90% of e-TOC was exported as DOC, since eddy re-circulation precluded the offshore transport of POC. Assuming that the calculated transport of e-TOC is representative of the annual average, the yearly offshore transport (3.1 x 10⁹ kg C) would represent about 25% of the upwelling primary production of the region of study.     

Artificial upwelling induced by ocean currents —Theory and experiment

A submerged apparatus, which consists of a buoy, several horizontal contraction and expansion tubes (Venturi-type tubes) and a long pipe, is expected to be used to pump the subsurface sea-water (200–300 meter depth) containing abundant nutrients to surface layer (50–100 m) by the dynamic of ocean currents. i.e. an artificial upwelling without energy cost. A preliminary experiment and analysis are undertaken and shows that the capacity of pumping the nutrient-rich sea-water is worth to build a pilot prototype model.     

Ridge development as revealed by sub-bottom profiles on the central New Jersey shelf

Closely-spaced 3.5 kHz seismic profiles were collected over the north-easterly trending ridge and swale system 50 km east-southeast of Atlantic City, New Jersey. They yield information on the Late Quaternary depositional history of the area, and on the origin of the ridge system. Four of the sub-bottom reflectors identified were sufficiently persistent to warrant investigation and interpretation. These reflectors, which have been cored, lithologically identified, and radiocarbon dated, are stratigraphically higher than the reflectors dealt with by the majority of previous studies. The upper three reflectors are definitely mid- and post-Wisconsin in age and present a record of the most recent glacial cycle. The upper three units associated with the observed reflectors appear to exert a pronounced influence on the bathymetry. The gently corrugated ridge system of Holocene sand is formed over the regionally flat-lying upper unit, an Early Holocene lagoonal silty clay. The characteristically flat, broad depressions of the area are floored by this lagoonal material. Locally, however, marine scour has cut through the silty clay into an underlying unit of unconsolidated fine Pleistocene sand. Several stages of trough development appear to be represented. After penetrating the lagoonal clay, troughs are initially narrow, but when incised through the sand into a lower, Pleistocene, silty-clay unit, the troughs become notably wider. As downcutting is inhibited by the lower clay, the upper clay is undercut as the trough widens in a fashion similar to a desert blowout.

The sub-bottom reflectors indicate that ridge development on the central shelf has involved aggradation as well as erosion. Some ridges seem to have grown by vertical and lateral accretion from small cores. The internal structure of other ridges suggests that they formed by the coalescence of several small ridges. Others appear to have undergone appreciable lateral migration.

The ridges appear to be in a state of continuing adjustment to the hydraulic regime of the deepening post-Pleistocene water column.     

Geopotential topography of deep levels in the Pacific Ocean

After examination of the baroclinic structure below 3000 db, recent data were used to map the geopotential topography at 1000, 1500, and 2000 db (referred to 3000 db) in the Pacific Ocean. In the high-latitude regions and in the western boundary currents, considerable relief is present at 1000 and 1500 db, and the Circumpolar Current is still well-developed at 2000 db. The geostrophic circulation inferred is very similar to the surface circulation in these areas. Neglect of the structure below 1000 db results in appreciable errors in estimates of the transport of these currents; direction of near-surface flow is properly shown, however, and computed speeds are not greatly in error. In the equatorial Pacific and central North Pacific, little relief is present, and the trends are generally unlike the surface flow.     

Estimation of winds over the sea from land-based measurements

Simultaneous measurements of wind velocities at two different sites, one over the sea and the other over land, can differ substantially and therefore cannot be interchanged. In situations where the wind data at an offshore site are missing while simultaneous measurements from a land-based station exist, a linear mean-square estimation (LMSE) technique can be used to estimate the missing data. This technique relies on past wind data gathered simultaneously at the two locations, and it generates from the associated correlation a set of four transfer functions capable of predicting one data set from the other. In the present case, the LMSE technique is outlined briefly, and is then applied to construct seasonal transfer functions between a land-based station and two coastal/offshore sites in Kuwait. Comparisons between the actually observed wind characteristics and those predicted by the LMSE technique are favorable, and thus tend to confirm the applicability of the technique under appropriate conditions.     

A densely sampled core and climate variable aliasing

Undersampled records are susceptible to aliasing, in which a high frequency appears incorrectly as a lower one. We study the sampling requirements in a core taken from Rockall Trough using bulk density, P-wave velocity, and magnetic susceptibility as measured on an automated system. At 2-cm spacing (approximately 33 years in this core), all variables show a characteristic red-noise behavior, but with a spectral slope that is sufficiently weak so that significant aliasing appears to be present. P-wave velocity shows the largest potential corruption, probably owing to the weaker spatial averaging present in the sensor. Approximately 50% of the apparent low-frequency energy is aliased in all variables at some frequencies in both quiet and active regions of the record. In this core, a sampling interval of 0.2 cm appears to be "safe" in both active and quiet portions of the core, aliasing little or no energy, except in the P-wave record. For cores of different duration, sampling interval, and measurement type, the considerations will be identical, the importance of the problem depending directly upon the shape of the overall spectrum describing the entire frequency (wavenumber) range of physical variability.     

Physical and biological factors influencing the spatial distribution of age-0 walleye pollock (Theragra chalcogramma) around the Pribilof Islands, Bering Sea

The waters around the Pribilof Islands, in the southeast Bering Sea, are a main nursery area for age-0 pollock. Each summer, the islands are surrounded by a well-mixed inshore region, separated from a stratified offshore region by a frontal zone. To study the spatial distribution of age-0 pollock around this frontal structure in relation to physical and biological factors that are likely to influence it, such as advection, age-0 pollock feeding, and predation, samples were collected during September of four consecutive years, 1994–97, along two transects. Samples collected included water column hydrography and currents, acoustic backscatter, and groundfish predator density.Our analysis suggested that different mechanisms may be involved in controlling age-0 pollock distribution north and south of the islands. On the shelf area north of the islands, high age-0 pollock density was significantly associated with areas of high potential for growth only in years or portions of the frontal transect in which predator numbers were relatively low, indicating the importance of predation in controlling fish distribution in this area. In contrast, south of the islands, age-0 pollock distribution was associated more with prey availability, which appeared to be determined by vertical spatial overlap between predators and prey. Moreover, south of the islands, the stronger geostrophic currents, typical of the slope region, were more likely to affect the overall standing biomass of juvenile pollock, by constantly advecting fish away from the area.     

An experimental pressure compensated wet suit

Personal thermal insulation by means of neoprene from wet suits provides adequate temporary control of body heat loss only at the shallow end of the air diving depth range, but it constitutes by far the most popular approach to diver thermal support. Howewer, compression of the trapped gas phase in neoprene foam seriously reduces its insulation performance on exposure to high ambient pressure. With conventional wet suits equipped with heating, the necessary level of power required at depths greater than about 30 m is too high, and also unsafe without the back up that increased insulation would provide. One approach to the goal of depth-insensitive insulation is to use a wet suit with a continuous internal gas space pressurized nominally to ambient pressure, so that its thickness remains substantially constant at all depths. The composite material properties required are: outer skins that are tough, flexible and free of pin holes; an open foam internal structure capable of resisting, without significant dimensional change, the relatively small pressure changes that occur over the height of a man; and a high bond strength.Samples of a composite material that meets these requirements have been developed, and a prototype suit has been successfully fabricated by conventional techniques.     

Harpacticoida taxocen diversity in the silty-sandy littoral zone of Kandalaksha Bay of the White Sea

The fauna composition, ecological groups, and life forms of Harpacticoids of soft littoral grounds from 15 sites off the Karelian coast in Kandalaksha Bay of the White Sea were studied. Six types of harpacticoid taxocens with different sets of dominating species are described. On silty sands with clear signs of desalination, the Stenchelia palustris taxocen is common; medium-grained sands are characterized by the Heterolaophonte minuta, Paraleptastacus kliei — Huntemannia jadensis, and Amphiascoides nanus — Scottopsyllus minor taxocens; while on coarse sands, the Ameira parvula and Ameira scotti — Mesochra lilljeborgi taxocens have developed. The diversity of the taxocens is partly explained by the differences in the grain-size composition and salinity at different sites. In addition, groups of various taxocens dwelling on the same type of the sediments were found in different minor bights of the coastline.