Random dynamic analysis of multi-body offshore structures

A general method for the dynamic analysis of multi-body offshore structures is presented, being based on a constraint matrix approach. A method of deriving the constraint matrix for a general structure is given, and this is then used to derive the equations of motion of a whole system from those of it's component parts. The response of the system to both first and second order random wave forces is found and then used to calculate the forces and moments in the connecting mechanisms. The structure is assumed to have rigid component parts and a linearised frequency domain analysis method is used, although other methods are discussed. To illustrate it's use, the method is applied to both the SBS and Yoke-CALM design of offshore mooring terminal.     

Estimation of winds over the sea from land-based measurements

Simultaneous measurements of wind velocities at two different sites, one over the sea and the other over land, can differ substantially and therefore cannot be interchanged. In situations where the wind data at an offshore site are missing while simultaneous measurements from a land-based station exist, a linear mean-square estimation (LMSE) technique can be used to estimate the missing data. This technique relies on past wind data gathered simultaneously at the two locations, and it generates from the associated correlation a set of four transfer functions capable of predicting one data set from the other. In the present case, the LMSE technique is outlined briefly, and is then applied to construct seasonal transfer functions between a land-based station and two coastal/offshore sites in Kuwait. Comparisons between the actually observed wind characteristics and those predicted by the LMSE technique are favorable, and thus tend to confirm the applicability of the technique under appropriate conditions.     

A densely sampled core and climate variable aliasing

Undersampled records are susceptible to aliasing, in which a high frequency appears incorrectly as a lower one. We study the sampling requirements in a core taken from Rockall Trough using bulk density, P-wave velocity, and magnetic susceptibility as measured on an automated system. At 2-cm spacing (approximately 33 years in this core), all variables show a characteristic red-noise behavior, but with a spectral slope that is sufficiently weak so that significant aliasing appears to be present. P-wave velocity shows the largest potential corruption, probably owing to the weaker spatial averaging present in the sensor. Approximately 50% of the apparent low-frequency energy is aliased in all variables at some frequencies in both quiet and active regions of the record. In this core, a sampling interval of 0.2 cm appears to be "safe" in both active and quiet portions of the core, aliasing little or no energy, except in the P-wave record. For cores of different duration, sampling interval, and measurement type, the considerations will be identical, the importance of the problem depending directly upon the shape of the overall spectrum describing the entire frequency (wavenumber) range of physical variability.     

Physical and biological factors influencing the spatial distribution of age-0 walleye pollock (Theragra chalcogramma) around the Pribilof Islands, Bering Sea

The waters around the Pribilof Islands, in the southeast Bering Sea, are a main nursery area for age-0 pollock. Each summer, the islands are surrounded by a well-mixed inshore region, separated from a stratified offshore region by a frontal zone. To study the spatial distribution of age-0 pollock around this frontal structure in relation to physical and biological factors that are likely to influence it, such as advection, age-0 pollock feeding, and predation, samples were collected during September of four consecutive years, 1994–97, along two transects. Samples collected included water column hydrography and currents, acoustic backscatter, and groundfish predator density.Our analysis suggested that different mechanisms may be involved in controlling age-0 pollock distribution north and south of the islands. On the shelf area north of the islands, high age-0 pollock density was significantly associated with areas of high potential for growth only in years or portions of the frontal transect in which predator numbers were relatively low, indicating the importance of predation in controlling fish distribution in this area. In contrast, south of the islands, age-0 pollock distribution was associated more with prey availability, which appeared to be determined by vertical spatial overlap between predators and prey. Moreover, south of the islands, the stronger geostrophic currents, typical of the slope region, were more likely to affect the overall standing biomass of juvenile pollock, by constantly advecting fish away from the area.     

Meanders in the Antarctic Polar Frontal Zone and their impact on phytoplankton

The Antarctic Polar Front is a complex set of meandering jets, which appear to support enhanced primary productivity. The US Joint Global Ocean Flux Study conducted a series of survey and process studies in part to study the processes regulating primary productivity in this high nutrient, low chlorophyll region. We deployed a set of surface velocity drifters, some of which were equipped with bio-optical sensors, to study the temporal and spatial scales of biological and physical processes in the Antarctic Polar Frontal Zone. There were two primary sets of deployments: November 1997 before the spring bloom and January 1998 after the spring bloom. The November deployment revealed a strong spring bloom that lasted about 10 days. In late spring, when incoming solar radiation began to increase, the vertical motions associated with the meanders strongly affected the accumulation of phytoplankton biomass, primarily through their impact on light availability. Weaker meandering was observed in the January deployment, and chlorophyll values remained relatively constant. As the bloom began to decay, it appears that nutrient availability became more important in regulating phytoplankton photosynthesis. Some of the drifters in the November deployment were deployed in coherent clusters, thus allowing us to calculate vertical velocities associated with the meanders. Estimates of fluorescence/chlorophyll suggest that areas of upwelling and downwelling alternately decrease and increase photosynthetic stress, perhaps as a result of changes in the availability of iron or light during the formation of the bloom.     

An experimental pressure compensated wet suit

Personal thermal insulation by means of neoprene from wet suits provides adequate temporary control of body heat loss only at the shallow end of the air diving depth range, but it constitutes by far the most popular approach to diver thermal support. Howewer, compression of the trapped gas phase in neoprene foam seriously reduces its insulation performance on exposure to high ambient pressure. With conventional wet suits equipped with heating, the necessary level of power required at depths greater than about 30 m is too high, and also unsafe without the back up that increased insulation would provide. One approach to the goal of depth-insensitive insulation is to use a wet suit with a continuous internal gas space pressurized nominally to ambient pressure, so that its thickness remains substantially constant at all depths. The composite material properties required are: outer skins that are tough, flexible and free of pin holes; an open foam internal structure capable of resisting, without significant dimensional change, the relatively small pressure changes that occur over the height of a man; and a high bond strength.Samples of a composite material that meets these requirements have been developed, and a prototype suit has been successfully fabricated by conventional techniques.     

Harpacticoida taxocen diversity in the silty-sandy littoral zone of Kandalaksha Bay of the White Sea

The fauna composition, ecological groups, and life forms of Harpacticoids of soft littoral grounds from 15 sites off the Karelian coast in Kandalaksha Bay of the White Sea were studied. Six types of harpacticoid taxocens with different sets of dominating species are described. On silty sands with clear signs of desalination, the Stenchelia palustris taxocen is common; medium-grained sands are characterized by the Heterolaophonte minuta, Paraleptastacus kliei — Huntemannia jadensis, and Amphiascoides nanus — Scottopsyllus minor taxocens; while on coarse sands, the Ameira parvula and Ameira scotti — Mesochra lilljeborgi taxocens have developed. The diversity of the taxocens is partly explained by the differences in the grain-size composition and salinity at different sites. In addition, groups of various taxocens dwelling on the same type of the sediments were found in different minor bights of the coastline.     

Interstitial water chemistry of villefranche bay sediments: Trace metal diagenesis

Pore water aliquots were taken with an in situ close interval sampler: the “Peeper”.We report here the pore water concentration profiles of TCO₂, SO₄, TH₂S, Ca and the trace metals Mn, Cu, Pb, Cd and Cr from sediments of a relatively polluted area, the Villefranche Bay, on the French Riviera (close to Nice).We investigated the major ion concentrations in order to establish geochemical mass balances of organic matter oxidation. ΔTCO₂/ΔSO₄ was <−2.0, reflecting the precipitation of calcite as confirmed by the calcium profile. Reduction of sulfate led to increasing sulfide concentrations with depth.Trace metal interstitial water concentrations decreased from 63 to 5 nM, 18 to 4 nM and 6.6 to less than 2 nM for Cu, Pb and Cr, respectively. Cd showed a different pattern with top and deep values of 0.7 nM and a minimum of 0.27 nM.Thermodynamic calculations were performed which suggest the potential formation of mineral phases such as sulfides.