Quick-look assessments to identify optimal CO2 EOR storage sites

A newly developed, multistage quick-look methodology allows for the efficient screening of an unmanageably large number of reservoirs to generate a workable set of sites that closely match the requirements for optimal CO₂ enhanced oil recovery (EOR) storage. The objective of the study is to quickly identify miscible CO₂ EOR candidates in areas that contain thousands of reservoirs and to estimate additional oil recovery and sequestration capacities of selected top options through dimensionless modeling and reservoir characterization. Quick-look assessments indicate that the CO₂ EOR resource potential along the US Gulf Coast is 4.7 billion barrels, and CO₂ sequestration capacity is 2.6 billion metric tons. In the first stage, oil reservoirs are screened and ranked in terms of technical and practical feasibility for miscible CO₂ EOR. The second stage provides quick estimates of CO₂ EOR potential and sequestration capacities. In the third stage, a dimensionless group model is applied to a selected set of sites to improve the estimates of oil recovery and storage potential using appropriate inputs for rock and fluid properties, disregarding reservoir architecture and sweep design. The fourth stage validates and refines the results by simulating flow in a model that describes the internal architecture and fluid distribution in the reservoir. The stated approach both saves time and allows more resources to be applied to the best candidate sites.     

On CO<Subscript>2</Subscript> fluid flow and heat transfer behavior in the subsurface,following leakage from a geologic storage reservoir

Geologic storage of CO₂ is expected to produce plumes of large areal extent, and some leakage may occur along fractures, fault zones, or improperly plugged pre-existing wellbores. A review of physical and chemical processes accompanying leakage suggests a potential for self-enhancement. The numerical simulations presented here confirm this expectation, but reveal self-limiting features as well. It seems unlikely that CO₂ leakage could trigger a high-energy run-away discharge, a so-called “pneumatic eruption,” but present understanding is insufficient to rule out this possibility. The most promising avenue for increasing understanding of CO₂ leakage behavior is the study of natural analogues.     

Screening and ranking framework for geologic CO<Subscript>2</Subscript> storage site selection on the basis of health,safety, and environmental risk

A screening and ranking framework (SRF) has been developed to evaluate potential geologic carbon dioxide (CO₂) storage sites on the basis of health, safety, and environmental (HSE) risk arising from CO₂ leakage. The approach is based on the assumption that CO₂ leakage risk is dependent on three basic characteristics of a geologic CO₂ storage site: (1) the potential for primary containment by the target formation; (2) the potential for secondary containment if the primary formation leaks; and (3) the potential for attenuation and dispersion of leaking CO₂ if the primary formation leaks and secondary containment fails. The framework is implemented in a spreadsheet in which users enter numerical scores representing expert opinions or published information along with estimates of uncertainty. Applications to three sites in California demonstrate the approach. Refinements and extensions are possible through the use of more detailed data or model results in place of property proxies.     

Seal integrity and feasibility of CO<Subscript>2</Subscript> sequestration in the Teapot Dome EOR pilot: geomechanical site characterization

This paper reports a preliminary investigation of CO₂ sequestration and seal integrity at Teapot Dome oil field, Wyoming, USA, with the objective of predicting the potential risk of CO₂ leakage along reservoir-bounding faults. CO₂ injection into reservoirs creates anomalously high pore pressure at the top of the reservoir that could potentially hydraulically fracture the caprock or trigger slip on reservoir-bounding faults. The Tensleep Formation, a Pennsylvanian age eolian sandstone is evaluated as the target horizon for a pilot CO₂ EOR-carbon storage experiment, in a three-way closure trap against a bounding fault, termed the S1 fault. A preliminary geomechanical model of the Tensleep Formation has been developed to evaluate the potential for CO₂ injection inducing slip on the S1 fault and thus threatening seal integrity. Uncertainties in the stress tensor and fault geometry have been incorporated into the analysis using Monte Carlo simulation. The authors find that even the most pessimistic risk scenario would require ∼10 MPa of excess pressure to cause the S1 fault to reactivate and provide a potential leakage pathway. This would correspond to a CO₂ column height of ∼1,500 m, whereas the structural closure of the Tensleep Formation in the pilot injection area does not exceed 100 m. It is therefore apparent that CO₂ injection is not likely to compromise the S1 fault stability. Better constraint of the least principal stress is needed to establish a more reliable estimate of the maximum reservoir pressure required to hydrofracture the caprock.     

Applications of particle-tracking techniques to bank infiltration: a case study from El Paso,Texas, USA

This paper presents results of a small scale study that utilized particle-tracking techniques to evaluate transport of river water through an alluvial aquifer in a bank infiltration testing site in El Paso, Texas, USA. The particle-tracking survey was used to better define filtration parameters. Several simulations were generated to allow visualization of the effects of well placement and pumping rate on flow paths, travel time, the size of the pumping influence zone, and proportion of river-derived water and groundwater mixing in the pumping well. Simulations indicate that migration of river water into the aquifer is generally slow. Most water does not arrive at the well by the end of an 18-day pumping period at 0.54 m³/min pumping rate for a well located 18 m from the river. Forty-four percent of the water pumped from the well was river water. The models provided important information needed to design appropriate sampling schedules for bank filtration practices and ensured meeting adequate soil-retention times. The pumping rate has more effect on river water travel time than the location of the pumping well from the river. The examples presented in this paper indicate that operating the pumping well at a doubled distance from the river increased the time required for the water to travel to the well, but did not greatly change the capture zone.     

Evaluation of geochemical impact of tsunami on Pichavaram mangrove ecosystem,southeast coast of India

The 26 December 2004-tsunami has deposited sediments in the Pichavaram mangrove ecosystem, east coast of India. Ten surface and three core sediment samples were collected within 30 days of the event and analyzed for nutrients. Water samples were also analyzed to see the impact of tsunami on the geochemical behavior of nutrients. An increase in the concentration of various nutrients namely nitrate and phosphate was observed. The geochemistry of the mangrove forest was observed to be influenced by a number of factors like rapid increase of aquaculture farms, agricultural practices and the anthropogenic discharge from the nearby-inhabited areas. Further the sediment column was disturbed due to energetic tsunami waves, which has caused a sheer increase in the dissolved oxygen in water. As a result, the change in the redox potential has resulted in change in the nutrients absorbed/associated with the sediments. In addition, role of retreating water after tsunami on the nutrient geochemistry was also evaluated.     

Wind wave-forced fine sediment erosion during the slack water periods in Hangzhou Bay,China

The shallow water wave simulation model-SWAN incorporated with a simple fine sediment erosion model is applied to Hangzhou Bay, China, to model the horizontal distribution of the maximum bottom orbital velocity and corresponding fine sediment erosion rates induced by: (1) southeasterly steady winds (5, 20 and 30 m/s), (2) southwesterly steady winds (5 and 20 m/s); (3) northwesterly steady winds (5 and 20 m/s); (4) east-southeasterly steady winds (5 and 20 m/s); (5) easterly steady winds (5 and 20 m/s) under closed and unclosed boundaries; and (6) unsteady winds during the slack water periods. Results suggest: (1) the steady wind wave-induced maximum bottom orbital velocities and corresponding fine sediment erosion rates generally increased with the increasing steady winds; (2) closed and unclosed boundary conditions had more significant influences on modeled fine sediment erosion rates under 5 m/s easterly steady winds than 20 m/s; and (3) steady and unsteady wind wave-induced maximum bottom currents could be significant in eroding fine sediment bed in Hangzhou Bay. The results show implications for geomorphology, sedimentology, coastal erosion, and environmental pollution mitigation in Hangzhou Bay.     

Potential for localized groundwater contamination in a porous pavement parking lot setting in Rhode Island

The control of polluted surface runoff and the assessment of possible impacts on groundwater is a concern at the local and regional scale. On this background, a study investigates possible impacts of organic and inorganic pollutants (including bacteria) originating from a permeable asphalt parking lot on the water quality immediately beneath it. The functioning of the permeable pavement, including clogging and restricted vertical percolation, was also evaluated. Four nested sample ports (shallow and deep) were installed below low- and high-traffic areas, including one port outside the parking lot. At least initially there was a good hydraulic connection between the parking surface and the shallow sample ports. The presence of a geotextile layer at the base of the parking lot structure, however, was identified in lab tests as one factor restricting vertical percolation to the deeper ports. Clogging of the permeable surface was most pronounced in heavy traffic areas and below snow pile storage areas. Corroborated by high electric conductivity and chloride measurements, sand brought in by cars during winter was the principal cause for clogging. No bacteria or BOD were found in percolating water. Polycyclic aromatic hydrocarbons (PAH) were present at concentrations near minimum detection limit. Nutrients (nitrate and phosphate) were being leached into the ground via the permeable parking lot surface at annual flux rates of 0.45–0.84 g/m²/year. A multi-species tracer test demonstrated a retention capacity of the permeable parking lot structure of >90% for metals and 27% for nutrients, respectively.     

Problems of soil and groundwater pollution in the disposal of “marble” slurries in NW Sicily

This work deals with disposal of slurries generated during the cutting and polishing processes of slabs of decorative sedimentary carbonate rocks in the north western Sicily. At present, they are used as fillers of dismantled quarries near the sawmills and, as a final step of reclamation, are covered with earth layers. In spite of such inexpensive solution, there is lack of knowledge about the composition of the waste. In order to assess if there is any threat for the environment and to suggest indications for alternative solutions, such as recycling or inactivation processes, the slurries were analysed by XR diffraction, simultaneous thermal analysis, ICP/MS, ionic chromatography, FTIR, UV-Vis, COD and TOC measurements, grain size analysis. Results indicate that the slurries can threaten the groundwater, because of the high chemical oxygen demand; furthermore they can modify the mechanism of groundwater recharge, because of their grain size distribution. Some laboratory tests show that, even in very aggressive conditions, the solid pollutants persist in the waste and slowly release into water the products of their degradation. The slurry therefore should be subjected to inactivation treatment before disposal or, alternatively, recycled as secondary raw material for a suitable process.