Total mercury,methyl mercury and sulphide in river carron sediments

Total mercury, methyl mercury and sulphide contents of River Carron sediments (Lothian, Scotland) have been determined. Total mercury concentrations are comparable to other mercury polluted estuaries in the UK, but the methyl mercury values for low-sulphide Carron sediments are generally higher. It has been found that methyl mercury levels are initially in direct proportion to the sulphide concentrations of the sediments but beyond sulphide concentrations of 1.8 mg g^?1 the methyl mercury levels decline sharply.     

Multiscale characterization of a heterogeneous aquifer using an ASR operation

Heterogeneity in the physical properties of an aquifer can significantly affect the viability of aquifer storage and recovery (ASR) by reducing the recoverable proportion of low-salinity water where the ambient ground water is brackish or saline. This study investigated the relationship between knowledge of heterogeneity and predictions of solute transport and recovery efficiency by combining permeability and ASR-based tracer testing with modeling. Multiscale permeability testing of a sandy limestone aquifer at an ASR trial site showed that small-scale core data give lower-bound estimates of aquifer hydraulic conductivity (K), intermediate-scale downhole flowmeter data offer valuable information on variations in K with depth, and large-scale pumping test data provide an integrated measure of the effective K that is useful to constrain ground water models. Chloride breakthrough and thermal profiling data measured during two cycles of ASR showed that the movement of injected water is predominantly within two stratigraphic layers identified from the flowmeter data. The behavior of the injectant was reasonably well simulated with a four-layer numerical model that required minimal calibration. Verification in the second cycle achieved acceptable results given the model's simplicity. Without accounting for the aquifer's layered structure, high precision could be achieved on either piezometer breakthrough or recovered water quality, but not both. This study demonstrates the merit of an integrated approach to characterizing aquifers targeted for ASR.     

Finite difference modeling of contaminant transport using analytic element flow solutions

The two-dimensional implementation of the analytic element method (AEM) is commonly used to simulate steady-state saturated groundwater flow phenomena at regional and local scales. However, unlike alternative groundwater flow simulation methods, AEM results are not ordinarily used as the basis for simulation of reactive solute transport. The use of AEM-simulated flow fields is impeded by the discrepancy between a continuous representation of flow and a typically discrete representation of transport, and requires translation of the flow solution to a discrete analog. This paper presents a variety of methods for analytically calculating conservative discrete water fluxes and integrated components of the dispersion tensor across cell interfaces. An Eulerian finite difference method based on these AEM-derived parameters is implemented for use in simulation of 2D (vertically averaged) solute transport. This implementation is first benchmarked against existing methods that use standard finite difference flow solutions, then used to investigate the effects of an inaccurate discrete water balance. It is shown that improper translation of AEM fluxes leads to significant water balance errors and inaccurate simulation of contaminant transport.     

GEOSECS AtlanticSi profiles

Measurements of five cosmogenic³²Si vertical profiles in Atlantic waters (27°N to 60°S) are presented. The amounts of dissolved SiO₂ extracted range from 2 to 54 g; the amounts of water from which SiO₂ was extracted range between 540 kg and 270, 000 kg. In additon, SiO₂ recovered from four surface particulate composites (64°N to 61°S) were also analyzed for³²Si.³²Si measurements were made by milking and counting the daughter activity, ³²P. The net³²P activities range from 0.7 to 6.8 cph; typical errors in measurements of the³²P activities are 20–30%.The³²Si concentrations vary from 0.6 dpm/10⁶ kg of water in the North Atlantic surface waters to 235 dpm/10⁶ kg at 400 m depth in the circumpolar waters. The vertical profiles of³²Si at the five Atlantic stations approximately follow the Si profiles but the depth gradients are different. This would be expected also considering the in-situ release mechanisms due to dissolution and advection/diffusion from the bottom waters. Except for the circumpolar station 89, where the Si and³²Si profiles show the effect of marked vertical mixing (nearly depth independent profiles), the profiles show the following features: (1) specific activities of³²Si (³²Si/SiO₂ ratios) are lowest at intermediate depths, and (2) on an average the surface specific activities are higher, by 2–4 times, than the bottom water values. These data are consistent with generation of the highest specific activity³²Si waters at the surface, where Si concentrations are lowest and precipitation adds cosmogenic³²Si scavenged from the troposphere. Rapid removal of biogenic silica to the water-sediment interface, without much dissolution during transit, leads to the second regime of high³²Si specific activities.The³²Si inventories in the water column in the latitude belt 27°N-27°S are in the range (1–1.4) × 10⁻² dpm³²Si/cm², which is consistent with the expected fallout of cosmogenic³²Si. However, the³²Si column inventories south of 40°S are higher by a factor of 5–7, whereas the corresponding Si inventories increase by only a factor of 3. This excess³²Si in the Southern Ocean cannot be explained by direct fallout from the stratosphere or by melting of Antarctic snow and ice. Instead, this excess is maintained primarily by the southward deep-water transport of³²Si dissolved from sinking particulates.     

Estimating Flow Using Tracers and Hydraulics in Synthetic Heterogeneous Aquifers

Regional ground water flow is most usually estimated using Darcy's law, with hydraulic conductivities estimated from pumping tests, but can also be estimated using ground water residence times derived from radioactive tracers. The two methods agree reasonably well in relatively homogeneous aquifers but it is not clear which is likely to produce more reliable estimates of ground water flow rates in heterogeneous systems. The aim of this paper is to compare bias and uncertainty of tracer and hydraulic approaches to assess ground water flow in heterogeneous aquifers. Synthetic two-dimensional aquifers with different levels of heterogeneity (correlation lengths, variances) are used to simulate ground water flow, pumping tests, and transport of radioactive tracers. Results show that bias and uncertainty of flow rates increase with the variance of the hydraulic conductivity for both methods. The bias resulting from the nonlinearity of the concentration–time relationship can be reduced by choosing a tracer with a decay rate similar to the mean ground water residence time. The bias on flow rates estimated from pumping tests is reduced when performing long duration tests. The uncertainty on ground water flow is minimized when the sampling volume is large compared to the correlation length. For tracers, the uncertainty is related to the ratio of correlation length to the distance between sampling wells. For pumping tests, it is related to the ratio of correlation length to the pumping test's radius of influence. In regional systems, it may be easier to minimize this ratio for tracers than for pumping tests.