Observation of azimuthal anisotropy from the seismic reflectivity of a Tertiary turbidite sand

P‐wave data from a time‐lapse 3D OBC survey have been analysed to estimate and interpret azimuthal seismic anisotropy. This is achieved by careful processing to preserve the azimuthal signature. The survey images a major reservoir body in a channelized turbidite field in the Gulf of Mexico. Three distinct and significant anisotropy anomalies are discovered on or around this particular ‘4500‐ft sand’, all of which change intensity but not orientation with hydrocarbon production. These anomalies are distributed along the highest concentration of cumulative sand thickness, with their symmetry axes aligned with the main channel axis. We suspect that this time‐lapse anisotropy could be caused by the alignment of the depositional grain fabric. Theoretical calculation predicts that this mechanism, when combined with fluid‐saturation changes, can generate the observed pattern of behaviour. If further supported by other researchers, this result would indicate that appropriately designed seismic surveys could be a useful tool for palaeo‐direction studies in clastic reservoirs and also a useful constraint for directional permeability in the reservoir flow simulation model.     

Morphodynamics of a bedrock‐alluvial meander bend that incises as it migrates outward: approximate solution of permanent form

In meandering rivers cut into bedrock, erosion across a channel cross‐section can be strongly asymmetric. At a meander apex, deep undercutting of the outer bank can result in the formation of a hanging cliff (which may drive hillslope failure), whereas the inner bank adjoins a slip‐off slope that connects to the hillslope itself. Here we propose a physically‐based model for predicting channel planform migration and incision, point bar and slip‐off slope formation, bedrock abrasion, the spatial distribution of alluvial cover, and adaptation of channel width in a mixed bedrock‐alluvial channel. We simplify the analysis by considering a numerical model of steady, uniform bend flow satisfying cyclic boundary conditions. Thus in our analysis, ‘sediment supply’, i.e. the total volume of alluvium in the system, is conserved. In our numerical simulations, the migration rate of the outer bank is a specified parameter. Our simulations demonstrate the existence of an approximate state of dynamic equilibrium corresponding to a near‐solution of permanent form in which a bend of constant curvature, width, cross‐sectional shape and alluvial cover distribution migrates diagonally downward at constant speed, leaving a bedrock equivalent of a point bar on the inside of the bend. Channel width is set internally by the processes of migration and incision. We find that equilibrium width increases with increasing sediment supply, but is insensitive to outer bank migration rate. The slope of the bedrock point bar varies inversely with both outer bank migration rate and sediment supply. Although the migration rate of the outer bank is externally imposed here, we discuss a model modification that would allow lateral side‐wall abrasion to be treated in a manner similar to the process of bedrock incision. Copyright © 2016 John Wiley & Sons, Ltd.     

Measurement of the spatial distribution of fluvial bedload transport velocity in both sand and gravel

Maps are presented of the spatial distribution of two‐dimensional bedload transport velocity vectors. Bedload velocity data were collected using the bottom tracking feature of an acoustic Doppler current pro?ler (aDcp) in both a gravel‐bed reach and a sand‐bed reach of Fraser River, British Columbia. Block‐averaged bedload velocity vectors, and bedload velocity vectors interpolated onto a uniform grid, revealed coherent patterns in the bedload velocity distribution. Concurrent Helley‐Smith bedload sampling in the sand‐bed reach corroborated the trends observed in the bedload velocity map. Contemporaneous 2D vector maps of near‐bed water velocity (velocity in bins centered between 25 cm and 50 cm from the bottom) and depth‐averaged water velocity were also generated from the aDcp data. Using a vector correlation coef?cient, which is independent of the choice of coordinate system, the bedload velocity distribution was signi?cantly correlated to the near‐bed and depth‐averaged water velocity distributions. The bedload velocity distribution also compared favorably with variations in depth and estimates of the spatial distribution of shear stress. Published in 2004 by John Wiley & Sons, Ltd.     

Quantifying potential propagule pressure of aquatic invasive species from the commercial shipping industry in Canada

We quantify and compare different measures of potential propagule pressure (PPP) of aquatic invasive species (AIS) from commercial vessels in Canada. We used ship arrivals and ballast water discharge volumes as proxies for PPP from ballast water organisms, and wetted surface area (WSA) as a proxy for hull fouling PPP, to determine their relative contributions to total PPP. For three regions studied, PPP proxies correlated significantly across ports and some vessel categories. Relative contributions of ship arrivals, ballast discharge, and WSAs to PPP, evidenced by non-significant correlations across these measures, varied across regions, ports, vessel types, and seasons. Flow-through (dominant on east and west coasts) and empty-refill (in Great Lakes-St. Lawrence region) were the major ballast water exchange methods employed by the vessels surveyed. These methods have different biological efficacy for AIS removal, influencing PPP. Our study illustrates benefits and limitations of using different PPP proxies to estimate invasion risk.     

Aminostratigraphy and thermoluminescence dating of coastal aeolianites and the later Quaternary history of a failed delta: The River Murray mouth region,South Australia

A geochronological framework for the sequential development of coastal barrier aeolianite complexes in the mouth region of the River Murray, Australia's largest river system is presented based on amino acid racemization and thermoluminescence dating. The sedimentary successions represent a foreshortened and condensed sequence of coastal barriers compared with those of the Coorong Coastal Plain in southern South Australia where the barrier complexes are more widely separated in response to tectonic uplift. The barriers have formed during interglacial sea-level highstands and are correlatives of genetically equivalent landforms of the Coorong Coastal Plain. Thermoluminescence dating and the extent of amino acid racemization in aeolianite ‘whole-rock’ sediment samples, reveal a general increase in age of the barriers landwards from the modern coastline. In detail, however, the individual barriers represent composite structures having formed in more than one interglaciation, due to the reoccupation of Pleistocene shoreline positions during sea-level highstands of similar amplitude, in a zone of gradual basin subsidence. The most seaward Pleistocene aeolianite at Surfer Beach is of interstadial age (Marine Isotope Stage 5c, 105 ± 5 ka; MIS 5c), and correlates with the Robe Range of the Coorong Coastal Plain. The last interglacial shoreline (130 ± 15 ka; MIS 5e) is particularly well-defined in the River Murray mouth region. It is represented by a complex association of coastal parabolic dunes superimposed on a transverse dune system, which runs parallel with the former coastline, and also includes associated estuarine, lagoonal and open ocean beach facies. Landward of the last interglacial succession are distinct barriers relating to the penultimate interglaciation (215 ± 35 ka; MIS 7), as well as earlier interglaciations (350 ± 65 ka; MIS 9 or 11 and 470 ± 70 ka; MIS 11 or 13). The coastal barriers have been successively breached by the ancestral River Murray at times of lower sea level during glacial cycles. Former mouths of the River Murray during interglacial sea-level highstands are likely to have existed near Tauwitchere Island during MIS 7, and between Goolwa and Hindmarsh Island and near the southern-most part of Lake Albert during the last interglacial (MIS 5e). The River Murray mouth region represents a failed delta as the limited sediment brought to this area since late middle Pleistocene time has been either rapidly incorporated within aeolian deposits during sea-level highstands, or transported to the edge of the Lacepede Shelf during glacial maxima. The Holocene and modern River Murray has not established a marine delta, but deposits its load in the settling basins of the terminal lakes. Only a small digitate delta has formed where the river enters Lake Alexandrina.     

Hydrological response characteristics of Mediterranean catchments at different time scales: a meta-analysis

ABSTRACT

This work examines 140 hydrological studies conducted in the Mediterranean region. It identifies key characteristics of the hydrological responses of Mediterranean catchments at various time scales and compares different methods and modelling approaches used for individual-catchment studies. The study area is divided into the northwestern (NWM), eastern (EM) and southern (SM) Mediterranean. The analysis indicates regional discrepancies in which the NWM shows the most extreme rainfall regime. A tendency for reduced water resources driven by both anthropogenic and climatic pressures and a more extreme rainfall regime are also noticeable. Catchments show very heterogeneous responses over time and space, resulting in limitations in hydrological modelling and large uncertainties in predictions. However, few models have been developed to address these issues. Additional studies are necessary to improve the knowledge of Mediterranean hydrological features and to account for regional specificities.

Editor D. Koutsoyiannis Associate editor A. Efstratiadis     

Gravel‐bed rivers: from particles to patterns

The papers in this special issue reflect several of the major themes and topics from the 7^th International Workshop on Gravel‐Bed Rivers. The papers focus primarily on aspects of bed material transport in gravel‐bed rivers and larger scale morpho‐dynamics. Research in gravel‐bed rivers is increasingly integrating processes over a wide range of temporal and spatial scales by combining field observation, lab experimentation, numerical modeling and theory testing in a range of river types, aided by new technological developments in particle tracking, computational modeling and high resolution spatial data. This is leading to greater understanding of the processes leading to distinctive morpho‐dynamics of river types and a more reliable basis for river management. Copyright © 2012 John Wiley & Sons, Ltd.     

Application of a multi‐temporal,LiDAR‐derived,digital terrain model in a landslide‐volume estimation

Sediments produced by landslides are crucial in the sediment yield of a catchment, debris flow forecasting, and related hazard assessment. On a regional scale, however, it is difficult and time consuming to measure the volumes of such sediment. This paper uses a LiDAR‐derived digital terrain model (DTM) taken in 2005 and 2010 (at 2 m resolution) to accurately obtain landslide‐induced sediment volumes that resulted from a single catastrophic typhoon event in a heavily forested mountainous area of Taiwan. The landslides induced by Typhoon Morakot are mapped by comparison of 25 cm resolution aerial photographs taken before and after the typhoon in an 83.6 km² study area. Each landslide volume is calculated by subtraction of the 2005 DTM from the 2010 DTM, and the scaling relationship between landslide area and its volume are further regressed. The relationship between volume and area are also determined for all the disturbed areas (V_L = 0.452A_L^1.242) and for the crown areas of the landslides (V_L = 2.510A_L^1.206). The uncertainty in estimated volume caused by use of the LiDAR DTMs is discussed, and the error in absolute volume estimation for landslides with an area >10⁵ m² is within 20%. The volume–area relationship obtained in this study is also validated in 11 small to medium‐sized catchments located outside the study area, and there is good agreement between the calculation from DTMs and the regression formula. By comparison of debris volumes estimated in this study with previous work, it is found that a wider volume variation exists that is directly proportional to the landslide area, especially under a higher scaling exponent. Copyright © 2013 John Wiley & Sons, Ltd.     

Sensitivity of the elastic anisotropy and seismic reflection amplitude of the Eagle Ford Shale to the presence of kerogen

The Eagle Ford Shale of Central and South Texas is currently of great interest for oil and gas exploration and production. Laboratory studies show that the Eagle Ford Shale is anisotropic, with a correlation between anisotropy and total organic carbon. Organic materials are usually more compliant than other minerals present in organic‐rich shales, and their shapes and distribution are usually anisotropic. This makes organic materials an important source of anisotropy in organic‐rich shales. Neglecting shale anisotropy may lead to incorrect estimates of rock and fluid properties derived from inversion of amplitude versus offset seismic data. Organic materials have a significant effect on the PP and PS reflection amplitudes from the Austin Chalk/Upper Eagle Ford interface, the Upper Eagle Ford/Lower Eagle Ford interface, and the Lower Eagle Ford/Buda Limestone interface. The higher kerogen content of the Lower Eagle Ford compared with that of the Upper Eagle Ford leads to a negative PP reflection amplitude that dims with offset, whereas the PS reflection coefficient increases in magnitude with increasing offset. The PP and PS reflection coefficients at the Austin Chalk/Upper Eagle Ford interface, the Upper Eagle Ford/Lower Eagle Ford interface, and the Lower Eagle Ford/Buda Limestone interface all increase in magnitude with increasing volume fraction of kerogen.     

High Resolution Radio Observations of Luminous IR Galaxies

High resolution radio observations provide a unique tool for investigation ofultraluminous infrared galaxies, due to the combination of high angularresolution and source transparency available at centimeter wavelengths. Thetypical angular size of the IR emitting region in the most luminous systems isof order 0.1 arcsec, while dust absorption appears to obscure this region fromdirect view at wavelengths shorter than 100 microns. Radio observationswith VLBI and MERLIN are revealing compact radio structures indicative of bothstarburst and AGN activity in these systems. Additional observations arerequired to clarify relationships between radio structures and the energygeneration mechanisms, and to realize the full potential of radio interferometryfor ULIRG studies.