End member and Bayesian mixing models consistently indicate near-surface flowpath dominance in a pristine humid tropical rainforest

The impacts of forest conversion on runoff generation in the tropics have received much interest, but scientific progress is still hampered by challenging fieldwork conditions and limited knowledge about runoff mechanisms. Here, we assessed the runoff generation, flow paths and water source dynamics of a pristine rainforest catchment in Costa Rica using end member mixing analysis (EMMA) and a Bayesian mixing model (MixSIAR). Geochemical tracer data collected over a 4-week field campaign were combined with tritium data used to assess potential deeper groundwater flow pathways to the perennial stream. The streamflow composition was best captured using three end-members, namely throughfall, shallow (5–15 cm) and deeper (15–50 cm) soil water. We estimated the end-member contributions to the main stream and two tributaries using the two mixing approaches and found good agreement between results obtained from EMMA and MixSIAR. The system was overwhelmingly dominated by near-surface sources, with little evidence for deeper and older groundwater as tritium-derived baseflow mean transit time was between 2.0 and 4.4 years. The shallow soil flow pathway dominated streamflow contributions in the main stream (median 39% and 49% based on EMMA and MixSIAR, respectively), followed by the deeper soil (32% and 31%) and throughfall (25% and 19%). The two tributaries had even greater shallow soil water contributions relative to the main stream (83% and 74% for tributary A and 42% and 63% for tributary B). Tributary B had no detectable deep soil water contribution, reflecting the morphology of the hillslope (steeper slopes, shallower soils and lower vegetation density compared to hillslope A). Despite the short sampling campaign and associated uncertainties, this study allowed to thoroughly assess runoff generation mechanisms in a humid tropical catchment. Our results also provide a first comparison of two increasingly used mixing models and suggest that EMMA and MixSIAR yield comparable estimates of water source partitioning in this tropical, volcanic rainforest environment.     

Key factors in vertical mixing processes in a reservoir bordering the Pantanal floodplain,Brazil

Abstract

The aim of this study was to understand seasonal variations in the vertical structure of the water column, and to quantify the importance of the physical forces (solar radiation, wind and hydraulic retention time) that control mixing processes in a reservoir bordering the Pantanal floodplain. Samples were taken every three months in the reservoir centre, at four depths, for the measurement of nine physical and chemical water quality parameters. The reservoir presented a long stratification period with complete mixing in winter. The vertical structure showed that, during the stratification period, the upper layers of the reservoir are homogeneous and the physical and chemical composition only changes at greater depths. The wind acting over an extended period is the only factor that significantly influences the vertical structure in the reservoir, giving rise to mixing processes. Moreover, the position of the draw-off point in the upper layer of the reservoir, together with the reservoir depth, enhances vertical stability.     

Assimilation of SeaWiFS chlorophyll data into a 3D-coupled physical–biogeochemical model applied to a freshwater-influenced coastal zone

In order to predict eutrophication events in coastal areas we tested an assimilation scheme based on sequential data assimilation of SeaWiFS chlorophyll data into a coupled 3D physical–biogeochemical model. The area investigated is a semi-enclosed estuarine system (Gulf of Fos–North-western Mediterranean Sea) closely linked to the Rhone River delta. This system is subjected to episodic eutrophication caused by certain hydrodynamic conditions and intermittent nutrient inputs. The 3D hydrodynamic model Symphonie was coupled to the biogeochemical modelling platform Eco3M. Surface chlorophyll concentrations were derived from SeaWiFS data using the OC5 algorithm and were sequentially assimilated using a singular evolutive extended Kalman filter. Assimilation efficiency was evaluated through an independent in situ data set collected during a field survey that took place in May 2001 (ModelFos cruise). An original approach was used in constructing the state vector and the observation vector. By assimilating pseudo-salinity extracted from the model biogeochemical dynamics in both open sea and plume region were respected. We proved that substantial improvements were made in short-term forecasts by integrating such satellite-estimated chlorophyll maps. We showed that missing freshwater inputs could be corrected to a certain extent by the assimilation process. Simulated concentrations of surface chlorophyll and other basic components of the pelagic ecosystem such as nitrates were improved by assimilating surface chlorophyll maps. Finally we showed the coherent spatial behaviour of the filter over the whole modelled domain.     

Two-stage prograde and retrograde Variscan metamorphism of glaucophane-eclogites, blueschists and greenschists from Ile de Groix (Brittany, France)

On Ile de Groix, Variscan metamorphic former tholeiitic and alkaline basalts occur as glaucophane-eclogites, blueschists and greenschists in isolated lenses and layers within metapelites. Whole-rock '¹⁸O_SMOW values of the metabasites show limited variations (10.4-12.0‰) and no systematic differences among rock types and metamorphic grades. This provides no argument for large-scale blueschist-to-greenschist transformation driven by infiltration of externally derived fluids. Metamorphic mineralogical changes should have been triggered by internal fluids. Element variations in interlayered blue- and greenschists can be attributed to magmatic fractionation. Assemblages with garnet, clinopyroxene and glaucophane of a high-pressure/low-temperature (HP-LT) metamorphism M1, and NaCa-amphiboles (barroisite, magnesiohornblende, actinolite) of a medium-pressure/medium-temperature metamorphism M2 crystallized during deformation D1. Detailed core-rim zonation profiles display increasing and then decreasing Al^IV in glaucophane of M1. NaCa-amphiboles of M2, mantling glaucophane and crystallized in porphyroblasts, show first increasing, then decreasing, Al^IV and Al^VI. Empirically calibrated thermobarometers allowed P-T path reconstructions. In glaucophane-eclogites of a metamorphic zone I, a prograde evolution to M1 peak conditions at 400-500°C/10-12 kbar was followed by a retrograde P-T path within the glaucophane stability field. The subsequent M2 evolution was again prograde up to >600°C at 8 kbar and then retrograde. Similarly, in metamorphic zones II and III, prograde and retrograde paths of M1 and M2 at lower maximal temperatures and pressures exist. The almost complete metamorphic cycle during M2 signalizes that the HP-LT rocks escaped from an early erosion by a moderate second burial event and explains the long-lasting slow uplift with low average cooling rates.     

Thrust sheet motion and earthquake mechanisms

The mechanism of thrust sheet motion and that of earthquake generation are two aspects of the same phenomenon. Studies of earthquake mechanisms show that only a part of the thrust fault, generally less than 10km in length, is in motion at any given instant; this part sweeps the length of the fault, moving at approximately 3 km/s. Since shear fracture propagation is inherently a dynamic phenomenon, it cannot be understood on the basis of the equations of static equilibrium. The previously proposed mechanisms all rest on such an equilibrium, which necessarily implies that the motion of a thrust sheet occurs simultaneously over its whole length; since the latter may exceed 100 km, the motion becomes a mechanical “enigma”. This enigma vanishes once the dynamic nature of the problem is recognized. The proposed mechanism also suggests that solution features on the fault result from the dissolution of barriers, thus explaining the motion of only part of a thrust sheet.     

Stability of Titanium Dioxide Nanoparticle Agglomerates in Transitional Waters and Their Effects Towards Plankton from Lagoon of Venice (Italy)

The present study explores the effect of salinity and dissolved organic carbon (DOC) gradients on the stability and reactivity of titanium dioxide nanoparticle (TiO₂-NP) agglomerates in ambient water from the Lagoon of Venice and their possible effect on nauplii sampled at the same locations. In all ambient water samples, TiO₂-NPs formed rapidly micrometre-sized agglomerates. The increase in the salinity and concomitant decrease in DOC content induced the formation of larger agglomerates, with z-average hydrodynamic diameter increasing with TiO₂-NP concentration and exposure duration. Under the studied conditions, ζ-potential exhibited negative values. In line with agglomeration results, enhancement of the salinity and lower DOC resulted in less negative ζ-potential with close to 0 values in the dispersions of 100 mg L^?1 TiO₂-NPs in sea water. Two-hour exposure to micrometre-sized agglomerates of TiO₂-NPs resulted in an increase in the fluorescence of propidium iodide (PI) stained nauplii in comparison with unexposed controls, but had no effect at 24-h exposure. The increase in nauplii-associated PI fluorescence was more noticeable in dispersions containing 100 mg L^?1 than those containing 10 mg L^?1 TiO₂-NPs, suggesting membrane permeability alteration in a concentration-dependent manner. However, the PI staining results have to be interpreted with caution because of the possible dye binding to the nauplii surface without penetration of cellular membrane. The effect of TiO₂-NPs on nauplii was more pronounced at higher salinity and decreased with increasing DOC concentrations at 2 h, while no trends were found at 24-h exposure, as well as exposure to 100 mg L^?1 TiO₂-NPs.     

Impacts of forest conversion and agriculture practices on water pathways in Southern Brazil

Land‐use/cover change (LUCC), and more specifically deforestation and multidecadal agriculture, is one of the various controlling factors of water fluxes at the hillslope or catchment scale. We investigated the impact of LUCC on water pathways and stream stormflow generation processes in a subtropical region in southern Brazil. We monitored, sampled and analysed stream water, pore water, subsurface water, and rainwater for dissolved silicon concentration (DSi) and ¹⁸O/¹⁶O (δ¹⁸O) signature to identify contributing sources to the streamflow under forest and under agriculture. Both forested and agricultural catchments were highly responsive to rainfall events in terms of discharge and shallow groundwater level. DSi versus δ¹⁸O scatter plots indicated that for both land‐use types, two run‐off components contributed to the stream discharge. The presence of a dense macropore network, combined with the presence of a compact and impeding B‐horizon, led to rapid subsurface flow in the forested catchment. In the agricultural catchment, the rapid response to rainfall was mostly due to surface run‐off. A 2‐component isotopic hydrograph separation indicated a larger contribution of rainfall water to run‐off during rainfall event in the agricultural catchments. We attributed this higher contribution to a decrease in topsoil hydraulic conductivity associated with agricultural practices. The chemical signature of the old water component in the forested catchment was very similar to that of the shallow groundwater and the pore soil water: It is therefore likely that the shallow groundwater was the main source of old water. This is not the case in the agricultural catchments where the old water component had a much higher DSi concentration than the shallow groundwater and the soil pore water. As the agricultural catchments were larger, this may to some extent simply be a scale effect. However, the higher water yields under agriculture and the high DSi concentration observed in the old water under agriculture suggest a significant contribution of deep groundwater to catchment run‐off under agriculture, suggesting that LUCC may have significant effects on weathering rates and patterns.     

SIMBOL-X: An hard X-ray formation flying mission

In 2004 and 2005 CNES decided to perform phase 0 studies on 4 scientific missions: ASPICS (Solar physics), MAX (γ-rays Laue lens), PEGASE (hot Jupiter study by an interferometer in the 2μm to 4.5μm range) and SIMBOL-X (hard X-rays telescope). This last mission had already undergone a feasibility study in 2003 (ref. [4]), however a complementary study was necessary to take into account the possibilities of increasing the payload mass allowance, as well as the developments in the payload design and science goals (see ref. [1]). The output of this new detailed study is described hereafter.