Derivative‐Assisted Classification of Fractured Zones Crossing a Deep Borehole

In this study, the derivative analysis using the derivative of drawdown with respect to log‐time was utilized to determine candidates for hydraulic conductor domains (HCDs). At a 500‐m deep borehole in the study site, the fractured rocks crossing the borehole were first classified in fractured and nonfractured zones by core logging and geophysical loggings, such as acoustic televiewing, density, and flow loggings. After conducting the hydraulic tests such as constant head withdrawal and recovery tests at the fractured zones and the nonfractured zones, the derivative analyses were carried out, of which the results were evaluated to determine the candidates for HCDs. For the nonfractured zones, the diagnostic plot has only a big hump indicating poor connection of the background fractures to the permeable geologic media, while those of the candidates for HCDs show various flow regimes. On the basis of these results, the candidates for HCDs among the fractured zones were determined. From discussion on the results, the combination of the spacing analysis and derivative analysis following a hydraulic test is recommended for determining the candidates for HCDs rather than other geophysical loggings.     

Estimation of non-CO2 GHGs emissions by analyzing burn severity in the Samcheok fire, South Korea

This study was performed to estimate the emission of non-CO 2 greenhouse gases(GHGs) from biomass burning at a large fire area.The extended methodology adopted the IPCC Guidelines(2003) equation for use on data from the Samcheok forest fire gathered using 30 m resolution Landsat TM satellite imagery,digital forest type maps,and growing stock information per hectare by forest type in 1999.Normalized burn ratio(NBR) technique was employed to analyze the area and severity of the Samcheok forest fire that occurred in 2000.The differences between NBR from pre-and post-fire datasets are examined to determine the extent and degree of change detected from burning.The results of burn severity analysis by dNBR of the Samcheok forest fire area revealed that a total of 16,200 ha of forest were burned.The proportion of the area characterized by a ’Low’ burn severity(dNBR below 152) was 35%,with ’Moderate’(dNBR 153-190) and ’High’(dNBR 191-255) areas were at 33% and 32%,respectively.The combustion efficiency for burn severity was calculated as 0.43 for crown fire where burn severity was ’High’,as 0.40 for ’Moderate’ severity,and 0.15 for ’Low’ severity surface fire.The emission factors for estimating non-CO 2 GHGs were separately applied to CO 130,CH 4 9,NO x 0.7 and N 2 O 0.11.Non-CO 2 GHGs emissions from biomass burning in the Samcheok forest fire area were estimated to be CO 44.100,CH 4 3.053,NO x 0.238 and N 2 O 0.038 Gg.     

A new methodology for measuring coastline recession using buffering and non‐linear least squares estimation

Coastline recession is one of the best indicators of coastal erosion. Three methods for computing coastline recession – the baseline approach, the dynamic segmentation approach and the area‐based approach – have been used, each of which has one or more drawbacks. To overcome these problems, a new methodology for measuring coastline recession is proposed, using buffering and non‐linear least squares estimation. The proposed method was compared with the three existing methods with respect to two simulated cases and two real coastlines. Test results confirmed that the new method is more reliable than the three other methods, all of which are susceptible to variability of recession, scale, number of line segments, length of coastlines and direction of the baseline. The proposed method, incorporating two physically meaningful values – magnitude and variability of coastline recession according to the mean and standard deviation of coastline offsets, respectively – presents itself as an effective alternative method of assessing coastline recession.     

The evaluation of the probability of rock wedge failure using the point estimate method

In a probabilistic analysis of rock slope stability, the Monte Carlo simulation technique has been widely used to evaluate the probability of slope failure. While the Monte Carlo simulation technique has many advantages, the technique requires complete information of the random variables in stability analysis; however, in practice, it is difficult to obtain complete information from a field investigation. The information on random variables is usually limited due to the restraints of sampling numbers. This is why approximation methods have been proposed for reliability analyses. Approximation methods, such as the first-order second-moment method and the point estimate method, require only the mean and standard deviation of the random variable; therefore, it is easy to utilize when the information is limited. Usually, a single closed form of the formula for the evaluation of the factor of safety is needed for an approximation method. However, the commonly used stability analysis method of wedge failure is complicated and cumbersome and does not provide a simple equation for the evaluation of the factor of safety. Consequently, the approximation method is not appropriate for wedge failure. In order to overcome this limitation, a simple equation, which is obtained from the maximum likelihood estimation method for wedge failure, is utilized to calculate the probability of failure. A simple equation for the direct estimation of the safety factors for wedge failure has been empirically derived from failed and stable cases of slope, using the maximum likelihood estimation method. The developed technique has been applied to a practical example, and the results from the developed technique were compared to the results from the Monte Carlo simulation technique.     

Evidence for significant clockwise rotations of the Korean Peninsula during Cretaceous

In an effort to evaluate the Cretaceous magnetostratigraphy for the Korean Peninsula and to establish the tectonic coherence of its various elements, we collected paleomagnetic data from 121 samples from 20 sites within the Chilgok Formation (108.3–109.9 Ma) in the Gyeongsang Basin. Together with previously published data, we evaluate the results from a total of 163 sites in the basin.We combine our age model with results from recent stratigraphic, paleomagnetic and radiometric geochemical studies. In this study, we found that two distinct declination shifts decrease with younging direction, indicating two clockwise rotational events of the Korean Peninsula with respect to the Eurasia continent. The earlier event took place during 130–100 Ma (Phase I, newly termed “Goguryeo Disturbance”) and a later one during 80–50 Ma (Phase III, belonging to “Bulguksa Orogeny”). The mean rotation rate in the interval from 115.2 to 103.8 Ma (Phase I) is about 0.74°/Ma, while the rate from 90.9 to 79.8 Ma (Phase II) is 0.19°/Ma. Based on paleolatitude change during Phase I, we infer that the Korean Peninsula (eastern part of the Sino-Korea Block) migrated southward about 300 km after the complete amalgamation of the Sino-Korea Block into the Eurasian continent resulting in N–S compression within the Korean peninsula and Manchuria. Large-scale strike-slip faults (e.g., Tan-Lu Fault, Okcheon Boundary Fault) were probably rejuvenated in the Sino-Korea Block during Phase I.     

An empirical formula for friction coefficient of a perforated wall with vertical slits

The friction coefficient in the permeability parameter of a perforated wall has been estimated on the basis of a best fit between measured and predicted values of such hydrodynamic coefficients as reflection and transmission coefficients. In the present study, an empirical formula for the friction coefficient is proposed in terms of known variables, i.e., the porosity and thickness of the perforated wall and the water depth. This enables direct estimation of the friction coefficient without invoking a best fit procedure. To obtain the empirical formula, hydraulic experiments are carried out, the results of which are used along with other researchers' results. The proposed formula is used to predict the reflection and transmission coefficients of various types of structures including a perforated wall. The concurrence between the experimental data and calculated results is good, verifying the appropriateness of the proposed formula. It is also shown that the proposed formula can be used for irregular waves as well.     

On the planar motion in the full two-body problem with inertial symmetry

Relative motion of binary asteroids, modeled as the full two-body planar problem, is studied, taking into account the shape and mass distribution of the bodies. Using the Lagrangian approach, the equations governing the motion are derived. The resulting system of four equations is nonlinear and coupled. These equations are solved numerically. In the particular case where the bodies have inertial symmetry, these equations can be reduced to a single equation, with small nonlinearity. The method of multiple scales is used to obtain a first-order solution for the reduced nonlinear equation. The solution is shown to be sufficient when compared with the numerical solution. Numerical results are provided for different example cases, including truncated-cone-shaped and peanut-shaped bodies.     

Biomarker responses in caged rockfish (Sebastes schlegeli) from Masan Bay and Haegeumgang, South Korea

The purpose of this study was to compare enzymatic biomarker activities in fish caged at two sites, Masan Bay (contaminated) and Haeguemgang (reference). In the present study, ethoxyresorufin O-deethylase (EROD), brain acetyl cholinesterase (bAChE), muscle acetyl cholinesterase (mAChE) and butyryl cholinesterase (mBChE) in caged rockfish (Sebastes schlegeli) were measured 0, 1, 3, 7, 14, 21 and 30 days after caging. The level of CYP1A mRNA and Protein expression was induced higher in Masan Bay at 1, 3, 7, 14 and 30 days after caging. EROD activity in the caged fish was significantly higher in Masan Bay than in Haeguemgang 3 and 7 days after caging, but not at 14 and 30 days after caging. bAChE activity was significantly inhibited at 7 and 14 days after caging in Masan Bay. However, mBChE activity was not significantly inhibited during the experiment. Taken together, the data suggest that the caged fish were exposed, at least transiently, to CYP1A inducers and ChE inhibitors, which is consistent with our previous observations.     

Evaluation of heavy metal contamination and implication of multiple sources from Hunchun basin, northeastern China

Present concentrations and distributions of heavy metals through profiles, surface soil, and stream sediment samples in the Hunchun area, north-eastern China, were investigated to determine the elemental background values. This study also aims to characterize potentially toxic materials such as pulverized fly ash (PFA) from power stations or ash and slag from coal used domestically in urban areas, agrochemicals applied inappropriately, and urban sewage sludges from Hunchun City, as well as to ascertain the possibility of natural enrichment through site characterization by mineralogical and geochemical investigation. The distribution of contaminants in the alluvial soils (fluvisol) of this area has been influenced by several interacting factors. The parent alluvial materials from weathered products of amphiboles have made coatings such as ferrihydrite, goethite, and hematite. This natural inheritance factor is supported by the fact that the concentrations of weak acid-extractable (plant-available) heavy metals are very low, except for Fe and Mn. However, in agricultural soils and adjacent stream sediments, an anthropogenic input of Cd, Pb, Ni and Cr by agrochemicals is strongly suggested. Also, F contamination by coal combustion and the dissolution of F-bearing minerals could cause some future problems. Wide distribution and significantly high concentrations of Cd, Fe, Mn, and F in soils throughout the combination of pollutants originating from lithogenic and the anthropogenic sources pose potential problems in utilizing water resources. Received: 14 June 1999 · Accepted: 27 December 1999     

A WIMP detector with two-phase xenon

We describe an important new technique to search for WIMPs. This technique employs a method of background discrimination using double phase xenon as detector target. We describe the construction of a two-phase, 1-kg xenon detector. The detector will be installed at the underground laboratory in the Mt. Blanc tunnel, which provides a low background rate. A comparison between the sensitivity curve of our detector and the theoretical events limit from SUSY calculations is presented.