A glancing incidence solar telescope for the soft x-ray region

This paper describes the instrumentation of an Aerobee rocket (NASA 4.95 GS) which was launched from White Sands Missile Range on May 20th 1966, to observe the Sun in the soft X-ray region. The experiment package, which was pointed at the sun by a control system stabilized about all three axes, carried two Wolter type I glancing incidence telescopes to photograph the sun in wavelength regions (determined by bandpass filters) between 3 and 75 Å, and two proportional counters to obtain flux data and rough spectral shapes in the regions 2–11 Å and 8–20 Å. The spatial resolution obtained was about 20 arc seconds. Limb brightening and polar darkening are very pronounced at the longer wavelengths. A tuft of emission was observed at the North Pole in addition to an arch-like structure on the NW limb. Several of the photographs are presented, and some preliminary results are discussed.     

Riometer observations in the polar caps of solar cosmic ray events during the IQSY

During the period of the IQSY, January 1964 through December 1965, the sun remained quiet, accelerating few energetic particles. There were many instances during the IQSY when lowenergy detectors on satellites and space probes registered small intensity increases. However, few of these events were associated with protons of energies exceeding 10 MeV. Moreover, the maximum intensities (E _p > 500 keV) were typically 1–8/cm²sec ster. Most of these events were below the threshold of riometer detection.The largest solar cosmic ray event observed in 1964 by polar-based riometers was that of March 16. This event was observed by 30 and 50 Mc/s riometers at McMurdo Sound, Antarctica, and Shepherd Bay, N.W.T., Canada.The largest event in 1965 occurred on February 5 and was the largest during the IQSY. It was associated with a class 2 flare at about 1750 UT, February 5. The propagation time between the sun and Earth was about one hour. This event was well observed by satellites, space probes, and riometers.This paper discusses primarily the 5 February 1965 event. Some discussion is also given to the 16 March 1964 event, other small events during the IQSY, and the recent event in March 1966.     

Powder- and single crystal Mössbauer spectroscopy on synthetic fayalite

Mössbauer measurements on synthetic iron orthosilicate Fe₂SiO₄ (fayalite) were carried out in the antiferromagnetic spin state below T _N 65 K. The Mössbauer parameters isomer shift , inner magnetic field H(0), angle between H(0) and the z-component of the electric field gradient (efg), quadrupole splitting QS and asymmetry parameter were determined as a function of temperature. These parameters could be attributed to the two crystallographic sites M1 and M2.The smaller isomer shift on M1 with respect to M2 displays the more covalent character of the Fe-O bond on M1, which is supported by previous neutron diffraction experiments. H(0) shows a Brillouin-type behaviour with different fields on the two crystallographic sites (stronger on M1) and a small discontinuity at T = 23 K which corresponds with previous magnetic measurements. The quadrupole splitting is equal on both sites within error bars, in agreement with previous theoretical results and in contradiction to previous Mössbauer refinements published elsewhere.     

Ionospheric Joule dissipation as a damping mechanism for high latitude ULF pulsations: Observational evidence

On 9 January 1979 an SI-excited pulsation event was observed by the Scandinavian Magnetometer Array. The pulsation period shows a clear variation with latitude which suggests decoupled oscillations of individual magnetic field shells. The pulsation amplitudes exhibit an e-fold decay with the damping rate γ varying both in longitudinal and latitudinal directions. Assuming Joule heating in the ionosphere as the dominant damping mechanism (and thus γ ～ Σ^?1_p) approximate height-integrated Pedersen conductivity profiles were calculated which fit well with previously observed Σ_p distributions. This is interpreted as observational evidence for ionosopheric Joule dissipation as the major damping mechanism for high-latitude ULF-pulsations.     

Tropospheric Ozone in a Global-Scale Three-Dimensional Lagrangian Model and Its Response to NOX Emission Controls

A three-dimensional Lagrangian tropospheric chemistry modelis used toinvestigate the impact of human activities on the tropospheric distributionofozone and hydroxyl radicals. The model describes the behaviour of 50 speciesincluding methane, carbon monoxide, oxides of nitrogen, sulphur dioxide andnineorganic compounds emitted from human activities and a range of other sources.Thechemical mechanism involves about 100 chemical reactions of which 16 arephotochemical reactions whose diurnal dependence is treated in full. The modelutilises a five minute chemistry time step and a three hour advection timestepfor the 50,000 air parcels. Meteorological data for the winds, temperatures,clouds and so on are taken from the UK Meteorological Office global model for1994 onwards. The impacts of a 50% reduction in European NO_Xemissions onglobal ozone concentrations are assessed. Surface ozoneconcentrations decrease in summertime and rise in wintertime, but to differentextents.     

Temperature dependence of the cation distribution in nickel aluminate (NiAl2O4) spinel: a powder XRD study

NiAl₂O₄ is a largely inverse spinel, which in detail shows increasing randomisation with temperature of Ni and Al between the octahedral and tetrahedral cation sites of the spinel structure. We have used powder XRD to determine this cation distribution in various samples of NiAl₂O₄ quenched after annealing between 700 and 1400° C. The inversion parameter (x) can be measured with a precision of ± 0.004 (one standard deviation), and a comparison of different methods of synthesis, X-ray diffraction and refinement techniques, suggests a probable accuracy of better than 0.01. The results are supported by some preliminary single crystal refinements on flux-grown samples.Below 800° C the rate of cation ordering becomes very slow, and, despite reaching an apparently steady state, it is doubtful if our samples attained complete internal equilibrium. Above 1250° C the cation redistribution becomes so fast that the quenching method becomes unreliable. Between 800 and 1250° C inclusive, the degree of inversion changes smoothly from 0.87 at 800° C to 0.79 at 1250° C, and is accompanied by linear changes in u, the oxygen parameter, from 0.2555 to 0.2563 (±0.0002), and a₀, the lattice parameter, from 8.0462 to 8.0522 Å (±0.0002 Å).     

Occurrence and characteristics of sporadic sodium layer observed by lidar at a mid-latitude location

Na lidar observations of SSL during the past 5 years at a mid-latitude location (Wuhan, China, 31°N, 114°E) are reported in this paper. From 26 SSL events detected in about 230 h of observation, an SSL occurrence rate of 1 event/9 h at our location was obtained. This result, combined with that reported by Nagasawa and Abo (Geophys. Res. Lett. 22 (1995) 263) at Tokyo, Japan, reveals that the SSL occurrence can be relatively frequent at some mid-latitude locations. The statistical analyses of main parameters for the 26 SSL events were made, and the results were compared with those previously reported. By examining the corresponding data from a nearby ionosonde, it was found that there was a fairly good correlation between SSL and Es. Of the 18 pairs of SSL and Es events checked, 15 of SSL were accompanied by Es, and 8 pairs of them were correlated within 1 h in time and within 5 km in altitude. From the analyses of observed perturbations during SSL development, the role of dynamic processes of atmosphere in the SSL formations were emphasized.     

Mineralogical, chemical, and crystallographic properties of supergene jarosite-group minerals from the Xitieshan Pb-Zn sulfide deposit, northern Tibetan Plateau, China

Supergene jarosite-group minerals are widespread in weathering profiles overlying Pb-Zn sulfide ores at Xitieshan, northern Tibetan Plateau, China. They consist predominantly of K-deficient natrojarosite, with lesser amounts of K-rich natrojarosite and plumbojarosite. Electron microprobe (EMP) analyses, scanning electron microcopy (SEM) investigation, and X-ray mapping reveal that the jarosite-group minerals are characterized by spectacular oscillatory zoning composed of alternating growth bands of K-deficient and K-bearing natrojarosite (K₂O >1 wt.%). Plumbojarosite, whenever present, occurs as an overgrowth in the outermost bands, and its composition can be best represented by K_0.29Na_0.19Pb_0.31Fe_2.66Al_0.22(SO₄)_1.65(PO₄)_0.31(AsO₄)_0.04(OH)_7.37. The substitution of monovalent for divalent cations at the A site of plumbojarosite is charge balanced by the substitution of five-valent for six-valent anions in XO₄ at the X site. Thermogravimetric analysis (TGA) of representative samples reveal mass losses of 11.46 wt.% at 446.6 °C and 21.42 wt.% at 683.4 °C due to dehydroxylation and desulfidation, respectively. TGA data also indicate that the natrojarosite structure collapses at 446.6 °C, resulting in the formation of NaFe(SO₄)₂ and minor hematite. The decomposition products of NaFe(SO₄)₂ are hematite and Na₂SO₄. Powder X-ray diffraction (XRD) analyses show that the jarosite-group minerals have mean unit-cell parameters of a?=?7.315 Å and c?=?016.598 Å. XRD and EMP data support the view that substitutions of Na for K in the A site and full Fe occupancy in the B site can considerably decrease the unit-cell parameter c, but only slightly increase a. The results from this study suggest that the observed oscillatory zoning of jarosite-group minerals at Xitieshan resulted mainly from substitutions of K for Na at the A site and P for S at the X site.     

Qualitätsanforderungen an Oberflächengewässer: Zielvorgaben,Qualitätsziele und chemische Gewässergüteklassifizierung

Quality Requirements for Fresh Waters: Water Quality Targets, Water Quality Objectives, and Chemical Water Quality Classification In the Federal Republic of Germany, water quality requirements for the protection of inland surface waters against hazardous substances are formulated on the basis of a quality targets derivation concept developed jointly by the Federal Government and the Federal States. The quality requirements were termed “water quality targets” in order to make it clear that the values derived are orientational values rather than legally binding limit values. The international comparison of quality requirements for surface waters shows that, on the whole, the national quality targets ensure a high level of protection. According to present scientific knowledge, impairments of uses, such as supply of drinking water, or risks to aquatic communities need not to be expected if the quality targets are complied with. A comparison of water quality data with the water quality targets makes it possible, on the one hand, to identify those substances whose inputs must be further reduced; on the other hand, it also shows that, for a number of substances, there is no need at present for concern over their adversely water quality. A further differentiation of the aquatic hazard potential of pollutants allows a water quality classification system to be developed on the basis of the quality targets derivation concept. The basic elements of this water quality classification system are presented, and its application is explained by way of examples.