Simulation of double cold cores of the 35°N section in the Yellow Sea with a wave-tide-circulation coupled model

Based on the MASNUM wave-tide-circulation coupled numerical model, the temperature structure along 35°N in the Yellow Sea was simulated and compared with the observations. One of the notable features of the temperature structure along 35°N section is the double cold cores phenomena during spring and summer. The double cold cores refer to the two cold water centers located near 122°E and 125°E from the depth of 30m to bottom. The formation, maintenance and disappearance of the double cold cores are discussed. At least two reasons make the temperature in the center (near 123°E) of the section higher than that near the west and east shores in winter. One reason is that the water there is deeper than the west and east sides so its heat content is higher. The other is invasion of the warm water brought by the Yellow Sea Warm Current (YSWC) during winter. This temperature pattern of the lower layer (from 30m to bottom) is maintained through spring and summer when the upper layer (0 to 30m) is heated and strong thermocline is formed. Large zonal span of the 35°N section (about 600 km) makes the cold cores have more opportunity to survive. The double cold cores phenomena disappears in early autumn when the west cold core vanishes first with the dropping of the thermocline position. Supported by the National Basic Research Program of China (No. G1999043809) and the National Science Foundation of China (No. 49736190).     

Stream Restoration Performance and Its Contribution to the Chesapeake Bay TMDL: Challenges Posed by Climate Change in Urban Areas

In large part driven by total maximum daily load (TMDL) mandates, the restoration community in the Chesapeake Bay region has been implementing novel best management practices (BMPs) and stream restoration designs in urban areas, such as regenerative stream/stormwater conveyance (RSC) structures and stream-wetland complexes (SWCs). However, the nutrient and sediment reduction efficiencies of these novel designs are virtually unknown, and the possibility of increasing riverine flow in the Chesapeake Bay watershed associated with climate change this century necessitates an evaluation of their performance to develop and utilize those that optimize reductions in nutrient and sediment fluxes. We compare pre- and post-construction loads (total nitrogen (TN), total phosphorus (TP), and total suspended solids (TSS)) from RSCs (i.e., upland BMPs) and a SWC (i.e., stream restoration) constructed at the outflow of a highly developed watershed in the Coastal Plain physiographic province of Maryland. The largest of the two RSCs performed best in relation to expected nutrient and sediment reductions because of superior water retention capability. By the length of river reach restored, the SWC attained from 79 to 88% of its N reduction TMDL goal, but only 19 to 23 and 2.7 to 3.1% for TP and TSS, respectively; by watershed area, % attainments of TMDL goals were much lower. Results indicate that SWCs have the potential to curtail N loading from developed catchments, but additional water quality benefits may be limited. Climate change projections indicate that there will be an increased frequency of larger-volume storms that will result in an increase in stormflow runoff from urban areas, and increased pollutant loads will likely curtail potential gains made by efforts to achieve TMDL goals. Given the large-scale implementation of BMPs currently underway to accommodate the Chesapeake Bay TMDL, the restoration community needs to adopt a concerted strategy of building climate resilience into many types of urban BMPs to help attain and maintain loads at TMDL levels in anticipation of a progressively wetter climate throughout this century.     

Investigation of the change in soil fabric during cone penetration in silt using 2D measurements

Interpretation of CPTU testing in silt is non-trivial because of the partially drained conditions that are likely to occur during penetration. A better understanding of the pore pressure generation/dissipation is needed in order to obtain reliable design parameters. Following a previous study using X-ray computed tomography (micro-CT) with volumetric digital image correlation (3D-DIC) that clearly showed the formation of distinct dilation and compression areas around the cone; the present work takes a closer look at those areas in order to link volumetric behavior to changes in soil fabric. High-resolution 2D backscattered electron images of polished thin sections prepared from frozen samples at the end of penetration are used. The images have a spatial resolution of 0.4 µm/pixel that allow a clear identification of grains and pore spaces. Image processing techniques are developed to quantify local porosity and obtain the statistical distribution of the particle orientation for the zones around the cone tip and shaft. It is shown that the formation of compaction regions is related to the ability of the grains to rearrange and align along a well-defined preferred orientation forming a more closed-fabric characterized by high anisotropy values, while zones of dilation are associated with a more open packing with grains randomly oriented and with large voids within. These observations suggested that for a saturated soil, water will move from a compressive zone to a neighboring dilative zone, creating a short drainage path. By shedding light on the link between soil fabric and drainage patterns, this study contributes toward a better understanding of the measured macro-response during CPTU tests on silt.     

Developing a small lake: The case of Palakpakin Lake,San Pablo City,Philippines

This study assesses the development issues of Palakpakin Lake. Premised on the scarcity of development studies on lakes (as the field is dominated by limnology and aquaculture studies) and small-lake studies (as the field is heavily concentrated on big-lake studies), the article argues that the lake has long been wanting of development initiatives from its administrative agencies. It further contends that the Laguna Lake Development Authority and the City Government of San Pablo must now act to promote development of the lake; specifically, by modifying their model-template approach, by formulating a zoning-development plan, and by fostering ecotourism. These basic actions are necessary in managing, developing and conserving the natural resource, as well as in preparing, informing and precipitating other actions on the lake.     

Resource allocation for regional earthquake risk mitigation: a case study of Tehran,Iran

This paper presents a new optimization model to help cities in seismically active developing countries decide (1) How much to spend on pre-earthquake mitigation versus waiting until after an event and paying for reconstruction or simply not rebuilding damaged buildings? (2) Which buildings to mitigate and how? and (3) Which buildings to reconstruct and how? It extends previously developed optimization models to consider the particular issues that arise in such countries. First, the model allows for the possibility that some damaged buildings will not be reconstructed immediately and keeps track of any lost building inventory. Second, buildings can be mitigated to, or when damaged, reconstructed to, any appropriate structural type and seismic design level. Finally, the model objectives include minimizing the chance of an extremely high death toll in any one earthquake and minimizing the average annual death toll across earthquakes. The model is illustrated through a case study analysis for Tehran, Iran.     

Sorption of uranium(VI) at the clay mineral–water interface

Batch experiments were conducted to study the sorption of uranium on selected clay minerals (KGa-1b and KGa-2 reference kaolinite, SWy-2 and STx-1b reference montmorillonite, and IBECO natural bentonite) as a function of pH (4–9) and 0.001, 0.01, and 0.025 M NaCl in equilibrium with the CO₂ partial pressure of the atmosphere. Uranium concentrations were kept below 100 μg L⁻¹ to avoid precipitation of amorphous Uranium-hydroxides. Solely PTFE containers and materials were used, because experiments showed significant sorption at higher pH on glass ware. All batch experiments were performed over a period of 24 h, since kinetic experiments proved that the common 10 or 15 min are in many cases by far not sufficient to reach equilibrium. Kaolinite showed much greater uranium sorption than the other clay minerals due to the more aluminol sites available. Sorption on the poorly crystallized KGa-2 was higher than on the well-crystallized KGa-1b. Uranium sorption on STx-1b and IBECO exhibited parabolic behavior with a sorption maximum around pH 6.5. Sorption of uranium on montmorillonites showed a distinct dependency on sodium concentrations because of the effective competition between uranyl and sodium ions, whereas less significant differences in sorption were found for kaolinite. The presence of anatase as impurity in kaolinite enhanced the binding of uranyl-carbonate complexes with surface sites. The kinetic of uranium sorption behavior was primarily dependent on the clay minerals and pH. A multisite surface complexation model without assuming exchange is based on the binding of the most dominant uranium species to aluminol and silanol edge sites of montmorillonite, respectively to aluminol and titanol surface sites of kaolinite. For eight surface species, the log_k was determined from the experimental data using the parameter estimation code PEST together with PHREEQC.     

Wetland Loss,Juvenile Salmon Foraging Performance,and Density Dependence in Pacific Northwest Estuaries

During the transition of juveniles from fresh water to estuarine and coastal environments, the survival of Pacific salmon (Oncorhynchus spp.) can be strongly size selective and cohort abundance is partly determined at this stage. Because quantity and quality of food influence juvenile salmon growth, high rates of prey and energy acquisition during estuarine residence are important for survival. Human activities may have affected the foraging performance of juvenile salmon in estuaries by reducing the area of wetlands and by altering the abundance of salmon. To improve our understanding of the effects of wetland loss and salmon density on juvenile salmon foraging performance and diet composition in estuaries, we assembled Chinook salmon (Oncorhynchus tshawytscha) diet and density data from nine US Pacific Northwest estuaries across a gradient of wetland loss. We evaluated the influence of wetland loss and density on juvenile Chinook salmon instantaneous ration and energy ration, two measures of foraging performance, and whether the effect of density varied among estuaries with different levels of wetland loss. We also assessed the influence of wetland loss and other explanatory variables on salmon diet composition. There was no evidence of a direct effect of wetland loss on juvenile salmon foraging performance, but wetland loss appeared to mediate the effect of density on salmon foraging performance and alter salmon diet composition. Specifically, density had no effect on foraging performance in the estuaries with less than 50 % wetland loss but had a negative effect on foraging performance in the estuaries with greater than 50 % wetland loss. These results suggest that habitat loss may interact with density to constrain the foraging performance of juvenile Chinook salmon, and ultimately their growth, during a life history stage when survival can be positively correlated with growth and size.     

Spatial Variability of Mass Movements in the Satluj Valley,Himachal Pradesh during 1990～2006

Satluj Valley is known to have a history of landslides and related mass movement activities since the geological times. Geological and geomorphological settings combined with anthropogenic activities constitute a propensity towards slope failure. During the last two decades,the area witnessed substantial increase in athropogenic pressure,mainly due to the exploitation of hydropower potential,changing landuse pattern and population growth. In addition,a shift of the climatic patterns in the form of larger area falling under the influence of rains was observed. These natural as well as anthropogenic changes in the area have resulted in increased spatial coverage of landslide in the area. This paper documents these changes during 1990～2006.     

The Impact of Large-Scale Reclamation on Hydro-Dynamic Environment——A Case Study of Xinghua Bay

A hydro-dynamic model is established on basis of MIKE21 FM to simulate the hydro-dynamic characteristics of Xinghua Bay and investigate the influence of reclamation project on the tidal elevation and tidal currents. Tidal elevation data was obtained at the six tide gauge stations around the Xinghua Bay, and another six current stations were established to observe the tidal current velocity and direction. Validation shows that the model-simulated tidal elevation and tidal currents agree well with observations made at different stations. Predictions are made according to the reclamation project proposed in the regional marine planning of Hanjiang Industrial Park around the port in Putian City. The variations of hydro-dynamic factors, such as tide, current velocity and direction and tidal influx are obtained, and the adverse effect of reclamation on marine environment is discussed. It is shown that the tidal level inside the Xinghua Bay during high tide decreases after the reclamation project is completed. The tidal currents during flooding tide generally decrease in the southeast of the reclamation region, with the maximum decreasing amplitude reaching 0.44 m s^-1. On the other hand, the tidal currents during flooding tide increase around the southeast and southwest corners of the reclamation region. The tidal currents during ebb tide increase around the southeast and southwest corners of the reclamation region, with the maximum increasing amplitude attaining 0.18 m s^-1. The results in this paper can give some guidance for the marine environment management and the effective utilization of land in Putian.     

An experimental study of the grain-scale processes of peridotite melting: implications for major and trace element distribution during equilibrium and disequilibrium melting

The grain-scale processes of peridotite melting were examined at 1,340°C and 1.5 GPa using reaction couples formed by juxtaposing pre-synthesized clinopyroxenite against pre-synthesized orthopyroxenite or harzburgite in graphite and platinum-lined molybdenum capsules. Reaction between the clinopyroxene and orthopyroxene-rich aggregates produces a melt-enriched, orthopyroxene-free, olivine + clinopyroxene reactive boundary layer. Major and trace element abundance in clinopyroxene vary systematically across the reactive boundary layer with compositional trends similar to the published clinopyroxene core-to-rim compositional variations in the bulk lherzolite partial melting studies conducted at similar P–T conditions. The growth of the reactive boundary layer takes place at the expense of the orthopyroxenite or harzburgite and is consistent with grain-scale processes that involve dissolution, precipitation, reprecipitation, and diffusive exchange between the interstitial melt and surrounding crystals. An important consequence of dissolution–reprecipitation during crystal-melt interaction is the dramatic decrease in diffusive reequilibration time between coexisting minerals and melt. This effect is especially important for high charged, slow diffusing cations during peridotite melting and melt-rock reaction. Apparent clinopyroxene-melt partition coefficients for REE, Sr, Y, Ti, and Zr, measured from reprecipitated clinopyroxene and coexisting melt in the reactive boundary layer, approach their equilibrium values reported in the literature. Disequilibrium melting models based on volume diffusion in solid limited mechanism are likely to significantly underestimate the rates at which major and trace elements in residual minerals reequilibrate with their surrounding melt. Electronic supplementary material  The online version of this article (doi:) contains supplementary material, which is available to authorized users.