The presolar grain inventory of fine‐grained chondrule rims in the Mighei‐type (CM) chondrites

We investigated the inventory of presolar silicate, oxide, and silicon carbide (SiC) grains of fine‐grained chondrule rims in six Mighei‐type (CM) carbonaceous chondrites (Banten, Jbilet Winselwan, Maribo, Murchison, Murray and Yamato 791198), and the CM‐related carbonaceous chondrite Sutter's Mill. Sixteen O‐anomalous grains (nine silicates, six oxides) were detected, corresponding to a combined matrix‐normalized abundance of ~18 ppm, together with 21 presolar SiC grains (~42 ppm). Twelve of the O‐rich grains are enriched in ¹⁷O, and could originate from low‐mass asymptotic giant branch stars. One grain is enriched in ¹⁷O and significantly depleted in ¹⁸O, indicative of additional cool bottom processing or hot bottom burning in its stellar parent, and three grains are of likely core‐collapse supernova origin showing enhanced ¹⁸O/¹⁶O ratios relative to the solar system ratio. We find a presolar silicate/oxide ratio of 1.5, significantly lower than the ratios typically observed for chondritic meteorites. This may indicate a higher degree of aqueous alteration in the studied meteorites, or hint at a heterogeneous distribution of presolar silicates and oxides in the solar nebula. Nevertheless, the low O‐anomalous grain abundance is consistent with aqueous alteration occurring in the protosolar nebula and/or on the respective parent bodies. Six O‐rich presolar grains were studied by Auger Electron Spectroscopy, revealing two Fe‐rich silicates, one forsterite‐like Mg‐rich silicate, two Al‐oxides with spinel‐like compositions, and one Fe‐(Mg‐)oxide. Scanning electron and transmission electron microscopic investigation of a relatively large silicate grain (490 nm × 735 nm) revealed that it was crystalline åkermanite (Ca₂Mg[Si₂O₇]) or a an åkermanite‐diopside (MgCaSi₂O₆) intergrowth.     

The brecciated texture of polymict eucrites: Petrographic investigations of unequilibrated meteorites from the Antarctic Yamato collection

We report on the petrography and mineralogy of five Yamato polymict eucrites to better constrain the formation and alteration of crustal material on differentiated asteroids. Each sample consists of different lithic clasts that altogether form four dominant textures and therefore appear to originate from closely related petrological areas within Vesta′s crust. The textures range from subophitic to brecciated, porphyritic, and quench‐textured, that differ from section to section. Comparison with literature data for these samples is therefore difficult, which stresses that polymict eucrites are extremely complex in their petrography and investigation of only one thick section may not be representative for the host rock. We also show that sample Y‐793548 consists of more than one lithic unit and must therefore be classified as polymict instead of monomict. The variety and nature of lithic textures in the investigated Yamato meteorites indicate shock events, intense post‐magmatic thermal annealing, and secondary alteration. These postmagmatic features occur in different intensities, varying from clast to clast or among coexisting mineral fragments on a small, local scale. Several clasts within the eucrites studied have been modified by late‐stage alteration processes that caused deposition of Fe‐rich olivine and Fe enrichment along cracks crosscutting pyroxene crystals. However, formation of these secondary phases seems to be independent of the degree of thermal metamorphism observed within every type of clast, which would support a late‐stage metasomatism model for their formation.     

Weak stability boundary trajectories for the deployment of lunar spacecraft constellations

Suitable lunar constellation coverage can be obtained by separating the satellites in inclinations and node angles. It is shown in the paper that a relevant saving of velocity variation ΔV can be achieved using weak stability boundary trajectories. The weakly stable dynamics of such transfers allows the separation of the satellites from the nominal orbit to the required orbit planes with a small amount of ΔV. This paper also shows that only one different set of orbital parameters at Moon can be reached with the same ΔV manoeuvre starting from a nominal trajectory and ending at a fixed periselenium altitude. In fact, such a feature is proved to be common to other simpler dynamical systems, such as the two- and three-body problems.     

Asteroid impact effects on Snowball Earth

Several Snowball Earth periods, in which the Earth has been (almost) totally glaciated, are known from Earth history. Neither the trigger for the initiation, nor the reason for the ending of such phases, are well understood. Here we discuss some mechanical effects of the impact of asteroids 5–10 km in diameter on the Snowball Earth environment. An impact of this scale is the largest impact that is statistically predictable for 10–60 Myr time periods. The impact cratering itself (shock waves, impact crater formation) is not powerful enough to change the natural climate evolution path on Earth. However, the products of impact (mainly—water vapor) can be quickly distributed over a substantial part of the globe, influencing the global circulation (e.g., facilitating cloud formation). It is a question for future studies to confirm if such an event (which is possible statistically during this interval) may or may not have influenced the global climate of the Snowball Earth, and/or contributed to deglaciation.     

The fusion crust of the Winchcombe meteorite: A preserved record of atmospheric entry processes

Fusion crusts form during the atmospheric entry heating of meteorites and preserve a record of the conditions that occurred during deceleration in the atmosphere. The fusion crust of the Winchcombe meteorite closely resembles that of other stony meteorites, and in particular CM2 chondrites, since it is dominated by olivine phenocrysts set in a glassy mesostasis with magnetite, and is highly vesicular. Dehydration cracks are unusually abundant in Winchcombe. Failure of this weak layer is an additional ablation mechanism to produce large numbers of particles during deceleration, consistent with the observation of pulses of plasma in videos of the Winchcombe fireball. Calving events might provide an observable phenomenon related to meteorites that are particularly susceptible to dehydration. Oscillatory zoning is observed within olivine phenocrysts in the fusion crust, in contrast to other meteorites, perhaps owing to temperature fluctuations resulting from calving events. Magnetite monolayers are found in the crust, and have also not been previously reported, and form discontinuous strata. These features grade into magnetite rims formed on the external surface of the crust and suggest the trapping of surface magnetite by collapse of melt. Magnetite monolayers may be a feature of meteorites that undergo significant degassing. Silicate warts with dendritic textures were observed and are suggested to be droplets ablated from another stone in the shower. They, therefore, represent the first evidence for intershower transfer of ablation materials and are consistent with the other evidence in the Winchcombe meteorite for unusually intense gas loss and ablation, despite its low entry velocity.     

Wind-induced drift of objects at sea: The leeway field method

A method for conducting leeway field experiments to establish the drift properties of small objects (0.1-25 m) is described. The objective is to define a standardized and unambiguous procedure for condensing the drift properties down to a set of coefficients that may be incorporated into existing stochastic trajectory forecast models for drifting objects of concern to search and rescue operations and other activities involving vessels lost at sea such as containers with hazardous material.An operational definition of the slip or wind and wave-induced motion of a drifting object relative to the ambient current is proposed. This definition taken together with a strict adherence to a 10 m wind speed allows us to refer unambiguously to the leeway of a drifting object. We recommend that all objects if possible be studied using what we term the direct method, where the object’s leeway is studied directly using an attached current meter.We establish a minimum set of parameters that should be estimated for a drifting object for it to be included in the operational forecast models used for prediction of search areas for drifting objects.We divide drifting objects into four categories, depending on their size. For the smaller objects (less than 0.5 m), an indirect method of measuring the object’s motion relative to the ambient current must be used. For larger objects, direct measurement of the motion through the near-surface water masses is strongly recommended. Larger objects are categorized according to the ability to attach current meters and wind monitoring systems to them.The leeway field method proposed here is illustrated with results from field work where three objects were studied in their distress configuration; a 1:3.3 sized model of a 40-foot Shipping container, a World War II mine and a 220 l (55-gallon) oil drum.     

Chemical composition and iron oxidation state of amorphous matrix silicates in the carbonaceous chondrite Acfer 094

Nanoscale amorphous silicates are a major component in primitive carbonaceous chondrite matrices and anhydrous interplanetary dust particles. Owing to their metastability and sensitive response to reactions with water, this material is of particular interest in understanding nebular and parent body processes in the early solar system. Here we investigated the amorphous silicate matrix (ASM) in the ungrouped carbonaceous chondrite Acfer 094 regarding its texture, chemical composition, and Fe oxidation state. We applied transmission electron microscopy techniques on six, focused ion beam technique-prepared, electron-transparent lamellae of Acfer 094 to determine the textures of this material. Furthermore, we used energy-dispersive X-ray analysis and electron energy loss spectroscopy to quantify the Fe content and the Fe oxidation state of the ASM. Textural investigations reveal differences in sulfide content, porosity, and distribution of the ASM among the samples, as well as evidence for rare recrystallization of phyllosilicate fibers. The chemical composition reveals mobilization of Fe. Furthermore, the determined Fe³⁺/ΣFe ratios of the ASM in the six samples display a homogeneously high oxidation state (0.66–0.73). This high and homogeneous Fe oxidation state in the ASM of Acfer 094 disagrees with its formation as a primary phase in a reduced solar gas and must have been induced in a later stage process. Most likely, this process was aqueous alteration on the Acfer 094 parent body, which led to hydration and oxidation of the ASM, which is supported by textural and chemical evidence of aqueous alteration.     

MHD simulations of the long-term evolution of a dipolar magnetosphere surrounded by an accretion disk

The evolution of a stellar, initially dipole type magnetosphere interacting with an accretion disk is investigated using numerical ideal MHD simulations. The simulations follow several 1000 Keplerian periods of the inner disk (for animated movies see http://www.aip.de～cfendt).Our model prescribes a Keplerian disk around a rotating star as a fixed boundary condition. The initial magnetic field distribution remains frozen into the star and the disk. The mass flow rate into the corona is fixed for both components. The initial dipole type magnetic field develops into a spherically radial outflow pattern with two main components – a disk wind and a stellar wind – both evolving into a quasi-stationary final state. A neutral field line divides both components, along which small plasmoids are ejected in irregular time intervals. The half opening angle of the stellar wind cone varies from 30° to55° depending on the ratio of the mass flow rates of disk wind and stellar wind. The maximum speed of the outflow is about the Keplerian speed at the inner disk radius. An axial jet forms during the first decades of rotations. However, this feature does not survive on the very long time scale and a pressure driven low velocity flow along the axis evolves. Within a cone of 15° along the axis the formation of knots may be observed if the stellar wind is weak. With the chosen mass flow rates and field strength we see almost no indication for a flow self-collimation. This is due to the weak net poloidal electric current in the magnetosphere which is in difference to typical jet models.     

Scanning electron microscopy,cathodoluminescence, and Raman spectroscopy of experimentally shock‐metamorphosed quartzite

Abstract— We studied unshocked and experimentally (at 12, 25, and 28 GPa, with 25, 100, 450, and 750°C pre‐shock temperatures) shock‐metamorphosed Hospital Hill quartzite from South Africa using cathodoluminescence (CL) images and spectroscopy and Raman spectroscopy to document systematic pressure or temperature‐related effects that could be used in shock barometry. In general, CL images of all samples show CL‐bright luminescent patchy areas and bands in otherwise nonluminescent quartz, as well as CL‐dark irregular fractures. Fluid inclusions appear dominant in CL images of the 25 GPa sample shocked at 750°C and of the 28 GPa sample shocked at 450°C. Only the optical image of our 28 GPa sample shocked at 25°C exhibits distinct planar deformation features (PDFs). Cathodoluminescence spectra of unshocked and experimentally shocked samples show broad bands in the near‐ultraviolet range and the visible light range at all shock stages, indicating the presence of defect centers on, e.g., SiO₄ groups. No systematic change in the appearance of the CL images was obvious, but the CL spectra do show changes between the shock stages. The Raman spectra are characteristic for quartz in the unshocked and 12 GPa samples. In the 25 and 28 GPa samples, broad bands indicate the presence of glassy SiO₂, while high‐pressure polymorphs are not detected. Apparently, some of the CL and Raman spectral properties can be used in shock barometry.