Analysis of Dynamic Characteristics of Submarine Free Spanning Pipelines by Complex Damping Method

Considering the effect of the internal flowing fluid and the external marine environmental condition, the differential equation for the vortex-induced vibration (V1V) of the free spanning pipeline is derived and is discretized by the Hermit interpolation function. The free vibration equation with the damping term is solved by the complex damping method for the natural frequency, and then the effect of fluid damping on the natural frequency of the free spanning pipeline is analyzed.The results show that fluid damping has a significant influence on the damped natural frequency of the free spanning pipeline in the lock-in state, while it has little influence when the pipeline is out of the lock-in state. In the meantime,the change of the free span length has the same effect on the damped natural frequency and the undamped natural frequency.     

Optimization Mathematical Model of Pile Forces for Offshore Piled Breasting Dolphins

An optimization mathematical model of the pile forces for piled breasting dolphins in the open sea under various loading conditions is presented. The optimum layout with the well distributed pile forces and the least number of piles is achieved by the multiplier penalty function method. Several engineering cases have been calculated and compared with the result of the conventional design method. It is shown that the number of piles can be reduced at least by 10%—20% and the piles‘ bearing state is improved greatly.     

长江口海水比重的直接测定

海水的比重是海水的一个重要物理性质,也是研究海水运动所必需的一个参数。关于大洋海水比重及其与氯度、盐度和电导的关系已有许多报导[3,5-9],为了制定新的国际海洋学常用表,Cox等人对世界各海洋表层海水的比重、盐度和温度的关系又进行了重新研究[3]。他们指出,除去低盐海水以外,所得结果与Knudsen水文表数据吻合较好,但Knudsen水文表的比重数据平均偏低0.006σ_t。     

Artificial upwelling induced by ocean currents —Theory and experiment

A submerged apparatus, which consists of a buoy, several horizontal contraction and expansion tubes (Venturi-type tubes) and a long pipe, is expected to be used to pump the subsurface sea-water (200–300 meter depth) containing abundant nutrients to surface layer (50–100 m) by the dynamic of ocean currents. i.e. an artificial upwelling without energy cost. A preliminary experiment and analysis are undertaken and shows that the capacity of pumping the nutrient-rich sea-water is worth to build a pilot prototype model.     

Ridge development as revealed by sub-bottom profiles on the central New Jersey shelf

Closely-spaced 3.5 kHz seismic profiles were collected over the north-easterly trending ridge and swale system 50 km east-southeast of Atlantic City, New Jersey. They yield information on the Late Quaternary depositional history of the area, and on the origin of the ridge system. Four of the sub-bottom reflectors identified were sufficiently persistent to warrant investigation and interpretation. These reflectors, which have been cored, lithologically identified, and radiocarbon dated, are stratigraphically higher than the reflectors dealt with by the majority of previous studies. The upper three reflectors are definitely mid- and post-Wisconsin in age and present a record of the most recent glacial cycle. The upper three units associated with the observed reflectors appear to exert a pronounced influence on the bathymetry. The gently corrugated ridge system of Holocene sand is formed over the regionally flat-lying upper unit, an Early Holocene lagoonal silty clay. The characteristically flat, broad depressions of the area are floored by this lagoonal material. Locally, however, marine scour has cut through the silty clay into an underlying unit of unconsolidated fine Pleistocene sand. Several stages of trough development appear to be represented. After penetrating the lagoonal clay, troughs are initially narrow, but when incised through the sand into a lower, Pleistocene, silty-clay unit, the troughs become notably wider. As downcutting is inhibited by the lower clay, the upper clay is undercut as the trough widens in a fashion similar to a desert blowout.

The sub-bottom reflectors indicate that ridge development on the central shelf has involved aggradation as well as erosion. Some ridges seem to have grown by vertical and lateral accretion from small cores. The internal structure of other ridges suggests that they formed by the coalescence of several small ridges. Others appear to have undergone appreciable lateral migration.

The ridges appear to be in a state of continuing adjustment to the hydraulic regime of the deepening post-Pleistocene water column.     

An experimental pressure compensated wet suit

Personal thermal insulation by means of neoprene from wet suits provides adequate temporary control of body heat loss only at the shallow end of the air diving depth range, but it constitutes by far the most popular approach to diver thermal support. Howewer, compression of the trapped gas phase in neoprene foam seriously reduces its insulation performance on exposure to high ambient pressure. With conventional wet suits equipped with heating, the necessary level of power required at depths greater than about 30 m is too high, and also unsafe without the back up that increased insulation would provide. One approach to the goal of depth-insensitive insulation is to use a wet suit with a continuous internal gas space pressurized nominally to ambient pressure, so that its thickness remains substantially constant at all depths. The composite material properties required are: outer skins that are tough, flexible and free of pin holes; an open foam internal structure capable of resisting, without significant dimensional change, the relatively small pressure changes that occur over the height of a man; and a high bond strength.Samples of a composite material that meets these requirements have been developed, and a prototype suit has been successfully fabricated by conventional techniques.     

X60钢在CO2饱和盐水中缓蚀作用的研究

本文采用动电位极化、线性极化、电偶电流和高压釜挂片失重等法,研究了含氮、硫有机缓蚀剂和/或Me~(2+)对X60钢在CO_2饱和的盐水溶液中的缓蚀作用。结果表明,含氮、硫的有机缓蚀剂在缓蚀过程中,开始是以抑制阳极过程为主,随后是以抑制阴极过程为主的混合型缓蚀剂。如与Me~(2+)复配使用,能明显地提高缓蚀效能。     

The buckling of a corrugated carbon fibre cylinder under external hydrostatic pressure

A theoretical and an experimental investigation was carried out, where a carbon fibre corrugated circular cylinder was tested to destuction under external hydrostatic pressure. The theoretical investigation was via the finite element method, where the structure was modelled with several orthotropic axisymmetric thin-walled shell elements. The experimental observations were aided with strategically placed strain gauges. Comparison between theory and experiment showed that the experimentally observed buckling pressure was a little lower than the theoretical prediction. This may have been due to the fact that the model had slight initial geometrical imperfections in the circumferenential direction.     

Bacterioplankton growth and production at the Louisiana hydrocarbon seeps

The growth rate and potential production of bacterioplankton in cold hydrocarbon seeps located along the Louisiana coast were determined using a pulse-labeling technique. Surprisingly, community doubling times are on the order of 1.1 h, which compares to laboratory-grown cultures. We also found that there are differences in growth rates on relatively small geographic scales, suggesting the influence of site-specific geological features (e.g., gas hydrate mounds). Proceeding downslope to deeper waters, methane-oxidizing bacteria appeared to play a more significant role in community productivity. These preliminary experiments indicated, quite unexpectedly, that water column microbes are growing at a more rapid rate than in any other marine system so far studied and that methane may serve as a primary nutrient (carbon) source in these seep-associated microbial assemblages.