饱和软土自由场地地震反应特性振动台试验

为了解软土自由场地地震反应特性,开展饱和软土自由场地地震反应特性大型振动台模型试验。分别从模型体系自振特性、震陷位移及不同土层深度测点的加速度、动孔压比等动力响应指标方面,较为深入和全面地分析饱和软土自由场地地震反应规律、破坏机理。同时还分析模型箱的"边界效应"以验证试验土箱的合理性、有效性和测试仪器性能,并由此进一步确定模型地基有效工作区域。研究表明:(1)地震动作用下,饱和软土自由场地特征频率降低,阻尼增大;(2)饱和软土自由场地对水平输入地震波具有短周期滤波、长周期放大效应,且强震作用下地基失效并表现为减隔震作用;(3)饱和软土自由场地动孔压比优势区域位于浅埋土层,并随着输入地震动强度的增大,该区域动孔压比优势逐渐减弱。该研究可为非自由软土场地试验研究提供必要的技术经验。     

不同减隔震措施下平板支座抗震性能试验研究

为探究不同减隔震措施对短边距混凝土网架平板支座的抗震性能和破坏模式的影响,分别针对不同混凝土边缘距离以及采用不同减隔震措施的四个平板支座缩尺试件进行拟静力加载试验,对平板支座破坏模式、滞回曲线、箍筋应变进行分析。试验结果表明:平板支座的运动伴随着平动和转动。当混凝土边距不足时,边缘混凝土在压剪作用下,会发生冲切破坏。开长孔支座能较好的释放水平位移,并且对锚栓约束较弱,使其受力较小,从而减轻了边缘混凝土的受力。对采用橡胶垫板的支座,混凝土边缘未发生破坏,原因是橡胶垫具有良好的变形能力,可以释放支座的位移和转角,使得边缘混凝土受力较小。因此,针对混凝土边缘距离较短的平板支座节点,为防止混凝土发生边缘破坏,可采用开长孔支座,但需要对孔长进行合理的设计。采用橡胶垫支座也可避免混凝土发生边缘破坏,橡胶垫板可按照我国相关设计规范进行设计。     

Structural architecture of Neoproterozoic rifting depression groups in the Tarim Basin and their formation dynamics

The Tarim Basin is the largest, oil-bearing, superimposed basin in the northwest of China. The evolution and tectonic properties of the initial Tarim Basin have been hotly disputed and remain enigmatic. The Neoproterozoic basin is covered by a vast desert and a huge-thickness of sedimentary strata, has experienced multiple tectonic movements, had a low signal to noise ratios(SNRs) of deep seismic reflection data, all of which have posed critical obstacles to research. We analysed four field outcrops, 18 wells distributed throughout the basin, 27 reprocessed seismic reflection profiles with higher SNRs across the basin and many ancillary local 2D and 3D profiles and aeromagnetic data. We found about 20 normal fault-controlled rifting depressions of the Cryogenian and Ediacaran scattered throughout the basin, which developed on the Precambrian metamorphic and crystalline basement. The structural framework is clearly different from that of the overlying Phanerozoic. The rifting depressions consist of mainly half grabens, symmetrical troughs and horst-grabens. From the northeast to southwest of the basin,they are divided into three rifting depression groups with the WNW, ENE, and NW-trends that are mainly controlled by normal faults. The maximum thicknesses of the strata are up to 4100 m. From the Cryogenian to Ediacaran, most of the main inherited faults to active and eventually ceased at the end of the Ediacaran or Early Cambrian, while subsidence centres appeared and migrated eastward along the faults. They revealed that the different parts of the Tarim continental block were in NNE-SSWoriented and NNW-SSE-oriented extensional paleo-stress fields(relative to the present) during the Neoproterozoic, and were accompanied by clockwise shearing. According to the analysis of the activities of syn-sedimentary faults, filling sediments,magmatic events, and coordination with aeromagnetic anomalies, the tectonic properties of the fault depressions are different and are primarily continental rifts or intra-continental fault-controlled basins. The rifting phases mainly occurred from 0.8–0.61 Ga.The formation of the rifting depression was associated with the initial opening of the South Altun-West Kunlun Ocean and the South Tianshan Ocean, which were located at the northern and southern margins of the Tarim Block, respectively, in response to the break-up of the Supercontinent Rodinia and the initial opening of the Proto-Tethys Ocean.     

地震应急微直播信息平台技术及应用

为了提高地震应急信息发布效率,解决传统地震应急信息服务不能满足当前需要的问题,基于地震网站内容管理信息系统,以地震信息数据为基础,根据信息类别和属性对Java easysite平台进行技术开发,设计了地震信息直播、地震参数、震区背景等核心功能模块。通过自动获取地震数据库信息系统,实现了平台各个功能模块信息的快速发布。该应用已被布置在中国地震局网站平台上,实现了地震应急信息平台的智能管理,进一步保证了地震应急信息的发布。     

Characteristics of the modern pollen assemblages from different vegetation zones in Northeast China: Implications for pollen-based climate reconstruction

Northeast China is an essential area for studying the strength of East Asian Summer Monsoon(EASM), due to its northernmost location in EASM domain. However, the lack of sufficient modern pollen data in this region hinders an effective interpretation of fossil pollen records and quantitative vegetation/climate reconstructions. Here, 44 surface pollen samples from forest, steppe, and meadow were used to explore pollen-vegetation-climate relationships. Cluster analysis, species indicator analysis, and principal components analysis, were used to identify the discontinuous and continuous trends in pollen dataset. In addition, correlation analysis and boosted regression trees were used to investigate primary explanatory variables, while coinertia analysis and redundancy analysis to examine pollen-vegetation and pollen-climate correlations respectively. Our results show that:(1) vegetation can be well represented by surface pollen assemblages, i.e. forest is characterized by a high proportion of tree pollen(70%) dominated by Betula(40%) along with Alnus, Larix, and Pinus, whereas Steppe by herb pollen(80%),dominated by Artemisia, Chenopodiaceae;(2) significant correlations exist between pollen assemblages and mean annual temperature and then mean annual precipitation;(3) pollen ratios of Artemisia/Chenopodiaceae and arboreal/non-arboreal can respectively be used as good indicators of humidity and temperature in Northeast China.     

APPLYING 3D INVERSION OF SINGLE-PROFILE MAGNETOTELLURIC DATA TO IDENTIFY THE SHADE AND YUNONGXI FAULTS

Many synthetic model studies suggested that the best way to obtain good 3D interpretation results is to distribute the MT sites at a 2D grid array with regular site spacing over the target area. However, MT 3D inversion was very difficult about 10 years ago. A lot of MT data were collected along one profile and then interpreted with 2D inversion. How to apply the state-of-the-art 3D inversion technique to interpret the accumulated mass MT profiles data is an important topic. Some studies on 3D inversion of measured MT profile data suggested that 2D inversions usually had higher resolution for the subsurface than 3D inversions. Meanwhile, they often made their interpretation based on 2D inversion results, and 3D inversion results were only used to evaluate whether the overall resistivity structures were correct. Some researchers thought that 3D inversions could not resolute the local structure well, while 2D inversion results could agree with the surface geologic features much well and interpret the geologic structures easily. But in the present paper, we find that the result of 3D inversion is better than that of 2D inversion in identifying the location of the two local faults, the Shade Fault(SDF)and the Yunongxi Fault(YNXF), and the deep structures. In this paper, we first studied the electrical structure of SDF and YNXF based on a measured magnetotelluric(MT) profile data. Besides, from the point of identifying active faults, we compared the capacity of identifying deep existing faults between 2D inversion models and 3D models with different inversion parameters. The results show that both 2D and 3D inversion of the single-profile data could obtain reasonable and reliable electrical structures on a regional scale. Combining 2D and 3D models, and according to our present data, we find that both SDF and YNXF probably have cut completely the high resistivity layer in the upper crust and extended to the high conductivity layer in the middle crust. In terms of the deep geometry of the faults, at the profile's location, the SDF dips nearly vertically or dips southeast with high dip angle, and the YNXF dips southeast at depth. In addition, according to the results from our measured MT profile, we find that the 3D inversion of single-profile MT data has the capacity of identifying the location and deep geometry of local faults under present computing ability. Finally, this research suggests that appropriate cell size and reasonable smoothing parameters are important factors for the 3D inversion of single-profile MT data, more specifically, too coarse meshes or too large smoothing parameters on horizontal direction of 3D inversion may result in low resolution of 3D inversions that cannot identify the structure of faults. While, for vertical mesh size and data error thresholds, they have limited effect on identifying shallow tectonics as long as their changes are within a reasonable range. 3D inversion results also indicate that, to some extent, adding tippers to the 3D inversion of a MT profile can improve the model's constraint on the deep geometry of the outcropped faults.     

高温高压下辉石岩的电导率实验研究

使用YJ-3000t紧装式六面顶高压设备和1260阻抗／增益-相位分析仪,在1．0～4．0GPa和773～1134K下用阻抗谱法就位测定了辉石岩的电导率。实验结果表明,电导率对频率具有很强的依赖性;温度是决定辉石岩电导率的一个重要物理参数,电导率随着温度升高而增大,lgσ与I／T之间符合Arrenhius关系式;随着压力升高。电导率降低,活化焓和独立于温度的指前因子亦降低。     

太湖生态脆弱性特征与消除对策的初步探讨

本文研究了Ｈｇ＾２＋,Ｃｄ＾２＋对痧生经济植物莼菜冬芽茎叶叶绿素含量,叶绿素ａ／ｂ值,可溶性蛋白含量,Ｏ＾－２含量以及活笥氧清除系统活性（ＳＯＤ,ＣＡＴ,ＰＯＤ）的影响,实验结果表明：叶绿素含量,叶绿素ａ／ｂ值、可溶性蛋白含量随着Ｈｇ＾２＋,Ｃｄ＾２＋处理浓度的加大呈下降趋势;     

多波束点云滤波算法初步研究及适用性分析

为提高多波束数据处理的准确性和简便性,研究了多波束水深点云处理的策略和关键算法,构建了kd-tree(k-dimensional tree)结构加速点云查找,针对大尺度噪点设计了半径滤波和统计滤波算法,针对小尺度噪点提出了双边滤波算法,并对以上算法的适用性进行了探讨分析。实验结果表明,当设置适合的滤波阈值,半径滤波和统计滤波能高效去除大尺度噪点,且保留地形特征,总误差分别为2.25%和2.76%。在大尺度噪点去除的基础上,改进的双边滤波可以实现地形平滑的同时,保持水深点云的有效数据量。研究成果为多波束点云数据的自动化处理提供了解决方案,对多波束测量工作的效果和效率提升做了有益尝试。     

青海湖流域50年来(1956-2007年)河川径流量变化趋势——以布哈河和沙柳河为例

通过对青海湖流域布哈河和沙柳河50年来的河川径流量分析发现,布哈河和沙柳河年径流量50年来没有显著的变化趋势,这两条河流的河川径流量对青海湖水位下降所起的作用不明显;布哈河月平均流量的年际变化在1月、2月和3月有减少的趋势,沙柳河月平均流量的年际变化在1月、2月、4月和5月亦有减少的趋势;布哈河的径流量大于沙柳河的径流量,在55%-91%频率范围内,布哈河的径流量小于沙柳河的径流量,在其它频率范围内,布哈河的径流量显著大于沙柳河的径流量,在一年中,布哈河和沙柳河的月径流量具有显著的差异;布哈河来水丰沛期是20世纪60年代,贫乏期是90年代,70和80年代为平水期;沙柳河月径流量从20世纪60年代到90年代一直比较稳定,没有发生显著的变化.