An ocean bottom,microprocessor based seismometer

We describe the design and construction of an ocean bottom seismometer configured as a computer, based on an Intersil IM6100 microprocessor plus appropriate peripheral devices. The sensors consist of triaxial 1 Hz seismometers and a hydrophone, each sensor channel being filtered prior to digitizing so that typical noise spectra are whitened. Digital data are recorded serially on magnetic tape. The instrument is placed on the ocean bottom by allowing it to fall freely from just below the surface. An acoustic system allows precise determination of instrument position, acoustic recall, and transmission of operational information to the surface. Release from an expendable anchor is accomplished by redundant pyrotechnic bolts which can be fired by acoustic command or by precision timers.The operational flexibility provided by the micro-computer, which executes the DEC PDP8/E instruction set, enables optimum use of the 6-hr recording capacity (at 128 samples/second/channel) in the context of the particular experiment being performed.

---

     

Interlaboratory calibration experiments using the polychaetous annelid Capitella capitata

An interlaboratory calibration experiment was conducted at three laboratories to test two sources of variation associated with bioassay experiments, variation due to the experimenter and to the natural seawater. Twenty-eight day static (with frequent media renewal) bioassays exposing the polychaete Capitella capitata to cadmium were conducted with synthetic and natural seawaters. Test results varied between the three laboratories; however, the variations are most probably explained by the shipment of the experimental animals to the participating laboratories.     

Variability of hydrodynamic load predictions for a tension leg platform

A survey of diffraction/radiation analyses has been performed on behalf of the International Ship and Offshore Structures Congress, Committee I.2. This paper presents the results from the survey, including data from 17 organisations plotted in a common format. The variability of the computed hydrodynamic loads and responses is discussed, and it is concluded that there is a degree of uncertainty in results predicted on the basis of commonly used idealisations. Even in long period waves the variability between the computed results is considerable. To obtain reliable results at the shorter periods associated with heave, pitch and roll resonances of a deep water TLP, much finer meshes than those used by most of the participating organisations would be required.     

Gravity field analysis of Sio Guyot: An isostatically compensated seamount in the Mid-Pacific Mountains

Positive gravity anomalies indicate two dense conduits or eruptive centers beneath the northern summit of Sio Guyot, western Mid-Pacific Mountains. The low amplitude of the positive anomalies and the gravity lows flanking the guyot can be explained by crust 2.5 times the normal Pacific Ocean crustal thickness extending to a depth of 22 ± 2 km. The excess mass of the seamount is 100% locally isostatically compensated by the mass deficit below; this compensation may result from flexural loading and voluminous sill injection near a former ridge-crest transform fault system trending roughly ENE and NNW.     

Tropospheric lapse rate and its relation to surface temperature from reanalysis data

Estimates of the tropospheric lapse rate γ and analysis of its relation to the surface temperature T _s in the annual cycle and interannual variability have been made using the global monthly mean data of the NCEP/NCAR reanalysis (1948–2001). The tropospheric lapse rate γ is about 6.1 K/km in the Northern Hemisphere (NH) as a whole and over the ocean and about 6.2 K/km over the continents. The value of γ decreases from 6.5 K/km at low latitudes to 4.5 K/km at polar latitudes. The values of dγ/dT _s, the parameter of sensitivity of γ to the variation of T _s for the NH in the interannual variability, are found to be about 0.04 km^?1 (0.041 km^?1 for the NH as a whole, 0.042 km^?1 over the ocean, and 0.038 km^?1 over the continents). This corresponds to an increase in γ of approximately 0.7% when the surface temperature of the NH is increased by 1 K. Estimates of dγ/dT _s vary from about 0.05 km^?1 in the subtropics to 0.10 km^?1 at polar latitudes. When dγ/dT _s is positive, the surface and tropospheric warming means a temperature decrease above a certain critical level H _cr. The height of the level H _cr with constant temperature, which is defined by the inverse value (dγ/dT _s)^?1, is about 25 km for the NH as a whole, i.e., above the tropopause. In the subtropics, H _cr is about 20 km. At polar latitudes, H _cr decreases to about 10 km. Positive values of dγ/dT _s characterize a positive climatic feedback through the lapse rate and indicate a general decrease in the static stability of the troposphere during global warming. Along with a general tendency of γ to increase with rising T _s, there are regional regimes with the opposite tendency, mainly over the ocean. The negative correlation of γ with T _s is found over the oceanic tropics and midlatitudes, in particular, over the oceanic belt around Antarctica.     

Sources and biogeochemical cycling of particulate selenium in the San Francisco Bay estuary

As part of a study of estuarine selenium cycling, we measured the concentration, chemical form (speciation), and distribution of particulate selenium under various river flow conditions in the North San Francisco Bay (from the Golden Gate to the Sacramento and San Joaquin Rivers). We also conducted laboratory studies on the accumulation of selenium by phytoplankton, the critical first step in the transformation of dissolved to particulate selenium. Total particulate selenium concentration in the North SF Bay was relatively constant between high and low flow periods, ranging spatially from 0.05 to 0.35 nmol l⁻¹ and comprising between 5 and 12% of the total water column selenium inventory. Mean concentrations were generally highest in the Carquinez Strait–Suisun Bay region (salinity 0–17) and lowest in Central Bay. However, selenium content of suspended particles varied with river flow, with higher content during low flow (9.76 ± 4.17 nmol g⁻¹; mean ± sd; n = 67) compared to high flow (7.10 ± 4.24 nmol g⁻¹; n = 39). Speciation analyses showed that most particulate selenium is organic selenide (45 ± 27%), with a smaller proportion (typically <30%) of adsorbed selenite + selenate and a varying proportion (35 ± 28%) of elemental selenium. Based on the amount of elemental selenium in the seston (total suspended material), we calculate that resuspension of estuarine sediments could contribute 29–100% of particulate selenium in the water column. While selenium content of SF Bay seston (>0.4 μm) is relatively unenriched compared to phytoplankton (13.6–155 nmol g⁻¹ dry weight) on a mass basis, when normalized to carbon or nitrogen, seston contains a similar selenium concentration to SF Bay sediments or phytoplankton cultures. SF Bay seston is thus comprised of selenium-rich phytoplankton and phyto-detritus, but also inorganic clay mineral particles that effectively “dilute” total particulate selenium. Selenium concentrations in algal cultures (11 species) exposed to 90 nmol l⁻¹ selenite show relatively large differences in selenium accumulation, with the diatoms, chlorophytes and cryptophytes generally having lower selenium cell content (3.8 ± 2.7 × 10⁻⁹ nmol selenium cell⁻¹) compared to the dinoflagellates (193 ± 73 × 10⁻⁹ nmol selenium cell⁻¹). Because phytoplankton are such a rich (but variable) source of selenium, their dynamics could have a profound effect on the particulate selenium inventory in the North SF Bay.