SHRIMP U–Pb ages of diagenetic and hydrothermal xenotime from the Archaean Witwatersrand Supergroup of South Africa

SHRIMP dating of xenotime overgrowths on detrital zircon grains can constrain maximum durations since diagenesis and therefore provide minimum dates of sediment deposition. Thus, xenotime dating has significant economic application to Precambrian sediment-hosted ore deposits, such as Witwatersrand Au–U, for which there are no precise depositional ages. The growth history of xenotime in the Witwatersrand Supergroup is texturally complex, with several phases evident. The oldest authigenic xenotime ²⁰⁷Pb/²⁰⁶Pb age obtained in sandstone underlying the Vaal Reef is 2764 ± 5 Myr (1 σ), and most likely represents a mixture of diagenetic and hydrothermal growth. Nevertheless, this represents the oldest authigenic mineral age yet recorded in the sequence and provides a minimum age of deposition. Other xenotime data record a spread of ages that correspond to numerous post-diagenetic thermotectonic events (including a Ventersdorp event at ≈ 2720 Ma) up to the ≈2020 Ma Vredefort event.     

The mass ratio of Nova Muscae 1991

We report intermediate resolution H spectroscopy of the black hole candidate Nova Muscae 1991 during quiescence. We classify the companion star as a K3-K4V which contributes 85±6 percent to the total flux from the binary. The photospheric absorption lines are broadened by 106±13 kms⁻¹ with respect to template field stars, leading to a system mass ratio of q =M₁/M₂ = 7.8_−2.0^+3.4. Doppler imaging of the H line shows strong emission coming from the secondary star (EW=3.1±0.6Å) which we associate with chromospheric activity. However, the hot-spot is not detected and this may indicate a lower mass transfer rate than in other X-ray transients of comparable orbital periods. The surface brightness distribution of the accretion disk in H follows a relation I∝R^−1.1, less steep than typically observed in cataclysmic variables. Updated system parameters are also presented.     

Near-Infrared Imaging Spectrophotometry Of Comet C/1995 O1 (Hale-Bopp) Near Perihelion

We present 1- to 5-μm broadband and CVF images of comet Hale-Bopp taken 1997 February 10.5 UT, 50 days before perihelion. All the images exhibit a nonspherical coma with a bright “ridge” in the direction of the dust tail approximately 10″ from the coma. Synthetic aperture spectrophotometry implies that the optically important grains are of a radius ≤0.4 μm; smallest radius for any comet seen to date. The variation of the integrated surface brightness with radial distance from the coma (ρ) in all the images closely follows the “steady state” ρ⁻¹ model for comet dust ablation (Gehrz and Ney, 1992). The near-infrared colors taken along the dust tail are not constant implying the dust grain properties vary with coma distance. This revised version was published online in July 2006 with corrections to the Cover Date.     

Porphyroblast inclusion-trail orientation data: eppure non son girate*!

Extensive examination of large numbers of spatially orientated thin sections of orientated samples from orogens of all ages around the world has demonstrated that porphyroblasts do not rotate relative to geographical coordinates during highly non-coaxial ductile deformation of the matrix subsequent to their growth. This has been demonstrated for all tectonic environments so far investigated. The work also has provided new insights and data on metamorphic, structural and tectonic processes including: (1) the intimate control of deformation partitioning on metamorphic reactions; (2) solutions to the lack of correlation between lineations that indicate the direction of movement within thrusts and shear zones, and relative plate motion; and (3) a possible technique for determining the direction of relative plate motion that caused orogenesis in ancient orogens.     

Simulation of adaptive optics for the Vacuum Tower Telescope

A simulation model of the adaptive optics of the German Vacuum Tower Telescope (VTT), Observatorio del Teide, Tenerife, is presented. The model uses modules from the integrated model of the Euro50 extremely large telescope, and includes submodels of a Shack-Hartmann wavefront sensor, a de-formable mirror, a tip-tilt mirror, high-voltage amplifier low-pass filters, a reconstructor and a controller. We investigate the impact on the closed loop bandwidth of changes in controller configuration and certain system parameters, such as low pass filter bandwidth and camera integration and readout time. Control strategies were tested on simple models before implementation on the full VTT model. Using the models, different control strategies are compared.     

Observing the CMB at high-ℓ using the VSA and AMI

We discuss two experiments – the Very Small Array (VSA) and the Arcminute MicroKelvin Imager (AMI) – and their prospects for observing the CMB at high angular multipoles. Whilst the VSA is primarily designed to observe primary anisotropies in the CMB, AMI is designed to image secondary anisotropies via the Sunyaev–Zel’dovich effect. The combined ℓ-range of these two instruments is between ℓ=150 and 10,000.     

Environmental effects on galaxy luminosity functions: the cluster Abell 496

We have derived the galaxy luminosity function in various regions of the cluster of galaxies Abell 496 from a wide field image in the I band. A Schechter function fit in the 17≤ I_AB ≤22(–19.5≤ M_IAB ≤ –14.5) magnitude interval gives a steep power law index, which is somewhat steeper in the outer regions than in the inner zones. This result agrees with previous findings obtained by several teams on the Coma cluster and can be interpreted as due to the fact that faint galaxies are accreted by large ones in the central regions. This revised version was published online in July 2006 with corrections to the Cover Date.     

Transient‐state groundwater flow in various geometries with wells at arbitrary positions: analytical methods

We have developed a method for analytically solving the porous medium flow equation in many different geometries for horizontal (two‐dimensional), homogeneous and isotropic aquifers containing impermeable boundaries and any number of pumping or injection wells located at arbitrary positions within the system. Solutions and results are presented for rectangular and circular aquifers but the method presented here is easily extendible to many geometries. Results are also presented for systems where constant head boundary conditions can be emulated internal to the aquifer boundary. Recommendations for extensions of the present work are briefly discussed. Copyright © 2003 John Wiley & Sons, Ltd.     

Structurally controlled gold and sulfosalt mineralization: the Altenberg example, Salzburg Province, Austria

Summary ?In the south-eastern Altenbergkar–Silbereck area in the eastern Tauern window (Lungau, Salzburg) structurally controlled precious-metal (Au–Ag) mineralization is hosted in marbles of the Permo(?)-Mesozoic Silbereck Formation and in the underlying Variscan Central gneiss. During the Alpine otogeny both lithologies were affected by ductile deformation (shearing, D1; folding, D2/D3) and subsequent brittle deformation (tension gashes, D4; normal faulting, D5) related to the uplift and exhumation of the Tauern window. Mineralization is controlled by brittle D4 structures. NE–SW trending steeply dipping tension gashes of the “Tauerngoldgang” type occur within the Central gneiss. Three different marble-hosted ore types following fracture systems as well as foliation and bedding planes can be distinguished: 1) metasomatic replacement ores, 2) ores in tension gashes and 3) ores in talc-bearing structures, often containing high-grade gold and silver mineralization (native gold in association with Ag–Pb–Bi–sulfosalts). Four stages of mineralization can be distinguished which occur in all ore types: arsenopyrite–pyrite–pyrrhotite (first stage), Au–(Ag–Pb–Bi–sulfosalts) (second stage), base-metal sulfides and tetrahedrite–tennantite (third stage) and Ag-rich galena (fourth stage). Preliminary fluid inclusion data indicate temperatures of ore formation well above 300 °C (346 °C mean) for the second stage within the Central gneiss and temperatures between 310 and 230 °C for the second and third stages in the marble. Received October 12, 2001; revised version accepted September 5, 2002 Published online March 10, 2003