Characterization of interface roughness of rippled sand off Fort Walton Beach, Florida

As part of the environmental characterization to model acoustic bottom scattering during the high-frequency sediment acoustics experiment (SAX99), fine-scale sediment roughness of a medium sand was successfully measured within a 600 /spl times/ 600-m area by two methods: stereo photography and a technique using a conductivity system. Areal coverage of the two methods, representing approximately 0.16 m/sup 2/ of the sea floor, was comparable, resulting in the depiction and quantification of half-meter wavelength sand ripples. Photogrammetric results were restricted to profiles digitized at 1-mm intervals; sediment conductivity results generated gridded micro-bathymetric measurements with 1- to 2-cm node spacing. Roughness power spectra give similar results in the low-spatial-frequency domains where the spectra estimated from both approaches overlap. However, spectra derived from higher resolution photogrammetric results appear to exhibit a multiple-power-law fit. Roughness measurements also indicate that spectrum changes as a function of time. Application of statistical confidence bounds on the power spectra indicates that roughness measurements separated by only 1-2 m may be spatially nonstationary.     

Surface heat fluxes and subsurface heat content at a site over the southeastern Bering Sea shelf, May–July 1996

Observations from a surface mooring, in a weak-flow regime over the southeastern Bering Sea shelf, were used to derive surface heat fluxes for the period May–July 1996. Changes in heat content of the water column also were determined from subsurface temperature measurements. Agreement of net surface heat flux and change in heat content was within 2%. This result provides additional evidence that heat advection and diffusion are small in this region.     

The effects of oil exploration and production in the northern North Sea: Part 2—microbial biodegradation of hydrocarbons in water and sediments, 1978–1981

The potential of heterotrophs to degrade aromatic hydrocarbons derived from oil in water and sediments in the northern North Sea around the Brent, Beryl, Forties and Murchison oilfields and at a number of stations, from the Forties field to the Firth of Forth, was estimated using 1-¹⁴C naphthalene and 7, 10-¹⁴C benzo(a)pyrene. The degradation of uniformly labelled ¹⁴C mixed 1-amino acids was used as a measure of total heterotrophic activity. Results showed that microorganisms have the potential to degrade the smaller aromatic hydrocarbon molecules rapidly in the water column and in surface sediments. Close to the Beryl platform, where diesel-washed drill cuttings have been continuously dumped, the rate of input of hydrocarbons to the sediment has exceeded the rate of degradation. Mineralization of benzo(a)pyrene, estimated in the sediments only, was minimal. Close to production platforms the biodegradation rate of mixed 1-amino acids showed no increase comparable with that found for naphthalene, suggesting that existing microbial populations had not increased but adapted to degrade oil in water and sediments.     

Effect of shallow and narrow water on added mass of cylinders with various cross-sectional shapes

The sway, heave and roll added masses of three uniform cylinders with semi-circular, rectangular and triangular cross-sectional shapes in shallow and narrow water are numerically analysed. The method is based on simulation of the potential flow induced by the cylinder's mode of motion. The effects of shallow and narrow water on added mass are analysed and presented. It is concluded that the shallow and narrow water effects on added mass depend on the different cross-section shapes of the cylinders. In particular, the water depth effect on sway added mass is stronger than that on heave added mass while the narrow water effect on sway is weaker than that on heave. The shallow water effect on added mass tends to weaken the narrow water effect. Lastly the effect of shallow and narrow water on added mass on a rectangular cylinder is the strongest while that on a triangular cylinder is the weakest.     

Sample Disturbance in Soft and Sensitive Clays: Analysis and Assessment

Despite the sophisticated methods employed to obtain high quality samples, they are prone to disturbance, due to stress release, let apart, due to sampling tools and techniques adopted. Critical reappraisal of different methods suggest that any method of sample quality assessment involving strength and deformation parameters would enable easier implementation and correct other engineering parameters for estimated sample disturbance. In this technical paper, sample disturbance index, using merely the slopes of compression paths, (representing mechanical response), in the pre- and post-yield stress regimes under odeometric loading conditions is proposed. This method is based on single oedometer test results on samples of unknown degrees of disturbance during sampling and handling. The unique feature of this approach is that the ideal rigid plastic material behavior is taken as reference. This eliminates the need for any additional experimental data or any calculations from the relationships formulated with any set of assumptions.     

Remote estimation of surficial seafloor properties through the application Angular Range Analysis to multibeam sonar data

The variation of the backscatter strength with the angle of incidence is an intrinsic property of the seafloor, which can be used in methods for acoustic seafloor characterization. Although multibeam sonars acquire backscatter over a wide range of incidence angles, the angular information is normally neglected during standard backscatter processing and mosaicking. An approach called Angular Range Analysis has been developed to preserve the backscatter angular information, and use it for remote estimation of seafloor properties. Angular Range Analysis starts with the beam-by-beam time-series of acoustic backscatter provided by the multibeam sonar and then corrects the backscatter for seafloor slope, beam pattern, time varying and angle varying gains, and area of insonification. Subsequently a series of parameters are calculated from the stacking of consecutive time series over a spatial scale that approximates half of the swath width. Based on these calculated parameters and the inversion of an acoustic backscatter model, we estimate the acoustic impedance and the roughness of the insonified area on the seafloor. In the process of this inversion, the behavior of the model parameters is constrained by established inter-property relationships. The approach has been tested using a 300 kHz Simrad EM3000 multibeam sonar in Little Bay, NH. Impedance estimates are compared to in situ measurements of sound speed. The comparison shows a very good correlation, indicating the potential of this approach for robust seafloor characterization.     

Variations in age-0 pollock distribution among eastern Bering Sea nursery areas: A comparative study through acoustic indices

Cohort abundance of walleye pollock (Theragra chalcogramma) is subject to strong interannual variation in the eastern Bering Sea, and this variation is known to be determined largely at the age-0 stage. We estimated the spatial distributions and densities of age-0 walleye pollock in five nursery areas around the eastern Bering shelf in three successive years (1997–1999) from acoustic survey data. Concurrently, we calculated estimates of the spatial distribution of euphausiids, a major prey of age-0 walleye pollock, and estimates of spatial overlap of groundfish predators with the age-0 walleye pollock. The analyses showed that all nursery areas had low densities of age-0 walleye pollock in 1997, which ultimately produced the weakest adult year-class. In the intermediate year of 1998, age-0 densities were low to medium, and in 1999, which produced the strongest of the three adult year-classes, all nursery areas had medium to high age-0 walleye pollock densities. Euphausiid distributions had a consistently positive spatial relationship with age-0 walleye pollock. Groundfish predator density ratios were positively related to age-0 walleye pollock density when age-0 walleye pollock were displaced relatively northward. Our results suggest that abundance of age-0 walleye pollock, and hence of adult cohorts in the eastern Bering Sea, can be predictable from a concise set of indicators: the densities of age-0 walleye pollock at nursery areas in mid- to late-summer, their spatial relationship to euphausiids and groundfish predators, and the latitudinal trend of their distributions. The 3 years 1997–1999 had significant differences of physical conditions in the eastern Bering Sea, and represent an advantageous framework for testing these hypotheses.     

4D seismic time-lapse monitoring of an active cold vent,northern Cascadia margin

Two single-channel seismic (SCS) data sets collected in 2000 and 2005 were used for a four-dimensional (4D) time-lapse analysis of an active cold vent (Bullseye Vent). The data set acquired in 2000 serves as a reference in the applied processing sequence. The 4D processing sequence utilizes time- and phase-matching, gain adjustments and shaping filters to transform the 2005 data set so that it is most comparable to the conditions under which the 2000 data were acquired. The cold vent is characterized by seismic blanking, which is a result of the presence of gas hydrate in the subsurface either within coarser-grained turbidite sands or in fractures, as well as free gas trapped in these fracture systems. The area of blanking was defined using the seismic attributes instantaneous amplitude and similarity. Several areas were identified where blanking was reduced in 2005 relative to 2000. But most of the centre of Bullseye Vent and the area around it were seen to be characterized by intensified blanking in 2005. Tracing these areas of intensified blanking through the three-dimensional (3D) seismic volume defined several apparent new flow pathways that were not seen in the 2000 data, which are interpreted as newly generated fractures/faults for upward fluid migration. Intensified blanking is interpreted as a result of new formation of gas hydrate in the subsurface along new fracture pathways. Areas with reduced blanking may be zones where formerly plugged fractures that had trapped some free gas may have been opened and free gas was liberated.