2017年南丹Ms4.0地震前后重力变化

利用广西及邻区2014~2017年流动重力观测资料,系统分析区域重力场变化及其与2017-07-15广西南丹MS4.0地震的关系,并结合GPS观测数据与地震地质调查成果,探讨区域重力场变化的时空分布特征及机理。结果表明：1）南丹M_S4.0地震前后,震区附近重力异常变化与主干断裂关系密切,反映沿控震断裂在2014~2017年间发生了引起地表重力变化效应的地壳变形和构造活动;2）差分重力图像表明,南丹M_S4.0地震前重力变化为“局部重力异常→四象限重力异常→重力反向变化发震”的过程;3）重力变化与GPS 观测反映的水平运动表明,南丹M_S4.0地震位于重力四象限分布中心部位及面压缩峰值附近,证明重力场和形变场动态变化对中强地震地点预测具有指示意义;4）天峨-南丹-环江一带是重力变化最剧烈地区,亦是水平形变面压缩过渡带,同时位于莫霍面等深线强烈变化地段、M_L3.0地震围空区、沿主断裂存在的低b值异常区。结合地震活动图像、定点前兆观测异常综合分析认为,该地区仍存在发生中强地震的可能。     

水牛蹄型深海集矿机履齿设计及牵引性能研究

作为深海采矿系统的重要组成部分,深海集矿机的技术研究和开发一直是许多国家的难题。为了提高深海集矿机在稀软沉积物上的牵引性能,基于水牛蹄的曲面结构特征和特殊几何结构,设计了一款仿水牛蹄蹄型履齿。以该款履齿的结构参数为研究对象,通过对朗肯被动土压力理论的优化,得到了仿水牛蹄蹄型履齿的牵引力解析解,建立了对应的履齿仿生参数对履齿牵引力的影响公式。结合正交试验方法进行了不同形式履齿在沉积物上运动的单、多履齿剪切试验,将仿水牛蹄蹄型履齿与直型履齿、仿水牛蹄轮廓履齿（另一种仿生履齿）进行对比试验,并通过模型车试验验证了该款履齿的可行性。结果表明：3种履齿中,仿水牛蹄蹄型履齿提供的最大牵引力最高。研究可为进一步优化仿水牛蹄蹄型履齿结构参数和提高深海稀软底质机械的牵引性能提供参考依据。     

An improved SPH method for saturated soils and its application to investigate the mechanisms of embankment failure: Case of hydrostatic pore‐water pressure

The method of smoothed particle hydrodynamics (SPH) has recently been applied to computational geomechanics and has been shown to be a powerful alternative to the standard numerical method, that is, the finite element method, for handling large deformation and post‐failure of geomaterials. However, very few studies apply the SPH method to model saturated or submerged soil problems. Our recent studies of this matter revealed that significant errors may be made if the gradient of the pore‐water pressure is handled using the standard SPH formulation. To overcome this problem and to enhance the SPH applications to computational geomechanics, this article proposes a general SPH formulation, which can be applied straightforwardly to dry and saturated soils. For simplicity, the current work assumes hydrostatic pore‐water pressure. It is shown that the proposed formulation can remove the numerical error mentioned earlier. Moreover, this formulation automatically satisfies the dynamic boundary conditions at a submerged ground surface, thereby saving computational cost. Discussions on the applications of the standard and new SPH formulations are also given through some numerical tests. Furthermore, techniques to obtain the correct SPH solution are also proposed and discussed throughout. As an application of the proposed method, the effect of the dilatancy angle on the failure mechanism of a two‐sided embankment subjected to a high groundwater table is presented and compared with that of other solutions. Finally, the proposed formulation can be considered a basic formulation for further developments of SPH for saturated soils. Copyright © 2011 John Wiley & Sons, Ltd.     

Ultra-high pressure metamorphic rocks in the Dabie-Su-Lu region, China: Their formation and exhumation

Abstract Based on petrological, structural, geological and geochronological research, the authors summarize the progress of ultra-high pressure (UHP) metamorphic rock study since 1989 by Chinese geoscientists and foreign geoscientists in the Dabie-Su-Lu region. The authors introduce and discuss a two-stage exhumation process for the UHP metamorphic rocks that have various lithologies; eclogite, ultramafics, jadeitic quartzite, gneiss, schist and marble. The metamorphic history of UHP metamorphic rocks is divided into three stages, that is, the pre-eclogite stage, coesite eclogite stage, and retrograde stage. Prior to UHP metamorphism, the ultramafics had a high temperature environment assemblage of mantle and others had blueschist facies assemblages. The granulite facies assemblages, which have recorded a temperature increase event with decompression, have developed locally in the Weihai basaltic rocks. Isotopic ages show a long range from > 700 Ma to 200 Ma. The diversity in protoliths of UHP metamorphic rocks may be related to the variation of isotopic ages older than 400 Ma. The Sm-Nd dating of ~ 220 Ma could reflect the initial exhumation stage after the peak UHP metamorphism in relation to the collision between the Sino-Korean and Yangtze blocks and subsequent events. Petrological and structural evidence imply a two-stage exhumation process. During the initial exhumation, the UHP metamorphic rocks were sheared and squeezed up in a high P/T regime. In the second exhumation stage the UHP metamorphic rocks were uplifted and eventually exposed with middle crustal rocks.     

Ultrahigh-pressure garnet lherzolite from Chijiadian, Rongcheng County, in the Su-Lu region of eastern China

Abstract Petrological studies of a serpentinized garnet lherzolite body in Rongcheng of the Su-Lu region of eastern China revealed unusually high pressure. Spinel lherzolite probably in a subducting slab was transformed to garnet lherzolite at mantle depth. During exhumation, they were subsequently subjected to the granulite and then amphibolite overprinting and a phase of serpentinization. The peak P–T conditions of the garnet lherzolite estimated after detailed analysis of the metamorphic texture are 4–5 GPa and 820°C or 5–6 GPa and 780°C, depending on the chosen geothermobarometers. The lower dP/dT of the garnet lherzolite can be interpreted as the results of subduction of an old (say 100 Ma older than the time of collision) and cold, slab underneath the margin of the Sino–Korean craton.     

在砂土液化的危险性评价中确定性与不确定性方法的应用研究

地震导致的砂土液化具有很大的随机性。据此 ,提出了评价砂土液化危险性的确定性与不确定性两种方法。确定性方法是以液化指数为变量的多因子判别分析方法 ,不确定性方法是概率分析法 ,即用概率密度函数判断砂土液化灾害的期望损失值。     

我国东部新生代玄武岩岩石化学的一些探讨

新生代是地球上玄武质岩浆的主要活动期。在我国东部,新生代玄武岩分布也极广泛,由北往南自大兴安岭、松辽盆地经华北、苏闽浙至台湾、海南岛以及近海大陆架均有不同程度的出露。时间上从老第三纪至史期均有玄武岩喷发活动。     

Lg Coda Q and its Relation to the Geology and Tectonics of the Middle East

—Regional seismograms were collected to image the lateral variations of Lg coda Q at 1 Hz (Q ₀?) and its frequency dependence <(eta)> in the Middle East using a back-projection method. The data include 124 vertical-component traces recorded at 10 stations during the period 1986–1996. The resulting images reveal lateral variations in both Q ₀ and <eta>. In the Turkish and Iranian Plateaus, a highly deformed and tectonically active region, Q ₀ ranges between about 150 and 300, with the lowest values occurring in western Anatolia where extremely high heat flow has been measured. The low Q ₀ values found in this region agree with those found in other tectonically active regions of the world. Throughout most of the Arabian Peninsula, a relatively stable region, Q ₀ varies between 350 and 450, being highest in the shield area and lowest in the eastern basins. All values are considerably lower than those found in most other stable regions. Low Q values throughout the Middle East may be caused by interstitial fluids that have migrated to the crust from the upper mantle, where they were probably generated by hydrothermal reactions at elevated temperatures known to occur there. Low Q ₀ values (about 250) are also found in the Oman folded zone, a region with thick sedimentary deposits. <eta> varies inversely with Q ₀ throughout most of the Middle East, with lower values (0.4–0.5) in the Arabian Peninsula and higher values (0.6–0.8) in Iran and Turkey. Q ₀ and <eta> are both low in the Oman folded zone and western Anatolia.     

Seismic Velocity and Q Structure of the Middle Eastern Crust and Upper Mantle from Surface-wave Dispersion and Attenuation

—Observed velocities and attenuation of fundamental-mode Rayleigh waves in the period range 7–82 sec were inverted for shear-wave velocity and shear-wave Q structure in the Middle East using a two-station method. Additional information on Q structure variation within each region was obtained by studying amplitude spectra of fundamental-mode and higher-mode Rayleigh waves. We obtained models for the Turkish and Iranian Plateaus (Region 1), areas surrounding and including the Black and Caspian Seas (Region 2), and the Arabian Peninsula (Region 3). The effect of continent-ocean boundaries and mixed paths in Region 2 may lead to unrealistic features in the models obtained there. At lower crustal and upper-mantle depths, shear velocities are similar in all three regions. Shear velocities vary significantly in the uppermost 10 km of the crust, being 3.21, 2.85, and 3.39 km/s for Regions 1, 2, and 3, respectively. Q models obtained from an inversion of interstation attenuation data show that crustal shear-wave Q is highest in Region 3 and lowest in Region 1. Q’s for the upper 10 km of the crust are 63, 71, and 201 for Regions 1, 2, and 3, respectively. Crustal Q’s at 30 km depth for the three regions are about 51, 71, and 134. The lower crustal Q values contrast sharply with results from stable continental regions where shear-wave Q may reach one thousand or more. These low values may indicate that fluids reside in faults, cracks, and permeable rock at lower crustal, as well as upper crustal depths due to convergence and intense deformation at all depths in the Middle Eastern crust.