A Simulation Model for the Evaluation of the Electrical Power Potential Harnessed by a Marine Current Turbine

This paper deals with the development of a Matlab-Simulink model of a marine current turbine system through the modeling of the resource and the rotor. The simulation model has two purposes: performances and dynamic loads evaluation in different operating conditions and control system development for turbine operation based on pitch and speed control. In this case, it is necessary to find a compromise between the simulation model accuracy and the control-loop computational speed. The blade element momentum (BEM) approach is then used for the turbine modeling. As the developed simulation model is intended to be used as a sizing and site evaluation tool for current turbine installations, it has been applied to evaluate the extractable power from the Raz de Sein (Brittany, France). Indeed, tidal current data from the Raz de Sein are used to run the simulation model over various flow regimes and yield the power capture with time.     

Statistical Analysis of Nitrate Movement through the Soil in Central Kansas

An earlier investigation by the Kansas Geological Survey in central Kansas studied the movement of nitrate from fertilizer through soil into the groundwater. Nitrate concentrations in soil water were measured on samples collected at three locations during a three-year span, from sets of lysimeters buried at different depths. Although patterns seemed apparent in the resulting measurements, no statistical analyses were performed to test their significance; this re-study of the data uses analyses of variance to test for differences in nitrate concentration attributable to time and to depth in the soil. The mean nitrate concentration of samples collected in the first year of the experiment was significantly higher than the means of second and third year samples at all three locations, perhaps reflecting the confounding influence of a previous flooding experiment. ANOVAs of depth across years determined few significant differences in nitrate concentration with depth. The wintertime gap in measurements and unequal sampling through time precludes formal time-series analyses, but graphs of concentration versus time show that peak concentration occurs at later times with increasing depth, and that maximum concentration decreases with depth. These statistical analyses support the conclusions from the original investigation.     

Physical properties of asteroid 433 Eros

Newly available photometric, polarimetric, spectroscopic, thermal-radiometric, radar, and occultation results are synthesized in order to derive a coherent model for Eros. The geometric albedo is 0.19±0.01 at the visual wavelength, and the overall dimensions are approximately 13 × 15 × 36km. The rotation is about the short axis, in the direct sense, with a sidereal period of 5^h16^m13^s.4. The pole of rotation lies within a few degrees of ecliptic coordinates λ = 16° and β = + 11°.Eros is uniformly coated with a particulate surface layer several millimeters thick. It has an iron-bearing silicate composition, similar to that of a minority of main-belt asteroids, and probably identifiable with H-type ordinary chondrites.     

Crystal fractionation in the friction melts of seismic faults (Alpine Fault, New Zealand)

Compositional variations are documented in friction melts along the Hari Hari section of the Alpine Fault, New Zealand, with multiple stages of melt injection into quartzo-feldspathic schists. Intermediate to felsic melts were heterogeneous in composition, but all fractions show a common trend, with a tendency for the younger melt layers and glasses to be more alkali − (Na + K) and Si-enriched, while being depleted in mafic (Fe + Mg + Mn) components. These changes are attributed primarily to crystal fractionation of the melt during transport. Farther traveled molten layers were on the whole less viscous, mostly due to a higher melt-to-clast ratio; however, compositional change, together with a decrease in volatile content, produced a progressively more viscous liquid melt with time. The glass phase is interpreted as a remnant of this high viscosity felsic residual melt that was preserved during final quenching. Following initial failure, the formation of largely phyllosilicate-derived, volatile-rich, lower viscosity melt corresponds with a phase of fault weakening. Subsequent rapid crystal fractionation during melt transport, the loss of volatiles and freezing of residual melt contributed to the strengthening of the fault during seismic slip.     

Prospection géoélectrique pour l'étude de l'aquifère thermal des calcaires récifaux, Hmeïma–Boujabeur (Centre ouest de la Tunisie)

The Hmeïma–Boujabeur zone is considered as an important geothermal province for Tunisia. The reef limestone, characterized by intense fracturation and important karstification, confers them the property to be a regional thermal aquifer. A geophysical study based on two complementary geoelectrical methods, the Electrical Sounding (ES) and Magneto-Telluric Sounding (MTS), turned out to be very efficient to provide a complete electrical image of the underground until about 1-km depth. The synthetic approach integrating all data allowed us to delimit the favourable area for thermal water exploitation. To cite this article: M. Gouasmia et al., C. R. Geoscience 338 (2006).     

Syn-folding remagnetization of Cambro-Ordovician carbonates from the Pennsylvania Salient post-dates oroclinal rotation

Paleomagnetic directions of 35 sites of Cambro-Ordovician carbonates from 10 anticlines were analyzed to test models of curvature along the Pennsylvania Salient of the Appalachians and to constrain the relative timing of magnetization acquisition. The sites yield directions of magnetization that are almost all reversed with near-horizontal inclinations upon appropriate structural correction. The common, Late Paleozoic (Kiaman-aged) direction and incremental fold tests show that these directions represent remagnetizations carried by authigenic magnetite, acquired just before or during the earlier phases of folding. No convincing indications were found of primary magnetizations. Mean declinations from the northeastern and southwestern limbs of the salient differ by a few degrees, indicating negligible, if any, rotation between the limbs. The results are similar to prior studies of overlying Siluro-Devonian carbonates, showing coherent behavior of the entire Paleozoic cratonic cover. We conclude that the statistically negligible difference in declination indicates that (previously demonstrated) oroclinal bending occurred before carbonates of the Paleozoic stratigraphic cover were remagnetized during the Permian and before regional folding was completed.