The relationship of total dissolved solids measurements to bulk electrical conductivity in an aquifer contaminated with hydrocarbon

A recent conceptual model links higher bulk conductivities at hydrocarbon impacted sites to higher total dissolved solids (TDS) resulting from enhanced mineral weathering due to acids produced during biodegradation. In this study, we evaluated the above model by investigating the vertical distribution of bulk conductivity, TDS, and specific conductance in groundwater. The results showed higher TDS at contaminated locations consistent with the above model. Further, steep vertical gradients in bulk conductivity and TDS suggest vertical and spatial heterogeneity at the site. We observed that at fluid conductivities <40 mS/m, bulk conductivity was inversely related to fluid conductivity, but at fluid conductivities >40 mS/m, bulk conductivity increased with increasing fluid conductivity. However, at fluid conductivities >80 mS/m, bulk conductivities increased without a corresponding increase in fluid conductivity, resulting in a poor correlation between bulk conductivity and fluid conductivity for the contaminated samples. This suggests that electrolytic conductivity was not completely responsible for the observed variability in bulk conductivity. We suggest two possible reasons for the inverse relationship at low fluid conductivity and poor positive correlation at high fluid conductivity: (1) geochemical heterogeneity due to biological processes not captured at a scale comparable to the bulk conductivity measurement and (2) variability in the surface conductivity, consistent with a simple petrophysical model that suggests higher surface conductivity for contaminated sediments. We conclude that biodegradation processes can impact both electrolytic and surface conduction properties of contaminated sediments and these two factors can account for the higher bulk conductivities observed in sediments impacted by hydrocarbon.     

Sediment movement rates and processes on cinder cones in the maritime Subantarctic (Marion Island)

Sediment transport in the scoria areas of Marion Island is primarily the result of needle‐ice‐induced frost creep associated with diurnal soil frost cycles. Clasts move most rapidly in ?ne textured areas (532 mm a^?1; SD 382), more slowly in stony areas (161 mm a^?1; SD 179), and most slowly in blocky areas (26 mm a^?1; SD 23). Movement rates increase with increasing frost susceptibility of sediments, slope angle and altitude. The heave of dowels indicates that frost heave is active in all the scoria areas examined. The depth of effective frost heave increases with increasing altitude, with frost heave being restricted to the upper 100 mm of the soil in low altitude areas (<200 m). The heave of 150 mm dowels at the higher altitude sites provides evidence for segregation ice formation at depths greater than those associated with needle ice and diurnal soil frost cycles. Vertical movement pro?les show a concave downslope pro?le, with sediment movement rates being most rapid at the soil surface and decreasing rapidly with depth. This pro?le shape is typical of areas dominated by diurnal freeze–thaw cycles and needle ice. The capture of sediments moving downslope in troughs and the sampling of material lifted by needle ice, suggest that sediment transport by needle ice under present conditions is extremely effective. Observations suggest that although both ?ne material and clasts are transported downslope, some preferential transport of clasts occurs. Experiment results and observations of soil frost processes suggest that frost creep associated with needle ice activity is the dominant slope process in the scoria areas of Marion Island. Other slope processes such as slopewash and debris ?ows appear to play a relatively minor and localized role in sediment transport. It is suggested that needle ice activity is likely to be the dominant geomorphic agent in other areas of the Subantarctic with similar climatic characteristics to Marion Island. Copyright © 2004 John Wiley & Sons, Ltd.     

Progressive hybridisation between Late Devonian mafic-intermediate and felsic magmas in the Meguma Zone of Nova Scotia, Canada

Two felsic plutons of Late Devonian (385–370 Ma) age in the Meguma Zone of southwestern Nova Scotia contain three circa 376 Ma synplutonic mafic-intermediate intrusions that collectively record progressive stages of in situ hybridisation. A 5 m wide spessartite dyke in the Port Mouton Pluton probably underwent rapid cooling and crystallisation immediately after intrusion, which heated and coarsened the adjacent tonalite. An 85 m long sheet of pillowed kersantite (also in tonalite of the Port Mouton Pluton) presumably contained residual magma after quenching and obtained K, P, Ba, Rb, more radiogenic Sr, Zr, Nb, and light REE from the tonalite during magma mingling. The third synplutonic body, a >100 m wide diorite sheet, intrudes granodiorite of the adjacent Shelburne Pluton and has a circa 45 m wide gradational contact of metaluminous hornblende-tonalite. This tonalite dominantly records magma mixing by the transfer of Ti, Mg, Fe, Ca, and V in hornblende, biotite, plagioclase, and (at least in part) apatite xenocrysts derived from dioritic pillows that were originally disaggregated in the granodiorite, probably in response to convection. Scattered data points, unusual “concave-down” variation trends for Al₂O₃, P₂O₅, and Sr, and non-hyperbolic Sr-Nd isotopic characteristics in the tonalite, apparently reflect syn- or post-mixing fractionation and accumulation of xenocrysts from residual magma. Phosphorus may have assisted diffusion of Sr, Zr, Nb, and light REE, and caused premature quenching of the hybrids at Mcleods Cove and Birchtown, during magma mingling and mixing. Received: 1 January 1996 / Accepted: 3 August 1996     

Another look at anisotropy in geostatistics

A thorough geostatistical data analysis includes a careful study of how the data's second-order variation, as characterized by the semivariogram, depends on the relative orientation of data locations. If the semivariogram depends on only the (Euclidean) distance between locations, then the semivariogram is isotropic; otherwise, it is anisotropic. In this article, I take another look at the modeling of anisotropy in geostatistics. A new, more specific classification of types of anisotropy is proposed. More importantly, some heretofore inadequately understood implications of the dependence of various semivariogram attributes on direction are discussed, and the wisdom of some current practices for modeling the direction-dependence of these attributes is questioned.     

Food habits of two larval flies (Dolichopodidae: Diptera) in two gulf coast oligohaline tidal marshes

Food habits of two species of dolichopodid fly larvae, from two Gulf Coast oligohaline tidal marshes, were analyzed from monthly collections taken between June 1979 and May 1980. Larvae ofPelastoneurus abbreviatus Loew andThinophilus frontalis Van Duzee, taken from aJuncus roemerianus Scheele dominated marsh, fed predominantly on oligochaetes and nematodes.Pelastoneurus abbreviatus, collected in a nearbySpartina cynosuroides (L.) Roth marsh, also fed on oligochaetes but consumed more polychaetes than nematodes. By being predators and prey in turn, these larvae serve in the transfer of energy between benthic, aquatic, and terrestrial components of the marsh, system.     

Computationally efficient restricted maximum likelihood estimation of generalized covariance functions

Computational aspects of the estimation of generalized covariance functions by the method of restricted maximum likelihood (REML) are considered in detail. In general, REML estimation is computationally intensive, but significant computational savings are available in important special cases. The approach taken here restricts attention to data whose spatial configuration is a regular lattice, but makes no restrictions on the number of parameters involved in the generalized covariance nor (with the exception of one result) on the nature of the generalized covariance function's dependence on those parameters. Thus, this approach complements the recent work of L. G. Barendregt (1987), who considered computational aspects of REML estimation in the context of arbitrary spatial data configurations, but restricted attention to generalized covariances which are linear functions of only two parameters.     

Seasonal abundance of aquatic diptera in two oligohaline tidal marshes in Mississippi

Nineteen species of Diptera (16 in each zone) from seven families were found in monthly collections (June 1979 through May 1980) in two Mississippi marsh plant zones dominated byJuncus roemerianus Scheele andSpartina cynosuroides (L.) Roth, respectively. TheJuncus zone was dominated by a species ofPalpomyia-Bezzia complex, two species ofBezzia (Ceratopogonidae),Paratendipes sp.,Limnophyes sp. (Chironomidae) andThinophilus frontalis (Dolichopodidae).Palpomyia-Bezzia sp.,Culicoides hollensis, Ormosia sp. (Tipulidae) andPelastoneurus abbreviatus (Dolichopodidae) dominated theSpartina zone. Total inset density and species richness were lowest in June and July in both zones, corresponding to a pulse of adult emergence. Overall, total density was significantly higher in theSpartina zone with mean values of 165 and 245 insects m^?2 for the {Juncus} and {Spartina} zones, respectively. In addition to total density, differences in abundance were apparent for a number of species between marsh zones. Patterns could be attributed to species-specific habitat preference., predation by aquatic predators, and/or by interactions of the infauna themselves.