Characterization of interface roughness of rippled sand off Fort Walton Beach, Florida

As part of the environmental characterization to model acoustic bottom scattering during the high-frequency sediment acoustics experiment (SAX99), fine-scale sediment roughness of a medium sand was successfully measured within a 600 /spl times/ 600-m area by two methods: stereo photography and a technique using a conductivity system. Areal coverage of the two methods, representing approximately 0.16 m/sup 2/ of the sea floor, was comparable, resulting in the depiction and quantification of half-meter wavelength sand ripples. Photogrammetric results were restricted to profiles digitized at 1-mm intervals; sediment conductivity results generated gridded micro-bathymetric measurements with 1- to 2-cm node spacing. Roughness power spectra give similar results in the low-spatial-frequency domains where the spectra estimated from both approaches overlap. However, spectra derived from higher resolution photogrammetric results appear to exhibit a multiple-power-law fit. Roughness measurements also indicate that spectrum changes as a function of time. Application of statistical confidence bounds on the power spectra indicates that roughness measurements separated by only 1-2 m may be spatially nonstationary.     

The dynamic method of calculating currents and analysis of the vertical kinematic structure

The basic relations of the classical dyamic method have been complemented with the condition allowing for the non-monotonicity of the vertical kinematic structure. The elements of the multi-layered system of geostrophic currents have been found to correlate over depth with seawater density and hydrostatic pressure distribution. An example of the analysis of the vertical structure of currents, involving specific hydrological data, is given. Translated by Vladimir A. Puchkin.     

The petroleum evaluation of a tectonically complex area: The western margin of the Southeast Basin (France)

The Southeast Basin of France is the thickest onshore French sedimentary basin which contains locally as much as 10 km of Mesozoic-Cenozoic sediment. Basin development occurred in several stages between late Carboniferous and late Cretaceous times. Partial tectonic inversion took place during two compressive events, the so-called ‘Pyrenean’ and ‘Alpine’ phases of late Cretaceous-early Tertiary and late Tertiary ages respectively. They are separated by an intervening stretching event of Oligocene age, which further south resulted in the opening of the western Mediterranean oceanic basin. As a result of this complex tectonic history, structural traps were difficult to image on the seismic data shot during the first phase of exploration prior to 1980. Oil and gas natural seeps, and shows in several wells, indicate that some petroleum systems are, or have been active, at least in some places.The present erosional western margin of the basin is more or less superimposed on the initial Triassic-Jurassic margin. Margin subsidence and Tertiary inversion are discussed using regional sections on which the polyphase history of the entire basin is well shown. These sections are located on three major segments where the Mesozoic margin is either partly preserved (Ardèche), or has been partly inverted in late Tertiary times (Vercors-Chartreuse), or has been completely inverted in early Tertiary times (Corbières-eastern Pyrenees). 1-D ‘Genex’ basin modelling on the Ardèche segment, and 2-D ‘Thrustpack’ structural-maturity modelling in the Vercors-Chartreuse segment are used to further assess the remaining petroleum plays.     

Effect of shallow and narrow water on added mass of cylinders with various cross-sectional shapes

The sway, heave and roll added masses of three uniform cylinders with semi-circular, rectangular and triangular cross-sectional shapes in shallow and narrow water are numerically analysed. The method is based on simulation of the potential flow induced by the cylinder's mode of motion. The effects of shallow and narrow water on added mass are analysed and presented. It is concluded that the shallow and narrow water effects on added mass depend on the different cross-section shapes of the cylinders. In particular, the water depth effect on sway added mass is stronger than that on heave added mass while the narrow water effect on sway is weaker than that on heave. The shallow water effect on added mass tends to weaken the narrow water effect. Lastly the effect of shallow and narrow water on added mass on a rectangular cylinder is the strongest while that on a triangular cylinder is the weakest.     

Sample Disturbance in Soft and Sensitive Clays: Analysis and Assessment

Despite the sophisticated methods employed to obtain high quality samples, they are prone to disturbance, due to stress release, let apart, due to sampling tools and techniques adopted. Critical reappraisal of different methods suggest that any method of sample quality assessment involving strength and deformation parameters would enable easier implementation and correct other engineering parameters for estimated sample disturbance. In this technical paper, sample disturbance index, using merely the slopes of compression paths, (representing mechanical response), in the pre- and post-yield stress regimes under odeometric loading conditions is proposed. This method is based on single oedometer test results on samples of unknown degrees of disturbance during sampling and handling. The unique feature of this approach is that the ideal rigid plastic material behavior is taken as reference. This eliminates the need for any additional experimental data or any calculations from the relationships formulated with any set of assumptions.     

Recent and Late Holocene environments on the southeastern shelf of the Laptev Sea as inferred from microfossil data

The study of diatoms and benthic foraminifers from the southeastern shelf of the Laptev Sea shows that their most diverse and abundant recent assemblages populate the peripheral underwater part of the Lena River delta representing the marginal filter of the sea. This area is characterized by an intense interaction between the fresh waters of the Siberian rivers and the basin seawater, the Atlantic one included. Local Late Holocene (～last 2300 years) environments reflect the main regional and global paleoclimatic changes, the Medieval Warm Period (～600–1100 years B.P.) and the Little Ice Age (～100–600 years B.P.) inclusive. In addition, the composition and distribution of planktonic foraminifers implies a strong influence of the Atlantic water during the Holocene optimum ～5100–6200 years B.P.