Reef exploration in the East Sengkang Basin,Sulawesi, Indonesia

Reconnaissance seismic shot in 1971/72 showed a number of well defined seismic anomalies within the East Sengkang Basin which were interpreted as buried reefs. Subsequent fieldwork revealed that Upper Miocene reefs outcropped along the southern margin of the basin. A drilling programme in 1975 and 1976 proved the presence of shallow, gas-bearing, Upper Miocene reefs in the northern part of the basin. Seismic acquisition and drilling during 1981 confirmed the economic significance of these discoveries, with four separate accumulations containing about 750 × 10⁹ cubic feet of dry gas in place at an average depth of 700 m. Kampung Baru is the largest field and contains over half the total, both reservoir quality and gas deliverability are excellent. Deposition in the East Sengkang Basin probably started during the Early Miocene. A sequence of Lower Miocene mudstones and limestones unconformably overlies acoustic basement which consists of Eocene volcanics. During the tectonically active Middle Miocene, deposition was interrupted by two periods of deformation and erosion. Carbonate deposition became established in the Late Miocene with widespread development of platform limestones throughout the East Sengkang Basin. Thick pinnacle reef complexes developed in the areas where reef growth could keep pace with the relative rise in sea level. Most reef growth ceased at the end of the Miocene and subsequent renewed clastic sedimentation covered the irregular limestone surface. Late Pliocene regression culminated in the Holocene with erosion. The Walanae fault zone, part of a major regional sinistral strike-slip system, separates the East and West Sengkang Basins. Both normal and reverse faulting are inferred from seismic data and post Late Pliocene reverse faulting is seen in outcrop.     

Multiple longshore sand bars in the upper Chesapeake Bay

In the upper Chesapeake Bay (Maryland, U.S.A.) field surveys were conducted at 18 multiple longshore sand bar sites. The multiple bar systems were found in water depths less than approximately 2 m (mean sea level), and exhibited mild bottom slopes of 0·0052 or less. The number of bars composing each system ranged from four to 17 and the spacing between the crests typically increased in the offshore direction, ranging from 12 to 70 m. Bar height also typically increased with distance offshore and ranged from 0·03 to 0·61 m. A grain size analysis of crest and trough sediment did not reveal any significant differences and the sediment was categorized as ‘fine sand’. A review of the literature data indicated that the Chesapeake Bay multiple bars possessed similar characteristics to those found in Gelding Bay (Baltic Sea); similarities in fetch, wave height and tidal range between the two bays may account for this finding. The surf-scaling parameter indicated that the multiple bar systems were extremely dissipative with regard to wave energy, and wave height appeared to be an important factor in controlling bar spacing and bar height. A multiple wave break point hypothesis was discussed as a possible mechanism for the formation of Chesapeake Bay multiple longshore bars, and limited observational evidence appeared to support such a mechanism.     

Microstructures of co-axially folded vein segments and crenulation cleavage： Evidence for dissolution phenomena in the Chamba Thrust Sheet, western Himalayas

The metasediments in the Chamba region experienced three phases of deformation: DF1, DF2 and DF3.Folded quartz veins are co-folded with the F2 crenulation folds. Their geometric and tectonic significance is studied by microstructures and shortening adjacent to the discrete crenulation cleavage, S2. Microstructures of folded vein segments, their geometric changes and truncation to cleavage (S2) are mainly due to pressure-solution phenomena and the estimated volume loss from reconstructed vein segments range from 16 to 25.5%,which is closely related to volume decrease (26%) calculated from the polydeformed slates of North Wales areas.     

Sonar cross sections of bodies partially insonified by finite sound beams

An object that is partially insonified by a collimated sound beam may have a scattering cross section sometimes much larger than when the object is totally covered by the incident beam. We quantitatively study this partial insonification problem here, under the classical method of physical optics. The importance of this study stems from the fact that partial coverage of the target by the beam is the situation most likely to occur in many cases of practical importance. We consider several basic target shapes partially insonified by finite beams. These shapes include the spherical, the infinite and finite cylinder, the flat plate, and the capped sphere. High-frequency approximations of the resulting integrals, obtained by means of the saddle-point method, show the relative importance of the scattering centers located at the beam's specular reflection points, or at the edges of the spots that the beam shines on the scatterers. The physical-optics method is extended to obtain formulas for the bistatic cross sections of partially insonified objects. The results are numerically evaluated and graphically displayed in many pertinent instances and compared to the predictions of approaches, such as the Fresnel-zones method and the Geometrical Theory of Diffraction (GTD). The predictions of the physical-optics method have all the advantages and deficiencies of this method and, with very minor modifications, hold equally well for the partial illumination of objects by beams of electromagnetic radiation.     

Finite-element analysis of time-dependent large-deformation problems

An updated Lagrangian finite-element formulation has been developed for time-dependent problems of soil consolidation involving finite deformations. Large plastic strains as well as rotations occur in such problems and nominal stress measures are introduced in the formulation to redefine stresses. This leads to corrective terms for equilibrium and yield violations in addition to geometric stiffening terms in the governing integral equations. The soil is considered to be either a linear elastic or an elastoplastic, critical-state material. Some simple numerical examples are studied to validate the formulation, followed by a detailed analysis of the problem of penetration of a pile into soil. The results of this problem are viewed with emphasis on the physical interpretation and practical significance.     

Porphyroblast inclusion-trail orientation data: eppure non son girate*!

Extensive examination of large numbers of spatially orientated thin sections of orientated samples from orogens of all ages around the world has demonstrated that porphyroblasts do not rotate relative to geographical coordinates during highly non-coaxial ductile deformation of the matrix subsequent to their growth. This has been demonstrated for all tectonic environments so far investigated. The work also has provided new insights and data on metamorphic, structural and tectonic processes including: (1) the intimate control of deformation partitioning on metamorphic reactions; (2) solutions to the lack of correlation between lineations that indicate the direction of movement within thrusts and shear zones, and relative plate motion; and (3) a possible technique for determining the direction of relative plate motion that caused orogenesis in ancient orogens.     

Rare earth, major and trace elements in Jurassic manganese shales of the Northern Calcareous Alps: hydrothermal versus hydrogenous origin of stratiform manganese deposits

Summary ?The rare earth, major and trace element geochemistry of Jurassic deep marine manganese shales allow insight into their environment of deposition. We present data of 24 samples from the Northern Calcareous Alps (Eastern Alps), collected from Late Jurassic strata of the Tennengebirge and from Early Jurassic strata of the Karwendel Mts. Whereas major and trace element geochemistry is controlled by the detrital input, rare earth element data and the relationship between total organic carbon and (pyritic) sulfur can be used to constrain the origin of the manganese accumulation. The data of this study are compatible with a hydrogenous precipitation of manganese by strongly varying redox-conditions at the sediment–water interface of a slope basin. Received December 21, 2001; revised version accepted February 18, 2002