Failure and flow development of a collapse induced complex landslide: the 2005 Kuzulu (Koyulhisar, Turkey) landslide hazard

Koyulhisar located in a slope of hilly region and constructed in the side of a mountain along the North Anatolian Fault Zone is frequently subject to landslides. A catastrophic landslide occurred on the morning of 17 March 2005 in the North of the Kuzulu district of Koyulhisar (Sivas, Turkey). This landslide caused widespread loss of life, and damage to buildings, and lifelines. Fifteen people were dead and five were injured, 21 houses and a minaret were covered and damaged severely. The case study presented in this paper describes and analyses the results of the detailed surveys of an interesting landslide in Kuzulu district of Koyulhisar (Sivas, Turkey), based on field and laboratory measurements and monitoring of the slide area. Landslide initiated as a collapse, and developed into debris avalanches in the valley. This phenomenon caused a disaster in the Kuzulu district. The importance of this landslide in particular has been recognized both in terms of its consequence for the people and structures and in terms of its role in allowing an understanding of process and properties of landslide triggered by a collapse in limestone karst. In view of the potential for such events to occur again in this area and environs, understanding of the failure mechanism is very crucial.     

Metal (Al, Fe, Mn and Cu) distributions and origins of polycyclic aromatic hydrocarbons (PAHs) in the surface sediments of the Marmara Sea and the coast of Istanbul, Turkey

In this study, total metal (Al, Fe, Mn and Cu) and PAHs analyses have been done in the surface sediments. Sediment samples have been collected from seven parts of the Marmara Sea and the coast of Istanbul during 2009. Total Al, Fe, Mn and Cu contents vary between 1.8% and 5.4%; 1.1% and 2.8%; 122 and 259 μg g⁻¹; 27 and 416 μg g⁻¹, respectively. EF and CF values of Fe and Mn are lower than 1.5 and 1, respectively, in all the stations. Total PAH contents range between 135 and 6009 ng g⁻¹ in the surface sediments. The origin of PAHs has been found pyrolitic according to the Phe/Ant ratio in the all stations. Contrastingly, at K0, MKC and MY1 Stations, PAH origins have been observed petrogenic according to the Flu/Pyr ratio.     

Removal of Cu2+ and Pb2+ Ions Using CMC Based Thermoresponsive Nanocomposite Hydrogel

In this study, carboxymethylcellulose (CMC) based thermoresponsive nanocomposite hydrogel was synthesized for the removal of Cu²⁺ and Pb²⁺ ions from aqueous solutions. To prepare nanocomposite hydrogel, graft copolymerization of N‐isopropyl acrylamide (NIPAm) and acrylic acid (AA) onto CMC was carried out in Na‐montmorillonite (MMT)/water suspension media and ammonium persulfate (APS) used as initiator. The chemical structures of hydrogels were characterized by Fourier transform infrared (FT‐IR) and X‐ray diffraction spectroscopy (XRD). Lower critical solution temperature (LCST), pH responsivity, swelling, and deswelling properties of the hydrogels were also examined. In addition competitive and non‐competitive removal of Cu²⁺ and Pb²⁺ studies were carried out. According to heavy metal sorption studies results, removal capacities of nanocomposite hydrogel for both metal ions were found to be higher than those of pure hydrogel. The analyzed adsorption data showed that the adsorption process of Cu²⁺ and Pb²⁺ could be explained by pseudo‐second order kinetic model. Moreover, according to competitive sorption studies, it is found to be that both hydrogels are more selective to Cu²⁺ ion rather than Pb²⁺.     

Color Removal from Synthetic Textile Wastewater by Sono‐Fenton Process

In this study, the oxidative decolorization of C.I. reactive yellow 145 (RY 145) from synthetic textile wastewater including RY 145 and polyvinyl alcohol by Fenton and sono‐Fenton processes which are the combination of Fenton process with ultrasound has been carried out. The effects of some operating parameters which are the initial pH of the solution, the initial concentration of Fe²⁺, H₂O₂, and the dye, temperature, and agitation speed on the color and chemical oxygen demand (COD) removals have been investigated. The optimum conditions have been found as [Fe²⁺] = 20 mg/L, [H₂O₂] = 20 mg/L, pH 3 for Fenton process and [Fe²⁺] = 20 mg/L, [H₂O₂] = 15 mg/L, pH 3 for sono‐Fenton process by indirectly sonication at 35 kHz ultrasonic frequency and 80 W ultrasonic power. The color and COD removal efficiencies have been obtained as 91 and 47% by Fenton process, and 95 and 51% by sono‐Fenton processes, respectively. Kinetic studies have been performed for the decolorization of RY 145 under optimum conditions at room temperature. It has been determined that the decolorization has occurred rapidly by sono‐Fenton process, compared to Fenton process.     

Build‐up and depositional dynamics of an arc front volcaniclastic complex: the Miocene Tepoztlán Formation (Transmexican Volcanic Belt,Central Mexico)

Volcanic terrains such as magmatic arcs are thought to display the most complex surface environments on Earth. Ancient volcaniclastics are notoriously difficult to interpret as they describe the interplay between a single or several volcanoes and the environment. The Early Miocene Tepoztlán Formation at the southern edge of the Transmexican Volcanic Belt belongs to the few remnants of this ancestral magmatic arc, and therefore is thought to represent an example of the initial phase of evolution of the Transmexican Volcanic Belt. Based on geological mapping, detailed logging of lithostratigraphic sections, palaeocurrent data of sedimentary features and anisotropy of magnetic susceptibility, mapping of two‐dimensional panels from outcrop to field scale, and geochronological data in an area of ca 1000 km², three periods in the evolution of the Tepoztlán Formation were distinguished, which lasted around 4 Myr and are representative of a volcanic cycle (edifice growth phases followed by collapse) in a magmatic arc setting. The volcaniclastic sediments accumulated in proximal to medial distances on partly coalescing aprons, similar to volcanic ring plains, around at least three different stratovolcanoes. These volcanoes resulted from various eruptions separated by repose periods. During the first phase of the evolution of the Tepoztlán Formation (22·8 to 22·2 Ma), deposition was dominated by fluvial sediments in a braided river setting. Pyroclastic material from small, andesitic–dacitic composite volcanoes in the near vicinity was mostly eroded and reworked by fluvial processes, resulting in sediments ranging from cross‐bedded sand to an aggradational series of river gravels. The second phase (22·2 to 21·3 Ma) was characterized by periods of strong volcanic activity, resulting in voluminous accumulations of lava and tuff, which temporarily overloaded and buried the original fluvial system with its detritus. Continuous build‐up of at least three major volcanic centres further accentuated the topography and, in the third phase (21·3 to 18·8 Ma), mass flow processes, represented by an increase of debris flow deposits, became dominant, marking a period of edifice destruction and flank failures.     

Gaseous emission comparison of a compression–ignition engine fueled with different biodiesels

In this study, it was performed a comparison of the performance and emissions of two methyl ester fuels: one obtained from animal fat and the other from crude canola oil, in a compression-ignition engine against diesel fuel. The experimental results compared with diesel fuel showed that significant reductions could be obtained by biodiesel derived from animal fat in carbon monoxide and oxides of nitrogen emissions. Carbon dioxide emissions showed a trend of decreasing with the biodiesel fuels. An increase in brake specific fuel consumption was observed for different biodiesel fuels when compared with diesel fuel. It was concluded that animal tallow methyl ester performed better than canola oil methyl ester, whereas slightly higher brake torque is observed with canola oil methyl ester.     

Natural radioactivity of bricks and brick material in the Salihli-Turgutlu area of Turkey

Some of the rocks and soil-originated materials used in building construction are the serious natural radiation sources. Soil-originated bricks and roof-tiles and their raw material in the Salihli-Turgutlu area were tested in situ for natural radiation levels using a gamma-ray spectrometer. The concentrations of the radioelements ⁴⁰K, ²³⁸U and ²³²Th and air-absorbed radiation rates were measured for soil, raw material heaps, brick and roof-tile stacks and waste brick heaps. The radium-equivalent activity Ra_eq of the raw material varied between 187.9 and 216.4 Bq kg^?1. The external radiation hazard index H_ex values ranged between 0.51 and 0.58. For building material and its products, recommended Ra_eq and H_ex levels are 370 Bq kg^-1 and 1.0, respectively. On the other hand, both Ra_eq and H_ex values for waste brick heaps, containing broken brick pieces, coal pieces and ash, were higher than the recommended levels, i.e. Ra_eq values varied from 473.8 to 651.0 Bq kg^-1 and H_ex values were within the range 1.15–1.76. The annual dose rate and radium-equivalent activity values of the brick and roof-tiles were below the level of criteria. Annual dose rate ranged between 0.42 and 0.62 mSv y^?1 and radium equivalent activity was in the range 172.9–245.2 Bq kg^?1. The external and internal radiation hazard indices were all below the value of 1.0 for the Salihli-Turgutlu area bricks and roof-tiles. Results of this study were compared with results of previous studies. Natural radiation levels of construction raw material of study area are generally higher than of those of previous studies.     

Time-Lapse Analysis of Methane Quantity in the Mary Lee Group of Coal Seams Using Filter-Based Multiple-Point Geostatistical Simulation

Coal seam degasification and its success are important for controlling methane, and thus for the health and safety of coal miners. During the course of degasification, properties of coal seams change. Thus, the changes in coal reservoir conditions and in-place gas content as well as methane emission potential into mines should be evaluated by examining time-dependent changes and the presence of major heterogeneities and geological discontinuities in the field. In this work, time-lapsed reservoir and fluid storage properties of the New Castle coal seam, Mary Lee/Blue Creek seam, and Jagger seam of Black Warrior Basin, Alabama, were determined from gas and water production history matching and production forecasting of vertical degasification wellbores. These properties were combined with isotherm and other important data to compute gas-in-place (GIP) and its change with time at borehole locations. Time-lapsed training images (TIs) of GIP and GIP difference corresponding to each coal and date were generated by using these point-wise data and Voronoi decomposition on the TI grid, which included faults as discontinuities for expansion of Voronoi regions. Filter-based multiple-point geostatistical simulations, which were preferred in this study due to anisotropies and discontinuities in the area, were used to predict time-lapsed GIP distributions within the study area. Performed simulations were used for mapping spatial time-lapsed methane quantities as well as their uncertainties within the study area. The systematic approach presented in this paper is the first time in literature that history matching, TIs of GIPs and filter simulations are used for degasification performance evaluation and for assessing GIP for mining safety. Results from this study showed that using production history matching of coalbed methane wells to determine time-lapsed reservoir data could be used to compute spatial GIP and representative GIP TIs generated through Voronoi decomposition. Furthermore, performing filter simulations using point-wise data and TIs could be used to predict methane quantity in coal seams subjected to degasification. During the course of the study, it was shown that the material balance of gas produced by wellbores and the GIP reductions in coal seams predicted using filter simulations compared very well, showing the success of filter simulations for continuous variables in this case study. Quantitative results from filter simulations of GIP within the studied area briefly showed that GIP was reduced from an initial ～73 Bcf (median) to ～46 Bcf (2011), representing a 37 % decrease and varying spatially through degasification. It is forecasted that there will be an additional ～2 Bcf reduction in methane quantity between 2011 and 2015. This study and presented results showed that the applied methodology and utilized techniques can be used to map GIP and its change within coal seams after degasification, which can further be used for ventilation design for methane control in coal mines.     

Luminosity–colour relations for red clump stars

We calibrated the absolute magnitudes M _V , M _J , $M_{K_{s}}$ and M _g of red clump stars in terms of colours. M _V and M _g are strongly dependent on colour, while the dependence of M _J and $M_{K_{s}}$ on colour is rather weak. The calibration of the absolute magnitudes M _V and $M_{K_{s}}$ is tested on 101 RC stars in the field SA 141. The Galactic model parameters estimated with this sample are in good agreement with earlier studies.     

Relatedness between contemporary and subfossil cladoceran assemblages in Turkish lakes

Cladocerans are valuable indicators of environmental change in lakes. Their fossils provide information on past changes in lake environments. However, few studies have quantitatively examined the relationships between contemporary and sub-fossil cladoceran assemblages and no investigations are available from Mediterranean lakes where salinity, eutrophication and top-down control of large-bodied cladocerans are known to be important. Here we compared contemporary Cladocera assemblages, sampled in summer, from both littoral and pelagic zones, with their sub-fossil remains from surface sediment samples from 40 Turkish, mainly shallow, lakes. A total of 20 and 27 taxa were recorded in the contemporary and surface sediment samples, respectively. Procrustes rotation was applied to both the principal components analysis (PCA) and redundancy analysis (RDA) ordinations in order to explore the relationship between the cladoceran community and the environmental variables. Procrustes rotation analysis based on PCA showed a significant accord between both littoral and combined pelagic–littoral contemporary and sedimentary assemblages. RDA ordinations indicated that a similar proportion of variance was explained by environmental variation for the contemporary and fossil Cladocera data. Total phosphorus and salinity were significant explanatory variables for the contemporary assemblage, whereas salinity emerged as the only significant variable for the sedimentary assemblage. The residuals from the Procrustes rotation identified a number of lakes with a high degree of dissimilarity between modern and sub-fossil assemblages. Analysis showed that high salinity, deep water and high macrophyte abundance were linked to a lower accord between contemporary and sedimentary assemblages. This low accord was, generally the result of poor representation of some salinity tolerant, pelagic and macrophyte-associated taxa in the contemporary samples. This study provides further confirmation that there is a robust relationship between samples of modern cladoceran assemblages and their sedimentary remains. Thus, sub-fossil cladoceran assemblages from sediment cores can be used with confidence to track long-term changes in this environmentally sensitive group and in Mediterranean lakes, subjected to large inter-annual variation in water level, salinity and nutrients.