A comparison between above-water surface and subsurface spectral reflectances collected over inland waters

The objective of the research was to undertake a quantitative comparison of spectral-reflectance measurements made slightly above the surface of water bodies with the measurements made slightly below the surface. The study is focused on three rivers; two in Georgia, USA and one in Japan. As expected, the differences in reflectance are not constant and vary with the wavelength. The contribution of surface-reflection effects to the surface reflectance measured slightly above the water is both pronounced and highly variable, but although they do alter the magnitude of the upwelling signal, they do not change the general shape of the spectral profiles. The correction of surface-reflection effects by assuming a proportionality factor (ρ) is not considered to be efficient for inland fresh water bodies. For in situ spectroscopy, the recommended approach is to measure upwelling radiance slightly below the water's surface as a means of minimizing extraneous noise. Researchers should be aware of the potential for diminishing the validity of findings because of measurement errors.     

A GIS-based logistic regression model in rock-fall susceptibility mapping along a mountainous road: Salavat Abad case study, Kurdistan, Iran

This study describes the application of logistic regression to rock-fall susceptibility mapping along 11?km of a mountainous road on the Salavat Abad saddle, in southwest Kurdistan, Iran. To determine the factors influencing rock-falls, data layers of slope degree, slope aspect, slope curvature, elevation, distance to road, distance to fault, lithology, and land use were analyzed by logistic regression analysis. The results are shown as rock-fall susceptibility maps. A spatial database, which included 68 sites (34 rock-fall point cells with value of 1 and 34 no rock-fall point cells with value of 0) was developed and analyzed using a Geographic Information System, GIS. The results are shown as four classes of rock-fall susceptibility. In this study, distance to fault, lithology, slope curvature, slope degree, and distance to road were found to be the most important factors affecting rock-fall. It was concluded that about 76?% of the study area can be classified as having moderate and high susceptibility classes. Rock-fall point cells were used to verify results of the rock-fall susceptibility map using success curve rate and the area under the curve. The verification results showed that the area under the curve for rock-fall susceptibility map is 77.57?%. The results from this study demonstrated that the use of a logistic regression model within a GIS framework is useful and suitable for rock-fall susceptibility mapping. The rock-fall susceptibility map can be used to reduce susceptibility associated with rock-fall.     

Groundwater resource development in Jamui District,Bihar, India: an overview

Because agriculture is the main source of livelihood for the bulk of the population in Jamui District, the importance of developing irrigation facilities in any programme of economic regeneration can hardly be over emphasized. It is, therefore, imperative that groundwater development be considered as an important step to drought mitigation in the Jamui district. The present study was carried out in such a way that technical and economic viability of any groundwater development plan can be thoroughly scrutinized. In this paper the hydrogeological framework of the district was established based on aquifer disposition, orientation of potential fracture systems and their hydraulic characteristics. Considering the aquifer geometry and yield potential of different structures, a blueprint for a groundwater development plan was prepared. An economic analysis of the development plan also was attempted. The analysis yielded results that made it possible to evaluate parameters such as cost–benefit ratio, incremental benefits and internal rate of return used to assess the economic viability of the groundwater development plan. Electronic Publication     

Reconnaissance geology in Upper Chitral,Baroghil and Karambar districts (northern Karakorum,Pakistan)

During the summer of 1992 a geological expedition crossed the northern Karakorum range in northern Pakistan, from the Chitral to Karambar valleys, from the villages of Mastuj to Imit. Some of the areas visited were geologically unknown. A number of structural units were crossed, belonging to the Karakorum block or to other crustal blocks north of it. They are: (a) the axial batholith, in which three plutonic bodies have been identified, and (b) the northern sedimentary belt (NSB), in which three major tectonostratigraphic units form thrust stacks dipping to the north. Their internal stratigraphy and structural style are partly different. The most complete contains a crystalline basement, transgressed by a marine succession during the Early Ordovician. The youngest strata are represented by the Reshun conglomerate, of inferred Cretaceous age. The northernmost unit of the NSB is tightly folded, whereas the central one forms a monocline. Vertical faults, mainly strike-slip, dissect the thrusted slabs. Metamorphic deformation is absent or reaches only the anchizone in the studied sector of the Karakorum NSB. To the north of the Karakorum proper there are several other tectonic units, separated by vertical faults. They are, from south to north: (a) the Taš Kupruk zone, with metavolcanics of basaltic to latibasaltic composition; (b) the Atark unit, mostly consisting of massive carbonate rocks of Mesozoic age; and (c) the Wakhan slates which consist of a thick widespread succession of dark slates, metasiltites and sandstones. The fine-grained elastic rocks are supposed to be Palaeozoic to Early Triassic in age. The Wakhan slates are intruded by plutons belonging to the East Hindu Kush batholith, from which a single K/Ar age on muscovite gave a Jurassic age.     

Solubility of platinum and palladium in silicate melts under high water pressure as a function of redox conditions

The solubility of platinum and palladium in a silicate melt of the composition Di ₅₅ An ₃₅ Ab ₁₀ was determined at 1200°C and 2 kbar pressure in the presence of H₂O-H₂ fluid at an oxygen fugacity ranging from the HM to WI buffer equilibria. The influence of sulfur on the solubility of platinum in fluid-bearing silicate melt was investigated at a sulfur fugacity controlled by the Pt-PtS equilibrium at 1200°C and a pressure defined in such a way that the \(f_{H_2 O} \) and \(f_{O_2 } \) values were identical to those of the experiments without sulfur. The experiments were conducted in a high pressure gas vessel with controlled hydrogen content in the fluid. Oxygen fugacity values above the NNO buffer were controlled by solid-phase buffer mixtures using the two-capsule technique. Under more reducing conditions, the contents of H₂O and H₂ were directly controlled by the argon to hydrogen ratio in a special chamber. The hydrogen fugacity varied from 5.2 × 10^?2 bar (HM buffer) to 1230 bar (\(X_{H_2 } \) = 0.5). Pt and Pd contents were measured in quenched glass samples by neutron activation analysis. The results of these investigations showed that the solubility of Pt and Pd increases significantly in the presence of water compared with experiments in dry systems. The content of Pd within the whole range of redox conditions and that of Pt at an oxygen fugacity between the HM to MW buffer reactions are weakly dependent on \(f_{O_2 } \) and controlled mainly by water fugacity. This suggests that, in addition to oxide Pt and Pd species soluble at the ppb level in haplobasaltic melts, much more soluble (ppm level) hydroxide complexes of these metals are formed under fluid-excess conditions. Despite a decrease in water fugacity under reducing conditions, Pt solubility increases sharply near the MW buffer. It was shown by electron paramagnetic resonance spectrometry that, in contrast to dry melts, fluid-saturated silicate melts do not contain a pure metal phase (micronuggets). Therefore, the increase in Pt solubility under reducing conditions can be explained by the formation of Pt hydride complexes or Pt-fluid-silicate clusters. At a sulfur fugacity controlled by the Pt-PtS equilibrium, the solubility of Pt in iron-free silicate melts as a function of redox conditions is almost identical to that obtained in the experiments without sulfur at the same water and oxygen fugacity values. These observations also support Pt dissolution in iron-free silicate melts as hydroxide species.     

Weather yield model for the semi tropical region (Pakistan)

Weather models are essential tools for checking of the effect of the weather elements in terms of their effect on the production of the crop. This research is an attempt to see the effect of only two variables i.e., temperature and rainfall for the division Faisalabad (semitropical region of Pakistan).The model fitted is of the linear form:the values of a,b, c have been found. The expected yield has been calculated by using the aridity indices (X1 and X2 ) and the result in the form of coefficient of determination R2 has been found equal to 0.166. The significance of the regression coefficient has been tested, which shows that the contribution to the yield from aridity index at germination and that at ripening is significant.The wheat yields are the results of a wide variety of variables, most of which show varying degree of relationship with one another, some positive and some negative in terms of output. These variables may be technology, fertilizers, pesticides, epidemics, kinds of seeds used, market price of crop and the area under cultivation etc, which can be the source of variation in the wheat yield. Since rainfall during germination and temperature at the ripening periods are the necessary factors for the yield of wheat, for this purpose these parameters have been studied in order to their contribution.     

Comparison of SEBAL,METRIC, and ALARM algorithms for estimating actual evapotranspiration of wheat crop

Theoretical and Applied Climatology - Evapotranspiration is one of the main components of water balance and its accurate estimation is of great importance in planning and optimizing water...     

Petrogenesis of the Late Cretaceous Tholeiitic Volcanism and Oceanic Island Arc Affinity of the Chagai Arc, Western Pakistan

The Late Cretaceous Chagai arc outcrops in western Pakistan, southern Afghanistan and eastern Iran. It is in the Tethyan convergence zone, formed by northward subduction of the Arabian oceanic plate beneath the Afghan block. The oldest unit of the Chagai arc is the Late Cretaceous Sinjrani Volcanic Group. This is composed of porphyritic lava flows and volcaniclastic rocks, and subordinate shale, sandstone, limestone and chert. The flows are fractionated low-K tholeiitic basalts, basaltic-andesites, and andesites. Relative enrichment in their LILE and depletion in HFSE, and negative Nb and Ta and positive K, Ba and Sr anomalies point to a subduction-related origin. Compared to MORB, the least fractionated Chagai basalts have low Na2O, Fe2O3T, CaO, Ti, Zr, Y and 87Sr/86Sr. Rather than an Andean setting, these results suggest derivation from a highly depleted mantle in an intraoceanic arc formed by Late Cretaceous convergence in the Ceno-Tethys. The segmented subduction zone formed between Gondwana and a collage of small continental blocks (Iran, Afghan, Karakoram, Lhasa and Burma) was accompanied by a chain of oceanic island arcs and suprasubduction ophiolites including Semail, Zagros, Chagai-Raskoh, Kandahar, Muslim Bagh, Waziristan and Kohistan-Ladakh, Nidar, Nagaland and Manipur. These complexes accreted to the southern margin of Eurasia in the Late Cretaceous.     

Introducing the recharge–discharge relationship to evaluate the recharge coefficient of karstic aquifers: thematic and indexing approaches

ABSTRACT

Karst aquifers and springs are important with respect to their potential for supplying drinking water in regions suffering from water scarcity in Iran. Accordingly, it is essential to determine the recharge potential of the catchment and the regions with higher obtainability potential. This study provides a road map for the Sheshpeer catchment in southern Iran. A recharge potential (RP) map was produced from which a recharge index (RI) was computed for several selected springs in the catchment. Furthermore, the unit discharge (q) – defined as the average annual discharge for a given catchment area and unit rainfall depth for each spring – was calculated. The plot of q versus RI for the springs showed a linear positive relationship between the two variables (R ² = 0.9). Applying the trend equation of this plot to the whole Sheshpeer karstic catchment reveals that its long-term recharge coefficient is 0.74.     

A PETROLOGICAL OVERVIEW OF THE KOHISTAN MAGMATIC ARC, NW HIMALAYA, N. PAKISTAN

A PETROLOGICAL OVERVIEW OF THE KOHISTAN MAGMATIC ARC, NW HIMALAYA, N. PAKISTAN1　TahirkheliRAK ,MattauerM .ProustF ,etal.1979.In :GeodynamicsofPakistan[C].FarahA ,DeJongKA ,eds.GeolSurvPakistan ,Quetta ,1979.12 5～ 130 . 2　CowardMP ,WindleyBF ,BroughtonRD ,etal.In :CollisionTectonics[C]..CowardMP ,RiesAC ,eds.GeolSoc,London ,SpecPub ,1986 ,19:2 0 3～ 2 19. 3　BardJP ,MaluskiH ,MattePh ,etal.GeolBull ,PeshawarUniversity ,1980 ,13:87～ 93. …