Vegetation dynamics during the late Pleistocene in the Barreirinhas region, Maranhão State, northeastern Brazil, based on carbon isotopes in soil organic matter

The study place is in the Barreirinhas region, Maranhão State, northeastern Brazil. A vegetation transect of 78 km was studied among four vegetation types: Restinga (coastal vegetation), Cerrado (woody savanna), Cerradão (dense woody savanna), and Forest, as well as three forested sites around Lagoa do Caçó, located approximately 10 km of the transect. Soil profiles in this transect were sampled for δ¹³C analysis, as well as buried charcoal fragments were used for ¹⁴C dating. The data interpretation indicated that approximately between 15,000 and ∼9000 ¹⁴C yr B.P., arboreal vegetation prevailed in the whole transect, probably due to the presence of a humid climate. Approximately between ∼9000 and 4000-3000 ¹⁴C yr B.P., there was the expansion of the savanna, probably related to the presence of drier climate. From ∼4000-3000 ¹⁴C yr B.P. to the present, the results indicated an increase in the arboreal density in the area, due to the return to a more humid and probably similar climate to the present. The presence of buried charcoal fragments in several soil depths suggested the occurrence of palaeofires during the Holocene. The vegetation dynamic inferred in this study for northeastern Brazil is in agreement with the results obtained in areas of Amazon region, based on pollen analysis of lake sediments and carbon isotope analysis of soil organic matter (SOM), implying than similar climatic conditions have affected these areas during the late Pleistocene until the present.     

Stratigraphic signatures of translation of thrust-sheet top basins over low-angle detachment faults

Abstract Low‐angle detachment faults and thrust‐sheet top basins are common features in foreland basins. However, in stratigraphic analysis their influence on sequence architecture is commonly neglected. Usually, only eustatic sea level and changing flexural subsidence are accounted for, and when deformation is considered, the emphasis is on the generation of local thrust‐flank unconformities. This study analyses the effects of detachment angle and repetitive detachment activation on stratigraphic stacking patterns in a large thrust‐sheet top basin by applying a three‐dimensional numerical model. Model experiments show that displacement over low‐angle faults (2–6°) at moderate rates (～5.0 m kyr^?1) results in a vertical uplift component sufficient to counteract the background flexural subsidence rate. Consequently, the basin‐wide accommodation space is reduced, fluvio‐deltaic systems carried by the thrust‐sheet prograde and part of the sediment supply is spilled over towards adjacent basins. The intensity of the forced regression and the interconnectedness of fluvial sheet sandstones increases with the dip angle of the detachment fault or rate of displacement. In addition, the delta plain is susceptible to the formation of incised valleys during eustatic falls because these events are less compensated by regional flexural subsidence, than they would be in the absence of fault displacement.     

Tectonic significance of the present relief of the Betic Cordillera

Tortonian calcarenites of the Betic Cordillera were deposited in coastal or very shallow marine environments and represent an ideal marker for estimating vertical movements from the late Miocene to the Present. A map showing the heights at which these Tortonian marine rocks are situated has a clear correlation with the present relief, indicating that today's relief has been formed since the Tortonian. There is also a good correlation between present relief and the Bouguer anomaly distribution in the Betic Cordillera, as well as with crustal thickness. Likewise, the present relief is directly related to the geodynamic setting of a horizontal N–S to NNW–SSE compression and an almost perpendicular extension, along with isostatic readjustment, existing in the Betic Cordillera from the Tortonian. As a result of these regional stresses, faults and folds have produced notable vertical movements. The highest rates of uplift of the Betic Cordillera coincide with large antiforms, in particular those of the Sierra Nevada and the Sierra Filabres. Several subsiding sectors also exist (for example, the Granada Basin or the Guadalquivir Basin). The foreland Guadalquivir Basin has a complex history because the uplift in its eastern sector and subsidence in the western sector coexisted during the late Tortonian. Today the whole Betic Cordillera is characterized by differential regional uplift, even in the aforementioned subsiding sectors.     

Submillimeter-wave and observations of the event on 28 November, 2001

We present a detailed study of a 1B/M6.9 impulsive flare combining high time resolution (1 ms) and instantaneous emission source localization observations at submillimeter frequencies (212 GHz), obtained with the solar submillimeter telescope (SST), and Hα data from the Hα solar telescope for argentina (HASTA). The flare, starting at 16:34 UT, occurred in active region (AR) 9715 (NOAA number) on November 28, 2001, and was followed by an Hα surge. We complement our data with magnetograms from the Michelson Doppler Imager (SOHO/MDI). SST observed a short impulsive burst at 212 GHz, presenting a weak bulk emission (of about 90 sfu) composed of a few shorter duration structures. The integrated Hα and the 212 GHz light curves present a remarkable agreement during the impulsive phase of the event. The delay between both curves stays below 12 s (the time resolution of the Hα telescope). The flare as well as the surge are linked to new flux emergence very close to the main AR bipole. Taking into account the AR magnetic field evolution, we infer that magnetic field reconnection, occurring at low coronal levels, could have been at the origin of the flare; while in the case of surge this would happen at the chromospheric level.     

Controlling factors of gullying in the Maracujá Catchment,southeastern Brazil

Hundreds of gullies (‘voçorocas’) of huge dimensions (up to 400–500 m long, 150 m wide and 50 m deep) are very common in the small Maracujá Catchment in southeastern Brazil. These erosional features, which occur with an uneven intensity throughout the area, started due to bad soil management practices at the beginning of European settlement, at the end of the 17th century, and nowadays are still evolving, but at a slower rate. As surface soils are usually very resistant to erosion, the outcrop of the more erodible basement saprolites seems to be an essential condition for their beginning. An analysis of well known erosion controlling factors was performed, aiming to explain the beginning and evolution of these gullies and to understand the reasons for their spatial distribution. Data shows that geology and, mainly, geomorphology are the main controlling factors, since gullies tend to be concentrated in basement rock areas with lower relief (domain 2) of Maracujá Catchment, mainly at the fringes of broad and flat interfluves. At the detailed scale (1:10 000), gullies are more common in amphitheatre‐like headwater hollows that frequently represent upper Quaternary gullies (paleogullies), which demonstrate the recurrence of channel erosion. So, gullies occur in areas of thicker saprolites (domain 2), in places with a natural concentration of surface and underground water (hollows). Saprolites of the preserved, non‐eroded hollows are usually pressurized (confined aquifer) due to a thick seal of Quaternary clay layer, in a similar configuration to the ones found in hollows of mass movement (mudflow) sites in southeastern Brazil. Therefore, the erosion of the resistant soils by human activities, such as road cuts and trenches (‘valos’), or their mobilization by mudflow movements, seem to be likely mechanisms of gullying initiation. Afterwards, gullies evolve by a combination of surface and underground processes, such as wash and tunnel erosion and falls and slumps of gully walls. Copyright © 2005 John Wiley & Sons, Ltd.     

Multi-refractor imaging with stacked refraction convolution section

Multi‐refractor imaging is a technique for constructing a single two‐dimensional image of a number of refractors by stacking multiple convolved and cross‐correlated reversed shot records. The method is most effective with high‐fold data that have been obtained with roll‐along acquisition programs because the stacking process significantly improves the signal‐to‐noise ratios. The major advantage of the multi‐refractor imaging method is that all the data can be stacked to maximize the signal‐to‐noise ratios before the measurement of any traveltimes. However, the signal‐to‐noise ratios can be further increased if only those traces that have arrivals from the same refractor are used, and if the correct reciprocal times or traces are employed. A field case study shows that multi‐refractor imaging can produce a cross‐section similar to the familiar reflection cross‐section with substantially higher signal‐to‐noise ratios for the equivalent interfaces.     

A comparative study of concentrated plasticity models in dynamic analysis of building structures

Concentrated plasticity (CP) models are frequently used in static and dynamic building analysis and have been implemented in available commercial software. This investigation deals with three different CP‐models, a simplified macroelement model (SEM) for a complete building story, a frame element with elasto‐plastic interaction hinges (PH), and a frame element with fiber hinges (FB). The objectives of this work are to evaluate the quality of the earthquake responses predicted by these models and to identify important aspects of their implementation and limitations for their use in dynamic analysis. The three elements are tested in a single‐story asymmetric plan building and in a three‐story steel building. Results show that base shear and global response values are usually computed with better accuracy than interstory deformations and local responses. Besides, the main limitation of elasto‐plastic CP models is to control the displacement offsets that result from perfect elasto‐plastic behavior. On the other hand, calibration of the SEM‐model shows that global responses in steel structures may be computed within 20% error in the mean at a computational cost two orders of magnitude smaller than that of the other CP elements considered. However, the three element models considered lead to increasing levels of accuracy in the dynamic response and their use depends on the refinement of the analysis performed. Copyright © 2005 John Wiley & Sons, Ltd.     

Groundwater flow regime under natural conditions as inferred from past evidence and contemporary field observations in a semi-arid basin: Cuenca de la Independencia, Guanajuato, México

This study was carried out in the Cuenca de la Independencia, a semi-arid basin in Central Mexico. The objective is to describe the main features of a groundwater flow regime under natural conditions, based on groundwater discharge manifestations. Information obtained from paleoecological, paleontological, archaeological and historical data suggests that, prior to heavy development (starting in the 1950s), the hydrogeologic regime was characterized by a larger groundwater availability in a more humid and colder climate. Manifestations associated to groundwater discharges are springs, lagoons, wetlands, saline soils, chalcedony deposits, phreatophytes, thermalism, and artesianism. The different types of manifestations and their position in the basin indicate the influence of groundwater flow systems hierarchically nested, forming concentric zones at ground level. The groundwater flow regime corresponds to a classical gravity-induced flow system with generation of local, intermediate and regional patterns. Integrating several types of data to establish the flow geometry and its dynamics has proven a useful tool to increase understanding of the original groundwater regimes. This approach can also be applied in other over-exploited semi-arid basins.     

Quantum-thermodynamic treatment of intrinsic anharmonicity; Wallace’s theorem revisited

Wallace (in Thermodynamics of crystals, 1972) developed a theorem, rooted in rigid lattice dynamics, which incorporates intrinsic anharmonic effects in solids. The practical application of this theorem in mineral physics is computationally involved and this is the main reason for the theorem not getting the attention it deserves. Because intrinsic anharmonicity is an important issue at the extreme conditions in planetary mantles, we derived a method which removes the computational obstacles in applying this theorem. We extended the theorem to incorporate details of the phonon spectrum and tested our algorithm on forsterite (Mg₂SiO₄). Using a least squares inversion technique applied to all available experimental data, we show that it results in an accurate representation of thermodynamic properties and sound wave velocities of Mg₂SiO₄ in its complete pressure–temperature stability range. We also show that the accuracy of our results is not significantly affected by the use of a different equation of state.