Analysis of simple shear tests with cell pressure confinement

The high cost of offshore infrastructure provides continuous encouragement for optimisation of design practices. Development of a more rational method to interpret results from simple shear tests with cell pressure confinement can reduce costs and improve reliability of offshore infrastructure. This paper addresses a commonly overlooked issue affecting design parameter selection: specimen shape varies from right cylinder to oblique cylinder after loading along a single shearing direction. Thus, horizontal stresses are not always equal to the cell pressure and their magnitude varies throughout the specimen’s lateral surface. An analysis is proposed that accounts for changing specimen geometry and lateral surface area during shearing and for the actual effect of cell pressure during testing. The analysis also describes how the intermediate principal stress can be assessed. Test results for medium dense silica sand are interpreted following de Josselin de Jong’s alternative shearing mechanism hypothesis. Conventional interpretation methods yield conservative design parameters for this soil. Failure states develop when the intermediate principal effective stress is halfway between major and minor principal effective stresses. Typical results for the soil tested show equipment performance meets standard direct simple shear requirements for shear strain rate, vertical stress and specimen height control.     

Evaluating proxies for estimating subaerial beach volume change across increasing time scales and various morphologies

Proxies, such as changes in beach profiles and shoreline positions, are commonly used in management and research for estimating changes in subaerial beach volume; however, the accuracy of these proxies across increasing time scales and complex morphologies is unclear. Volume changes associated with along‐beach morphologic variability may not be captured well by changes in profiles, while volume changes associated with across‐beach morphologic variability may not be captured well by measuring shoreline change. This study assesses the impacts of morphologic variations, associated with beach cusps and nourishment material, on volume change estimates from profiles and shoreline change at 0.5 to 3.5 year time periods. Results indicate that profiles spaced ≥ 150 m apart and the shoreline‐change proxy will likely estimate volume change inaccurately over periods ≤ 1 year at beaches that are consistently eroding or accreting and contain cusps. However, over longer time periods (1–3.5 years), estimates of volume change from both proxies improved at those types of beaches. Volume changes at the edges of nourishment areas are not captured well by profiles. When the nourishment material is graded to a ramped morphology, which minimizes across‐beach morphologic variability, the shoreline‐change proxy does accurately estimate volume changes. Both proxies estimate volume changes inaccurately at beaches where volume changes oscillate between erosion and accretion on both short and long time scales because the magnitude of small‐scale changes in volume from the formation and erosion of morphologic features, such as cusps and berms, will always be similar to the longer‐term net volume change. This study suggests that decadal records of shoreline change, which are commonly developed using aerial photography, can be used to help identify the best proxy for estimating volume change; however, recent anthropogenic modifications that impact patterns of beach sedimentation, including nourishment, terminal groins, and inlet‐channel dredging, makes decadal records less useful. Copyright © 2013 John Wiley & Sons, Ltd.     

Paleoflood events recorded by speleothems in caves

Speleothems are usually composed of thin layers of calcite (or aragonite). However, cemented detrital materials interlayered between laminae of speleothemic carbonate have been also observed in many caves. Flowstones comprising discontinuous carbonate layers form due to flowing water films, while flood events introduce fluviokarstic sediments in caves that, on occasion, are recorded as clayey layers inside flowstones and stalagmites. This record provides a potential means of understanding the frequency of palaeofloods using cave records. In this work, we investigate the origin of this type of detrital deposit in El Soplao Cave (Northern Spain). The age of the lowest aragonite layer of a flowstone reveals that the earliest flood period occurred before 500 ka, though most of the flowstone formed between 422 +69/‐43 ka and 400 +66/‐42 ka. This suggests that the cave was periodically affected by palaeoflood events that introduced detrital sediments from the surface as a result of occasional extreme rainfall events, especially at around 400 ka. The mineralogical data enable an evolutionary model for this flowstone to be generated based on the alternation of flood events with laminar flows and carbonate layers precipitation that can be extrapolated to other caves in which detrital sediments inside speleothems have been found. Copyright © 2014 John Wiley & Sons, Ltd.     

Fire severity and surface rock fragments cause patchy distribution of soil water repellency and infiltration rates after burning

Although fire‐induced soil water repellency (SWR) and its effects on soil hydrology and geomorphology have been studied in detail, very few studies have considered the effect of rock fragments resting on the soil surface or partly embedded in soil. In this research, we have studied the effect of rock fragments on the strength and spatial distribution of fire‐induced SWR at different fire severities. A fire‐affected area was selected for this experiment and classified into different zones according to fire severity (unburned, low, moderate and high) and rock fragment cover (low, <20% and high, >60%). During 7 days after fire, SWR and infiltration rates were assessed in the soil surface covered by individual rock fragments and in the midpoint between two adjacent rock fragments (with maximum spacing of 20 cm). SWR increased with fire severity. Rock fragments resting on the soil surface increased the heterogeneity of the spatial distribution of fire‐induced SWR. SWR increased significantly with rock fragment cover in bare areas under moderate and high fire severity, but quantitatively important changes were only observed under high fire severity. In areas with a low rock fragment cover, water repellency from soil surfaces covered by rock fragments increased relative to bare soil surfaces, with increasing SWR. In areas with a high rock fragment cover, SWR increased significantly from non‐covered to covered soil surfaces only after low‐severity burning. Rock fragment cover did not affect infiltration rates, although it decreased significantly in soil surfaces after high‐severity burning in areas under low and high rock fragment cover. Copyright © 2013 John Wiley & Sons, Ltd.     

Effect of selection and sequencing of representative wave conditions on process-based predictions of equilibrium embayed beach morphology

In order to decrease the simulation time of morphodynamic models, often-complex wave climates are reduced to a few representative wave conditions (RWC). When applied to embayed beaches, a test of whether a reduced wave climate is representative or not is to see whether it can recreate the observed equilibrium (long-term averaged) bathymetry of the bay. In this study, the wave climate experienced at Milagro Beach, Tarragona, Spain was discretized into ‘average’ and ‘extreme’ RWCs. Process-based morphodynamic simulations were sequenced and merged based on ‘persistent’ and ‘transient’ forcing conditions, the results of which were used to estimate the equilibrium bathymetry of the bay. Results show that the effect of extreme wave events appeared to have less influence on the equilibrium of the bay compared to average conditions of longer overall duration. Additionally, the persistent seasonal variation of the wave climate produces pronounced beach rotation and tends to accumulate sediment at the extremities of the beach, rather than in the central sections. It is, therefore, important to account for directional variability and persistence in the selection and sequencing of representative wave conditions as is it essential for accurately balancing the effects beach rotation events.     

1D velocity structure of the Po River plain (Northern Italy) assessed by combining strong motion and ambient noise data

Strong ground motions recorded on the sedimentary deposits of the Po River alluvial plain during the Emilia (Northern Italy) Mw 5.7 earthquake of May 29, 2012 are used to assess the vertical profile of shear-wave velocity above the limestone basement. Data were collected by a linear array installed for site effect studies after the Mw 5.9 mainshock of May 20, 2012. The array stations, equipped with both strong and weak motion sensors, are aligned in the South–North direction, at distances ranging from 1 to 26 km from the epicenter. The vertical components of ground motion show very distinctive, large-amplitude, low-frequency dispersive wave trains. Wavelet analysis yields group-velocity dispersion curve in the 0.2–0.7 Hz frequency band. The availability of a long ambient noise record allows estimates of the site resonance frequency along with its stability among stations. The joint inversion of dispersion of surface waves and ellipticity curves derived from ambient noise H/V allows extending investigations down to the sediment-limestone interface, at a depth of about 5,000 m. Our results add new information about the velocity structure at a scale that is intermediate between the local scale already investigated by other authors with small-aperture arrays using ambient noise and the regional scale inferred from modeling of seismogram waveforms recorded at hundreds of kilometers from the source.     

Archaeological evidence for destructive earthquakes in Sicily between 400 B.C. and A.D. 600

A systematic archaeoseismological study indicates that at least three earthquakes occurred between 400 B.C. and A.D. 600, causing destruction to numerous ancient monuments in Sicily. Evidence for these earthquakes comes from the collapse style of buildings (toppled walls, column drums in a domino‐style arrangement, directional collapses, etc.), and the exclusion of other likely causes for such effects. Dating of inferred earthquakes is based on coins (accurate to within 5–10 years), pottery (accurate to within 50–200 years), and other artifacts. The oldest documented earthquake occurred between 370 and 300 B.C. and caused the collapse of two Greek temples in Selinunte. This otherwise poorly documented event was probably also the cause of extensive destruction in northeastern Sicily in the first century A.D. Destruction of some sites may be assigned to an earthquake that occurred between 360 and 374 and correlates with the A.D. 365 seismic sequence known from historical sources. This study covers a wider region and provides a more precise dating of earthquakes than previous studies. Although it focuses on a certain period (4th–3rd centuries B.C., 4th–7th centuries A.D.), it indicates that the period before A.D. 1000 is not a period of seismic quiescence in Sicily as was previously believed, but to a period characterized by strong and destructive earthquakes. © 2009 Wiley Periodicals, Inc.     

10 Years of the optical &; UV monitor (OM) on-board <Emphasis Type="Italic">XMM-Newton</Emphasis>

The XMM-Newton X-ray observatory was launched at the end of 1999 and it is still successfully operated. In addition to the X-ray instruments, the payload carries a small telescope, the Optical Monitor, which provides simultaneous imaging and spectroscopic observations in the optical and UV ranges. In this report we review the status of the OM and its main achievements after 10 years of operations. We also introduce the XMM-OM Serendipitous Ultra-violet Source Survey (SUSS) Catalogue.