A shipborne- type wave-height meter for oceangoing vessels, using microwave Doppler radar

A wave-height meter using a simple microwave Doppler radar,simeq10mW in power and 10.525 GHz in frequency, is proposed so that we can measure oceanic waves effectively while the ship is steaming. It was first applied to the measurement of the variation of water level generated in a wave tank, which suggested that it is adequately applicable to the measurement of oceanic waves. A field test was carried out off the cape of Nojimazaki by installing the Doppler radar 5 m above the sea level at the bow of the ship. The result agreed reasonably well with that measured simultaneously by the ultrasonic wave-height meter installed at the same position. Another test is running successfully on a larger ship with the wave-height meter installed at 9 m above the sea level. The significant wave height measured by the present meter is being compared with that observed visually by the navigation officers.     

Preliminary organic petrography of Palaeozoic rocks from the Grand Banks,Newfoundland

Samples of lower Palaeozoic bedrock from the Grand Banks of Newfoundland were examined using reflected light microscopy and Rock-Eval pyrolysis. These samples contained organic material which included bitumen (structureless organic material), acritarchs, chitinozoa, scolecodonts and graptolites. The reflectance of the organic material increased from acritarchs towards graptolites with bitumen showing a wide range of reflectance. Multiple phases of oil migration through one sample were inferred by examination of the bitumens: the lowest reflecting being more recent than the highest reflecting bitumen. Combined reflectance and Rock-Eval analysis indicate that these samples are mature to overmature. The two oldest samples (Arenig-Llanvirn, Ordovician) are assessed as mature and as having potential for generation of liquid hydrocarbons, but must be considered as mainly gas prone.     

Hydrodynamic control of phytoplankton in low salinity waters of the James River estuary,Virginia, U.S.A.

Autotrophic biomass and productivity as well as nutrient distributions and phytoplankton cell populations in the James River estuary, Virginia, were quantified both spatially and temporally over a 17-month period. Emphasis was placed on the very low salinity region of the estuary in order to gain information on the fate of freshwater phytoplankters. Differing amounts of freshwater plant biomass are advected into the estuary as living material, DOC or POC and the demonstrated variability of this input must play an important role in marine biogeochemical cycling.Late summer and fall maxima in both chlorophyll a and the photosynthetic production of particulate organic carbon in very low salinity regions were inversely correlated with river discharge.During periods of low river discharge greater than 50% of the chlorophyll a biomass measured at 0‰ disappeared within a narrow range of salinity (0–2‰). Cell enumeration data suggest that species introduced from the freshwater end-member tend to comprise the bulk of the biomass removed. Confounding factors, which may contribute to the regulation of both the abundance and species of phytoplankters mid-river, include the flocculation of colloidal material with phytoplankton cells, the presence of the turbidity maximum and the growth of endemic phytoplankton populations.An inverse relationship exists between the phytoplankton abundance in very low salinity waters and the abundance of biomass measured in the lower portion of the river (estuary). Thus, autotrophic production in the fresh and very low salinity areas may indirectly regulate the onset on the spring bloom in the estuary by controlling the amount of nutrients available.     

Seismotectonic significance of the 29 January 1989 Etne earthquake, SW Norway

The integrated analysis of geological, seismological and field observations with lineament data derived from satellite images allows the identification of a possible seismogenic fault zone for an earthquake which occurred near Etne in southwestern Norway, on 29 February 1989. The hypocentre of the earthquake was located at the mid-crust at a depth of 13.8±0.9 km which is typical of small intraplate earthquakes. The Etne earthquake occurred as a result of normal faulting with a dextral strike-slip component on a NW–SE trending fault. Available geological and lineament data indicate correlation of the inferred seismogenic fault with the NW–SE trending Etne fault zone. An aeromagnetic anomaly related to the Etne fault zone forms a regional feature intersecting both Precambrian basement and allochthonous Caledonian rocks. Based on these associations the occurrence of the Etne event is ascribed to the reactivation of a zone of weakness along the Etne fault zone. Slope-instabilities developed in the superficial deposits during the Etne event demonstrate the existence of potentially hazardous secondary-effects of such earthquakes even in low seismicity areas such as southwestern Norway.     

Thaw modification of frost-fissure wedges,Richards Island,Pleistocene Mackenzie Delta,Western Arctic Canada

Thaw modification is the general process whereby frost-fissure wedges are modified during thaw, and by which frost-fissure pseudomorphs may develop. Specific processes of thaw modification are inferred from ice-wedge pseudomorphs, composite-wedge pseudomorphs and deformed sand wedges in the Pleistocene Mackenzie Delta: i.e. thermal erosion, collapse, subsidence, refreezing, loading, buoyancy, spreading, folding and shearing. Thaw modification is believed to result in selective preservation of pseudomorphs and wedges. Sand wedges are more likely to be preserved than are ice-wedge pseudomorphs or compositewedge pseudomorphs, because only those sand wedges that penetrate massive ice or icy sediments are prone to thaw modification. Furthermore, whereas ice wedges preferentially develop in ice-rich, fine-grained sediments (thaw-sensitive), their pseudomorphs appear to be selectively preserved in ice-poor, coarse-grained sediments (thaw-stable).     

Recharge and salinization in the Madrid Basin

The purpose of this work was to reinvestigate the existing hydrogeological conceptual model of the basin of Madrid, Spain. A cumulative chemical isotopic diagram which enabled the distinction between different groups of water as well as calculation of the mode of their blending was used for this investigation. It was found that the groups of discharge were lighter in their isotopic composition than that of recharge. The previous explanation of this fact, backed by carbon-14 dating, was the long residence time due to flow lines going down to depths of more than 1000 m. This flow model assumes homogenous conditions to these depths. This assumption can not be supported by evidence from deep wells. Thus a modified model is suggested which maintains homogenous conditions only to about 300 m and a deep confined aquifer below containing paleowater. The higher degree of depletion of this water has been explained by a colder climate on top of an altitude effect. Another interesting observation was the correlation between the isotopic composition of the rains, the month of the rain event and the composition of the recharge group groundwater. It could be seen that the winter rains resemble the groundwater composition, which shows that practically all the spring and summer rains were evapotranspirated.     

THE EUROPEAN MACROSEISMIC SCALE (MSK-92)

A new updated version of the MSK macroseismic intensity scale has been prepared by a Working Group of the European Seismological Commission and has been published in April 1993 (European Macroseismic Scale 1992: updated MSK scale, 1993, ed. by G. Grünthal, Cahiers du Centre Européen de Geodynamique et de Séismologie, no. 7).     

The stable isotope signature of kilometre-scale fracturedominated metamorphic fluid pathways, Mary Kathleen, Australia

Abstract Large calcite veins and pods in the Proterozoic Corella Formation of the Mount Isa Inlier provide evidence for kilometre-scale fluid transport during amphibolite facies metamorphism. These 10- to 100-m-scale podiform veins and their surrounding alteration zones have similar oxygen and carbon isotopic ratios throughout the 200 × 10-km Mary Kathleen Fold Belt, despite the isotopic heterogeneity of the surrounding wallrocks. The fluids that formed the pods and veins were not in isotopic equilibrium with the immediately adjacent rocks. The pods have δ¹³C_calcite values of –2 to –7% and δ¹⁸O_calcite values of 10.5 to 12.5%. Away from the pods, metadolerite wallrocks have δ¹⁸O_whole-rock values of 3.5 to 7%. and unaltered banded calc-silicate and marble wallrocks have δ¹³C_calcite of –1.6 to –0.6%, and δ¹⁸O_calcite of 18 to 21%. In the alteration zones adjacent to the pods, the δ¹⁸O values of both metadolerite and calc-silicate rocks approach those of the pods. Large calcite pods hosted entirely in calc-silicates show little difference in isotopic composition from pods hosted entirely in metadolerite. Thus, 100- to 500-m-scale isotopic exchange with the surrounding metadolerites and calc-silicates does not explain the observation that the δ¹⁸O values of the pods are intermediate between these two rock types. Pods hosted in felsic metavolcanics and metasiltstones are also isotopically indistinguishable from those hosted in the dominant metadolerites and calc-silicates. These data suggest the veins are the product of infiltration of isotopically homogeneous fluids that were not derived from within the Corella Formation at the presently exposed crustal level, although some of the spread in the data may be due to a relatively small contribution from devolatilization reactions in the calc-silicates, or thermal fluctuations attending deformation and metamorphism. The overall L-shaped trend of the data on plots of δ¹³C vs. δ¹⁸O is most consistent with mixing of large volumes of externally derived fluids with small volumes of locally derived fluid produced by devolatilization of calc-silicate rocks. Localization of the vein systems in dilatant sites around metadolerite/calc-silicate boundaries indicates a strong structural control on fluid flow, and the stable isotope data suggest fluid migration must have occurred at scales greater than at least 1 km. The ultimate source for the external fluid is uncertain, but is probably fluid released from crystallizing melts derived from the lower crust or upper mantle. Intrusion of magmas below the exposed crustal level would also explain the high geothermal gradient calculated for the regional metamorphism.     

Monsoon-induced sea surface temperature changes recorded in Indian corals

The South Asian Summer Monsoon induces vertical mixing in the surface Arabian Sea, leading to a reduction in the Sea Surface Temperature (SST) of the order of 3–4°C. This reduction in temperature is recorded by modern corals (Porites) that grow in the Lakshadweep Islands (coralline islands located at about 350 km off the south-west coast of India) in their stable oxygen isotope ratios (denoted by δ¹⁸O). As large coral colonies of this genus are available, our results show that palaeomonsoon records for a few centuries back in time, a crucial input for climatic models aimed at predicting the Asian Monsoon, can be obtained from these corals. We also show that two corals separated by ? 60 km show similar (518O variations as does a giant clam (Tridacna maximus) that grew near one end of the coral colonies. As this clam is known to precipitate CaCO3 in isotopic equilibrium with the ambient sea-water, it is possible to estimate the isotopic offset of coralline δ¹⁸O from that of the CaCO3 precipitated in isotopic equilibrium. This ‘disequilibrium effect’ appears to be constant around 4.5±0.2%0. Our calculations show that SST (t, °C) is related to the coral δ¹⁸O (δ_c) and the sea-water δ¹⁸O (δ_w) by the equation t = 3.0–4.68 (δ_c - δ_w), which is in good agreement with such relationships for corals from the Pacific and Atlantic.