JECSS news no. 7 R/V Akademik Korolyev,nautical archaeology,ts-ts meander,oki island-canyon system

JECSS news no. 7 R/V Akademik Korolyev, nautical archaeology, ts-ts meander, oki island-canyon system     

Simple determination of dimethylsulfide (DMS) and dimethylsulfoniopropionate (DMSP) using solid-phase microextraction and gas chromatography-mass spectrometry

Solid-phase microextraction (SPME) is a simple, sensitive and less destructive method for the determination of dimethylsulfide (DMS) in seawater. Combined with detection by gas chromatography-mass spectrometry (GC-MS), the method had sufficient sensitivity (minimum detectable concentration of DMS was 0.05 nM), and practical levels of reproducibility (relative standard deviation ≤7%) and linearity (r ² > 0.995) over a wide concentration range (0.5 to 910 nM). The protocol developed was applied to a Sagami Bay water sample to determine concentrations of DMS and DMSP, and in situ DMSP-lyase activity.     

Oil-generation kinetics for organic facies with Type-II and -IIS kerogen in the Menilite Shales of the Polish Carpathians

The Menilite Shales (Oligocene) of the Polish Carpathians are the source of low-sulfur oils in the thrust belt and some high-sulfur oils in the Carpathian Foredeep. These oil occurrences indicate that the high-sulfur oils in the Foredeep were generated and expelled before major thrusting and the low-sulfur oils in the thrust belt were generated and expelled during or after major thrusting. Two distinct organic facies have been observed in the Menilite Shales. One organic facies has a high clastic sediment input and contains Type-II kerogen. The other organic facies has a lower clastic sediment input and contains Type-IIS kerogen. Representative samples of both organic facies were used to determine kinetic parameters for immiscible oil generation by isothermal hydrous pyrolysis and S₂ generation by non-isothermal open-system pyrolysis. The derived kinetic parameters showed that timing of S₂ generation was not as different between the Type-IIS and -II kerogen based on open-system pyrolysis as compared with immiscible oil generation based on hydrous pyrolysis. Applying these kinetic parameters to a burial history in the Skole unit showed that some expelled oil would have been generated from the organic facies with Type-IIS kerogen before major thrusting with the hydrous-pyrolysis kinetic parameters but not with the open-system pyrolysis kinetic parameters. The inability of open-system pyrolysis to determine earlier petroleum generation from Type-IIS kerogen is attributed to the large polar-rich bitumen component in S₂ generation, rapid loss of sulfur free-radical initiators in the open system, and diminished radical selectivity and rate constant differences at higher temperatures. Hydrous-pyrolysis kinetic parameters are determined in the presence of water at lower temperatures in a closed system, which allows differentiation of bitumen and oil generation, interaction of free-radical initiators, greater radical selectivity, and more distinguishable rate constants as would occur during natural maturation. Kinetic parameters derived from hydrous pyrolysis show good correlations with one another (compensation effect) and kerogen organic-sulfur contents. These correlations allow for indirect determination of hydrous-pyrolysis kinetic parameters on the basis of the organic-sulfur mole fraction of an immature Type-II or -IIS kerogen.     

Early Jurassic rift structures associated with the Soapaga and Boyacá faults of the Eastern Cordillera, Colombia: Sedimentological inferences and regional implications

The NW-trending Bucaramanga fault links, at its southern termination, with the Soapaga and Boyacá faults, which by their NW trend define an ample horsetail structure. As a result of their Neogene reactivation as reverse faults, they bound fault-related anticlines that expose the sedimentary fill of two Early Jurassic rift basins. These sediments exhibit the wedge-like geometry of rift fills related to west-facing normal faults. Their structural setting was controlled further by segmentation of the bounding faults at approximately 10 km intervals, in which each segment is separated by a transverse basement high. Isopach contours and different facies associations suggest these transverse anticlines may have separated depocenters of their adjacent subbasins, which were shaped by a slightly different subsidence history and thereby decoupled. The basin fill of the relatively narrow basin associated with the Soapaga fault is dominated by fanglomeratic successions organized in two coarsening-upward cycles. In the larger basin linked to the Boyacá fault, the sedimentary fill consists of two coarsening-upward sequences that, when fully developed, vary from floodplain to alluvial fan deposits. These Early Jurassic rift fills temporally constrain the evolution of the Bucaramanga fault, which accommodated right-lateral displacement during the early Mesozoic rift event.     

Assessing the Vibrational Frequencies of the Cathedral of Cologne (Germany) by Means of Ambient Seismic Noise Analysis

Ambient seismic noise measurements were conducted inside the Cathedral of Cologne (Germany) for assessing its frequencies of vibration and for checking whether these occur in the range where soil amplification is expected. If this is the case, damages may increase in case of an earthquake due to an increased structural response of the building. Analysis of the ratio between the horizontal and vertical components of the spectra recorded at stations located inside the building as well as the ratio between the corresponding components of the spectra recorded simultaneously inside the building and at a reference station placed in the basement of the cathedral indicated several modes of vibration. Facilitated by these results an assessment of the seismic vulnerability was attempted for a 2D ground motion scenario using the finite element method.     

Early Holocene water budget of the Nakuru-Elmenteita basin, Central Kenya Rift

The Nakuru-Elmenteita basin in the Central Kenya Rift, contains two shallow, alkaline lakes, Lake Nakuru (1770 m above sea level) and Lake Elmenteita (1786 m). Ancient shorelines and lake sediments at 1940 m suggest that these two lakes formed a single large and deep lake as a result of a wetter climate during the early Holocene. Here, we used a hydrological model to compare the precipitation–evaporation balance during the early Holocene to today. Assuming that the Nakuru-Elmenteita basin was hydrologically closed, as it is today, the most likely climate scenario includes a 45% increase in mean-annual precipitation, a 0.5°C decrease in air temperature, and an increase of 9% in cloud coverage from the modern values. Compared to the modeling results from other East African lake basins, this dramatic increase in precipitation seems to be unrealistic. Therefore, we propose a significant flow of water from the early Holocene Lake Naivasha in the south towards the Nakuru-Elmenteita basin to compensate the extremely negative hydrological budget of this basin. Since we did not find any field evidence for a surface connection, as often proposed during the last 70 years, the hydrological deficit of the Nakuru-Elmenteita basin could have also been compensated by a subsurface water exchange.     

Strike-slip fault bridge fluid pumping mechanism: insights from field-based palaeostress analysis and numerical modelling

We present a finite-element study of stress perturbation in evolving compressive and extensional strike-slip fault bridges. The results are compared with a fracture study of a compressive bridge at St Donats, UK. Horizontally interbedded calcareous mudstone and bioclastic calcilutite at St Donats have a distinct vertical permeability anisotropy. This sedimentary sequence behaves as a set of horizontal aquifers. The fluid flow in these aquifers is sensitive to mean stress gradients. Paleostress analysis of field fracture data, verified by finite-element modelling, indicates a rotation of σ₁ towards parallelism with boundary faults inside the growing compressive bridge. Boundary faults and bridge faults recorded numerous fluid flow events. The modelled mean stress pattern shows a regional maximum within the bridge and local maxima/minima pairs at boundary fault tips.Finite-element modelling of an extensional bridge indicates that σ₃ rotates towards parallelism with boundary faults. The mean stress pattern is similar to the pattern in compressive bridge but with maxima and minima locations interchanged. The stress patterns are reestablished by each stress build-up preceding the rupturation of the boundary faults throughout the development stages of strike-slip fault bridges. Mean stress gradients developed pre-failure control the fluid flow in fractures of the strike-slip fault system at and after the end of each stress build-up and the fluid flow in boundary faults post-failure. Fracture reactivation and new fracture generation within an evolving bridge is a process consisting of multiple successive events that retain the storage capacity of the bridge. Rupture and sealing of the main bounding-faults is a step-wise process that opens and closes fluid conduits between areas with different pressures.