An inverse procedure to estimate transmissivity from heads and SP signals

Experimental hydraulic heads and electrical (self-potential) signals associated with a pumping test were used in an inverse model to estimate the transmissivity distribution of a real aquifer. Several works reported in the literature show that there is a relatively good linear relationship between the hydraulic heads in the aquifer and electrical signals measured at the ground surface. In this experimental test field, first, the current coupling coefficient was determined by the best fit between experimental and modeled self-potential signals at the end of the pumping phase. Soon afterward, with the hydraulic heads obtained from the self-potential signals, the transmissivity distribution of the aquifer was conditioned by means an inverse model based on the successive linear estimator (SLE). To further substantiate the estimated T field from the SLE analysis, we analyzed the drawdown rate, the derivative of the drawdown with respect to the ln(t), because the drawdown rate is highly sensitive to the variability in the transmissivity field. In our opinion, these results show that self-potential signals allow the monitoring of subsurface flow in the course of pumping experiments, and that electrical potentials serve as a good complement to piezometric observations to condition and characterize the transmissivity distribution of an aquifer.     

Monte-Carlo Simulations of Cosmic-ray and Internal Radiation Effects on ISOCAM on Board ISO

One of the main limitations to the sensitivity of the infrared camera ISOCAM on-board the Infrared Space Observatory (ISO) comes from responsivity variations and glitches caused by the impacts of charged particles in photo-detectors. Glitch rate measurements, glitch properties and removal methods have already been addressed during the first ISO detector workshop(Madrid, 1998) and published in a special issue of Experimental Astronomy. It appeared that glitch rate and most of glitch properties could be reproduced by Monte-Carlo simulations. This is very interesting in order to predict before launch the effect of charged particles in photo-detectors operated in space. This paper presents results of Monte-Carlo simulations of radiation effects on ISOCAM detectors. Glitch rates, spatial and energetic properties of glitches have been computed and are compared with measured values. This revised version was published online in July 2006 with corrections to the Cover Date.     

Isotropic and anisotropic pointing models

This paper describes an alternative approach for generating pointing models for telescopes equipped with serial kinematics, esp. equatorial or alt-az mounts. Our model construction does not exploit any assumption for the underlying physical constraints of the mount, however, one can assign various effects to the respective components of the equations. In order to recover the pointing model parameters, classical linear least squares fitting procedures can be applied. This parameterization also lacks any kind of parametric singularity. We demonstrate the efficiency of this type of model on real measurements with meter-class telescopes where the results provide a root mean square accuracy of 1.5?2 arcseconds.     

Analysis of anisotropy of magnetic susceptibility in iron-oolitic beds: a potential tool for paleocurrent identification

A combined sedimentological, shape-preferred orientation and anisotropy of magnetic susceptibility (AMS) analysis has been performed at the Arroyofrío Bed (Callovian–Oxfordian boundary level) in the locality of Moneva (Iberian Range, NE Spain). The Arroyofrío bed is a widespread iron-ooid limestone interval forming a condensed sequence. The present study has focused on the analysis of the potential presence of a preferred ooid orientation at the Arroyofrío bed. The obtained data show that ooids were originally ellipsoidal and had an imbricate disposition with respect to the bedding/lamination surface. The main ooid orientation within the bedding plane shows a NNE–SSW trend. Results of AMS analyses show a magnetic foliation parallel or slightly imbricated with respect to bedding and magnetic lineation parallel to the main ooid orientation. Magnetic mineralogy of studied samples shows that AMS is mainly controlled by magnetite with minor contributions of hematite and paramagnetic minerals (that can reach contributions of 35 %). The analyzed ooids show axial ratios between 1.4 and 2.8 (intrinsic anisotropy), while the anisotropy of their distribution shows lower anisotropies (e.g., Rs = 1.15) or very low values of the anisotropic magnetic parameters (e.g., P′ < 1.01). Sedimentary texture, matrix features, bioturbation and fossil content influenced both ooid main orientation and the magnetic fabric. Magnetic lineation and main orientation of long ooid axes are transverse to the inferred coastline in the studied area and parallel to the expected paleocurrent direction with respect to the Ejulve-Maestrazgo paleogeographic high. The direct correlation between AMS magnetic lineation and the ooid analysis permits to demonstrate that the paleocurrent imprint can be recorded by means of AMS despite the highly ferromagnetic context fabric and at coarse deposits. Obtained results support the interest and reliability of AMS to unravel paleocurrent imprints for paleogeographic reconstructions.     

Performance enhancement of a GIS-based facility location problem using desktop grid infrastructure

This paper presents the integration of desktop grid infrastructure with GIS technologies, by proposing a parallel resolution method in a generic distributed environment. A case study focused on a discrete facility location problem, in the biomass area, exemplifies the high amount of computing resources (CPU, memory, HDD) required to solve the spatial problem. A comprehensive analysis is undertaken in order to analyse the behaviour of the grid-enabled GIS system. This analysis, consisting of a set of the experiments on the case study, concludes that the desktop grid infrastructure is able to use a commercial GIS system to solve the spatial problem achieving high speedup and computational resource utilization. Particularly, the results of the experiments showed an increase in speedup of fourteen times using sixteen computers and a computational efficiency greater than 87 % compared with the sequential procedure.     

Heat balance for the high-temperature component of a solar flare

Shortly after the occurrence of the impulsive spikes of the two-ribbon flare of May 21, 1980, a temperature analysis of the X-ray emitting flare plasma showed the presence of a low-temperature component [n = 15 × 10¹⁰ cm^#X2212;3; T = 20 × 10⁶ K] and a high-temperature component [n = 2 × 10¹⁰ cm^#X2212;3; T = 40 × 10⁶ K]. The mean free path of an electron in the hot component is comparable to the size of the source (≈ 10⁴ km). Heat losses from the hot source can therefore not be described with classical formulae. Theoretical arguments show that most likely the electron to ion temperature ratio T _e/T_i in the hot plasma is close to unity. This implies the presence of a hot ion component (T _i ≈ 40 × 10⁶ K) as well. Under these conditions (T _e ≈ T _i) heat flux limitation by electrostatic turbulence is ineffective. However, reduction of the heat flux is still possible due to the breakdown of classical theory. It is demonstrated that only non-classical current dissipation processes can sustain a hot source against cooling by a saturated heat flux. Investigation of the collisionality as a function of position along a magnetic loop shows that the breakdown of classical theory should be expected to occur first near the base of the loop. We conclude that the newly discovered hot source is important for the energy budget of the flare, even if the heat losses are considerably reduced. It is estimated that for the May 21, 1980 flare a total of about 10³¹ ergs were necessary to maintain the hot source against heat losses over the time period that it was observed (≈ 10 min).     

Temporal variability of selected dissolved elements in the lower Orinoco River,Venezuela

Monthly analyses of pH, conductance, alkalinity, total suspended solids, dissolved major cations (Na, K, Ca and Mg), and selected dissolved trace elements (Fe, Al, Mn, Cu, Zn and Cr) were conducted on waters of the lower Orinoco River from February 2004 to May 2006. The data show strong seasonal variability. Major cations had maximum concentrations at low water, and were correlated with pH, conductance and alkalinity because of the tributaries coming from the Andean zones, where the weathering of evaporites and carbonate shales controls water chemistry. K concentrations did not show any relation with evaporite weathering, probably because large amounts of K come from the Guayana Shield rivers as a consequence of feldspar weathering. The concentrations of dissolved Fe, Mn and Cu were highest during the high water stage. Concentrations of the elements K, Cr, Zn and Cu are correlated with each other but not with dissolved Fe and Al, which probably are complexed with humic and fulvic substances. Mn concentrations did not show relationships with other variables. Inter‐annual variability of dissolved elements is explained by temporal changes in precipitation. Copyright © 2008 John Wiley & Sons, Ltd.     

Species richness,diversity and density of understory vegetation along disturbance gradients in the Himalayan conifer forest

We investigated whether species richness, diversity and density of understory herbaceous plants differed along logging(gap) and grazing(primarily by cattle) disturbance gradients, and sought to identify drivers of richness, diversity and density of understory vegetation of logged sites. A factorial experiment was conducted in the mixed conifer forest of Gidakom in Western Bhutan. Levels of the logging treatment included small(0.15 – 0.24 ha), medium(0.25 – 0.35 ha) and large(0.36 – 1.31 ha) gaps. The grazing treatment included grazed(primarily by cattle) and ungrazed(where herbivores were excluded by a fence) plots nested within each gap. Data were collected from 12 gaps(4 replicates at each level of logging) using the point intercept method. Shannon Weaver Diversity and Margalef's indices were used to estimate species diversity and describe species richness, respectively. Soil samples were analyzed for pH and nutrients. The interaction effect of logging and grazing was significant(p≤0.001) only on species diversity. Relative to ungrazed areas, species diversity was significantly higher(0.01≤p≤0.05) in medium grazed gaps. Under grazed conditions, soil P was negatively correlated with gap size and species diversity. While species diversity was positivelycorrelated(0.01≤p≤0.05) with soil N in grazed plots species richness was positively correlated(0.001≤p≤0.01) with soil N in ungrazed plots. Relative density of Yushania microphylla and Carex nubigena were higher under ungrazed conditions. Our study suggests that the combined effect of cattle grazing and logging results in higher species diversity of understory vegetation in medium and grazed gaps in mixed conifer forests of Bhutan,whereas increase or decrease in relative density of major species is determined primarily by the independent effects of grazing and logging. From management perspective, forest managers must refrain from creating large gaps to avoid loss of nutrients(mainly P and N), which may eventually affect tree regeneration. Managers intending to maintain understory vegetation diversity must consider the combined effects of grazing and logging, ensuring low to moderate grazing pressure.     

Mushroom production as an alternative for rural development in a forested mountainous area

Wild mushrooms are recognized as important non-wood forest products in mountainous ecosystems, but their real potential for generating rural economies has not been fully evaluated due to the difficulties in obtaining reliable productivity data, minimizing their true potential as contributor to rural economies. Mushroom yield models based on large data series from Pinus forest ecosystems in the region of Catalonia(Spain), combined with data from the Spanish National Forest Inventory allow us to estimate the potential mushroom productivity by forest ecosystems. The results of 24,500 tons/yr of mushrooms of which 16,300 tons are classified as edible and 7,900 tons are commonly marketed demonstrate the importance of mushroom productions in Catalonian pine forests, mostly located in mountainous areas where the development of agricultural activities is limited. Economic mushroom value is estimated at 48 million € for the edible mushroom and 32 million € for those corresponding to marketable yields, confirming the potential of this non-wood forest product. These production results and corresponding economic values provide a basis for the incorporation of wild mushrooms as significant non-wood forest products in the development of forest policies in mountainous areas.